Preparation of Pb(Zr0.52Ti0.48)O3-Ni0.5Zn0.5Fe2O4 Bilayer Thin Films and their Magnetic and Ferroelectric Properties

2012 ◽  
Vol 248 ◽  
pp. 212-217
Author(s):  
Fu Xue Yan ◽  
Gao Yang Zhao ◽  
Na Song ◽  
Yuan Qing Chen

Ni0.5Zn0.5Fe2O4-Pb(Zr0.52Ti0.48)O3 (NZFO-PZT) composite films were prepared using sol–gel method on Si (100) substrate with different bilayer structures, namely, the NZFO/PZT (NP) and the PZT/NZFO (PN). Their structure, magnetic and ferroelectric properties were characterized by X-ray diffractometer (XRD), vibration sample magnetometer (VSM) and ferroelectric testing unit. Both the NP and the PN films exhibit coexistence of magnetic and ferroelectric properties. The overlapping sequence has much influence on the electrical properties. Whereas, such an overlapping structure of the films has slightly effect on its magnetic properties. The NP structured composite film is more suitable to get a promising magnetoelectric coupling.

2005 ◽  
Vol 19 (01n03) ◽  
pp. 671-673
Author(s):  
PENG XIAO ◽  
WANLU WANG

The Fe 3+- TiO 2 thin films obtained through sol-gel method were characterized by x-ray diffraction, AFM and Raman spectroscopy. It was found that TiO 2 films consisted of nanometer particles. The experimental results shows that the nanometer TiO 2 thin films doped with Fe 3+ were greatly improved in the activity aspect. This may be ascribed to change their structure and electrical properties after doping with Fe 3+. The results were discussed theoretically in detail.


2012 ◽  
Vol 501 ◽  
pp. 236-241 ◽  
Author(s):  
Ftema W. Aldbea ◽  
Noor Bahyah Ibrahim ◽  
Mustafa Hj. Abdullah ◽  
Ramadan E. Shaiboub

Thin films nanoparticles TbxY3-xFe5O12 (x=0.0, 1.0, 2.0) were prepared by the sol-gel process followed by annealing process at various annealing temperatures of 700° C, 800° C and 900° C in air for 2 h. The results obtained from X-ray diffractometer (XRD) show that the films annealed below 900°C exhibit peaks of garnet mixed with small amounts of YFeO3 and Fe2O3. Pure garnet phase has been detected in the films annealed at 900°C. Before annealing the films show amorphous structures. The particles sizes measurement using the field emission scanning electron microscope (FE-SEM) showed that the particles sizes increased as the annealing temperature increased. The magnetic properties were measured at room temperature using the vibrating sample magnetometer (VSM). The saturation magnetization (Ms) of the films also increased with the annealing temperature. However, different behavior of coercivity (Hc) has been observed as the annealing temperature was increased.


2015 ◽  
Vol 76 (1) ◽  
pp. 220-226 ◽  
Author(s):  
Dongfang Chen ◽  
Shengli Huang ◽  
Jianguo Chen ◽  
Jinrong Cheng

2012 ◽  
Vol 23 (9) ◽  
pp. 1711-1714 ◽  
Author(s):  
Changyong Liu ◽  
Yiping Gong ◽  
Dongyun Guo ◽  
Chuanbin Wang ◽  
Qiang Shen ◽  
...  

2012 ◽  
Vol 64 (3) ◽  
pp. 711-717 ◽  
Author(s):  
Ling Pei ◽  
Ni Hu ◽  
Gang Deng ◽  
Yiwan Chen ◽  
Yeguang Bie ◽  
...  

2013 ◽  
Vol 756 ◽  
pp. 91-98 ◽  
Author(s):  
Ftema W. Aldbea ◽  
Noor Bahyah Ibrahim ◽  
Mustafa Hj. Abdullah

Terbium –substituted yttrium iron garnet (Tb1.5Y1.5Fe5O12) films nanoparticles were successfully prepared by a sol-gel method. The films were deposited on the quartz substrate using spin coating technique. To study effect of annealing temperature, the annealing process was executed at 700, 800 and 900 °C in air for 2 hours. The X-ray diffraction (XRD) proved that the pure phase of garnet structure was detected for the film annealed at 900 °C. The lattice parameter increased with the increment of annealing temperature and the highest value of 12.35 Å was obtained at 900 °C. Field Emission Scanning Electron Microscope (FE-SEM) results showed that the particle size increased from 43nm to 56nm as annealing temperature increased from 700 to 900°C. The film’s thickness also affected by increasing of annealing temperature and become thin at 900 °C due to densification process occurred at high annealing temperature. The elemental compositions of the Tb1.5Y1.5Fe5O12 film were detected using an Energy Dispersive X-raySpectroscopy (EDX). Magnetic properties at room temperature were measured using a Vibrating Sample Magnetometer (VSM).The saturation magnetization Ms increased with the annealingtemperature and showed a high value of 104emu/cm3, but the coercivity Hc of the film was decreased due to the increment of the particle size. Normal 0 21 false false false MS X-NONE X-NONE MicrosoftInternetExplorer4 Terbium –substituted yttrium iron garnet (Tb1.5Y1.5Fe5O12) films nanoparticles were successfully prepared by a sol-gel method. The films were deposited on the quartz substrate using spin coating technique. To study effect of annealing temperature, the annealing process was executed at 700, 800 and 900°C in air for 2 hours. The X-ray diffraction (XRD) proved that the pure phase of garnet structure was detected for the film annealed at 900 °C. The lattice parameter increased with the increment of annealing temperature and the highest value of 12.35 Å was obtained at 900 °C. Field Emission Scanning Electron Microscope (FE-SEM) results showed that the particle size increased from 43nm to 56nm as annealing temperature increased from 700 to 900 °C. The film’s thickness also affected by increasing of annealing temperature and become thin at 900 °C due to densification process occurred at high annealing temperature. The elemental compositions of the Tb1.5Y1.5Fe5O12 film were detected using an Energy Dispersive X-ray Spectroscopy (EDX). Magnetic properties at room temperature were measured using a Vibrating Sample Magnetometer (VSM).The saturation magnetization Ms increased with the annealing temperature and showed a high value of 104emu/cm3, but the coercivity Hc of the film was decreased due to the increment of the particle size. st1\:*{behavior:url(#ieooui) } /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin:0cm; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:11.0pt; font-family:"Calibri","sans-serif"; mso-ascii-font-family:Calibri; mso-ascii-theme-font:minor-latin; mso-fareast-font-family:"Times New Roman"; mso-fareast-theme-font:minor-fareast; mso-hansi-font-family:Calibri; mso-hansi-theme-font:minor-latin; mso-bidi-font-family:"Times New Roman"; mso-bidi-theme-font:minor-bidi;}


2013 ◽  
Vol 652-654 ◽  
pp. 519-522
Author(s):  
Jun Chen ◽  
Yue Hui Hu ◽  
Hong Hao Hu ◽  
Yi Chuan Chen

Transparent thin films of Sn-doped ZnO (ZnO:Sn) were deposited onto silica glass substrates by the sol–gel method. The effect of different Sn doping on the crystallinity, structural, optical and electrical properties of ZnO:Sn thin films were investigated by XRD, SEM, UV-VIS spectrophotometer and four-point probe method respectively. Among all of ZnO:Sn thin films in this paper, Sn-doped with 2 at.% exhibited the best properties, the surface demonstrate an accumulative crystallization and hexagonal structure, with a high-preferential c-axis orientation, namely an average transmittance of 90% and the resistivity of 19.6 Ω·cm.


2011 ◽  
Vol 268-270 ◽  
pp. 356-359 ◽  
Author(s):  
Wen Song Lin ◽  
C. H. Wen ◽  
Liang He

Mn, Fe doped ZnO powders (Zn0.95-xMnxFe0.05O2, x≤0.05) were synthesized by an ameliorated sol-gel method, using Zn(CH3COO)2, Mn(CH3COO)2and FeCl2as the raw materials, with the addition of vitamin C as a kind of chemical reducer. The resulting powder was subsequently compacted under pressure of 10 MPa at the temperature of 873K in vacuum. The crystal structure and magnetic properties of Zn0.95-xMnxFe0.05O2powder and bulk samples have been investigated by X-ray diffraction (XRD) and vibrating sample magnetometer (VSM). X-ray photoelectron spectroscopy (XPS) was used to study chemical valence of manganese, iron and zinc in the samples. The x-ray diffraction (XRD) results showed that Zn0.95-xMnxFe0.05O (x≤0.05) samples were single phase with the ZnO-like wurtzite structure. No secondary phase was found in the XRD spectrum. X-ray photoelectron spectroscopy (XPS) showed that Fe and Mn existed in Zn0.95-xMnxFe0.05O2samples in Fe2+and Mn2+states. The results of VSM experiment proved the room temperature ferromagnetic properties (RTFP) of Mn, Fe co-doped ZnO samples.


Sign in / Sign up

Export Citation Format

Share Document