Stirling Engines Powered by Renewable Energy Sources

2016 ◽  
Vol 831 ◽  
pp. 263-269
Author(s):  
Jacek Kropiwnicki ◽  
Aleksandra Szewczyk

Stirling engine is a device that produces mechanical energy using heat from any source of energy, without the need of combustion of any fuel inside the device. Renewable energy sources, which are mostly low-temperature energy sources, can be used to produce mechanical and electrical energy in Stirling engines. The paper presents an overview of the existing prototype Stirling engines designed for using of low-temperature energy sources, including renewable energy sources. Commercial devices for electric power generation offered for use in home, usually do not exceed 1 kW. Using the Schmidt model, the analyze of influence of temperature working fluid in the expansion space (heater) on the efficiency and the electric power generated in the Stirling engine of alpha type has been presented in the paper.

Author(s):  
Leonid Yuferev

The transmission of electric energy from renewable energy sources requires a system of transmission of electrical energy. The most widespread system of electric power transmission is AC and DC. The chapter presents a description of a resonant system of electric power transmission on one wire. This system converts AC or DC voltage and transmits it over a single wire. At the end of a transmission line is a reverse converter that generates the standard voltage. This system of transmission of electrical energy can be applied to lighting systems.


2021 ◽  
Vol 11 (2) ◽  
pp. 429-436
Author(s):  
Widi Aribowo ◽  
Achmad Imam Agung ◽  
Subuh Isnur Haryudo ◽  
Syamsul Muarif

The need for electrical energy has increased every year. On the other hand, the largest power plants in Indonesia still use non-renewable energy sources such as coal and petroleum, while these non-renewable energy sources will eventually run out. To anticipate running out of this energy, a renewable energy source is needed. This existence will not run out even though it is consumed every day. Renewable energy that can be used for conversion into electrical energy in coastal areas is wave power.  The waves that always crash on the shoreline can be used to drive turbines. The turbine rotates due to the crashing waves connected to a DC generator. It will convert mechanical energy into electrical energy. The electrical energy generated by the DC generator is used to charge the battery. The purpose of this research is the know-how to design a wave power generator and to determine the performance. The experimental method is used in this study. In the results, the generator works optimally during the day with the resulting voltage of 10.6 V to 10.7 V with rotation speed of 623 Rpm to With 710 Rpm.


Energies ◽  
2021 ◽  
Vol 14 (10) ◽  
pp. 2862
Author(s):  
Mika Korkeakoski

Renewable Energy Sources (RES) have become increasingly desirable worldwide in the fight against global climate change. The sharp decrease in costs of especially wind and solar photovoltaics (PV) have created opportunities to move from dependency on conventional fossil fuel-based electricity production towards renewable energy sources. Renewables experience around 7% (in 2018) annual growth rate in the electricity production globally and the pace is expected to further increase in the near future. Cuba is no exception in this regard, the government has set an ambitious renewable energy target of 24% RES of electricity production by the year 2030. The article analyses renewable energy trajectories in Isla de la Juventud, Cuba, through different future energy scenarios utilizing EnergyPLAN tool. The goal is to identify the best fit and least cost options in transitioning towards 100% electric power systemin Isla de la Juventud, Cuba. The work is divided into analysis of (1) technical possibilities for five scenarios in the electricity production with a 40% increase of electricity consumption by 2030: Business As Usual (BAU 2030, with the current electric power system (EPS) setup), VISION 2030 (according to the Cuban government plan with 24% RES), Advanced Renewables (ARES, with 50% RES), High Renewables (HiRES, with 70% RES), and Fully Renewables (FullRES, with 100% RES based electricity system) scenarios and (2) defining least cost options for the five scenarios in Isla de la Juventud, Cuba. The results show that high penetration of renewables is technically possible even up to 100% RES although the best technological fit versus least cost options may not favor the 100% RES based systems with the current electric power system (EPS) setup. This is due to realities in access to resources, especially importation of state of the art technological equipment and biofuels, financial and investment resources, as well as the high costs of storage systems. The analysis shows the Cuban government vision of reaching 24% of RES in the electricity production by 2030 can be exceeded even up to 70% RES based systems with similar or even lower costs in the near future in Isla de la Juventud. However, overcoming critical challenges in the economic, political, and legal conditions are crucially important; how will the implementation of huge national capital investments and significant involvement of Foreign Direct Investments (FDI) actualize to support achievement of the Cuban government’s 2030 vision?


2015 ◽  
Vol 785 ◽  
pp. 576-580 ◽  
Author(s):  
Liaw Geok Pheng ◽  
Rosnani Affandi ◽  
Mohd Ruddin Ab Ghani ◽  
Chin Kim Gan ◽  
Jano Zanariah

Solar energy is one of the more attractive renewable energy sources that can be used as an input energy source for heat engines. In fact, any heat energy sources can be used with the Stirling engine. Stirling engines are mechanical devices working theoretically on the Stirling cycle, or its modifications, in which compressible fluids, such as air, hydrogen, helium, nitrogen or even vapors, are used as working fluids. When comparing with the internal combustion engine, the Stirling engine offers possibility for having high efficiency engine with less exhaust emissions. However, this paper analyzes the basic background of Stirling engine and reviews its existing literature pertaining to dynamic model and control system for parabolic dish-stirling (PD) system.


Author(s):  
Alexey Dragunov ◽  
Eugene Saltanov ◽  
Igor Pioro ◽  
Pavel Kirillov ◽  
Romney Duffey

It is well known that the electrical-power generation is the key factor for advances in any other industries, agriculture and level of living. In general, electrical energy can be generated by: 1) non-renewable-energy sources such as coal, natural gas, oil, and nuclear; and 2) renewable-energy sources such as hydro, wind, solar, biomass, geothermal and marine. However, the main sources for electrical-energy generation are: 1) thermal - primary coal and secondary natural gas; 2) “large” hydro and 3) nuclear. The rest of the energy sources might have visible impact just in some countries. Modern advanced thermal power plants have reached very high thermal efficiencies (55–62%). In spite of that they are still the largest emitters of carbon dioxide into atmosphere. Due to that, reliable non-fossil-fuel energy generation, such as nuclear power, becomes more and more attractive. However, current Nuclear Power Plants (NPPs) are way behind by thermal efficiency (30–42%) compared to that of advanced thermal power plants. Therefore, it is important to consider various ways to enhance thermal efficiency of NPPs. The paper presents comparison of thermodynamic cycles and layouts of modern NPPs and discusses ways to improve their thermal efficiencies.


Author(s):  
Я.М. КАШИН ◽  
Л.Е. КОПЕЛЕВИЧ ◽  
А.В. САМОРОДОВ ◽  
Ч. ПЭН

Описаны конструктивные особенности трехвходовой аксиальной генераторной установки (ТАГУ), преобразующей кинетическую энергию ветра и световую энергию солнца и суммирующей механическую, световую и тепловую энергию с одновременным преобразованием полученной суммарной энергии в электрическую. Показаны преимущества ТАГУ перед двухвходовыми генераторными установками. Дополнительное включение стабилизатора напряжения в схему ТАГУ позволило расширить область применения стабилизированной трехвходовой аксиальной генераторной установки за счет стабилизации ее выходного напряжения. The design features of the three-input axial generating installation (TAGI), which converts the kinetic energy of wind and light energy of the sun and sums the mechanical, light and thermal energy with the simultaneous conversion of the total energy into electrical energy, are described. The benefits of TAGI in front of the two-input generating installation shown. The additional introduction of a voltage regulator into the TAGI scheme allowed to expand the scope of the stabilized three-input axial generating installation by stabilizing its output voltage.


2013 ◽  
Vol 4 (2) ◽  
Author(s):  
Aleksandra Kanevče ◽  
Igor Tomovski ◽  
Ljubčo Kocarev

In this paper we analyze the impact of the renewable energy sources on the overall electric power system of the Republic of Macedonia. Specifically, the effect of the photovoltaic power plants is examined. For this purpose we developed an electricity production optimization model, based on standard network flow model. The renewable energy sources are included in the model of Macedonia based on hourly meteorological data. Electricity producers that exist in 2012 are included in the base scenario. Two more characteristic years are analyzed, i.e. 2015 and 2020. The electricity producers planned to be constructed in these two years (which include the renewable energy sources) are also included. The results show that the renewable energy sources introduce imbalance in the system when the minimum electricity production is higher than the electricity required by the consumers. But, in these critical situations the production from photovoltaic energy sources is zero, which means that they produce electricity during the peak load, and do not produce when the consumption is at minimum.


Author(s):  
V. V. Shevchenko ◽  
A. N. Minko ◽  
M. Dimov

The paper defines the directions of improving turbogenerators as the basis for ensuring the energy independence of Ukraine. The analysis of the state, problems and prospects for the development of modern electric power industry. Goal of the work is to identify promising directions for sustainable development of the national electric power industry in order to ensure energy security of Ukraine, to conduct a comparative analysis of electricity sources, to confirm the need to improve the main sources – turbogenerators. Methodology. During the research, an analytical analysis of the electricity sources, which are installed at power plants in Ukraine and the world, was carried out, taking into account the growth of the planet's population and its energy activity. Cyclic theory was chosen as the theoretical basis for forecasting. On the basis of this theory, global development trends, advantages and disadvantages of currently used sources of electricity - thermal (including nuclear) power plants and stations that operate from renewable energy sources - have been established. A review of literary sources on the methods of the energy sector forecasting the development, including the development of the energy sector in Ukraine, has been carried out. Originality. It has been established that due to the active growth of the planet's population, with the increase in its energy activity, obtaining electricity from renewable energy sources is not enough, that for the next 20-30 years nuclear power plants will be the main sources of electricity. The internal and external threats to the energy security of Ukraine, directions of development of turbogenerator construction, ways to improve turbogenerators, to increase their energy efficiency, power per unit of performance, to increase the readiness and maneuverability factors, and overload capacity have been identified. Practical significance. The need to continue the modernization and improvement of the turbogenerators of nuclear power plant units, as the main sources of electricity, has been proved. The directions of their improvement are established: increasing the power in the established sizes, making changes to the design of the turbogenerators inactive elements, replacing the cooling agent to keep Ukrainian turbogenerators at the world level, improving auxiliary systems, improving and increasing the reliability of the excitation system, introduction of automatic systems for monitoring the state turbogenerators. Possible limits of use, advantages, disadvantages and problems of using renewable energy sources for Ukraine have been established.


Sign in / Sign up

Export Citation Format

Share Document