The Structural Characteristics of CIS Thin Films Prepared by Electro-Deposited Method

2013 ◽  
Vol 818 ◽  
pp. 88-91
Author(s):  
Kun Liu ◽  
Ji Sheng Yang ◽  
Rui Li ◽  
Wei Peng ◽  
Shi Pan
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Raman Spectroscopy ◽  
Raman Spectrum ◽  
Structural Characteristics ◽  
X Ray Diffraction ◽  
Electro Deposition ◽  
X Ray ◽  
Micro Raman Spectroscopy ◽  
Deposition Technology

The properties of the absorber layer of solar cell CuInSe2(CIS) thin film made by electro-depostied method were researched in this article. Different concentration of reactant and voltage was applied to prepare the CIS film. The micro-Raman spectroscopy and X-ray diffraction (XRD) of CIS film was carried out. A correlation between the linewidth A1 mode of Raman spectrum and the XRD line and the voltage of electro-deposition technology was found.

Micro-Raman spectroscopy and X-ray diffraction studies of atomic-layer-deposited ZrO2 and HfO2 thin films

2005 ◽  
Vol 40 (16) ◽  
pp. 4293-4298 ◽  
Author(s):  
S. N. Tkachev ◽  
M. H. Manghnani ◽  
A. Niilisk ◽  
J. Aarik ◽  
H. Mändar
Keyword(s):  
Thin Films ◽  
Raman Spectroscopy ◽  
Atomic Layer ◽  
X Ray Diffraction ◽  
X Ray ◽  
Micro Raman Spectroscopy

PREFERENTIAL ORIENTATION GROWTH OF AlN THIN FILMS ON Si(111) SUBSTRATES BY PLASMA-ASSISTED MOLECULAR BEAM EPITAXY

2009 ◽  
Vol 16 (06) ◽  
pp. 925-928 ◽  
Author(s):  
L. S. CHUAH ◽  
Z. HASSAN ◽  
H. ABU HASSAN
Keyword(s):  
Thin Films ◽  
Raman Spectroscopy ◽  
Molecular Beam Epitaxy ◽  
Molecular Beam ◽  
X Ray Diffraction ◽  
X Ray ◽  
Micro Raman Spectroscopy ◽  
Raman Modes ◽  
Orientation Growth ◽  
Good Agreement

This article reports the use of plasma-assisted molecular beam epitaxy (MBE) to grow AlN on Si (111) substrate at 850°C under UHV conditions for 15, 30, and 45 min. The films were characterized by high-resolution X-ray diffraction (HR-XRD) and micro-Raman spectroscopy. XRD measurement revealed that the AlN was epitaxially grown on Si (111). Micro-Raman result showed that all the allowed Raman modes of AlN and Si were clearly visible. Fourier transform infrared (FTIR) spectroscopy has been used to investigate the A1 (LO) and E1 (TO) modes with frequencies (890–899) cm-1 and (668–688) cm-1, respectively. The results are in good agreement with reported phonon frequencies of AlN grown on Si (111).

scholarly journals Electrodeposition of Cu2O thin Film Onto Copper Substrate by Linear Sweep Voltammetry at Low Duration: Effect of Bath pH

2021 ◽  
Vol 12 (6) ◽  
pp. 7715-7724
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Raman Spectroscopy ◽  
Copper Substrate ◽  
Linear Sweep Voltammetry ◽  
Complexing Agent ◽  
X Ray Diffraction ◽  
Linear Sweep ◽  
X Ray ◽  
Cu2o Thin Films

Copper (II) oxide (Cu2O) has attracted much interest as a semiconductor material for solar cell applications. Here we report the synthesis of Cu2O, thin films through an economical and simple electrodeposition method at low duration (10 min) by linear sweep voltammetry (LSV) method at 50 °C bath temperature, with the use of citric acid as a complexing agent. The influence of pH value (pH = 9.5, 10.5, 11.5, and 12.5) on structural, morphological, and optical properties of the synthesized Cu2O thin films onto copper substrate was investigated. The synthesized Cu2O thin films have been characterized using various techniques like X-ray diffraction (XRD), Raman spectroscopy, Scanning Electron Microscopy (SEM-EDX), UV-vis spectrophotometry. The X-ray diffraction showed that the deposited thin films at pH= 9.5, 10.5, 11.5 matched well with the cubic (Pn-3m) structure and showed an improvement of the crystallinity near the value pH=10.5. Raman spectroscopy confirms the cubic structure of the synthesized thin film. Thin films show a high absorption coefficient in the visible spectra, and the calculated band gap energy value is near 1.8 eV.

Formation of the YBa2Cu2NbOy phase in thin films

2009 ◽  
Vol 24 (1) ◽  
pp. 212-216
Author(s):  
Srinivas Sathiraju ◽  
Paul N. Barnes ◽  
Robert A. Wheeler
Keyword(s):  
Thin Films ◽  
Raman Spectroscopy ◽  
Photoelectron Spectroscopy ◽  
X Ray Diffraction ◽  
X Ray ◽  
Force Microscopy ◽  
Micro Raman Spectroscopy ◽  
Atomic Force ◽  
Transmission Electron ◽  
New Phase

We report the systematic substitution of Nb at the Cu1 site of YBa2Cu3Oy in thin films to form a new phase of YBa2Cu2NbO8. These films were deposited on SrTiO3(100) crystals using pulsed laser deposition and deposited at an optimal temperature of 850 °C. Films were characterized using x-ray diffraction (XRD), atomic force microscopy, x-ray photoelectron spectroscopy (XPS), micro-Raman spectroscopy, and transmission electron microscopy. XRD of these films indicate c-axis oriented YBa2Cu2NbOy formation. XPS and micro-Raman spectroscopy analysis suggests Cu exists in the +2 state.

Palladium Nanowire Thin Films via Template Growth

2003 ◽  
Vol 775 ◽  
Author(s):  
Donghai Wang ◽  
David T. Johnson ◽  
Byron F. McCaughey ◽  
J. Eric Hampsey ◽  
Jibao He ◽  
...  
Keyword(s):  
Thin Film ◽  
Electron Microscopy ◽  
Thin Films ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Conductive Substrate ◽  
Palladium Nanowires ◽  
Efficient Route ◽  
Silica Thin Film

AbstractPalladium nanowires have been electrodeposited into mesoporous silica thin film templates. Palladium continually grows and fills silica mesopores starting from a bottom conductive substrate, providing a ready and efficient route to fabricate a macroscopic palladium nanowire thin films for potentially use in fuel cells, electrodes, sensors, and other applications. X-ray diffraction (XRD) and transmission electron microscopy (TEM) indicate it is possible to create different nanowire morphology such as bundles and swirling mesostructure based on the template pore structure.

Al1-x ScxN Thin Film Structures for Pyroelectric Sensing Applications

MRS Advances ◽  
2016 ◽  
Vol 1 (39) ◽  
pp. 2711-2716 ◽  
Author(s):  
V. Vasilyev ◽  
J. Cetnar ◽  
B. Claflin ◽  
G. Grzybowski ◽  
K. Leedy ◽  
...  
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Pyroelectric Coefficient ◽  
X Ray Diffraction ◽  
Ir Detectors ◽  
Pyroelectric Properties ◽  
X Ray ◽  
Sensing Applications ◽  
Pyroelectric Material ◽  
Deposited Films

ABSTRACTAlN thin film structures have many useful and practical piezoelectric and pyroelectric properties. The potential enhancement of the AlN piezo- and pyroelectric constants allows it to compete with more commonly used materials. For example, combination of AlN with ScN leads to new structural, electronic, and mechanical characteristics, which have been reported to substantially enhance the piezoelectric coefficients in solid-solution AlN-ScN compounds, compared to a pure AlN-phase material.In our work, we demonstrate that an analogous alloying approach results in considerable enhancement of the pyroelectric properties of AlN - ScN composites. Thin films of ScN, AlN and Al1-x ScxN (x = 0 – 1.0) were deposited on silicon (004) substrates using dual reactive sputtering in Ar/N2 atmosphere from Sc and Al targets. The deposited films were studied and compared using x-ray diffraction, XPS, SEM, and pyroelectric characterization. An up to 25% enhancement was observed in the pyroelectric coefficient (Pc = 0.9 µC /m2K) for Sc1-xAlxN thin films structures in comparison to pure AlN thin films (Pc = 0.71 µC/m2K). The obtained results suggest that Al1-x ScxN films could be a promising novel pyroelectric material and might be suitable for use in uncooled IR detectors.

Crystallization of Zn-rich and P-rich amorphous Zn3P2 thin films

1988 ◽  
Vol 66 (5) ◽  
pp. 373-375 ◽  
Author(s):  
C. J. Arsenault ◽  
D. E. Brodie
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Activation Energy ◽  
Electrical Properties ◽  
Structural Properties ◽  
Crystallization Process ◽  
X Ray Diffraction ◽  
Electrical Measurements ◽  
Conductivity Activation Energy ◽  
X Ray

Zn-rich and P-rich amorphous Zn3P2 thin films were prepared by co-evaporation of the excess element during the normal Zn3P2 deposition. X-ray diffraction techniques were used to investigate the structural properties and the crystallization process. Agglomeration of the excess element within the as-made amorphous Zn3P2 thin film accounted for the structural properties observed after annealing the sample. Electrical measurements showed that excess Zn reduces the conductivity activation energy and increases the conductivity, while excess P up to 15 at.% does not alter the electrical properties significantly.

Synthesis of CaWO4:(Eu3+,Tb3+) Thin Films by a Two-Step Method at Room Temperature

2013 ◽  
Vol 710 ◽  
pp. 170-173
Author(s):  
Lian Ping Chen ◽  
Yuan Hong Gao
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Phase Composition ◽  
Room Temperature ◽  
Electrochemical Techniques ◽  
Luminescent Properties ◽  
X Ray Diffraction ◽  
Step Method ◽  
X Ray ◽  
Rare Earth Doped

It is hardly possible to obtain rare earth doped CaWO4thin films directly through electrochemical techniques. A two-step method has been proposed to synthesize CaWO4:(Eu3+,Tb3+) thin films at room temperature. X-ray diffraction, energy dispersive X-ray analysis, spectrophotometer were used to characterize their phase, composition and luminescent properties. Results reveal that (Eu3+,Tb3+)-doped CaWO4films have a tetragonal phase. When the ratio of n (Eu)/n (Tb) in the solution is up to 3:1, CaWO4:(Eu3+,Tb3+) thin film will be enriched with Tb element; on the contrary, when the ratio in the solution is lower than 1:4, CaWO4:(Eu3+,Tb3+) thin film will be enriched with Eu element. Under the excitation of 242 nm, sharp emission peaks at 612, 543, 489 and 589 nm have been observed for CaWO4:(Eu3+,Tb3+) thin films.

Sign in / Sign up

Export Citation Format

Share Document