On Construction Wastes Recycling and its Economy

2013 ◽  
Vol 567 ◽  
pp. 119-122
Author(s):  
Yue Qin Tang
Keyword(s):  
High Performance ◽  
Drying Shrinkage ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Bleeding Rate ◽  
Aggregate Concrete ◽  
Ordinary Concrete ◽  
Easy Bleeding ◽  
Large Water ◽  
Water Absorbability

This paper addresses problems of aggregate concrete of construction wastes, which were featured as large water absorption, quick slump loss, as well as easy bleeding and low strength of concrete. A comparative analysis by experiment between recycled aggregate concrete and ordinary concrete was made on aspects of water absorbability, compressive strength, slump loss, bleeding rate, drying shrinkage and economic efficiency. It has found possible to preparing the recycled aggregate concrete of high performance through the prewetting recycled aggregate. It is concluded that construction wastes can be recycled by obtaining the optimum mole of preparing recycled aggregate concrete of construction wastes and evaluating their reliability on cost-lefficiency and mechanic capability，thus, it also recycled the limited resources and solve some environment problems.

The Research of Green High Performance Recycled Construct Materials

2011 ◽  
Vol 71-78 ◽  
pp. 4471-4475
Author(s):  
Xiao Xiong Zha ◽  
Kai Zhang
Keyword(s):  
Compressive Strength ◽  
High Performance ◽  
Experimental Studies ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Aggregate Concrete ◽  
Concrete Aggregates ◽  
Recycled Concrete Aggregates ◽  
Large Water

Recycled concrete aggregates have large porosity, large water absorption and high crush index. Mechanical properties of recycled concrete aggregates could be improved by adding activated water instead of ordinary water. On the basis of the experimental studies, this paper analyzes the influences on recycled concrete compression strength when using activated water. There are many different factors such as the kinds and amounts of alkali and the water slag ratio affecting the compressive strength of recycle geopolymer. The results show that activated water has a high enhancement on compressive strength of recycled aggregate concrete, and the highest compressive strength of recycled geopolymer is 57.3MPa.

scholarly journals Experimental Study on a Prediction Model of the Shrinkage and Creep of Recycled Aggregate Concrete

2019 ◽  
Vol 9 (20) ◽  
pp. 4322 ◽  
Author(s):  
Lv ◽  
Liu ◽  
Zhu ◽  
Bai ◽  
Qi
Keyword(s):  
Substitution Rate ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Creep Model ◽  
Aggregate Concrete ◽  
Ordinary Concrete ◽  
Group I ◽  
Significant Difference ◽  
Shrinkage And Creep ◽  
Group Ii

The significant difference between recycled aggregate and natural aggregate is the content of the attached mortar layer. With the increase of the replacement rate of recycled aggregate, the shrinkage and creep of recycled aggregate concrete is significantly increased. In this paper, 180-day shrinkage and creep tests of recycled aggregate concrete with different water–cement ratios were designed in order to analyze the effect of the substitution rate and water–cement ratio on shrinkage and creep properties. The results show that the shrinkage strain of recycled aggregate concrete with a substitution rate of 50% and 100% at 180 days is 26% and 48% higher than that of ordinary concrete, respectively, and the growth of group II is 22% and 47%, respectively. When the load was 180 days old, the creep coefficient of recycled aggregate concrete with a substitution rate of 50% and 100% in group I increased by 19.6% and 39.6%, respectively compared with ordinary concrete, and group II increased by 23.6% and 44.3%, respectively. Based on the difference of adhering mortar content, the creeping increase coefficient and shrinkage increase coefficient of the attached mortar were proposed, and a shrinkage and creep model of recycled aggregate concrete was established. When compared with the experimental results, the model calculation results met the accuracy requirements.

scholarly journals Discrete Element Mesoscale Modeling of Recycled Lump Concrete under Axial Compression

Materials ◽  
2019 ◽  
Vol 12 (19) ◽  
pp. 3140 ◽  
Author(s):  
Yong Yu ◽  
Bo Wu
Keyword(s):  
Mechanical Properties ◽  
Axial Compression ◽  
Discrete Element ◽  
Relative Strength ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Aggregate Concrete ◽  
Ordinary Concrete ◽  
Coarse Aggregates ◽  
Spatial Locations

In the past decade, directly reusing large pieces of coarsely crushed concrete (referred to as demolished concrete lumps or DCLs) with fresh concrete in new construction was demonstrated as an efficient technique for the recycling of waste concrete. Previous studies investigated the mechanical properties of recycled lump concrete (RLC) containing different sizes of DCLs; however, for actual application of this kind of concrete, little information is known about the influence of the spatial locations of DCLs and coarse aggregates on the concrete strength. Moreover, the mechanical responses of such a concrete containing various shapes of DCLs are also not well illustrated. To add knowledge related to these topics, two-dimensional mesoscale simulations of RLC containing DCLs under axial compression were performed using the discrete element method. The main variables of interest were the relative strength of the new and old concrete, the distribution of the lumps and other coarse aggregates, and the shape of the lumps. In addition, the differences in compression behavior between RLC and recycled aggregate concrete were also predicted. The numerical results indicate that the influence tendency of the spatial locations of DCLs and coarse aggregate pieces on the compressive stress–strain curves for RLC is similar to that of the locations of coarse aggregates for ordinary concrete. The strength variability of RLC is generally higher than that of ordinary concrete, regardless of the relative strength of the new and old concrete included; however, variability has no monotonic trend with an increase in the lump replacement ratio. The mechanical properties of RLC in compression are little influenced by the geometric shape of DCLs as long as the ratio of the length of their long axis to short axis is smaller than 2.0. The compressive strength and elastic modulus of RLC are always superior to those of recycled aggregate concrete designed with a conventional mixing method.

scholarly journals Sulfate Resistance of Recycled Aggregate Concrete with GGBS and Fly Ash-Based Geopolymer

Materials ◽  
2019 ◽  
Vol 12 (8) ◽  
pp. 1247 ◽  
Author(s):  
Jianhe Xie ◽  
Jianbai Zhao ◽  
Junjie Wang ◽  
Chonghao Wang ◽  
Peiyan Huang ◽  
...  
Keyword(s):  
Fly Ash ◽  
Construction Projects ◽  
High Performance ◽  
High Performance Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Aggregate Concrete ◽  
Sulfate Resistance ◽  
Coarse Aggregates

There is a constant drive for the development of ultra-high-performance concrete using modern green engineering technologies. These concretes have to exhibit enhanced durability and incorporate energy-saving and environment-friendly functions. The object of this work was to develop a green concrete with an improved sulfate resistance. In this new type of concrete, recycled aggregates from construction and demolition (C&D) waste were used as coarse aggregates, and granulated blast furnace slag (GGBS) and fly ash-based geopolymer were used to totally replace the cement in concrete. This study focused on the sulfate resistance of this geopolymer recycled aggregate concrete (GRAC). A series of measurements including compression, X-ray diffraction (XRD), and scanning electron microscopy (SEM) tests were conducted to investigate the physical properties and hydration mechanisms of the GRAC after different exposure cycles in a sulfate environment. The results indicate that the GRAC with a higher content of GGBS had a lower mass loss and a higher residual compressive strength after the sulfate exposure. The proposed GRACs, showing an excellent sulfate resistance, can be used in construction projects in sulfate environments and hence can reduce the need for cement as well as the disposal of C&D wastes.

scholarly journals A Study on the Properties of Recycled Aggregate Concrete and Its Production Facilities

2019 ◽  
Vol 9 (9) ◽  
pp. 1935 ◽  
Author(s):  
Jung-Ho Kim ◽  
Jong-Hyun Sung ◽  
Chan-Soo Jeon ◽  
Sae-Hyun Lee ◽  
Han-Soo Kim
Keyword(s):  
Drying Shrinkage ◽  
Quality Standards ◽  
Poor Quality ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Freezing And Thawing ◽  
Construction Waste ◽  
Aggregate Concrete ◽  
Air Volume

In recent years, the amount of construction waste and recycled aggregate has been increasing every year in Korea. However, as the recycled aggregate is poor quality, it is not used for concrete, and the Korean government has strengthened the quality standards for recycled aggregate for concrete. In this study, research was conducted on the mechanical and durability characteristics of concrete using recycled aggregate, after developing equipment to improve the quality of recycled aggregate to increase the use of recycled aggregate for environmental improvements. The results illustrated improvements in the air volume, slump, compressive strength, freezing and thawing resistance, and drying shrinkage. Furthermore, this study is expected to contribute to the increased use of recycled aggregate in the future.

scholarly journals Experimental Characterization of Prefabricated Bridge Deck Panels Prepared with Prestressed and Sustainable Ultra-High Performance Concrete

2020 ◽  
Vol 10 (15) ◽  
pp. 5132
Author(s):  
Muhammad Naveed Zafar ◽  
Muhammad Azhar Saleem ◽  
Jun Xia ◽  
Muhammad Mazhar Saleem
Keyword(s):  
High Performance ◽  
Bridge Deck ◽  
High Performance Concrete ◽  
High Strength ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Ultra High Performance Concrete ◽  
Aggregate Concrete ◽  
Deck Panels

Enhanced quality and reduced on-site construction time are the basic features of prefabricated bridge elements and systems. Prefabricated lightweight bridge decks have already started finding their place in accelerated bridge construction (ABC). Therefore, the development of deck panels using high strength and high performance concrete has become an active area of research. Further optimization in such deck systems is possible using prestressing or replacement of raw materials with sustainable and recyclable materials. This research involves experimental evaluation of six full-depth precast prestressed high strength fiber-reinforced concrete (HSFRC) and six partial-depth sustainable ultra-high performance concrete (sUHPC) composite bridge deck panels. The composite panels comprise UHPC prepared with ground granulated blast furnace slag (GGBS) with the replacement of 30% cement content overlaid by recycled aggregate concrete made with replacement of 30% of coarse aggregates with recycled aggregates. The experimental variables for six HSFRC panels were depth, level of prestressing, and shear reinforcement. The six sUHPC panels were prepared with different shear and flexural reinforcements and sUHPC-normal/recycled aggregate concrete interface. Experimental results exhibit the promise of both systems to serve as an alternative to conventional bridge deck systems.

Influence of Recycled Aggregate on Physical and Mechanical Properties of High Performance Recycled Aggregate Concrete

2011 ◽  
Vol 460-461 ◽  
pp. 764-767 ◽  
Author(s):  
Yi Dong Xu ◽  
Jia Ying Sun
Keyword(s):  
High Performance ◽  
Physical And Mechanical Properties ◽  
Chloride Ion ◽  
Poor Quality ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Ion Permeability ◽  
Negative Effects ◽  
Aggregate Concrete ◽  
Positive Effects

Influence of recycled aggregate on slump, compressive strength and chloride ion permeability of recycled aggregate concrete was investigated. As is shown by the results, although recycled aggregate belongs to the category of poor quality aggregate, the properties of high performance recycled aggregate concrete are not reduced dramatically with the increasing amount of recycled aggregate, for recycled aggregate have both positive effects and negative effects on the properties of recycled aggregate concrete. The high performance recycled aggregate concrete can be developed by double-mixture of ultra fine fly ash and superplasticizer.

Analysis of Microstructure of Interfacial Transition Zone (ITZ) in Recycled Aggregate Concrete

2013 ◽  
Vol 811 ◽  
pp. 249-253 ◽  
Author(s):  
Wei Li ◽  
Hai Ying Zhang
Keyword(s):  
High Performance ◽  
High Performance Concrete ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Interfacial Structure ◽  
Recycled Aggregate ◽  
Concrete Aggregate ◽  
Interfacial Zone ◽  
Aggregate Concrete ◽  
Mortar Strength

Experiments on influence of species of aggregate and mixing method on interfacial zone in recycled aggregate concrete were investigated. SEM observations revealed that a recycle normal-strength concrete aggregate consist of loose and porous interfacial structure, whereas a recycled high performance concrete (HPC) aggregate and a triple mixing (TM) consist mainly of dense hydrates. Various admixtures on ITZ was produced that consumed CH in the pore, modified attached cement mortar. Strength of recycled concrete was explained by interaction between cements paste and recycled aggregate. The result verified that the relatively dense pore structure of the recycled concrete benefit to development of mechanical properties.

scholarly journals Experimental Research on the Wettability of Recycled Aggregate Concrete with Fly Ash

2013 ◽  
Vol 7 (1) ◽  
pp. 232-236
Author(s):  
Yuanchen Guo ◽  
Xue Wang ◽  
Jueshi Qian
Keyword(s):  
Fly Ash ◽  
Moisture Absorption ◽  
Drying Shrinkage ◽  
Absorption Capacity ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Structure Theory ◽  
Replacement Rate ◽  
Aggregate Concrete ◽  
Main Factors

Material adsorption, the reverse process of evaporation diffusion, directly reflects the wettability of materials. Wettability is one of the main factors that affect the drying shrinkage of materials. A device that measures the wettability of recycled aggregate concrete (RAC) with fly ash is proposed in this study based on pore structure theory. The isothermal absorption curve of RAC is examined with different fly ash contents. Results show that as the recycled aggregate replacement rate increases, the moisture absorption capacity of RAC gradually increases. The addition of fly ash improves the porosity of RAC structures and reduces material wettability.

Sign in / Sign up

Export Citation Format

Share Document