scholarly journals Autofluorescence in freshly isolated adult human liver sinusoidal cells

2021 ◽  
Vol 65 (4) ◽  
Author(s):  
Anett Kristin Larsen ◽  
Jaione Simón-Santamaría ◽  
Kjetil Elvevold ◽  
Bo Göran Ericzon ◽  
Kim Erlend Mortensen ◽  
...  

Autofluorescent granules of various sizes were observed in primary human liver endothelial cells (LSECs) upon laser irradiation using a wide range of wavelengths. Autofluorescence was detected in LAMP-1 positive vesicles, suggesting lysosomal location. Confocal imaging of freshly prepared cultures and imaging flow cytometry of non-cultured cells revealed fluorescence in all channels used. Treatment with a lipofuscin autofluorescence quencher reduced autofluorescence, most efficiently in the near UV-area. These results, combined with the knowledge of the very active blood clearance function of LSECs support the notion that lysosomally located autofluorescent material reflected accumulation of lipofuscin in the intact liver. These results illustrate the importance of careful selection of fluorophores, especially when labelling of live cells where the quencher is not compatible.

2020 ◽  
Author(s):  
Daniel J. Shiwarski ◽  
Joshua W. Tashman ◽  
Alkiviadis Tsamis ◽  
Jacqueline M. Bliley ◽  
Malachi A. Blundon ◽  
...  

AbstractMechanical forces are integral to a wide range of cellular processes including migration, differentiation and tissue morphogenesis; however, it has proved challenging to directly measure strain at high spatial resolution and with minimal tissue perturbation. Here, we fabricated, calibrated, and tested a fibronectin (FN)-based nanomechanical biosensor (NMBS) that can be applied to cells and tissues to measure the magnitude, direction, and dynamics of strain from subcellular to tissue length-scales. The NMBS is a fluorescently-labeled, ultrathin square lattice FN mesh with spatial resolution tailored by adjusting the width and spacing of the lattice fibers from 2-100 µm. Time-lapse 3D confocal imaging of the NMBS demonstrated strain tracking in 2D and 3D following mechanical deformation of known materials and was validated with finite element modeling. Imaging and 3D analysis of the NMBS applied to single cells, cell monolayers, and Drosophila ovarioles demonstrated the ability to dynamically track microscopic tensile and compressive strains in various biological applications with minimal tissue perturbation. This fabrication and analysis platform serves as a novel tool for studying cells, tissues, and more complex systems where forces guide structure and function.


2002 ◽  
Vol 15 (4) ◽  
pp. 209-218 ◽  
Author(s):  
Hardi Lührs ◽  
Bertram Illert ◽  
Wolfgang Timmermann ◽  
Heinrich Volk ◽  
Wolfgang Scheppach ◽  
...  

2020 ◽  
Vol 7 (2) ◽  
pp. 34-41
Author(s):  
VLADIMIR NIKONOV ◽  
◽  
ANTON ZOBOV ◽  

The construction and selection of a suitable bijective function, that is, substitution, is now becoming an important applied task, particularly for building block encryption systems. Many articles have suggested using different approaches to determining the quality of substitution, but most of them are highly computationally complex. The solution of this problem will significantly expand the range of methods for constructing and analyzing scheme in information protection systems. The purpose of research is to find easily measurable characteristics of substitutions, allowing to evaluate their quality, and also measures of the proximity of a particular substitutions to a random one, or its distance from it. For this purpose, several characteristics were proposed in this work: difference and polynomial, and their mathematical expectation was found, as well as variance for the difference characteristic. This allows us to make a conclusion about its quality by comparing the result of calculating the characteristic for a particular substitution with the calculated mathematical expectation. From a computational point of view, the thesises of the article are of exceptional interest due to the simplicity of the algorithm for quantifying the quality of bijective function substitutions. By its nature, the operation of calculating the difference characteristic carries out a simple summation of integer terms in a fixed and small range. Such an operation, both in the modern and in the prospective element base, is embedded in the logic of a wide range of functional elements, especially when implementing computational actions in the optical range, or on other carriers related to the field of nanotechnology.


2017 ◽  
Vol 68 (4) ◽  
pp. 745-747 ◽  
Author(s):  
Marius Mioc ◽  
Sorin Avram ◽  
Vasile Bercean ◽  
Mihaela Balan Porcarasu ◽  
Codruta Soica ◽  
...  

Angiogenesis plays an important function in tumor proliferation, one of the main angiogenic promoters being the vascular endothelial growth factor (VEGF) which activates specific receptors, particularly VEGFR-2. Thus, VEGFR-2 has become an essential therapeutic target in the development of new antitumor drugs. 1,2,4-triazoles show a wide range of biological activities, including antitumor effect, which was documented by numerous reports. In the current study the selection of 5-mercapto-1,2,4-triazole structure (1H-3-styryl-5-benzylidenehydrazino-carbonyl-methylsulfanil-1,2,4-triazole, Tz3a.7) was conducted based on molecular docking that emphasized it as suitable ligand for VEGFR-2 and EGFR1 receptors. Compound Tz3a.7 was synthesized and physicochemically and biologically evaluated thus revealing a moderate antiproliferative activity against breast cancer cell line MDA-MB-231.


1996 ◽  
Vol 118 (3) ◽  
pp. 439-443 ◽  
Author(s):  
Chuen-Huei Liou ◽  
Hsiang Hsi Lin ◽  
F. B. Oswald ◽  
D. P. Townsend

This paper presents a computer simulation showing how the gear contact ratio affects the dynamic load on a spur gear transmission. The contact ratio can be affected by the tooth addendum, the pressure angle, the tooth size (diametral pitch), and the center distance. The analysis presented in this paper was performed by using the NASA gear dynamics code DANST. In the analysis, the contact ratio was varied over the range 1.20 to 2.40 by changing the length of the tooth addendum. In order to simplify the analysis, other parameters related to contact ratio were held constant. The contact ratio was found to have a significant influence on gear dynamics. Over a wide range of operating speeds, a contact ratio close to 2.0 minimized dynamic load. For low-contact-ratio gears (contact ratio less than two), increasing the contact ratio reduced gear dynamic load. For high-contact-ratio gears (contact ratio equal to or greater than 2.0), the selection of contact ratio should take into consideration the intended operating speeds. In general, high-contact-ratio gears minimized dynamic load better than low-contact-ratio gears.


1998 ◽  
Vol 162 ◽  
pp. 100-105
Author(s):  
Andrew J. Norton ◽  
Mark H. Jones

The Open University is the UK's foremost distance teaching university. For over twenty five years we have been presenting courses to students spanning a wide range of degree level and vocational subjects. Since we have no pre-requisites for entry, a major component of our course profile is a selection of foundation courses comprising one each in the Arts, Social Science, Mathematics, Technology and Science faculties. The Science Faculty's foundation course is currently undergoing a substantial revision. The new course, entitled “S103: Discovering Science”, will be presented to students for the first time in 1998.


2021 ◽  
Vol 22 (4) ◽  
pp. 2104
Author(s):  
Pedro Robles ◽  
Víctor Quesada

Eleven published articles (4 reviews, 7 research papers) are collected in the Special Issue entitled “Organelle Genetics in Plants.” This selection of papers covers a wide range of topics related to chloroplasts and plant mitochondria research: (i) organellar gene expression (OGE) and, more specifically, chloroplast RNA editing in soybean, mitochondria RNA editing, and intron splicing in soybean during nodulation, as well as the study of the roles of transcriptional and posttranscriptional regulation of OGE in plant adaptation to environmental stress; (ii) analysis of the nuclear integrants of mitochondrial DNA (NUMTs) or plastid DNA (NUPTs); (iii) sequencing and characterization of mitochondrial and chloroplast genomes; (iv) recent advances in plastid genome engineering. Here we summarize the main findings of these works, which represent the latest research on the genetics, genomics, and biotechnology of chloroplasts and mitochondria.


2021 ◽  
Vol 22 (15) ◽  
pp. 7773
Author(s):  
Neann Mathai ◽  
Conrad Stork ◽  
Johannes Kirchmair

Experimental screening of large sets of compounds against macromolecular targets is a key strategy to identify novel bioactivities. However, large-scale screening requires substantial experimental resources and is time-consuming and challenging. Therefore, small to medium-sized compound libraries with a high chance of producing genuine hits on an arbitrary protein of interest would be of great value to fields related to early drug discovery, in particular biochemical and cell research. Here, we present a computational approach that incorporates drug-likeness, predicted bioactivities, biological space coverage, and target novelty, to generate optimized compound libraries with maximized chances of producing genuine hits for a wide range of proteins. The computational approach evaluates drug-likeness with a set of established rules, predicts bioactivities with a validated, similarity-based approach, and optimizes the composition of small sets of compounds towards maximum target coverage and novelty. We found that, in comparison to the random selection of compounds for a library, our approach generates substantially improved compound sets. Quantified as the “fitness” of compound libraries, the calculated improvements ranged from +60% (for a library of 15,000 compounds) to +184% (for a library of 1000 compounds). The best of the optimized compound libraries prepared in this work are available for download as a dataset bundle (“BonMOLière”).


Mindfulness ◽  
2021 ◽  
Author(s):  
Karin Matko ◽  
Ulrich Ott ◽  
Peter Sedlmeier

Abstract Objectives Meditation is an umbrella term for a vast range of contemplative practices. Former proposals have struggled to do justice to this variety. To our knowledge, there is to date no comprehensive overview of meditation techniques spanning all major traditions. The present studies aimed at providing such a comprehensive list of meditation techniques. Methods In a qualitative study, we compiled a collection of 309 meditation techniques through a literature search and interviews with 20 expert meditators. Then, we reduced this collection to 50 basic meditation techniques. In a second, quantitative study, 635 experienced meditators from a wide range of meditative backgrounds indicated how much experience they had with each of these 50 meditation techniques. Results Meditators’ responses indicated that our choice of techniques had been adequate and only two techniques had to be added. Our additional statistical and cluster analyses illustrated preferences for specific techniques across and within diverse traditions as well as sets of techniques commonly practiced together. Body-centered techniques stood out in being of exceptional importance to all meditators. Conclusions In conclusion, we found an amazing variety of meditation techniques, which considerably surpasses previous collections. Our selection of basic meditation techniques might be of value for future scientific investigations and we encourage researchers to use this set.


Author(s):  
Joanna Balcerek ◽  
Evelin Trejo ◽  
Kendall Levine ◽  
Paul Couey ◽  
Zoe V Kornberg ◽  
...  

Abstract Objectives Serologic testing for antibodies to severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) in potential donors of coronavirus disease 2019 (COVID-19) convalescent plasma (CCP) may not be performed until after blood donation. A hospital-based recruitment program for CCP may be an efficient way to identify potential donors prospectively Methods Patients who recovered from known or suspected COVID-19 were identified and recruited through medical record searches and public appeals in March and April 2020. Participants were screened with a modified donor history questionnaire and, if eligible, were asked for consent and tested for SARS-CoV-2 antibodies (IgG and IgM). Participants positive for SARS-CoV-2 IgG were referred for CCP collection. Results Of 179 patients screened, 128 completed serologic testing and 89 were referred for CCP donation. IgG antibodies to SARS-CoV-2 were detected in 23 of 51 participants with suspected COVID-19 and 66 of 77 participants with self-reported COVID-19 confirmed by polymerase chain reaction (PCR). The anti–SARS-CoV-2 IgG level met the US Food and Drug Administration criteria for “high-titer” CCP in 39% of participants confirmed by PCR, as measured by the Ortho VITROS IgG assay. A wide range of SARS-CoV-2 IgG levels were observed. Conclusions A hospital-based CCP donor recruitment program can prospectively identify potential CCP donors. Variability in SARS-CoV-2 IgG levels has implications for the selection of CCP units for transfusion.


Sign in / Sign up

Export Citation Format

Share Document