A Critical Examination of Dynamic Shear Modulus Vrs. Shear Strain Relationships for Municipal Solid Waste

2009 ◽  
Author(s):  
S. Singh
Keyword(s):  
Shear Modulus ◽  
Municipal Solid Waste ◽  
Shear Strain ◽  
Solid Waste ◽  
Critical Examination ◽  
Dynamic Shear Modulus ◽  
Dynamic Shear

Shear Modulus and Damping Ratio of Gravel Material

2011 ◽  
Vol 105-107 ◽  
pp. 1426-1432 ◽  
Author(s):  
De Gao Zou ◽  
Tao Gong ◽  
Jing Mao Liu ◽  
Xian Jing Kong
Keyword(s):  
Shear Modulus ◽  
Shear Strain ◽  
Strain Amplitude ◽  
Damping Ratio ◽  
Confining Pressure ◽  
Dynamic Shear Modulus ◽  
Test Results ◽  
Dynamic Shear ◽  
Data Points ◽  
Shear Strain Amplitude

Two of the most important parameters in dynamic analysis involving soils are the dynamic shear modulus and the damping ratio. In this study, a series of tests were performed on gravels. For comparison, some other tests carried out by other researchers were also collected. The test results show that normalized shear modulus and damping ratio vary with the shear strain amplitude, (1) normalized shear modulus decreases with the increase of dynamic shear strain amplitude, and as the confining pressure increases, the test data points move from the low end toward the high end; (2) damping ratio increases with the increase of shear strain amplitude, damping ratio is dependent on confining pressure where an increase in confining pressure decreased damping ratio. According to the test results, a reference formula is proposed to evaluate the maximum dynamic shear modulus, the best-fit curve and standard deviation bounds for the range of data points are also proposed.

Experimental Study on Dynamic Characteristics of Ionic Soil Stabilizer Reinforcing Red Clay

2011 ◽  
Vol 374-377 ◽  
pp. 1391-1395
Author(s):  
Xue Song Lu ◽  
Wei Xiang
Keyword(s):  
Shear Modulus ◽  
Shear Strain ◽  
Dynamic Condition ◽  
Damping Ratio ◽  
Confining Pressure ◽  
Natural Soil ◽  
Dynamic Shear Modulus ◽  
Dynamic Shear ◽  
Red Clay ◽  
Soil Stabilizer

Based on the red clay of Wuhan reinforced by Ionic Soil Stabilizer, the red clay soil is treated by different matches of ISS at first, then is tested in the Atterberg limits test and dynamic triaxia test. The results show that the plastic index decreases, and the red clay were greatly improved under the dynamic condition, the maximum dynamic shear modulus ratio acquired an incensement of 27.72% on average after mixing the ISS into the red clay. In addition, It was concluded that the confining pressure influenced the dynamic shear modulus and damping ratio to a certain extent. Given the same strain conditions, with the incensement of confining pressure increases, the dynamic shear modulus increased and the damping ratio decreased. Moreover, when plotting the dynamic shear modulus versus the dynamic shear strain, the similar curve can be formed for both the natural soil and the modified one, the dynamic shear modulus monotonously decreased with the incensement of the dynamic shear strain. However, the value of dynamic shear modulus differed in the same shear strain between the natural soil and the soil modified by ISS.

scholarly journals Characterization of the Dynamic Properties of Clay–Gravel Mixtures at Low Strain Level

2020 ◽  
Vol 12 (4) ◽  
pp. 1616 ◽  
Author(s):  
Xianwen Huang ◽  
Aizhao Zhou ◽  
Wei Wang ◽  
Pengming Jiang
Keyword(s):  
Shear Modulus ◽  
Shear Strain ◽  
Mechanical Performance ◽  
Dynamic Properties ◽  
Damping Ratio ◽  
Confining Pressure ◽  
Strain Level ◽  
Dynamic Shear Modulus ◽  
Dynamic Shear ◽  
Gravel Content

In order to support the dynamic design of subgrade filling engineering, an experiment on the dynamic shear modulus (G) and damping ratio (D) of clay–gravel mixtures (CGMs) was carried out. Forty-two groups of resonant column tests were conducted to explore the effects of gravel content (0%, 10%, 20%, 30%, 40%, 50%, and 60%, which was the mass ratio of gravel to clay), gravel shape (round and angular gravels), and confining pressure (100, 200, and 300 kPa) on the dynamic shear modulus, and damping ratio of CGMs under the same compacting power. The test results showed that, with the increase of gravel content, the maximum dynamic shear modulus of CGMs increases, the referent shear strain increases linearly, and the minimum and maximum damping ratios decrease gradually. In CGMs with round gravels, the maximum dynamic shear modulus and the maximum damping ratio are greater, and the referent shear strain and the minimum damping ratio are smaller, compared to those with angular gravels. With the increase of confining pressure, the maximum dynamic shear modulus and the referent shear strain increase nonlinearly, while the minimum and maximum damping ratios decrease nonlinearly. The predicting equation for the dynamic shear modulus and the damping ratio of CGMs when considering confining pressure, gravel content, and shape was established. The results of this research may put forward a solid foundation for engineering design considering low-strain-level mechanical performance.

scholarly journals EXPERIMENTAL STUDY ON THE DYNAMIC SHEAR MODULUS AND DAMPING RATIO OF SATURATED SAND UNDER CYCLIC LOADING

2021 ◽  
Vol 55 (5) ◽  
Author(s):  
Jian Zhang ◽  
Jiuting Cao ◽  
Sijie Huang ◽  
Baocun Shi
Keyword(s):  
Shear Stress ◽  
Shear Modulus ◽  
Shear Strain ◽  
Vibration Frequency ◽  
Damping Ratio ◽  
Test System ◽  
Dynamic Shear Modulus ◽  
Dynamic Shear ◽  
Saturated Sand ◽  
Good Agreement

Initial shear stress is inevitable in actual engineering slopes, subgrades and foundations, and soils exhibit different dynamic characteristics under the influence of initial shear stress. Using a dynamic triaxial test system, this study explores the dynamic shear modulus and damping ratio of saturated sand from Wenchuan, investigates the effects of the initial shear stress and vibration frequencies on the dynamic shear modulus and damping ratio of saturated sand and proposes a normalised dynamic shear modulus formula that considers the initial shear stress and vibration frequency. Results show a threshold dynamic shear strain of the saturated sand. When the dynamic shear strain is below this threshold, the dynamic shear modulus significantly increases with the initial shear stress and vibration frequency. Otherwise, the influence of the initial shear stress and vibration frequency gradually decreases and eventually stabilises. The initial shear stress significantly affects the normalised dynamic shear modulus/strain curves where a larger initial shear stress corresponds to a higher curve. Meanwhile, the vibration frequency only exerts a slight influence. The curves under different frequencies are generally within the same band and fall near the Seed upper envelope. The initial shear stress also has a significant influence on the damping ratio where a larger initial shear stress corresponds to a smaller damping ratio. On the basis of the experimental results, a normalised dynamic shear modulus/shear strain formula that considers the influence of the initial shear stress and vibration frequency is established. Fitting results indicate that this formula shows good agreement with the test data.

The Effect of Nonlinear Dynamic Shear Modulus under Anisotropic Consolidation on Response Spectrum of Soil Layer

2011 ◽  
Vol 243-249 ◽  
pp. 2250-2253 ◽  
Author(s):  
Jing Sun ◽  
Xiao Ming Yuan ◽  
Mao Sheng Gong
Keyword(s):  
Shear Modulus ◽  
Shear Strain ◽  
Response Spectrum ◽  
Soil Layer ◽  
Nonlinear Behavior ◽  
Earthquake Ground Motion ◽  
Dynamic Shear Modulus ◽  
Dynamic Shear ◽  
Anisotropic Consolidation ◽  
Period Decrease

The dynamic shear modulus (DSM) is the most basic soil parameter in earthquake or other dynamic loading conditions and can be obtained through testing in the field and in the laboratory. By using the resonant column tests, the effect of the consolidation ratios on the nonlinear behavior of DSM versus the shear strain, G/Gmax-γ, for two types of sands and fourteen types of undisturbed silty soil is investigated and its effect on the surface response spectrum is presented in the paper. The results here indicate that consolidation ratios have certain effect on the shape of the nonlinear behavior of DSM versus the shear strain and G/Gmax increases with increasing of the consolidation ratios. By comparing to the isotropic consolidation, the consideration for the actual anisotropic consolidation makes the acceleration peak amplitude increase and makes the characteristic period decrease. For the incidence of the strong seismic excitation, the effect of the anisotropic consolidation on earthquake ground motion should be considered.

scholarly journals Dynamic Nonlinear and Residual Deformation Behaviors of the Fly Ash-Modified Loess

2021 ◽  
Vol 2021 ◽  
pp. 1-11
Author(s):  
Qian Wang ◽  
Jun Wang ◽  
Xiumei Zhong ◽  
Haiping Ma ◽  
Xiaowei Xu
Keyword(s):  
Fly Ash ◽  
Shear Modulus ◽  
Shear Strain ◽  
Residual Strain ◽  
Damping Ratio ◽  
Ash Content ◽  
Triaxial Tests ◽  
Dynamic Shear Modulus ◽  
Dynamic Shear ◽  
Modulus Ratio

Metastable loess soils can deform, inducing geological and engineering disasters. Therefore, the behavior of the loess under dynamic load is gaining massive attention from researchers to improve the strength of the soils. Fly ash mixed with loess can improve strength and reduce construction costs and environmental pollution. Moreover, it has strong economic and social benefits. This paper investigates the influence of fly ash on the dynamic properties of the modified loess through a series of dynamic triaxial tests of the fly ash modified loess with different fly ash contents. The treated soil samples were prepared using a static compaction method in both ends and cured for 28 days. The dynamic shear modulus ratio, the damping ratio, and the dynamic residual strain of the modified loess were analyzed. The variation characteristics of the dynamic shear modulus ratio and damping ratio with the dynamic shear strain of the fly ash modified loess were obtained. The effect of fly ash content on the dynamic nonlinear parameters of the modified loess was also investigated. In addition, the relationship between the dynamic residual strain and the fly ash content was discussed. The results show that the dynamic shear modulus ratio of fly ash modified loess decreases nonlinearly with the increase in the dynamic shear strain. However, the attenuation rate difference of the curves is small. The damping ratio increases gradually with increasing dynamic shear strain. Under a certain dynamic shear strain level, the damping ratio decreases with the increase in the fly ash content. The dynamic residual strain increases with the increase in the dynamic stress. However, it decreases with the increase in the fly ash content. When the fly ash content is between 10% and 20%, the dynamic residual strain of fly ash modified loess is reduced rapidly. However, when the fly ash content exceeds 20%, the dynamic residual strain decreases slowly. The fly ash content of 20% could be suggested as an optimal content for seismic resistance of the loess foundation.

Sign in / Sign up

Export Citation Format

Share Document