A Laboratory Study of N-Oleoyl Sarcosine As a Rust Inhibitor in Some Petroleum Products★

CORROSION ◽  
1957 ◽  
Vol 13 (10) ◽  
pp. 92-96 ◽  
Author(s):  
ROBERT M. PINES ◽  
JOHN D. SPIVACK

Abstract Laboratory studies indicate that N-oleoyl sarcosine (I) is an effective oil soluble rust inhibitor in solution in gasoline, mineral oil and silicone lubricants. Rusting tests used included: Turbine Oil Rusting Test (ASTM D665-54), a Static Immersion Test, Humidity Cabinet Test (JAN H-792), Static Water Drop Test (MIL-L-17353 Bu. Ord.). In addition, a number of auxiliary tests were run to indicate the effect of (I) on other properties of the test liquid. Hydrocarbon solutions of N-oleoyl sarcosine are particularly effective in preventing rusting in the presence of synthetic sea water and in resisting water extraction of the inhibitor. 5.8.2

CORROSION ◽  
1959 ◽  
Vol 15 (3) ◽  
pp. 44-46 ◽  
Author(s):  
E. J. SCHWOEGLER ◽  
L. U. BERMAN

Abstract The Static Water Drop Test adapted to research methods has been utilized to evaluate the corrosion inhibiting ability of a number of heterocyclic nitrogen compounds. Most of these heterocyclic N derivatives were synthesized and purified and evaluated in a petroleum-type lubricating oil and a synthetic diester-type lubricating oil. The effect of various functional groups and their positions in the molecule was related to the corrosion inhibiting properties. It was found that the adsorptive power was a function of the heterocyclic nitrogen containing a hydrogen atom as the substituent. It was also found that the adsorptive power at the heterocyclic nitrogen atom was lost when other substituents replaced the hydrogen. It was concluded that the adsorptive effect of the heterocyclic nitrogen is due to its unshared electron pair, which is sterically hindered when substituents other than hydrogen are attached. N-Hydroxyalkyl derivatives in diester oil seemed to arrange themselves in order of effectiveness on the basis of the position of the hydroxyl group in the alkyl chain. The closer the hydroxyl was to the heterocyclic nitrogen the more effective it was as a corrosion inhibitor. There was no way to explain the order of effectiveness of the same compounds in petroleum oil. 5.8.1


2011 ◽  
Vol 53 (5) ◽  
pp. 303-310
Author(s):  
Müzeyyen Marşoğlu ◽  
Ahmet Topuz ◽  
Ali Erdoğmuş ◽  
Oğuzhan Yurdalan ◽  
Sertaç Bilgin ◽  
...  

2003 ◽  
Vol 3 (3) ◽  
pp. 2963-3050 ◽  
Author(s):  
R. Sander ◽  
W. C. Keene ◽  
A. A. P. Pszenny ◽  
R. Arimoto ◽  
G. P. Ayers ◽  
...  

Abstract. The cycling of inorganic bromine in the marine boundary layer (mbl) has received increased attention in recent years. Bromide, a constituent of sea water, is injected into the atmosphere in association with sea-salt aerosol by breaking waves on the ocean surface. Measurements reveal that supermicrometer sea-salt aerosol is depleted in bromine by about 50% relative to conservative tracers, whereas marine submicrometer aerosol is often enriched in bromine. Model calculations, laboratory studies, and field observations strongly suggest that these depletions reflect the chemical transformation of particulate bromide to reactive inorganic gases that influence the processing of ozone and other important constituents of marine air. However, currently available techniques cannot reliably quantify many \\chem{Br}-containing compounds at ambient concentrations and, consequently, our understanding of inorganic Br cycling over the oceans and its global significance are uncertain. To provide a more coherent framework for future research, we have reviewed measurements in marine aerosol, the gas phase, and in rain. We also summarize sources and sinks, as well as model and laboratory studies of chemical transformations. The focus is on inorganic bromine over the open oceans, excluding the polar regions. The generation of sea-salt aerosol at the ocean surface is the major tropospheric source producing about 6.2 Tg/a of bromide. The transport of  Br from continents (as mineral aerosol, and as products from biomass-burning and fossil-fuel combustion) can be of local importance. Transport of degradation products of long-lived Br-containing compounds from the stratosphere and other sources contribute lesser amounts. Available evidence suggests that, following aerosol acidification, sea-salt bromide reacts to form Br2 and BrCl that volatilize to the gas phase and photolyze in daylight to produce atomic Br and Cl. Subsequent transformations can destroy tropospheric ozone, oxidize dimethylsulfide (DMS) and hydrocarbons in the gas phase and S(IV) in aerosol solutions, and thereby potentially influence climate. The diurnal cycle of gas-phase \\Br and the corresponding particulate Br deficits are correlated. Higher values of Br in the gas phase during daytime are consistent with expectations based on photochemistry. Mechanisms that explain the widely reported accumulation of particulate Br in submicrometer aerosols are not yet understood. We expect that the importance of inorganic Br cycling will vary in the future as a function of both increasing acidification of the atmosphere (through anthropogenic emissions) and climate changes. The latter affects bromine cycling via meteorological factors including global wind fields (and the associated production of sea-salt aerosol), temperature, and relative humidity.


1997 ◽  
Vol 54 (8) ◽  
pp. 1837-1864 ◽  
Author(s):  
A Soleng ◽  
T A Bakke

The salinity tolerance of the freshwater monogenean Gyrodactylus salaris, infecting Atlantic salmon (Salmo salar) parr, was studied experimentally. Following direct transfer of infected fish from fresh water to 5.0omicron salinity, parasite population growth increased at the same rate as in fresh water and was positively correlated with temperature (1.4, 6.0, and 12.0°C). In 7.5omicron salinity the populations declined and became extinct after a maximum of 56 days, without any significant difference between 6.0 and 12.0°C. However, some infrapopulations demonstrated short periods of growth. At higher salinities (10.0, 15.0, 20.0, and 33.0omicron) the survival time decreased, and there was a negative correlation between survival time and temperature (1.4, 6.0, and 12.0°C). When transferred directly to sea water (33.0omicron) the parasites became opaque and ceased moving after a few minutes. There was no difference in parasite survival time between direct and gradual transfer from fresh water to 7.5 and 10.0omicron, except for one infrapopulation which demonstrated population growth from day 22 after some fluctuations following gradual transfer to 7.5omicron. The present findings support the hypothesis of brackish water dispersal of G. salaris with infected fish migrating between rivers in fjord systems.


2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Črtomir Donik ◽  
Jakob Kraner ◽  
Aleksandra Kocijan ◽  
Irena Paulin ◽  
Matjaž Godec

AbstractThe key feature of Fe–Mn alloys is gradual degradability and non-magneticity, with laser power bed fusion (LPBF) parameters influencing the microstructure and chemical composition. Our study focuses on biodegradable Fe–Mn alloys produced by mechanically mixing pure metal feedstock powders as part of the LPBF process. The Mn content and, consequently, the γ-ε phase formation in LPBF samples are directly correlated with an adapted energy–density (E) equation by combining the five primary LPBF parameters. We varied laser power (P) in a range of 200–350 W and scanning speed at 400 and 800 mm/s, and a comprehensive study was performed on samples with similar E. The study also showed an almost linear correlation between the LPBF's laser power and the material's hardness and porosity. The corrosion resistance was significantly reduced (from 13 to 400 μm/year) for the LPBF samples compared to a conventionally produced sample due to the dual-phase microstructure, increased porosity and other defects. The static immersion test showed that the process parameters greatly influence the quantity of oxides and the distribution of their diameters in the LPBF samples and, therefore, their corrosion stability. The most challenging part of the study was reducing the amount of ε phase relative to γ phase to increase the non-magnetic properties of the LPBF samples.


1963 ◽  
Vol 4 (36) ◽  
pp. 669-688 ◽  
Author(s):  
Kenneth O. Bennington

AbstractLaboratory studies of the supercooling and freezing of baths of sea-water are described and compared with features of natural sea ice. By using dyes the convection cells in the sea-water test baths could be studied. and the growth of crystals relative to this cell structure could be observed. Brine expelled by the separation of ice from the system commonly followed the pre-existing convection channels. Sections of sea ice are interpreted in the light of these observations, and sea ice is shown to inherit drainage channels and banding features from the characteristics of the parent liquid system.


Sign in / Sign up

Export Citation Format

Share Document