Silent VLPs At Stromboli: Implications For Slug Vs. Plug

Author(s):  
Kathleen McKee ◽  
Diana Roman ◽  
David Fee ◽  
Gregory Waite ◽  
Maurizio Ripepe

<p>Very long period (VLP) seismic signals observed in volcanic environments are thought to be produced by magma and gas flow through conduits. Stromboli Volcano, Italy, typically produces hundreds of VLPs per day. These have been generally attributed to the flow of gas slugs through the shallow plumbing system and thus linked to the mechanism thought to drive Strombolian explosions. During a 6-day-long seismo-acoustic campaign in May 2018 (a period characterized by relatively low activity) we recorded 1900+ seismic events, the majority of which have significant energy in the VLP (2-100 s) band. We used a coincident STA/LTA trigger to identify seismic events in continuous waveform data and then used the PeakMatch algorithm (Rodgers et al., 2015) to identify seismic multiplets, with a focus on VLPs. To identify explosions, we applied the same coincident trigger to infrasound data, and manually identified gas jetting events using spectrograms and high-pass-filtered (20 Hz) waveforms. </p><p> </p><p>We identified ~250 explosions and ~600 jetting events. Seismic multiplet analysis identified two main families of repeating events. Family 1 (F1) has over 500 events and Family 2 (F2) has over 150 events based on a 0.7 correlation threshold. We find that F1 VLPs coincide in time with ~6% of explosions and ~0.8% of jetting events and F2 VLPs coincide in time with ~28% of explosions and ~2.7% of jetting events (we term these “silent VLPs”). These VLPs do not correspond with lava effusion (Marchetti and Ripepe, 2005; Ripepe et al., 2015). F2 have a higher dominant period (8-10 s) compared to F1 (3-4 s). The repeating VLPs are part of a broadband signal and the higher frequencies start after the VLP. VLP peak amplitudes are generally larger for F1 events. The dip of the VLP particle motion roughly locates the F1 and F2 VLP source centroids beneath the active crater and are stable throughout the dataset. Both VLP displacements show a small outward, large inward, and subsequent large outward motion from the crater. The lack of explosions relative to repeating VLPs does not support the slug model, where a slug rises through a conduit, generates a VLP through interactions with changes in conduit geometry, and then bursts at the lava free surface. Our observations support the plug model (Suckale et al., 2016). We suggest the “silent” VLPs are generated when the gas bubbles interact with and move into the semipermeable plug. Then the plug behaves as a mechanical filter for gas escape and allows for passive and explosive escape mechanisms.</p>

1997 ◽  
Vol 40 (6) ◽  
Author(s):  
F. Quattrocchi ◽  
M. Calcara ◽  
B. Porfidia

A new 222Rn monitoring prototype has been designed, assembled and tested at the Istituto Nazionale di Geofisica (ING) specifically addressed to seismic surveillance tasks, exploiting environmental monitoring, etc. It operates with an a scintillation technique (photomultiplier + Lucas Cell) coupled with a water input system, that lets continuous dehumidified gas flow, stripped from groundwater under monitoring. Several laboratory tests have been carried out to check the stability and versatility of the system; moreover statistical tests have been accomplished on several data sets obtained with an 241Am radioactive standard source, to check stability of the photomultiplier. A customised water flow system has been developed to perform both the highest efficiency and lowest influence of external noise parameters. This new prototype is very cheap and will be integrated within the new multiparametric geochemical monitoring system GMS II, that is currently being developed at ING, specifically designed for geochemical surveillance of seismic events.


Author(s):  
N. David Theodore ◽  
Mamoru Tomozane ◽  
Ming Liaw

There is extensive interest in SiGe for use in heterojunction bipolar transistors. SiGe/Si superlattices are also of interest because of their potential for use in infrared detectors and field-effect transistors. The processing required for these materials is quite compatible with existing silicon technology. However, before SiGe can be used extensively for devices, there is a need to understand and then control the origin and behavior of defects in the materials. The present study was aimed at investigating the structural quality of, and the behavior of defects in, graded SiGe layers grown by chemical vapor deposition (CVD).The structures investigated in this study consisted of Si1-xGex[x=0.16]/Si1-xGex[x= 0.14, 0.13, 0.12, 0.10, 0.09, 0.07, 0.05, 0.04, 0.005, 0]/epi-Si/substrate heterolayers grown by CVD. The Si1-xGex layers were isochronally grown [t = 0.4 minutes per layer], with gas-flow rates being adjusted to control composition. Cross-section TEM specimens were prepared in the 110 geometry. These were then analyzed using two-beam bright-field, dark-field and weak-beam images. A JEOL JEM 200CX transmission electron microscope was used, operating at 200 kV.


Author(s):  
A. R. Landa Canovas ◽  
L.C. Otero Diaz ◽  
T. White ◽  
B.G. Hyde

X-Ray diffraction revealed two intermediate phases in the system MnS+Er2S3,:MnEr2S4= MnS.Er2S3, and MnEr4S7= MnS.2Er2S3. Their structures may be described as NaCl type, chemically twinned at the unit cell level, and isostructural with CaTi2O4, and Y5S7 respectively; i.e. {l13} NaCl twin band widths are (4,4) and (4,3).The present study was to search for structurally-related (twinned B.) structures and or possible disorder, using the more sensitive and appropiate technigue of electron microscopy/diffraction.A sample with nominal composition MnEr2S4 was made by heating Mn3O4 and Er2O3 in a graphite crucible and a 5% H2S in Ar gas flow at 1500°C for 4 hours. A small amount of this material was thenannealed, in an alumina crucible, contained in sealed evacuated silica tube, for 24 days at 1100°C. Both samples were studied by X-ray powder diffraction, and in JEOL 2000 FX and 4000 EX microscopes.


Author(s):  
B.S. Soroka ◽  
V.V. Horupa

Natural gas NG consumption in industry and energy of Ukraine, in recent years falls down as a result of the crisis in the country’s economy, to a certain extent due to the introduction of renewable energy sources along with alternative technologies, while in the utility sector the consumption of fuel gas flow rate enhancing because of an increase the number of consumers. The natural gas is mostly using by domestic purpose for heating of premises and for cooking. These items of the gas utilization in Ukraine are already exceeding the NG consumption in industry. Cooking is proceeding directly in the living quarters, those usually do not meet the requirements of the Ukrainian norms DBN for the ventilation procedures. NG use in household gas stoves is of great importance from the standpoint of controlling the emissions of harmful components of combustion products along with maintenance the satisfactory energy efficiency characteristics of NG using. The main environment pollutants when burning the natural gas in gas stoves are including the nitrogen oxides NOx (to a greater extent — highly toxic NO2 component), carbon oxide CO, formaldehyde CH2O as well as hydrocarbons (unburned UHC and polyaromatic PAH). An overview of environmental documents to control CO and NOx emissions in comparison with the proper norms by USA, EU, Russian Federation, Australia and China, has been completed. The modern designs of the burners for gas stoves are considered along with defining the main characteristics: heat power, the natural gas flow rate, diameter of gas orifice, diameter and spacing the firing openings and other parameters. The modern physical and chemical principles of gas combustion by means of atmospheric ejection burners of gas cookers have been analyzed from the standpoints of combustion process stabilization and of ensuring the stability of flares. Among the factors of the firing process destabilization within the framework of analysis above mentioned, the following forms of unstable combustion/flame unstabilities have been considered: flashback, blow out or flame lifting, and the appearance of flame yellow tips. Bibl. 37, Fig. 11, Tab. 7.


2016 ◽  
Vol 136 (5) ◽  
pp. 252-258 ◽  
Author(s):  
Chiharu Shimizu ◽  
Mitsuteru Sato ◽  
Yasuji Hongo ◽  
Fuminori Tsuchiya ◽  
Yukihiro Takahashi

Sign in / Sign up

Export Citation Format

Share Document