scholarly journals Effectiveness of modified pushover analysis procedure for the estimation of seismic demands of buildings subjected to near-fault ground motions having fling step

2013 ◽  
Vol 13 (6) ◽  
pp. 1579-1593 ◽  
Author(s):  
A. Mortezaei ◽  
H. R. Ronagh
Keyword(s):  
Ground Motions ◽  
Pushover Analysis ◽  
Time History ◽  
Building Structures ◽  
Seismic Demands ◽  
Near Fault ◽  
Load Pattern ◽  
Dynamic Time ◽  
Near Fault Earthquakes ◽  
Nonlinear Time History

Abstract. Near-fault ground motions with long-period pulses have been identified as being critical in the design of structures. These motions, which have caused severe damage in recent disastrous earthquakes, are characterized by a short-duration impulsive motion that transmits large amounts of energy into the structures at the beginning of the earthquake. In nearly all of the past near-fault earthquakes, significant higher mode contributions have been evident in building structures near the fault rupture, resulting in the migration of dynamic demands (i.e. drifts) from the lower to the upper stories. Due to this, the static nonlinear pushover analysis (which utilizes a load pattern proportional to the shape of the fundamental mode of vibration) may not produce accurate results when used in the analysis of structures subjected to near-fault ground motions. The objective of this paper is to improve the accuracy of the pushover method in these situations by introducing a new load pattern into the common pushover procedure. Several pushover analyses are performed for six existing reinforced concrete buildings that possess a variety of natural periods. Then, a comparison is made between the pushover analyses' results (with four new load patterns) and those of FEMA (Federal Emergency Management Agency)-356 with reference to nonlinear dynamic time-history analyses. The comparison shows that, generally, the proposed pushover method yields better results than all FEMA-356 pushover analysis procedures for all investigated response quantities and is a closer match to the nonlinear time-history responses. In general, the method is able to reproduce the essential response features providing a reasonable measure of the likely contribution of higher modes in all phases of the response.

Sensitivity analysis of the influence of ground motion intensity levels on the seismic behavior of steel frames in assessment of the target displacement considering near-fault effects

2020 ◽  
Vol 47 (4) ◽  
pp. 470-486
Author(s):  
Alireza Esfahanian ◽  
Ali Akbar Aghakouchak
Keyword(s):  
Ground Motions ◽  
Steel Frames ◽  
Time History ◽  
Time History Analysis ◽  
Nonlinear Time History Analysis ◽  
Seismic Demands ◽  
Near Fault ◽  
History Analysis ◽  
Nonlinear Time History ◽  
Far Fault

Nonlinear time-history analysis conducted as part of a performance-based seismic design approach often require that the ground motion records are selected and then scaled to a specified level of seismic intensity. In such analyses, besides an adequate structural model, a set of acceleration time-series is needed as the most realistic representation of the seismic action. In this paper, the effects of scaling procedure on seismic demands of steel frames are investigated. To this, two special steel moment-resisting frames with considerable higher mode effects, and two sets of ground motions, including near-fault and far-fault motions are considered. Moreover, three scaling procedures are introduced for performing nonlinear dynamic time-history analysis of structures. Among different demands, lateral roof displacement and interstory drift are selected as seismic demands. The height-wise distribution of demands shows that the inelastic seismic demands of the near-fault pulse-like ground motions differ considerably from those of far-fault ones. These results show that the story drifts are mostly larger for far-fault motions in the upper story levels in comparison to near-fault records and in the lower floors, the reverse is true. Thus, the scaling procedures directly affect the results of seismic demands and choosing different methods would result in varying responses. Moreover, a low-cost and fairly effective procedure is proposed to estimate the target displacement demands of buildings from response-spectrum analyses, considering near-fault effects. The precision of this method is verified by nonlinear time-history analysis results, as the benchmark solution, and acceptable improvements have been achieved.

Influence of Earthquake Attack Angle on Seismic Demands for Structures under Bi-Directional Ground Motions

2011 ◽  
Vol 255-260 ◽  
pp. 2330-2334 ◽  
Author(s):  
Yu Zhang ◽  
Quan Wang Li ◽  
Jian Sheng Fan
Keyword(s):  
Seismic Design ◽  
Ground Motions ◽  
Time History ◽  
Earthquake Excitation ◽  
Seismic Demands ◽  
3 Dimensional ◽  
Nonlinear Time History Analyses ◽  
Modification Factor ◽  
Structural Responses ◽  
Nonlinear Time History

The earthquake may attack the structural building from any angle, but in current seismic design codes, this type of uncertainty is seldom accounted. The uncertainty associated with the direction of earthquake excitation was considered in this paper, and its effect on structural responses was investigated. For this purpose, a simple 3-dimensional model with symmetric plan was established, which had fundamental periods ranged from 0.1s to 5.0s, and was subjected to a set of 30 ground motion pairs for which both linear and nonlinear time history analyses were performed. Analyzing results showed that, on average, the elastic roof acceleration is 32% underestimated, and the inelastic roof displacement is 18% underestimated if the variation of earthquake excitation direction is not consider. Recognizing this, a modification factor for the seismic demand was proposed thorough a statistical analysis, which guarantees a probability of 95% design safety

scholarly journals Development of synthetic ground motion at a specific site in Yogyakarta town, Indonesia utilizing the PSHA Method

2020 ◽  
Vol 156 ◽  
pp. 02011
Author(s):  
Widodo Pawirodikromo ◽  
Lalu Makrup ◽  
Mochamad Teguh ◽  
Bambang Suryo
Keyword(s):  
Pilot Study ◽  
Ground Motion ◽  
Hazard Analysis ◽  
Ground Motions ◽  
Time History ◽  
Building Structures ◽  
Uniform Hazard Spectra ◽  
Crustal Earthquakes ◽  
History Analysis ◽  
Dynamic Time

This paper presents the development of synthetic ground motion at specific sites in Yogyakarta town. In the 2019 Indonesian Seismic Code [1] provides an alternative method in the analysis of building structures by applying the dynamic time history analysis. At least 11-pairs of earthquake recordings must be used in the analysis. Synthetic ground motion utilizing the Method of Probability Seismic Hazard Analysis (PSHA) was used in this study. A selected site in Yogyakarta town was chosen as a pilot study considering that there were many fatalities and building damage caused by the 2006 Yogyakarta earthquake. The Uniform Hazard Spectra (UHS) based on the shallow crustal earthquake source is higher than the Megathrust. The risk targeted spectrum demand MCEr has been considered, which on average 12.3% greater than the UHS. The synthetic ground motions (SGM) are accordingly based on the shallow crustal earthquakes. The dominant magnitude and distance are MD = 6.5 and RD = 14.5 km. They show that the contribution of the Opak River fault to the hazard in Yogyakarta town is very dominant because the distance is very close. Based on the obtained MD and RD, spectral matching, and testing significant duration D595, the 12-synthetic ground motions were successfully developed.

Evaluation of Seismic Behavior on Steel Frames with TSW Semi-Rigid Connections under the Nonlinear Time History Analysis

2012 ◽  
Vol 166-169 ◽  
pp. 2083-2087
Author(s):  
Miaad Najdian ◽  
Mohsen Izadinia
Keyword(s):  
Time History ◽  
High Energy ◽  
Time History Analysis ◽  
Nonlinear Time History Analysis ◽  
Near Fault ◽  
Good Ability ◽  
History Analysis ◽  
Ductile Behavior ◽  
Near Fault Earthquakes ◽  
Nonlinear Time History

Movements of pulse shape and the high energy applied in short duration by the near fault earthquake, causes brittle fracture in rigid connections that during the Northridge 1994 and Kobe 1995 earthquakes was frequently seen. Rigid connections, which are generally welded due to lack of ductility, have low energy absorption capability. On the other hand semi-rigid connections have a ductile behavior and have a good ability to absorb energy. The purpose of this paper is analysis and compares the behaviors of “rigid” and “TSW semi-rigid” connections under the near fault earthquakes with nonlinear time history analysis by perform 3D software.

Adaptive Spectra-Based Pushover Procedure for Seismic Evaluation of Structures

2000 ◽  
Vol 16 (2) ◽  
pp. 367-391 ◽  
Author(s):  
Balram Gupta ◽  
Sashi K. Kunnath
Keyword(s):  
Response Spectrum ◽  
Pushover Analysis ◽  
Nonlinear Dynamic Analysis ◽  
Time History ◽  
Northridge Earthquake ◽  
Seismic Evaluation ◽  
Seismic Demands ◽  
Ground Shaking ◽  
Motion Characteristics ◽  
Nonlinear Time History

The estimation of inelastic seismic demands using nonlinear static procedures, or pushover analyses, are inevitably going to be favored by practicing engineers over nonlinear time-history methods. While there has been some concern over the reliability of static procedures to predict inelastic seismic demands, improved procedures overcoming these drawbacks are still forthcoming. In this paper, the potential limitations of static procedures, such as those recommended in FEMA 273, are highlighted through an evaluation of the response of instrumented buildings that experienced strong ground shaking in the 1994 Northridge earthquake. A new enhanced adaptive “modal” site-specific spectra-based pushover analysis is proposed, which accounts for the effect of higher modes and overcomes the shortcomings of the FEMA procedure. Features of the proposed procedure include its similarity to traditional response spectrum-based analysis and the explicit consideration of ground motion characteristics during the analysis. It is demonstrated that the proposed procedure is able to reasonably capture important response attributes, such as interstory drift and failure mechanisms, even for structures with discontinuities in strength and/or stiffness that only a detailed nonlinear dynamic analysis could predict.

Performance of Bridges Isolated with Sliding-Lead Rubber Bearings Subjected to Near-Fault Earthquakes

2020 ◽  
Vol 20 (02) ◽  
pp. 2050023 ◽  
Author(s):  
Wenzhi Zheng ◽  
Hao Wang ◽  
Hong Hao ◽  
Kaiming Bi ◽  
Huijun Shen
Keyword(s):  
Time History ◽  
Isolation System ◽  
Peak Displacement ◽  
Residual Displacement ◽  
Near Fault ◽  
Lead Rubber Bearing ◽  
Base Forces ◽  
Near Fault Earthquakes ◽  
Rubber Bearings ◽  
Nonlinear Time History

This paper investigates the seismic performance of bridges installed with a sliding-lead rubber bearing (LRB) isolation system subjected to near-fault earthquakes. A three-span continuous bridge isolated with sliding-LRB system is used as an example. Nonlinear time history analyses are conducted to investigate the sensitivity effects of isolation period, friction coefficient and sliding displacement limit on the bridge responses. The responses of the sliding-LRB system are compared with those of the conventional LRB system. The results show that the base forces of the piers can be reduced by employing proper friction coefficients. However, the residual displacement of the sliding-LRB system may be larger compared with that of the conventional LRB system. To overcome this disadvantage, an improved solution to reduce the residual displacement is proposed with its effectiveness investigated. It was also demonstrated that the residual displacement and peak displacement can be effectively reduced by employing the shape memory alloy devices in the sliding-LRB system without significantly increasing the base forces.

scholarly journals Special Moment Resistant Steel Buildings

2021 ◽  
pp. 444-448
Author(s):  
Deepan Dev B ◽  
Dr V Selvan
Keyword(s):  
Pushover Analysis ◽  
Time History ◽  
Nonlinear Time History Analysis ◽  
Building Structures ◽  
Braced Frames ◽  
Steel Buildings ◽  
Braced Frame ◽  
Moment Resisting ◽  
Frame Systems ◽  
Nonlinear Time History

The seismic response of special moment-resisting frames (SMRF), buckling restrained braced (BRB) frames and self-centering energy dissipating (SCED) braced frames is compared when used in building structures many stories in height. The study involves pushover analysis as well as 2D and 3D nonlinear time history analysis for two ground motion hazard levels. The SCED and BRB braced frames generally experienced similar peak interstory drifts. The SMRF system had larger interstory drifts than both braced frames, especially for the shortest structures. The SCED system exhibited a more uniform distribution of the drift demand along the building height and was less prone to the biasing of the response in one direction due to P-Delta effects. The SCED frames also had significantly smaller residual lateral deformations. The two braced frame systems experienced similar interstory drift demand when used in torsional irregular structures.

Seismic Behavior Evaluation of Semi-Rigid Steel Frames with EEP Connections under the near-Fault Earthquakes

2012 ◽  
Vol 174-177 ◽  
pp. 561-565
Author(s):  
Miaad Najdian ◽  
Mohsen Izadinia
Keyword(s):  
Time History ◽  
The Other ◽  
Nonlinear Time History Analysis ◽  
Near Fault ◽  
Good Ability ◽  
History Analysis ◽  
Ductile Behavior ◽  
Near Fault Earthquakes ◽  
Nonlinear Time History ◽  
3D Software

Pulse shape motions and huge amount of energy applied in short duration by the near fault earthquake, cause brittle fracture in welded connections, which is widely observed in Kobe 1995 and Northridge 1994 earthquakes. Rigid connections, which are generally welded due to lack of ductility, have low energy absorption capability. On the other hand, Semi-rigid connections have a ductile behavior and have a good ability to absorb energy. The purpose of this paper is analysis and compares the behaviors of “rigid” and “EEP semi-rigid” connections in cases of “four bolt extended”, “eight bolt extended stiffened” and “eight bolt, four bolts wide, extended stiffened” under the near fault earthquakes with nonlinear time history analysis by perform 3D software. The results shown that the steel frame with “four bolt extended” semi-rigid connections have appropriate performance compared to the other frames.

Sign in / Sign up

Export Citation Format

Share Document