scholarly journals Which product would be chosen? A fuzzy VIKOR method for evaluation and selection of products in terms of customers' point of view; Case study: Iranian cell phone market

2012 ◽  
pp. 23-32 ◽  
Author(s):  
Jahangir Yadollahi Farsi ◽  
Javad Siahkali Moradi ◽  
Behrooz Jamali
2021 ◽  
Vol 9 ◽  
Author(s):  
Zahra Sobhani ◽  
Yunlong Luo ◽  
Christopher T. Gibson ◽  
Youhong Tang ◽  
Ravi Naidu ◽  
...  

As an emerging contaminant, microplastic is receiving increasing attention. However, the contamination source is not fully known, and new sources are still being identified. Herewith, we report that microplastics can be found in our gardens, either due to the wrongdoing of leaving plastic bubble wraps to be mixed with mulches or due to the use of plastic landscape fabrics in the mulch bed. In the beginning, they were of large sizes, such as > 5 mm. However, after 7 years in the garden, owing to natural degradation, weathering, or abrasion, microplastics are released. We categorize the plastic fragments into different groups, 5 mm–0.75 mm, 0.75 mm–100 μm, and 100–0.8 μm, using filters such as kitchenware, meaning we can collect microplastics in our gardens by ourselves. We then characterized the plastics using Raman image mapping and a logic-based algorithm to increase the signal-to-noise ratio and the image certainty. This is because the signal-to-noise ratio from a single Raman spectrum, or even from an individual peak, is significantly less than that from a spectrum matrix of Raman mapping (such as 1 vs. 50 × 50) that contains 2,500 spectra, from the statistical point of view. From the 10 g soil we sampled, we could detect the microplastics, including large (5 mm–100 μm) fragments and small (<100 μm) ones, suggesting the degradation fate of plastics in the gardens. Overall, these results warn us that we must be careful when we do gardening, including selection of plastic items for gardens.


2019 ◽  
Vol 7 (10) ◽  
pp. 359 ◽  
Author(s):  
Hwang ◽  
Jeong ◽  
Jung ◽  
Kim ◽  
Zhou

This research was focused on a comparative analysis of using LNG as a marine fuel with a conventional marine gas oil (MGO) from an environmental point of view. A case study was performed using a 50K bulk carrier engaged in domestic services in South Korea. Considering the energy exporting market for South Korea, the fuel supply chain was designed with the two largest suppliers: Middle East (LNG-Qatar/MGO-Saudi Arabia) and U.S. The life cycle of each fuel type was categorized into three stages: Well-to-Tank (WtT), Tank-to-Wake (TtW), and Well-to-Wake (WtW). With the process modelling, the environmental impact of each stage was analyzed based on the five environmental impact categorizes: Global Warming Potential (GWP), Acidification Potential (AP), Photochemical Potential (POCP), Eutrophication Potential (EP) and Particulate Matter (PM). Analysis results reveal that emission levels for the LNG cases are significantly lower than the MGO cases in all potential impact categories. Particularly, Case 1 (LNG import to Korea from Qatar) is identified as the best option as producing the lowest emission levels per 1.0 × 107 MJ of fuel consumption: 977 tonnages of CO2 equivalent (for GWP), 1.76 tonnages of SO2 equivalent (for AP), 1.18 tonnages of N equivalent (for EP), 4.28 tonnages of NMVOC equivalent (for POCP) and 26 kg of PM 2.5 equivalent (for PM). On the other hand, the results also point out that the selection of the fuel supply routes could be an important factor contributing to emission levels since longer distances for freight transportation result in more emissions. It is worth noting that the life cycle assessment can offer us better understanding of holistic emission levels contributed by marine fuels from the cradle to the grave, which are highly believed to remedy the shortcomings of current marine emission indicators.


Geosciences ◽  
2019 ◽  
Vol 9 (3) ◽  
pp. 107 ◽  
Author(s):  
Jacek Rapinski ◽  
Artur Janowski

Modern Global Navigation Satellite Systems (GNSS) allow for positioning with accuracies ranging from tens of meters to single millimeters depending on user requirements and available equipment. A major disadvantage of these systems is their unavailability or limited availability when the sky is obstructed. One solution is to use additional range measurements from ground-based nodes located in the vicinity of the receiver. The highest accuracy of distance measurement can be achieved using ultra wide band (UWB) or ZigBee phase shift measurement. The position of the additional transmitter must be carefully selected in order to obtain the optimal improvement in the dilution of precision (DOP), which reflects the improvement in the geometry of solution. The presented case study depicts a method for selecting the optimal location of a ground-based ranging source. It is based on a search of a minimum DOP value as a transmitter location function. The parameters of objective function are the elevation and azimuth of the transceiver. The solution was based on a limited-memory Broyden–Fletcher–Goldfarb–Shanno with Box constraints (L-BFGS-B) method and a numerical optimization algorithm for parameter value estimation. The presented approach allows for the selection of the optimal location of a ground-based source of ranging signals in GNSS processing from a geometry of solution point of view. This can be useful at the design stage of an augmentation network of ground-based transceivers. This article presents a theoretical basis and a case study presenting the selection of the optimal location of a ground-based ranging source.


Author(s):  
Abit Balin ◽  
Bekir Şener ◽  
Hakan Demirel

Tugboats have a very critical role in numerous fields of the maritime sector. There are many types of tugboats with different characteristics that give superior results in different operations. Choosing the most suitable tugboat type for the desired operation is a multi-criteria problem that requires expertise. The design features of the tugboat and the propulsion system are important features used for classification. In addition, operational, environmental, and financial factors are also of considerable importance. In this article, determined criteria for tugboats classified according to their propulsion systems have been evaluated by subject-matter experts through a questionnaire. Fuzzy Shannon Entropy has been used to calculate the weights of each determined criterion. Then, fuzzy VIKOR was selected to rank the alternatives due to good compatibility with Entropy and the ability to adequately distinguish the table values that compose the ranking. Finally, the most suitable tugboat type was chosen in accordance with these results.


2011 ◽  
Vol 4 (1) ◽  
pp. 105 ◽  
Author(s):  
Roksana Begum

AbstractThough mobile assisted language learning is an important issue in ELT in many countries, Bangladesh is far away from this method of learning. The present paper has focused on the mobile assisted language learning where the author has tried to explore the potential of cell phone usages as instructional tool in EFL classroom of Bangladesh. The researcher conducted a case study on Jahangirnagar University of Bangladesh. Some undergraduate EFL students participated in the study as subjects. To find out the benefits and challenges of using cell phones in the classroom, some SMS based class tests were conducted where the teachers sent mobile SMS to students as a means of instruction for teaching appropriate use of preposition and to find out the efficacy of SMS based class, a test was also taken via SMS and students also replied and students were given feedback through SMS. After that, students and teachers opinion regarding the cell phone usages; its benefits and inhibiting factors for the implementations in the EFL classroom are collected through students’ questionnaire, teacher interviews and classroom observation reports. The research results imply that cell phone has great potential as instructional tool despite some challenges that can be solved by the sincere attempts of the authority, teachers and by changing the ethical point of view that consider cell phones as mere  a disturbing factor in the classroom. Some probable solutions for the challenges of using cell phone in the class are also presented. The study will be beneficial for educators of Bangladesh and many developing countries like Bangladesh. It will also be supportive for the EFL teachers and students who are always pursuing for more innovative way for teaching and learning English. Such studies are rare in Bangladesh, though some studies regarding m-learning are done by some researchers previously.


2015 ◽  
Vol 2015 ◽  
pp. 1-16 ◽  
Author(s):  
Rasim M. Alguliyev ◽  
Ramiz M. Aliguliyev ◽  
Rasmiyya S. Mahmudova

Personnel evaluation is an important process in human resource management. The multicriteria nature and the presence of both qualitative and quantitative factors make it considerably more complex. In this study, a fuzzy hybrid multicriteria decision-making (MCDM) model is proposed to personnel evaluation. This model solves personnel evaluation problem in a fuzzy environment where both criteria and weights could be fuzzy sets. The triangular fuzzy numbers are used to evaluate the suitability of personnel and the approximate reasoning of linguistic values. For evaluation, we have selected five information culture criteria. The weights of the criteria were calculated using worst-case method. After that, modified fuzzy VIKOR is proposed to rank the alternatives. The outcome of this research is ranking and selecting best alternative with the help of fuzzy VIKOR and modified fuzzy VIKOR techniques. A comparative analysis of results by fuzzy VIKOR and modified fuzzy VIKOR methods is presented. Experiments showed that the proposed modified fuzzy VIKOR method has some advantages over fuzzy VIKOR method. Firstly, from a computational complexity point of view, the presented model is effective. Secondly, compared to fuzzy VIKOR method, it has high acceptable advantage compared to fuzzy VIKOR method.


2018 ◽  
Vol 26 (2) ◽  
pp. 76-82
Author(s):  
Aleksandra Sulik-Górecka

Abstract Modern manufacturing entities often operate in capital groups, and their role is sometimes limited to the function of cost centers. From the legal point of view, however, they are separate entities obliged to apply transfer pricing regulations. Meeting the requirements of the arm's length principle can be very difficult at this time, given the relationships and conflicts of interest in the capital group. Complexity increases in capital groups operating in different countries, due to differences in tax regulations. The main purpose of the paper is to demonstrate that the need to valuate the sale of finished goods to a manufacturing entity, which is a subject to a different tax jurisdiction, may lead to a problem of compliance with the arm's length principle. In addition, the paper proposes a methodology for comparability analysis that may be used by manufacturing entities to defend conditions of setting transfer pricing. The paper presents the different functional profiles of manufacturing entities and points out the difficulties that they may encounter when preparing the comparability analysis. It has also been noted that there are differences in transfer pricing regulations in different countries, for example by analyzing Polish and Czech regulations. The lack of uniform benchmarking legislation can cause inconsistencies in the selection of comparable data, resulting in differences in transfer pricing. The paper uses the method of legal regulation review and analysis of results of published studies concerning the scope of transfer pricing and comparability analysis. The paper also adopts a case study analysis.


2005 ◽  
Vol 19 ◽  
pp. 123-150 ◽  
Author(s):  
Christian M.I.M. Matthiessen ◽  
Annabelle Lukin ◽  
David G. Butt ◽  
Chris Cleirigh ◽  
Christopher Nesbitt

The domains of application in applied linguistics have changed considerably since the early 1960s. In most of these domains, the fundamental property of language as a resource for making meaning has increasingly been foregrounded. This approach recognises, amongst other dimensions of language, its multi-stratal character, i.e. that a given instance of language consists of patterns of meaning (semantics), realized by patterns of wording (grammar), realized by patterns of sounding (phonology) or writing (graphology). The co-selection of these patterns both construes and expresses the kind of social context in which the language operates. There has not yet been a register of English described from the point of view of all four strata. In this paper, we report on a research project which is developing a multi-stratal description of a service encounter, namely the ordering of fast food by telephone. We present some of the findings here regarding the likely cross-stratal patterns for this kind of service encounter, and suggest areas of future research.


Author(s):  
Ahmet Kaya ◽  
Veysi Başhan ◽  
Yasin Ust

Ships have to maintain many auxiliary machineries with high power consumption, and these machineries generally run continuously for long hours. One of the auxiliary machineries that consume a lot of power in ships is the air compressor. These air compressors are especially important as they are used at the start of the main engine and generator diesel engines. Therefore, a suitable selection of these compressors is vital, in terms of technical requirement, energy efficiency, and cost effectiveness. The main focus of this study is to decide the optimum compressor in terms of all technical and operational criteria. In this context, using the fuzzy VIKOR method, five different and worldwide known compressor brands are listed in terms of selection by evaluating seven different and important criteria. These criteria were evaluated by five experts working as technical directors in shipping companies without being informed of each other. Briefly, this study aims to assist shipping companies in choosing the optimal compressor to suit their primary operating goals, considering the navigating routes and conditions of commercial ships. We believe that it is possible to close this gap in the literature and to select the optimum compressor according to the technical and operational needs.


Sign in / Sign up

Export Citation Format

Share Document