Abstract
Reservoir transmissibility and storage values can be obtained from pressure pulses induced in one well and measured at a second well. Such pulse-test values are generally calculated from pulse-test values are generally calculated from equations which assume the formation is homogeneous. This paper examines the effects of areally distributed heterogeneities on pulse-test values. An influence area is first developed for a pulse-tested well pair; only those heterogeneities pulse-tested well pair; only those heterogeneities within this area significantly affect pulse-test results. Next, for three limiting cases, the manner in which a pulse test averages heterogeneities within the influence area is described. These are the cases for which one of the three formation properties - hydraulic diffusivity, transmissibility properties - hydraulic diffusivity, transmissibility and storage - is constant throughout the influence area. Finally, a method called directional correction is developed that when applied to pulse-test values of transmissibility and storage restores some, if not most, of the true degree of heterogeneity to these values. Accuracy of the method depends upon the relative variability of the true values.
Introduction
The pulse-testing method of Johnson et al. uses a sequence of rate changes at one well to create a low-level pressure interference response at an adjacent well. This response is readily analyzed for reservoir properties if one assumes an infinite, homogeneous reservoir model. The field data of McKinley et al. show that, despite the use of a simple analytical model, pulse-test values are sensitive to between-well pulse-test values are sensitive to between-well formation properties. Calculated values for transmissibility and storage exhibit considerable variation with direction around a central pulsing well. These values cannot, however, reflect the exact degree of heterogeneity since flow about the pulsing well is usually nonradial. pulsing well is usually nonradial. This paper examines the effects of certain idealized types of areal heterogeneities on pulse-test values calculated from the simple model. In pulse-test values calculated from the simple model. In particular, an influence area for a pulse-tested well particular, an influence area for a pulse-tested well pair is first developed. This area is defined as that pair is first developed. This area is defined as that areal portion of the formation whose properties determine the numerical value, obtained from pulse testing the well pair. Its size depends on the length of the pulse and the hydraulic diffusivity of the formation. We then determine the type of average values yielded by a pulse test when heterogeneities are distributed randomly throughout the influence area. Results of these studies provide a simple correction scheme that restores some of the true degree of heterogeneity to pulse-test values of transmissibility and storage. Accuracy of the method depends on the relative variability of the latter two reservoir parameters.
PULSE-TEST TERMINOLOGY AND ANALYSIS
PULSE-TEST TERMINOLOGY AND ANALYSIS A typical rate-change sequence at the pulsing well appears at the bottom of Fig. 1. The pulse rate is q reservoir B/D and the pulse length is delta t minutes. The time between pulses is R delta t minutes. Each such pulse cycle induces at the responding well the pressure response (pulse) shown at the top of Fig. 1. According to the analysis method of Johnson et al., each pressure pulse is characterized by two quantities - a time lag, tL minutes, and a pulse amplitude, delta p psi. How these values are pulse amplitude, delta p psi. How these values are determined from the pressure response is apparent from Fig. 1. For an infinite, homogeneous formation, the time lag, tL, the R-value and the well spacing, rws, are sufficient to determine the hydraulic diffusivity, of the formation. These values, coupled with pulse amplitude, p, and pulse rate, q, determine formation transmissibility, =kh/ . Formation storage, = ch, is obtained from the ratio = / . Charts to facilitate this analysis are given by Brigham for R=1.
SPEJ
P. 181
AUTOMATIC TRANSFER SWITCH UNTUK RUMAH TINGGAL SEDERHANA BERBASIS ARDUINO NANO
