Geo-Temporal Signatures of Physicochemical and Heavy Metals Pollution in Groundwater of Khulais Region—Makkah Province, Saudi Arabia

Seawater has intruded into many of Saudi Arabia’s Red Sea coastal aquifers, with varying degrees of extension depending on location, hydrogeology, and population density. This study aimed to evaluate and comprehend the processes that influence the hydrogeochemical characteristics of the coastal aquifer in Saudi Arabia’s Khulais region. Groundwater samples were taken from nineteen locations during the winter and summer of 2021, and data from major ions and trace elements were examined and interpreted using ArcGIS software. The total dissolved solids (TDS) concentrations ranged between 480 and 15,236 mg/L and 887–18,620 mg/L in winter and summer, respectively. Groundwater TDS concentration was observed to be influenced by groundwater flow, lithogenic, anthropogenic, and seawater intrusion in this study (2021) when compared to 2016. The concentration of nitrate (NO3−) and strontium (Sr) in most samples exceeds the drinking guidelines. The occurrence of high concentrations of bromide (Br), Fluoride (F), Iron (Fe) (winter and summer) and Aluminum (Al), Boron (B), Chromium (Cr), Nickel (Ni), lead (Pb), cadmium (Cd), cobalt (Co), copper (Cu) and manganese (Mn) (winter) was also exhibited and observed up to more than drinking and irrigation limits. The central part of the study area was affected by seawater intrusion. The hydraulic conductivity of the topsoil was measured, and it ranged from 0.24 to 29.3 m/day. Based on electrical conductivity (EC) and sodium absorption ratio, most aquifer samples were unsuitable for irrigation (SAR).

A Review on the Application of Isotopic Techniques to Trace Groundwater Pollution Sources within Developing Countries

Owing to a lack of efficient solid waste management (SWM) systems, groundwater in most developing countries is found to be contaminated and tends to pose significant environmental health risks. This review paper proffers guidelines on the application of isotopic techniques to trace groundwater pollution sources from data spanning from 2010 to 2020 within developing countries. Earlier groundwater studies in those countries were mainly focused on using hydrochemical and geophysical techniques. The limitation of these techniques is that they can only monitor the concentration of pollutants in the water bodies and possible leachate infiltration but cannot determine the specific sources of the pollution. Stable isotopes of δ18O, δ2H and δ13C can confirm leachate migration to water bodies due to methanogenesis. The high tritium in landfill leachates is useful to identify leachate percolation in groundwater. The δ15N technique has been used to distinguish between synthetic and organic nitrogen sources but its application is limited to differentiating between atmospheric vs. inorganic nitrogen sources. The use of a dual isotope of δ15N–NO3− and δ18O–NO3− is beneficial in terms of identifying various sources of nitrogen such as atmospheric and inorganic fertilizers but is yet to be used to differentiate between nitrogen pollution sources from dumpsites, sewage and animal manure. The coupling of the 11B isotope with δ15N–NO3− and δ18O–NO3− and other hydrochemical parameters has proven to be effective in distinguishing between nitrate fertilizer, animal manure, seawater contamination and sewage. Therefore, in areas affected by agricultural activities, landfill leachates, domestic or sewage effluent and seawater intrusion, it is incumbent to couple hydrochemical (Cl−, NO3−, B, DO) and isotope techniques (δ18O, 2H, δ13C, δ18O–NO3−, δ15N–NO3−, δ11B and 3H) to effectively determine pollution sources of groundwater in developing countries. The foregoing review will provide guidelines for studies that may aim to critically distinguish between seawater intrusion, dumpsites, sewage and septic leachates.

Effects of aquifer geometry on seawater intrusion in annulus segment island aquifers

Seawater intrusion in island aquifers was considered analytically, specifically for annulus segment aquifers (ASAs), i.e., aquifers that (in plan) have the shape of an annulus segment. Based on the Ghijben–Herzberg and hillslope-storage Boussinesq equations, analytical solutions were derived for steady-state seawater intrusion in ASAs, with a focus on the freshwater–seawater interface and its corresponding watertable elevation. Predictions of the analytical solutions compared well with experimental data, and so they were employed to investigate the effects of aquifer geometry on seawater intrusion in island aquifers. Three different ASA geometries were compared: convergent (smaller side is facing the lagoon, larger side is the internal no-flow boundary and flow converges towards the lagoon), rectangular and divergent (smaller side is the internal no-flow boundary, larger side is facing the sea and flow diverges towards the sea). Depending on the aquifer geometry, seawater intrusion was found to vary greatly, such that the assumption of a rectangular aquifer to model an ASA can lead to poor estimates of seawater intrusion. Other factors being equal, compared with rectangular aquifers, seawater intrusion is more extensive, and watertable elevation is lower in divergent aquifers, with the opposite tendency in convergent aquifers. Sensitivity analysis further indicated that the effects of aquifer geometry on seawater intrusion and watertable elevation vary with aquifer width and distance from the circle center to the inner arc (the lagoon boundary for convergent aquifers or the internal no-flow boundary for divergent aquifers). A larger aquifer width and distance from the circle center to the inner arc weaken the effects of aquifer geometry, and hence differences in predictions for the three geometries become less pronounced.

Assessment of Seawater Intrusion in Coastal Aquifers Using Multivariate Statistical Analyses and Hydrochemical Facies Evolution-Based Model

Groundwater (GW) studies have been conducted worldwide with regard to several pressures, including climate change, seawater intrusion, and water overexploitation. GW quality is a very important sector for several countries in the world, in particular for Tunisia. The shallow coastal aquifer of Sfax (located in Tunisia) was found to be under the combined conditions of continuous drop in GW and further deterioration of the groundwater quality (GWQ). This study was conducted to identify the processes that control GWQ mainly in relation to mineralization sources in the shallow Sfax coastal aquifer. To perform this task, 37 wells are considered. Data include 10 physico-chemical properties of groundwater analyzed in water samples: pH, EC, calcium (Ca), sodium (Na), magnesium (Mg), potassium (K), chloride (Cl), sulfate (SO4), bicarbonate (HCO3), and nitrate (NO3), i.e., investigation was based on a database of 370 observations. Principal component analysis (PCA) and hydrochemical facies evolution (HFE) were conducted to extract the main factors affecting GW chemistry. The results obtained using the PCA model show that GWQ is mainly controlled by either natural factors (rock–water interactions) or anthropogenic ones (agricultural and domestic activities). Indeed, the GW overexploitation generated not only the GWQ degradation but also the SWI. The inverse distance weighted (IDW) method, integrated in a geographic information system (GIS), is employed to achieve spatial mapping of seawater intrusion locations. Hydrochemical facies evolution (HFE) results corroborate the seawater intrusion and its spatial distribution. Furthermore, the mixing ratio showed that Jebeniana and Chaffar–Mahares localities are characterized by high SWI hazard. This research should be done to better manage GW resources and help to develop a suitable plan for the exploitation and protection of water resources.