Electrochemical Sensor for Methamphetamine Detection Using Laser-Induced Porous Graphene Electrode

A 3D porous graphene structure was directly induced by CO2 laser from the surface of Kapton tape (carbon source) supported by polyethylene terephthalate (PET) laminating film. A highly flexible laser-induced porous graphene (LI-PGr) electrode was then fabricated via a facile one-step method without reagent and solvent in a procedure that required no stencil mask. The method makes pattern design easy, and production cost-effective and scalable. We investigated the performance of the LI-PGr electrode for the detection of methamphetamine (MA) on household surfaces and in biological fluids. The material properties and morphology of LI-PGr were analysed by scanning electron microscopy (SEM), energy dispersive x-ray (EDX) and Raman spectroscopy. The LI-PGr electrode was used as the detector in a portable electrochemical sensor, which exhibited a linear range from 1.00 to 30.0 µg mL−1 and a detection limit of 0.31 µg mL−1. Reproducibility was good (relative standard deviation of 2.50% at 10.0 µg mL−1; n = 10) and anti-interference was excellent. The sensor showed good precision and successfully determined MA on household surfaces and in saliva samples.

Manufacturing Process of Polymeric Microneedle Sensors for Mass Production

In this work, we present a fabrication process for microneedle sensors made of polylactic acid (PLA), which can be utilized for the electrochemical detection of various biomarkers in interstitial fluid. Microneedles were fabricated by the thermal compression molding of PLA into a laser machined polytetrafluoroethylene (PTFE) mold. Sensor fabrication was completed by forming working, counter, and reference electrodes on each sensor surface by Au sputtering through a stencil mask, followed by laser dicing to separate individual sensors from the substrate. The devised series of processes was designed to be suitable for mass production, where multiple microneedle sensors can be produced at once on a 4-inch wafer. The operational stability of the fabricated sensors was confirmed by linear sweep voltammetry and cyclic voltammetry at the range of working potentials of various biochemical molecules in interstitial fluid.

Stencil mask defined doctor blade printing of organic single crystal array for high-performance organic field-effect transistors

Organic field-effect transistor (OFET) is one of the promising candidates for next generation electronics due to its solution processability and good performance superior to amorphous Si devices. Patterning the organic...

Sub-ppm NO2 Sensing in Temperature Cycled Mode with Ga Doped ZnO Thin Films Deposited by RF Sputtering

In this work Ga doped ZnO thin films have been deposited by RF magnetron sputtering onto a silicon micro-hotplate and their structural, microstructural and gas sensing properties have been studied. ZnO:Ga thin film with a thickness of 50 nm has been deposited onto a silicon based micro-hotplates without any photolithography process thanks to a low cost and reliable stencil mask process. Sub-ppm sensing (500 ppb) of NO2 gas at low temperature (50 °C) has been obtained with promising responses R/R0 up to 18.