oxide removal
Recently Published Documents


TOTAL DOCUMENTS

286
(FIVE YEARS 50)

H-INDEX

29
(FIVE YEARS 6)

Nanomaterials ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 1408
Author(s):  
Lu Xie ◽  
Huilong Zhu ◽  
Yongkui Zhang ◽  
Xuezheng Ai ◽  
Junjie Li ◽  
...  

For the formation of nano-scale Ge channels in vertical Gate-all-around field-effect transistors (vGAAFETs), the selective isotropic etching of Ge selective to Ge0.8Si0.2 was considered. In this work, a dual-selective atomic layer etching (ALE), including Ge0.8Si0.2-selective etching of Ge and crystal-orientation selectivity of Ge oxidation, has been developed to control the etch rate and the size of the Ge nanowires. The ALE of Ge in p+-Ge0.8Si0.2/Ge stacks with 70% HNO3 as oxidizer and deionized (DI) water as oxide-removal was investigated in detail. The saturated relative etched amount per cycle (REPC) and selectivity at different HNO3 temperatures between Ge and p+-Ge0.8Si0.2 were obtained. In p+-Ge0.8Si0.2/Ge stacks with (110) sidewalls, the REPC of Ge was 3.1 nm and the saturated etching selectivity was 6.5 at HNO3 temperature of 20 °C. The etch rate and the selectivity were affected by HNO3 temperatures. As the HNO3 temperature decreased to 10 °C, the REPC of Ge was decreased to 2 nm and the selectivity remained at about 7.4. Finally, the application of ALE in the formation of Ge nanowires in vGAAFETs was demonstrated where the preliminary Id–Vds output characteristic curves of Ge vGAAFET were provided.


ACS Omega ◽  
2021 ◽  
Author(s):  
Yasinalli Tamboli ◽  
Bharat B. Kashid ◽  
Ram Prasad Yadav ◽  
Mohammad Rafeeq ◽  
Ravindra Yeole ◽  
...  

2021 ◽  
Author(s):  
Utkirjon Sharopov ◽  
Kulwinder Kaur ◽  
Muzaffar Kurbanov ◽  
Dilmurod Saidov ◽  
Erkin Juraev ◽  
...  

Abstract A comparative study is carried out for etching a surface with negative and positive ions, and the results show completely opposite physical processes occur on a silicon surface. Irradiation with positive ions exhibits oxide removal, while irradiation with negative ions shows an intense oxidation of the sample surface. Technology for low-temperature ion cleaning and the electron-spectrometric control of silicon wafers has been developed. This technology has been shown that only irradiation with caesium ions followed by annealing at 650 °C leads to an atomically clean silicon surface for several minutes, which is dependent on the pressure of residual gases under vacuum. After cleaning in a vacuum of 10-9 Pa, the silicon surface begins to oxidize again within 10 min.


Sign in / Sign up

Export Citation Format

Share Document