Throughput maximization in poisson aerial base station-based networks with coverage probability and power density constraints

2018 ◽  
Vol 29 (8) ◽  
pp. e3456 ◽  
Author(s):  
Arvin Saeedi ◽  
Arman Azizi ◽  
Nader Mokari
Author(s):  
Hassan El Alami ◽  
Abdellah Najid

Energy efficiency and throughput are critical factors in the design routing protocols of WSNs. Many routing protocols based on clustering algorithm have been proposed. Current clustering algorithms often use cluster head selection and cluster formation to reduce energy consumption and maximize throughput in WSNs. In this chapter, the authors present a new routing protocol based on smart energy management and throughput maximization for clustered WSNs. The main objective of this protocol is to solve the constraint of closest sensors to the base station which consume relatively more energy in sensed information traffics, and also decrease workload on CHs. This approach divides network field into free area which contains the closest sensors to the base station that communicate directly with, and clustered area which contains the sensors that transmit data to the base station through cluster head. So due to the sensors that communicate directly to the base station, the load on cluster heads is decreased. Thus, the cluster heads consume less energy causing the increase of network lifetime.


Electronics ◽  
2020 ◽  
Vol 9 (9) ◽  
pp. 1495
Author(s):  
Noha Hassan ◽  
Xavier Fernando

Fifth-generation (5G) wireless networks and beyond will be heterogeneous in nature, with a mixture of macro and micro radio cells. In this scenario where high power macro base stations (MBS) coexist with low power micro base stations (mBS), it is challenging to ensure optimal usage of radio resources to serve users with a multitude of quality of service (QoS) requirements. Typical signal to interference and noise ratio (SINR)-based user allocation protocols unfairly assign more users to the high power MBS, starving mBS. There have been many attempts in the literature to forcefully assign users to mBS with limited success. In this paper, we take a different approach using second order statistics of user data, which is a better indicator of traffic fluctuations. We propose a new algorithm for user association to the appropriate base station (BS) by utilizing the standard deviation of the overall network load. This is done through an exhaustive search of the best user equipment (UE)–BS combinations that provide a global minimum to the standard deviation. This would correspond to the optimum number of UEs assigned to every BS, either macro or micro. We have also derived new expressions for coverage probability and network energy efficiency for analytical performance evaluation. Simulation results prove the validity of our proposed methods to balance the network load, improve data rate, average energy efficiency, and coverage probability with superior performance compared with other algorithms.


Author(s):  
Fabrice Lacroux ◽  
Albert Carrasco ◽  
Azeddine Gati ◽  
Man-fai Wong ◽  
Joe Wiart
Keyword(s):  

Author(s):  
Nor Adibah Ibrahim ◽  
Tharek Abd Rahman ◽  
Razali Ngah ◽  
Omar Abd Aziz ◽  
Olakunle Elijah

The fifth-generation (5G) network has been broadly investigated by many researchers. The capabilities of 5G include massive system capacity, incredibly high data rates everywhere, very low latency and the most important point is that it is exceptionally low device cost and low energy consumption. A key technology of 5G is the millimeter wave operating at 28 GHz and 38 GHz frequency bands which enable massive MIMO and small cell base station densification. However, there has been public concern associated with human exposure to electromagnetic fields (EMF) from 5G communication devices. Hence, this paper studies the power density of a 5G antenna array that can be used for the indoor base station. The power density is the amount of power or signal strength absorbed by a receiver such as the human body located a distance from the base station. To achieve this, the design of array antennas using CST software at 28 GHz, fabrication and measurement were carried out in an indoor and hallway environment. The measurement processes were set up at IC5G at UTM Kuala Lumpur in which the distance of the transmitter to receiver where 1 m, 4 m, 8 m, and 10 m. In this study, the measured power density is found to be below the set limit by ICNIRP and hence no health implication is feared. Regardless, sufficient act of cautionary has to be applied by those staying close to small cell base stations and more studies are still needed to ensure the safety of use of 5G base stations.


2021 ◽  
Author(s):  
Hamed Nassar ◽  
Gehad Taher ◽  
El-Sayed El-Hady

We prove that under stochastic geometric modelling of cellular networks, the coverage probability is <i>not</i> a function of base stations density, contrary to widespread belief. That is, we reveal that the base station density, $\lambda$, that is appears in a plethora of published cellular coverage probability expressions is superfluous.<br>


2021 ◽  
Author(s):  
Hamed Nassar ◽  
Gehad Taher ◽  
El-Sayed El-Hady

We prove that under stochastic geometric modelling of cellular networks, the coverage probability is <i>not</i> a function of base stations density, contrary to widespread belief. That is, we reveal that the base station density, $\lambda$, that is appears in a plethora of published cellular coverage probability expressions is superfluous.<br>


Author(s):  
Aremu O. A. ◽  
Makinde O. S. ◽  
Oyinkanola L. O. A. ◽  
Akande Ademola

Several base stations have been installed due to large economy demand for advancement in technologies. In this work, measurements of radiation level emitted from the base stations were made using a hand held GQ-380 EMF RF meter, the distance was measured at the interval of 20 m from the foot of the base station using a digital distance wheel meter. The electric field of the base station was measured using a GM 3120 electromagnetic radiation tester. The experimental results from this study shows that generally, for all base stations considered, the power density increases between (0 – 40 m) from the base stations and it decreases as the distance increases from 40 – 300 m. The maximum radiated value obtained was 13.35% of the Non-ionizing radiation protection standards (ICNIRP) recommended limit and the average power density for the multiple network was found to be 0.021 mW/m2 while that of single network was found to be 0.006 mW/m2, this is far below the recommended safety level standard for public exposure. Going by the low level of radiations obtained from the various locations in this study, it is discovered that all the operators comply with the ICNIRP recommended level which is 0.45 W/m2. It is therefore concluded that the electromagnetic emission from GSM base stations in the selected areas pose no threat to members of the public within this area.


2021 ◽  
Vol 2021 ◽  
pp. 1-13
Author(s):  
Junpeng Yu ◽  
Hongtao Zhang ◽  
Yuqing Chen ◽  
Yaduan Ruan

In 5G ultradense heterogeneous networks, wireless backhaul, as one of the important base station (BS) resources that affect user services, has attracted more and more attention. However, a user would access to the BS which is the nearest for the user based on the conventional user association scheme, which constrains the network performance improvement due to the limited backhaul capacity. In this paper, using backhaul-aware user association scheme, semiclosed expressions of network performance metrics are derived in ultradense heterogeneous networks, including coverage probability, rate coverage, and network delay. Specifically, all possible access and backhaul links within the user connectable range of BSs and anchor base stations (A-BSs) are considered to minimize the analytical results of outage probability. The outage for the user occurs only when the access link or backhaul link which forms the link combination with the optimal performance is failure. Furthermore, the theoretical analysis and numerical results evaluate the impact of the fraction of A-BSs and the BS-to-user density ratio on network performance metric to seek for a more reasonable deployment of BSs in the practical scenario. The simulation results show that the coverage probability of backhaul-aware user association scheme is improved significantly by about 2× compared to that of the conventional user association scheme when backhaul is constrained.


Electronics ◽  
2020 ◽  
Vol 9 (12) ◽  
pp. 2182
Author(s):  
Ngo Tan Vu Khanh ◽  
Van Dinh Nguyen

The skyrocketing growth in the number of Internet of Things (IoT) devices has posed a huge traffic demand for fifth-generation (5G) wireless networks and beyond. In-band full-duplex (IBFD), which is theoretically expected to double the spectral efficiency of a half-duplex wireless channel and connect more devices, has been considered as a promising technology in order to accelerate the development of IoT. In order to exploit the full potential of IBFD, the key challenge is how to handle network interference (including self-interference, co-channel interference, and multiuser interference) more effectively. In this paper, we propose a simple yet efficient user grouping method, where a base station (BS) serves strong downlink users and weak uplink users and vice versa in different frequency bands, mitigating severe network interference. First, we aim to maximize a minimum rate among all of the users subject to bandwidth and power constraints, which is formulated as a nonconvex optimization problem. By leveraging the inner approximation framework, we develop a very efficient iterative algorithm for solving this problem, which guarantees at least a local optimal solution. The proposed iterative algorithm solves a simple convex program at each iteration, which can be further cast to a conic quadratic program. We then formulate the optimization problem of sum throughput maximization, which can be solved by the proposed algorithm after some slight modifications. Extensive numerical results are provided to show not only the benefit of using full-duplex radio at BS, but also the advantage of the proposed user grouping method.


Sign in / Sign up

Export Citation Format

Share Document