Amorphous Silicon Temperature Sensors Integrated with Thin Film Heaters for Thermal Treatments of Biomolecules

2017 ◽  
pp. 183-193
Author(s):  
Nicola Lovecchio ◽  
Domenico Caputo ◽  
Giulia Petrucci ◽  
Augusto Nascetti ◽  
Marco Nardecchia ◽  
...  
Keyword(s):  
Thin Film ◽  
Amorphous Silicon ◽  
Temperature Sensors ◽  
Thermal Treatments

The Instability Characteristics of Amorphous Silicon Thin Film Transistors with Various Interfacial and Bulk Defect States

1997 ◽  
Vol 36 (Part 1, No. 10) ◽  
pp. 6226-6229 ◽  
Author(s):  
Huang-Chung Cheng ◽  
Jun-Wei Tsai ◽  
Chun-Yao Huang ◽  
Fang-Chen Luo ◽  
Hsing-Chien Tuan
Keyword(s):  
Thin Film ◽  
Amorphous Silicon ◽  
Thin Film Transistors ◽  
Defect States ◽  
Silicon Thin Film

Amorphous-silicon thin film transistor with two-step exposure process

2000 ◽  
Author(s):  
Pi-Fu Chen ◽  
Jr-Hong Chen ◽  
Dou-I Chen ◽  
HsixgJu Sung ◽  
June-Wei Hwang ◽  
...  
Keyword(s):  
Thin Film ◽  
Amorphous Silicon ◽  
Thin Film Transistor ◽  
Silicon Thin Film ◽  
Exposure Process

Hot-Wire Deposited Amorphous Silicon Thin-Film Transistors

1996 ◽  
Vol 424 ◽  
Author(s):  
R. E. I. Schropp ◽  
K. F. Feenstra ◽  
C. H. M. Van Der Werf ◽  
J. Holleman ◽  
H. Meiling
Keyword(s):  
Thin Film ◽  
Amorphous Silicon ◽  
Thin Film Transistors ◽  
Gate Dielectric ◽  
Chemical Vapor ◽  
Current Crowding ◽  
Hot Wire ◽  
Saturation Regime ◽  
Silicon Thin Film ◽  
Order Of Magnitude

AbstractWe present the first thin film transistors (TFTs) incorporating a low hydrogen content (5 - 9 at.-%) amorphous silicon (a-Si:H) layer deposited by the Hot-Wire Chemical Vapor Deposition (HWCVD) technique. This demonstrates the possibility of utilizing this material in devices. The deposition rate by Hot-Wire CVD is an order of magnitude higher than by Plasma Enhanced CVD. The switching ratio for TFTs based on HWCVD a-Si:H is better than 5 orders of magnitude. The field-effect mobility as determined from the saturation regime of the transfer characteristics is still quite poor. The interface with the gate dielectric needs further optimization. Current crowding effects, however, could be completely eliminated by a H2 plasma treatment of the HW-deposited intrinsic layer. In contrast to the PECVD reference device, the HWCVD device appears to be almost unsensitive to bias voltage stressing. This shows that HW-deposited material might be an approach to much more stable devices.

Development of n-μc-SiOx:H as cost effective back reflector and its application to thin film amorphous silicon solar cells

Solar Energy ◽  
2013 ◽  
Vol 97 ◽  
pp. 591-595 ◽  
Author(s):  
C. Banerjee ◽  
T. Srikanth ◽  
U. Basavaraju ◽  
R.M. Tomy ◽  
M.G. Sreenivasan ◽  
...  
Keyword(s):  
Thin Film ◽  
Solar Cells ◽  
Amorphous Silicon ◽  
Cost Effective ◽  
Silicon Solar Cells ◽  
Back Reflector

Hydrogenated Nanocrystalline Silicon Thin Film Transistor Array for X-ray Detector Application

2008 ◽  
Vol 1066 ◽  
Author(s):  
Kyung-Wook Shin ◽  
Mohammad R. Esmaeili-Rad ◽  
Andrei Sazonov ◽  
Arokia Nathan
Keyword(s):  
Thin Film ◽  
Amorphous Silicon ◽  
Threshold Voltage ◽  
Hydrogenated Amorphous Silicon ◽  
Nanocrystalline Silicon ◽  
Amorphous Selenium ◽  
Breakdown Field ◽  
Storage Capacitor ◽  
X Ray ◽  
Hydrogenated Amorphous

ABSTRACTHydrogenated nanocrystalline silicon (nc-Si:H) has strong potential to replace the hydrogenated amorphous silicon (a-Si:H) in thin film transistors (TFTs) due to its compatibility with the current industrial a-Si:H processes, and its better threshold voltage stability [1]. In this paper, we present an experimental TFT array backplane for direct conversion X-ray detector, using inverted staggered bottom gate nc-Si:H TFT as switching element. The TFTs employed a nc-Si:H/a-Si:H bilayer as the channel layer and hydrogenated amorphous silicon nitride (a-SiNx) as the gate dielectric; both layers deposited by plasma enhanced chemical vapor deposition (PECVD) at 280°C. Each pixel consists of a switching TFT, a charge storage capacitor (Cpx), and a mushroom electrode which serves as the bottom contact for X-ray detector such as amorphous selenium photoconductor. The chemical composition of the a-SiNx was studied by Fourier transform infrared spectroscopy. Current-voltage measurements of the a-SiNx film demonstrate that a breakdown field of 4.3 MV/cm.. TFTs in the array exhibits a field effect mobility (μEF) of 0.15 cm2/V·s, a threshold voltage (VTh) of 5.71 V, and a subthreshold leakage current (Isub) of 10−10 A. The fabrication sequence and TFT characteristics will be discussed in details.

Corrigendum to “Enhanced performance of thin-film amorphous silicon solar cells with a top film of 2.85 nm silicon nanoparticles” [Solar Energy 125 (2016) 332–338]

Solar Energy ◽  
2017 ◽  
Vol 153 ◽  
pp. 784 ◽  
Author(s):  
Farsad Imtiaz Chowdhury ◽  
Aaesha Alnuaimi ◽  
Nazek E-Atab ◽  
Munir Nayfeh ◽  
Ammar Nayfeh
Keyword(s):  
Thin Film ◽  
Solar Cells ◽  
Solar Energy ◽  
Amorphous Silicon ◽  
Silicon Nanoparticles ◽  
Silicon Solar Cells

Low frequency noise in amorphous silicon thin film transistors with SiNx gate dielectric

2009 ◽  
Vol 105 (12) ◽  
pp. 124504 ◽  
Author(s):  
S. L. Rumyantsev ◽  
Sung Hun Jin ◽  
M. S. Shur ◽  
Mun-Soo Park
Keyword(s):  
Thin Film ◽  
Amorphous Silicon ◽  
Thin Film Transistors ◽  
Gate Dielectric ◽  
Low Frequency ◽  
Frequency Noise ◽  
Low Frequency Noise ◽  
Silicon Thin Film

Determination of Thermal Conductivity of Amorphous Silicon Thin Films via Non-Contacting Optical Probing

2006 ◽  
Vol 326-328 ◽  
pp. 689-692
Author(s):  
Seung Jae Moon
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Thermal Conductivity ◽  
Amorphous Silicon ◽  
Optical Transmission ◽  
Film Deposition ◽  
Transmission Measurement ◽  
Conductive Heat ◽  
Optical Transmission Measurement

The thermal conductivity of amorphous silicon (a-Si) thin films is determined by using the non-intrusive, in-situ optical transmission measurement. The thermal conductivity of a-Si is a key parameter in understanding the mechanism of the recrystallization of polysilicon (p-Si) during the laser annealing process to fabricate the thin film transistors with uniform characteristics which are used as switches in the active matrix liquid crystal displays. Since it is well known that the physical properties are dependent on the process parameters of the thin film deposition process, the thermal conductivity should be measured. The temperature dependence of the film complex refractive index is determined by spectroscopic ellipsometry. A nanosecond KrF excimer laser at the wavelength of 248 nm is used to raise the temperature of the thin films without melting of the thin film. In-situ transmission signal is obtained during the heating process. The acquired transmission signal is fitted with predictions obtained by coupling conductive heat transfer with multi-layer thin film optics in the optical transmission measurement.

Sign in / Sign up

Export Citation Format

Share Document