Coherent structures of the particle-laden turbulent round jet at different reynolds number

2004 ◽  
Vol 7 (3) ◽  
pp. 177-177
Author(s):  
Shuihua Zheng ◽  
Jianren Fan ◽  
Xueming Shao ◽  
Kun Luo ◽  
Kefa Cen
2001 ◽  
Vol 448 ◽  
pp. 367-385 ◽  
Author(s):  
T. B. NICKELS ◽  
IVAN MARUSIC

This paper examines and compares spectral measurements from a turbulent round jet and a turbulent boundary layer. The conjecture that is examined is that both flows consist of coherent structures immersed in a background of isotropic turbulence. In the case of the jet, a single size of coherent structure is considered, whereas in the boundary layer there are a range of sizes of geometrically similar structures. The conjecture is examined by comparing experimental measurements of spectra for the two flows with the spectra calculated using models based on simple vortex structures. The universality of the small scales is considered by comparing high-wavenumber experimental spectra. It is shown that these simple structural models give a good account of the turbulent flows.


Actuators ◽  
2021 ◽  
Vol 10 (8) ◽  
pp. 185
Author(s):  
Zuzana Antošová ◽  
Zdeněk Trávníček

This paper deals with active control of a continuous jet issuing from a long pipe nozzle by means of a concentrically placed annular synthetic jet. The experiments in air cover regimes of laminar, transitional, and turbulent main jet flows (Reynolds number ranges 1082–5181). The velocity profiles (time-mean and fluctuation components) of unforced and forced jets were measured using hot-wire anemometry. Six flow regimes are distinguished, and their parameter map is proposed. The possibility of turbulence reduction by forcing in transitional jets is demonstrated, and the maximal effect is revealed at Re = 2555, where the ratio of the turbulence intensities of the forced and unforced jets is decreased up to 0.45.


2014 ◽  
Vol 752 ◽  
pp. 602-625 ◽  
Author(s):  
Kengo Deguchi ◽  
Philip Hall

AbstractOur concern in this paper is with high-Reynolds-number nonlinear equilibrium solutions of the Navier–Stokes equations for boundary-layer flows. Here we consider the asymptotic suction boundary layer (ASBL) which we take as a prototype parallel boundary layer. Solutions of the equations of motion are obtained using a homotopy continuation from two known types of solutions for plane Couette flow. At high Reynolds numbers, it is shown that the first type of solution takes the form of a vortex–wave interaction (VWI) state, see Hall & Smith (J. Fluid Mech., vol. 227, 1991, pp. 641–666), and is located in the main part of the boundary layer. On the other hand, here the second type is found to support an equilibrium solution of the unit-Reynolds-number Navier–Stokes equations in a layer located a distance of $\def \xmlpi #1{}\def \mathsfbi #1{\boldsymbol {\mathsf {#1}}}\let \le =\leqslant \let \leq =\leqslant \let \ge =\geqslant \let \geq =\geqslant \def \Pr {\mathit {Pr}}\def \Fr {\mathit {Fr}}\def \Rey {\mathit {Re}}O(\ln \mathit{Re})$ from the wall. Here $\mathit{Re}$ is the Reynolds number based on the free-stream speed and the unperturbed boundary-layer thickness. The streaky field produced by the interaction grows exponentially below the layer and takes its maximum size within the unperturbed boundary layer. The results suggest the possibility of two distinct types of streaky coherent structures existing, possibly simultaneously, in disturbed boundary layers.


2009 ◽  
Vol 10 (6) ◽  
pp. 447-454
Author(s):  
Najah Kechiche ◽  
Ali Abbassi ◽  
Taoufik Filali ◽  
Jacques Jay ◽  
Habib Ben Aissia

Author(s):  
Olanrewaju Miracle Oyewola ◽  
Adebunmi Okediji ◽  
Olusegun Olufemi Ajide ◽  
Muyiwa Samuel Adaramola

In this study, the Reynolds number effect on the development of round jet flow is presented. The jet is produced from a smoothly contracting round nozzle and the flow structure is controlled by varying the air blower speed in order to obtain various Reynolds numbers (Re). The flow Reynolds number considered varies between 1140 and 9117. Mean velocity measurements were taken using hot-wire probe at different axial and lateral distances (0≤x/d≤50, where x is the downstream distance and d is the nozzle diameter) for the jet flow and at for 0≤x/d≤30 in long pipe attached to the nozzle. Measurements reveal that Reynolds number dictate the potential core length such that the higher the Reynolds number, the lower the potential core which is a measure of mixing of jet and ambient fluid. It shows that further away from the jet exit section, potential core decreases as Reynolds number increases, the velocity profile has a top hat shape very close to the nozzle exit and the shape is independent of Reynolds number. It is found that potential core extends up to x/d=8 for Reynolds number of 1140 as against conventional near field 0≤x/d≤6. This may suggest effect of very low Reynolds number. However, further investigation is required to ascertain this at extremely low Reynolds numbers. It is also observed that further away from the jet exit section, the higher the downstream distance, the higher the jet half-width (R1/2). Furthermore, the flow in the pipe shows almost constant value of normalised axial centerline velocity for a longer distance and this clearly indicates that there is mass redistribution rather than entrainment of ambient fluid. Overall, the Reynolds number controls the magnitude rather than the wavelength of the oscillation


2019 ◽  
Vol 870 ◽  
pp. 460-491 ◽  
Author(s):  
Jérémy Basley ◽  
Laurent Perret ◽  
Romain Mathis

The influence of a cube-based canopy on coherent structures of the flow was investigated in a high Reynolds number boundary layer (thickness $\unicode[STIX]{x1D6FF}\sim 30\,000$ wall units). Wind tunnel experiments were conducted considering wall configurations that represent three idealised urban terrains. Stereoscopic particle image velocimetry was employed using a large field of view in a streamwise–spanwise plane ($0.55\unicode[STIX]{x1D6FF}\times 0.5\unicode[STIX]{x1D6FF}$) combined to two-point hot-wire measurements. The analysis of the flow within the inertial layer highlights the independence of its characteristics from the wall configuration. The population of coherent structures is in agreement with that of smooth-wall boundary layers, i.e. consisting of large- and very-large-scale motions, sweeps and ejections, as well as smaller-scale vortical structures. The characteristics of vortices appear to be independent of the roughness configuration while their spatial distribution is closely linked to large meandering motions of the boundary layer. The canopy geometry only significantly impacts the wall-normal exchanges within the roughness sublayer. Bi-dimensional spectral analysis demonstrates that wall-normal velocity fluctuations are constrained by the presence of the canopy for the densest investigated configurations. This threshold in plan area density above which large scales from the overlying boundary layer can penetrate the roughness sublayer is consistent with the change of the flow regime reported in the literature and constitutes a major difference with flows over vegetation canopies.


2019 ◽  
Vol 862 ◽  
pp. 1029-1059 ◽  
Author(s):  
Qiang Yang ◽  
Ashley P. Willis ◽  
Yongyun Hwang

A new set of exact coherent states in the form of a travelling wave is reported in plane channel flow. They are continued over a range in $Re$ from approximately $2600$ up to $30\,000$, an order of magnitude higher than those discovered in the transitional regime. This particular type of exact coherent states is found to be gradually more localised in the near-wall region on increasing the Reynolds number. As larger spanwise sizes $L_{z}^{+}$ are considered, these exact coherent states appear via a saddle-node bifurcation with a spanwise size of $L_{z}^{+}\simeq 50$ and their phase speed is found to be $c^{+}\simeq 11$ at all the Reynolds numbers considered. Computation of the eigenspectra shows that the time scale of the exact coherent states is given by $h/U_{cl}$ in channel flow at all Reynolds numbers, and it becomes equivalent to the viscous inner time scale for the exact coherent states in the limit of $Re\rightarrow \infty$. The exact coherent states at several different spanwise sizes are further continued to a higher Reynolds number, $Re=55\,000$, using the eddy-viscosity approach (Hwang & Cossu, Phys. Rev. Lett., vol. 105, 2010, 044505). It is found that the continued exact coherent states at different sizes are self-similar at the given Reynolds number. These observations suggest that, on increasing Reynolds number, new sets of self-sustaining coherent structures are born in the near-wall region. Near this onset, these structures scale in inner units, forming the near-wall self-sustaining structures. With further increase of Reynolds number, the structures that emerged at lower Reynolds numbers subsequently evolve into the self-sustaining structures in the logarithmic region at different length scales, forming a hierarchy of self-similar coherent structures as hypothesised by Townsend (i.e. attached eddy hypothesis). Finally, the energetics of turbulent flow is discussed for a consistent extension of these dynamical systems notions to high Reynolds numbers.


Author(s):  
C. J. Fang ◽  
M. C. Wu ◽  
C. H. Peng ◽  
Y. C. Lee ◽  
Y. H. Hung

An effective method for performing the thermal optimization of stationary and rotating MCM disks with an unconfined round-jet impingement under space limitation constraint has been successfully developed. The design variables of stationary and rotating MCM disks with an unconfined round-jet impingement include: the ratio of jet separation distance to nozzle diameter (H/d), steady-state Grashof number (Grs), jet Reynolds number (Rej), rotational Reynolds number (Rer). The total experimental cases for stationary and rotating MCM disks are statistically designed by the Central Composite Design (CCD) method. In addition, a sensitivity analysis, the so-called ANOVA, for the design factors has been performed. In the stationary MCM disk with an unconfined round-jet impingement, the contribution percentage of jet Reynolds number on the thermal performance is 95.86%. The effect of jet Reynolds numbers on chip temperature distribution is more significant than that of the H/d ratio and steady-state Grashof number. In rotating MCM disk with an unconfined round-jet impingement, the effect of jet Reynolds number, which has the contribution percentage of 91.81%, dominates the thermal performance. Furthermore, the comparisons between the predictions by using the quadratic Response Surface Methodology (RSM) and the experimental data are made. The maximum deviations for transient stagnation Nusselt number and transient average Nusselt number for the cases of stationary MCM disk are 10.05% and 11.82%, respectively; and 9.41% and 12.44% for the cases of rotating MCM disk, respectively. Finally, with the Sequential Quadratic Programming (SQP) technique, a series of thermal optimal designs under space limitation constraint H/d≤12 has been efficiently performed. Comparisons between the numerical optimization results and the experimental data are made with a satisfactory agreement.


2019 ◽  
Vol 141 (12) ◽  
Author(s):  
Filipe S. Pereira ◽  
Luís Eça ◽  
Guilherme Vaz

The importance of the turbulence closure to the modeling accuracy of the partially-averaged Navier–Stokes equations (PANS) is investigated in prediction of the flow around a circular cylinder at Reynolds number of 3900. A series of PANS calculations at various degrees of physical resolution is conducted using three Reynolds-averaged Navier–Stokes equations (RANS)-based closures: the standard, shear-stress transport (SST), and turbulent/nonturbulent (TNT) k–ω models. The latter is proposed in this work. The results illustrate the dependence of PANS on the closure. At coarse physical resolutions, a narrower range of scales is resolved so that the influence of the closure on the simulations accuracy increases significantly. Among all closures, PANS–TNT achieves the lowest comparison errors. The reduced sensitivity of this closure to freestream turbulence quantities and the absence of auxiliary functions from its governing equations are certainly contributing to this result. It is demonstrated that the use of partial turbulence quantities in such auxiliary functions calibrated for total turbulent (RANS) quantities affects their behavior. On the other hand, the successive increase of physical resolution reduces the relevance of the closure, causing the convergence of the three models toward the same solution. This outcome is achieved once the physical resolution and closure guarantee the precise replication of the spatial development of the key coherent structures of the flow.


Sign in / Sign up

Export Citation Format

Share Document