scholarly journals Emergence of Rigid Polycrystals from Atomistic Systems with Heitmann–Radin Sticky Disk Energy

2021 ◽  
Vol 240 (2) ◽  
pp. 627-698
Author(s):  
Manuel Friedrich ◽  
Leonard Kreutz ◽  
Bernd Schmidt

AbstractWe investigate the emergence of rigid polycrystalline structures from atomistic particle systems. The atomic interaction is governed by a suitably normalized pair interaction energy, where the ‘sticky disk’ interaction potential models the atoms as hard spheres that interact when they are tangential. The discrete energy is frame invariant and no underlying reference lattice on the atomistic configurations is assumed. By means of $$\Gamma $$ Γ -convergence, we characterize the asymptotic behavior of configurations with finite surface energy scaling in the infinite particle limit. The effective continuum theory is described in terms of a piecewise constant field delineating the local orientation and micro-translation of the configuration. The limiting energy is local and concentrated on the grain boundaries, that is, on the boundaries of the zones where the underlying microscopic configuration has constant parameters. The corresponding surface energy density depends on the relative orientation of the two grains, their microscopic translation misfit, and the normal to the interface. We further provide a fine analysis of the surface energies at grain boundaries both for vacuum–solid and solid–solid phase transitions. The latter relies fundamentally on a structure result for grain boundaries showing that, due to the extremely brittle setup, interpolating boundary layers near cracks are energetically not favorable.

Author(s):  
P. J. Goodhew

Cavity nucleation and growth at grain and phase boundaries is of concern because it can lead to failure during creep and can lead to embrittlement as a result of radiation damage. Two major types of cavity are usually distinguished: The term bubble is applied to a cavity which contains gas at a pressure which is at least sufficient to support the surface tension (2g/r for a spherical bubble of radius r and surface energy g). The term void is generally applied to any cavity which contains less gas than this, but is not necessarily empty of gas. A void would therefore tend to shrink in the absence of any imposed driving force for growth, whereas a bubble would be stable or would tend to grow. It is widely considered that cavity nucleation always requires the presence of one or more gas atoms. However since it is extremely difficult to prepare experimental materials with a gas impurity concentration lower than their eventual cavity concentration there is little to be gained by debating this point.


2011 ◽  
Vol 2011 ◽  
pp. 1-14 ◽  
Author(s):  
Kuninori Kitahara ◽  
Toshitomo Ishii ◽  
Junki Suzuki ◽  
Takuro Bessyo ◽  
Naoki Watanabe

Raman microscopy was applied to characterize polycrystalline silicon (poly-Si) on glass substrates for application as thin-film transistors (TFTs) integrated on electronic display panels. This study examines the crystallographic defects and stress in poly-Si films grown by industrial techniques: solid phase crystallization and excimer laser crystallization (ELC). To distinguish the effects of defects and stress on the optical-phonon mode of the Si–Si bond, a semiempirical analysis was performed. The analysis was compared with defect images obtained through electron microscopy and atomic force microscopy. It was found that the Raman intensity for the ELC film is remarkably enhanced by the hillocks and ridges located around grain boundaries, which indicates that Raman spectra mainly reflect the situation around grain boundaries. A combination of the hydrogenation of films and the observation of the Si-hydrogen local-vibration mode is useful to support the analysis on the defects. Raman microscopy is also effective for detecting the plasma-induced damage suffered during device processing and characterizing the performance of Si layer in TFTs.


2016 ◽  
Vol 94 (6) ◽  
pp. 594-603 ◽  
Author(s):  
Maryam Keivani ◽  
Ali Koochi ◽  
Naeime Abadian ◽  
Morteza Rezaei ◽  
Mohamadreza Abadyan

Surface energy and microstructure-dependent size phenomena can play significant roles in physical performance of nanoelectromechanical systems (NEMS). Herein, the static and dynamic pull-in instability of cantilever and double-clamped NEMS fabricated from conductive cylindrical nanowires with circular cross section is studied. The Gurtin–Murdoch surface elasticity in combination with the couple stress continuum theory is employed to incorporate the coupled effects of surface energy and microstructure-dependent size phenomenon. Using Green–Lagrange strain, the higher order surface stress components are incorporated into the governing equation. The effect of gas damping is considered in the model as well as structural damping. The nonlinear governing equation is solved using analytical reduced order method. The effects of various parameters on the static and dynamic pull-in parameters, phase plans, and stability threshold of the nanowire-based structures are demonstrated.


2013 ◽  
Vol 77 (11) ◽  
pp. 1386-1390 ◽  
Author(s):  
O. A. Kogtenkova ◽  
P. Zieba ◽  
T. Czeppe ◽  
L. Litynska-Dobrzynska ◽  
B. B. Straumal ◽  
...  
Keyword(s):  

Crystals ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 1515
Author(s):  
Halyna Klym ◽  
Ivan Karbovnyk ◽  
Andriy Luchechko ◽  
Yuriy Kostiv ◽  
Viktorija Pankratova ◽  
...  

BaGa2O4 ceramics doped with Eu3+ ions (1, 3 and 4 mol.%) were obtained by solid-phase sintering. The phase composition and microstructural features of ceramics were investigated using X-ray diffraction and scanning electron microscopy in comparison with energy-dispersive methods. Here, it is shown that undoped and Eu3+-doped BaGa2O4 ceramics are characterized by a developed structure of grains, grain boundaries and pores. Additional phases are mainly localized near grain boundaries creating additional defects. The evolution of defect-related extended free volumes in BaGa2O4 ceramics due to the increase in the content of Eu3+ ions was studied using the positron annihilation lifetime spectroscopy technique. It is established that the increase in the number of Eu3+ ions in the basic BaGa2O4 matrix leads to the agglomeration of free-volume defects with their subsequent fragmentation. The presence of Eu3+ ions results in the expansion of nanosized pores and an increase in their number with their future fragmentation.


1994 ◽  
Vol 144 (2) ◽  
pp. 383-392 ◽  
Author(s):  
A. L. Vasiliev ◽  
E. A. Stepantsov ◽  
N. A. Kiselev
Keyword(s):  

Author(s):  
P. Smith ◽  
J. Narayan

Gettering of undesirable impurities from the junctions or the electrically active regions improves electrical characteristics of semiconductor devices. This removal of impurities can be accomplished either by point defects or more efficiently by line defects such as dislocations and small-angle grain boundaries. The small-angle grain boundaries containing arrays of dislocations constitute two-dimensional defects which are more effective in removing the impurities. This removal of undesirable impurities involves dislocation - impurity interaction and subsequent segregation of impurities at the dislocations. The gettering efficiency of dislocations is determined by the nature of dislocations and also by the stability of dislocation network against annealing. In previous studies, it has been shown Ar+ implantation damage is very effective in gettering undesireable impurities. However, the mechanisms of enhanced gettering by Ar+ ion damage were not clear. The purpose of this investigation was to explore the mechanism of enhanced gettering by Ar+ damage and charaterize the Ar+ damage as a function of annealing treatments.


1987 ◽  
Vol 35 (3) ◽  
pp. 361-370
Author(s):  
P.A.C. Raats

The continuum theory of mixtures is used to show the common basis of models in three areas. In each, the central problem is the description of the deformation and motion of a reference continuum and of the movement of one or more constituents relative to this reference continuum. The three applications concern the movement of solutes relative to soil water, the movement of soil water relative to the solid phase of swelling/shrinking soils, and the movement of water, solutes, and gases relative to growing plant tissues. (Abstract retrieved from CAB Abstracts by CABI’s permission)


A satisfactory model for cavitational failure in creep must account for the fact that fracture can occur under a very low stress, for example, only 0.7 MPa for a solid solution magnesium alloy. A mechanism for growth based on the transfer of vacancies from high angle grain boundaries to intergranular cavities satisfies this low stress requirement for it converts a relatively high fraction of the work done by the applied load into surface energy of fracture. However, for such growth to proceed, cavity nuclei of radius greater than a critical value, r c , must exist on those grain boundaries which are approximately normal to the applied tensile stress axis. It can be shown quite simply that r c = 2y/o, where y is the surface energy per unit area and o the applied tensile stress. A typical value for r c is 1 pm which is far too large to occur spontaneously by chance accumulation of vacancies. It is in fact generally agreed that cohesion is lost owing to the concentration of stress at some small obstacle in a sliding grain boundary. These cavities are nucleated along the boundary under applied stresses which are lower than those needed to cause triple point cracking where the whole of the length of the boundary is available to concentrate stress. This was a puzzle until Smith & Barnby (1967) demonstrated that the stress concentrated at a small obstacle in a sliding boundary was far higher than that concentrated at a very large obstacle as incorporated in, for example, the Stroh derivation.


Sign in / Sign up

Export Citation Format

Share Document