Natural fractures maintain a significant role in many hydrocarbon plays, in both conventional and unconventional reservoirs. In exploration and development scenarios, specific fracture properties, such as orientation and density, are important. However, more critical is their internal architecture: are the fractures open to fluid flow or filled with minerals? Borehole microresistivity imaging tools are widely used to determine these fracture characteristics. In wells drilled with water-based muds, open fractures are filled with conductive borehole fluid that enables distinguishing open, water-filled fractures from resistive, mineral-filled fractures and the surrounding rock. However, many wells today are drilled with oil-based muds. In this case, mineral-filled fractures and oil-based-mud-filled fractures are equally highly resistive and cannot be directly distinguished using resistivity images only. The latest-generation wireline oil-based-mud microresistivity imagers operate in the megahertz frequency range, radiating the electrical current capacitively through the nonconductive mud column and delivering photorealistic borehole images. Both electrical conductivity and dielectric permittivity components constitute the measured signal, from which button standoff, formation resistivity, and dielectric permittivity are inverted. Our example case shows highly resistive, high-angle fractures from the resistivity images with their orientation and density. The standoff image determines if the mud column penetrates the fracture plane, showing an apparently high standoff compared with the surrounding rock. If the standoff appears high in the fracture plane, the fracture is classified as open to fluid flow. However, are these fractures indeed fully dilated and open, or are they filled with different materials—are they partially mineralized with calcite and partially open, filled with mud? To further determine the fracture fill and susceptibility to fluid flow, a new workflow employs the material dependency of the relative dielectric permittivity. The relative permittivity is estimated as a function of resistivity and frequency pixel by pixel on the resistivity image. The estimate formula is based on several hundred laboratory measurements on core plugs with different fluid saturations and salinities. The resulting borehole image enables distinguishing materials in the volume of investigation, where low values correspond to mud-dominated oil in open fracture planes, medium values correspond to rock-forming minerals, and high values are attributed to shales and other clay-rich rocks. Fracture planes filled with patches of both low- and medium-permittivity values are classified as partially open.
Magnetorheological Hybrid Elastomers Based on Silicone Rubber and Magnetorheological Suspensions with Graphene Nanoparticles: Effects of the Magnetic Field on the Relative Dielectric Permittivity and Electric Conductivity