Plastic waste has been incorporated with asphalt to improve the physical properties of asphalt and alleviate the increasing trend of plastic waste being introduced into the environment. However, plastic waste comes in different types such as thermoplastic or thermoset, which results in varied properties of polymer modified asphalt (PMA). In this work, four thermoplastic vulcanizates (TPVs) were prepared using different peroxide concentrations to produce four formulations of gel content (with varying extent of crosslinked part) in order to imitate the variation of plastic waste. All four TPVs were then mixed with asphalt at 5 wt% thus producing four formulations of PMA, which went through physical, rheological, and storage stability assessments. PMA with higher gel content possessed lower penetration and higher softening temperature, indicating physically harder appearance of PMA. Superpave parameters remained unchanged among different gel content PMA at temperatures of 64, 70, and 76 °C. PMA with any level of gel content had lower Brookfield viscosity than PMA without gel content at a temperature of 135 °C. Higher gel content resulted in shorter storage stability measured with greater different softening temperatures between top and bottom layers of PMA after 5 days of 163 °C storage. This study shows that asphalt with thermoset plastic waste is harder and easier to pave, thus making the non-recycling thermoset plastic waste more useful and friendly to the environment.
The Influence of WPC 80 Additive on the Stability of Water-In-Oil Emulsions
