Assessment of odour emissions by the use of a dispersion model in the context of the proposed new law in Chile

2021 ◽  
Vol 295 ◽  
pp. 113208
Author(s):  
Cristian Varela-Bruce ◽  
Christian Antileo
2018 ◽  
Vol 20 (3) ◽  
pp. 654-658

<p>Odours are among the main causes of complaints in regards to environmental issues for a variety of plants, including landfills. The emissions from landfills can affect the quality of life and negatively influence the area nearby. To protect people living in the surroundings from excessive odour exposures, different environmental protection practices may be implemented. In order to optimize technical and economic aspects, various configurations should be taken into account. In this view, the odour dispersion modelling represents a suitable tool to simulate different scenarios. In the present study, the odour impact from a large landfill located in Borgo Montello (Lazio Region, Italy) has been assessed by a dispersion model. Different operating conditions were simulated, in view of minimizing the odour annoyance during the phase of temporary closure of an area of the investigated plant. The Calpuff model was selected as it is well recognized among the preferred models for assessing the long range transport of pollutants. The Odour Emission Rates, inputs to the model, were calculated based on the results of dynamic olfactometry. The outputs from the dispersion model were investigated to define the best measures for the control of the odour emissions during the most impactful operations.</p>


2013 ◽  
Vol 12 (1) ◽  
pp. 46-53

One of the main environmental impacts of pig farms are the swine odours emitted from the various stages of the process. The main cause of odour emissions from pig farms are the anaerobic processes in manure. Numerous factors affect odour emissions such as diet, manure management and manure age. The majority of the odorous compounds emitted from pig farms are sulfurous organic compounds, hydrogen sulfide, phenols and indoles, ammonia, volatile amines and volatile fatty acids (VFA’s) whose presence in the atmosphere causes annoyance at relatively low concentrations. However, the detection and quantification of these compounds at a daily basis is difficult because of their chemical instability and the fact that they can be tracked only using techniques of gas chromatography. For the needs of the present study many instantaneous measurements performed during the day in order to estimate the daily variation of their emissions. This is the reason why the compounds studied were hydrogen sulfide and ammonia. Both compounds have low odour threshold (0.47 ppb for hydrogen sulfide and 130 ppb for ammonia). In the present study, the results of odour concentration measurements sampled from a pig production unit placed close to the city of Rethymno (Crete, Greece) are presented. These measurements are used to estimate the emissions of hydrogen sulfide and ammonia from the various chambers of the pig farm. The emission data were used as input data for the dispersion model AERMOD for an area of 10 km2 surrounding the odour source in order to determine the maximum allowed emissions in order not to cause complaints from nearby residents. Modifications were performed in the model based on the “peak to mean” ratio in order to predict the maximum odour concentrations with few seconds time-scale. Also, relations between odour annoyance and odour exposure concentrations have been used in order to express the odour impacts in terms of probability of detection, probability of discrimination and degree of annoyance. These parameters were embedded into the AERMOD model in order to be able to use this program as an odour dispersion model. The results are provided as probability of detection and probability of annoyance instead of hourly mean concentrations. Several scenarios were examined using the modified AERMOD program taking into account the complex terrain around the pig farm. Finally, the effect of raising the height of the stacks to the concentrations around the facility was examined as a possible solution to the situation.


1993 ◽  
Vol 58 (5) ◽  
pp. 1078-1086
Author(s):  
Zdeněk Palatý

The paper deals with the mass transfer in a liquid on a plate with mobile packing. A procedure has been suggested which enables estimation of the mass transfer coefficients from experimental data considering the dispersion flow of the liquid. The results obtained from the desorption of CO2 from water are presented graphically and in the form of empirical equation.


1996 ◽  
Vol 61 (2) ◽  
pp. 242-258 ◽  
Author(s):  
Vladimír Kudrna ◽  
Libor Vejmola ◽  
Pavel Hasal

Recently developed stochastic model of a one-dimensional flow-through chemical reactor is extended in this paper also to the non-isothermal case. The model enables the evaluation of concentration and temperature profiles along the reactor. The results are compared with the commonly used one-dimensional dispersion model with Danckwerts' boundary conditions. The stochastic model also enables to evaluate a value of the segregation index.


2006 ◽  
Vol 258-260 ◽  
pp. 586-591
Author(s):  
António Martins ◽  
Paulo Laranjeira ◽  
Madalena Dias ◽  
José Lopes

In this work the application of delay differential equations to the modelling of mass transport in porous media, where the convective transport of mass, is presented and discussed. The differences and advantages when compared with the Dispersion Model are highlighted. Using simplified models of the local structure of a porous media, in particular a network model made up by combining two different types of network elements, channels and chambers, the mass transport under transient conditions is described and related to the local geometrical characteristics. The delay differential equations system that describe the flow, arise from the combination of the mass balance equations for both the network elements, and after taking into account their flow characteristics. The solution is obtained using a time marching method, and the results show that the model is capable of describing the qualitative behaviour observed experimentally, allowing the analysis of the influence of the local geometrical and flow field characteristics on the mass transport.


1985 ◽  
Vol 40 (7) ◽  
pp. 736-747
Author(s):  
Sang H. Kim ◽  
Vladimir Hlavacek

The dynamic behavior of an autocatalytic reaction with a product inhibition term is studied in a flow system. A unique steady state exists in the continuous tank reactor. Linear stability analysis predicts either a stable node, a focus or an unstable saddle-focus. Sustained oscillations around the unstable focus can occur for high values of the Damköhler number (Da). In the distributed system, travelling, standing or complex oscillatory waves are detected. For a low value of Da, travelling waves with a pseudo-constant pattern are observed. With an intermediate value of Da, single or multiple standing waves are obtained. The temporal behavior indicates also the appearance of retriggering or echo waves. For a high value of Da, both single peak and complex multipeak oscillations are found. In the cell model, both regular oscillations near the inlet and chaotic behavior downstream are observed. In the dispersion model, higher Peclet numbers (Pe) eliminate the oscillations. The spatial profile shows a train of pulsating waves for the discrete model and a single pulsating or solitary wave for the continuous model.


2020 ◽  
Vol 4 (1) ◽  
pp. 17
Author(s):  
Saisantosh Vamshi Harsha Madiraju ◽  
Ashok Kumar

Transportation sources are a major contributor to air pollution in urban areas. The role of air quality modeling is vital in the formulation of air pollution control and management strategies. Many models have appeared in the literature to estimate near-field ground level concentrations from mobile sources moving on a highway. However, current models do not account explicitly for the effect of wind shear (magnitude) near the ground while computing the ground level concentrations near highways from mobile sources. This study presents an analytical model based on the solution of the convective-diffusion equation by incorporating the wind shear near the ground for gaseous pollutants. The model input includes emission rate, wind speed, wind direction, turbulence, and terrain features. The dispersion coefficients are based on the near field parameterization. The sensitivity of the model to compute ground level concentrations for different inputs is presented for three different downwind distances. In general, the model shows Type III sensitivity (i.e., the errors in the input will show a corresponding change in the computed ground level concentrations) for most of the input variables. However, the model equations should be re-examined for three input variables (wind velocity at the reference height and two variables related to the vertical spread of the plume) to make sure that that the model is valid for computing ground level concentrations.


2021 ◽  
Vol 31 (1) ◽  
Author(s):  
Shin Yu ◽  
Chang Tang Chang ◽  
Chih Ming Ma

AbstractThe traffic congestion in the Hsuehshan tunnel and at the Toucheng interchange has led to traffic-related air pollution with increasing concern. To ensure the authenticity of our simulation, the concentration of the last 150 m in Hsuehshan tunnel was simulated using the computational fluid dynamics fluid model. The air quality at the Toucheng interchange along a 2 km length highway was simulated using the California Line Source Dispersion Model. The differences in air quality between rush hours and normal traffic conditions were also investigated. An unmanned aerial vehicle (UAV) with installed PM2.5 sensors was developed to obtain the three-dimensional distribution of pollutants. On different roads, during the weekend, the concentrations of pollutants such as SOx, CO, NO, and PM2.5 were observed to be in the range of 0.003–0.008, 7.5–15, 1.5–2.5 ppm, and 40–80 μg m− 3, respectively. On weekdays, the vehicle speed and the natural wind were 60 km h− 1 and 2.0 m s− 1, respectively. On weekdays, the SOx, CO, NO, and PM2.5 concentrations were found to be in the range of 0.002–0.003, 3–9, 0.7–1.8 ppm, and 35–50 μg m− 3, respectively. The UAV was used to verify that the PM2.5 concentrations of vertical changes at heights of 9.0, 7.0, 5.0, and 3.0 m were 45–48, 30–35, 25–30, and 50–52 μg m− 3, respectively. In addition, the predicted PM2.5 concentrations were 40–45, 25–30, 45–48, and 45–50 μg m− 3 on weekdays. These results provide a reference model for environmental impact assessments of long tunnels and traffic jam-prone areas. These models and data are useful for transportation planners in the context of creating traffic management plans.


Sign in / Sign up

Export Citation Format

Share Document