A study about the stabilization of anatase phase at high temperatures on sol–gel cerium and copper doped titania and titania–silica powders

2005 ◽  
Vol 351 (1) ◽  
pp. 84-88 ◽  
Author(s):  
Robson F. de Farias ◽  
Claudio Airoldi
2019 ◽  
Vol 97 (4) ◽  
pp. 347-354 ◽  
Author(s):  
Rizwin Khanam ◽  
Dambarudhar Mohanta

We report on the effect of chromium doping on the band gap lowering of nano-titania (TiO2) and subsequent implications as regards coloration characteristics mediated via photochromism and thermochromism processes. As can be found in the X-ray diffractograms, the sol-gel derived, Cr3+-doped nano-TiO2 systems have exhibited an anatase phase with the evidence of peak shifting towards a lower diffraction angle. The average crystallite size decreases, whereas lattice unit cell parameters and, consequently, cell volume, tend to increase with the inclusion of Cr3+ into the titania host. To be specific, 1% Cr-doped titania system showed nearly 5.8% cell expansion as compared to its un-doped counterpart. As revealed from the optical absorption spectroscopy, a narrowing of band gap is observed for the Cr doped nano-titania system: 3.18 eV for the un-doped system, and 2.61 and 2.41 eV for 0.3% and 1% Cr doping cases, respectively, considering direct band-to-band transitions. Moreover, doping led noticeable lowering of the exponent (n value), from its normal value, which suggests inclusion of adequate non-parabolicity feature to the energy band scheme. The photochromic feature, for a given incident radiation, demonstrates a lowered transmission response with increasing Cr content. A reversible thermochromism response has also been demonstrated for doped nano-titania systems subjected to heating with temperature varying between 0–55 °C. The Cr3+ doped nano-titania and similar systems would find scope in smart windows, display components, photocatalysis, etc., when a select coloration is desired.


2007 ◽  
Vol 43 (3) ◽  
pp. 299-304 ◽  
Author(s):  
Pradeepan Periyat ◽  
K. V. Baiju ◽  
P. Mukundan ◽  
P. Krishna Pillai ◽  
K. G. K. Warrier

2010 ◽  
Vol 8 (1) ◽  
pp. 142-148 ◽  
Author(s):  
L. Gomathi Devi ◽  
Nagaraju Kottam ◽  
S. Girish Kumar ◽  
K. Eraiah Rajashekhar

AbstractAnatase TiO2 was prepared by sol-gel method through the hydrolysis of TiCl4. Ni2+ was doped into the TiO2 matrix in the concentration range of 0.02 to 0.1 at.% and characterized by various analytical techniques. Powder X-ray diffraction revealed only anatase phase for all the samples, while diffuse reflectance spectral studies indicated a red shift in the band gap absorption to the visible region. The photocatalytic activities of these photocatalysts were probed for the degradation of methyl orange under natural solar light. The photocatalyst with optimum doping of 0.08 at.% Ni2+, showed enhanced activity, which is attributed to: (i) effective separation of charge carriers and (ii) large red shift in the band gap to visible region. The influence of crystallite size and dopant concentration on the charge carrier trapping — recombination dynamics is investigated.


2010 ◽  
Vol 24 (06n07) ◽  
pp. 667-675 ◽  
Author(s):  
M. ŠĆEPANOVIĆ ◽  
S. AŠKRABIĆ ◽  
M. GRUJIĆ-BROJČIN ◽  
A. GOLUBOVIĆ ◽  
Z. DOHČEVIĆ-MITROVIĆ ◽  
...  

Pure titania ( TiO 2) nanopowders and TiO 2 doped with 10 mol % of vanadium ions ( V 3+) are synthesized by sol-gel method. The dependence of structural characteristics of nanopowders on synthesis conditions is investigated by X-ray diffraction and Raman spectroscopy. Very intensive modes observed in Raman spectra of all nanopowders are assigned to anatase phase of TiO 2. Additional Raman modes of extremely low intensity which can be related to the presence of small amount of brookite amorphous phase are observed in pure TiO 2 nanopowders. In V -doped nanopowders anatase was the only TiO 2 phase detected. The variations in duration and heating rate of calcination influence slightly the Raman spectra of pure TiO 2, but have a great impact on Raman modes of anatase, as well as the additional Raman modes related to the presence of vanadium oxides in V -doped samples.


2004 ◽  
Vol 19 (6) ◽  
pp. 1808-1817 ◽  
Author(s):  
Francis J. Allison ◽  
David M. Grant ◽  
Karen McKinlay ◽  
Philip G. Harrison

Sol-gel materials of aluminum-modified TiO2 of nominal composition 5.7 wt% and 10.8 wt% aluminum and aluminum/vanadium co-modified TiO2 of nominal composition 5.7Al–3.5V wt% have been prepared by evaporation of aqueous colloidal sols obtained by the hydrolysis of aqueous solutions of titanium chloride with the appropriate amount of vanadyl oxalate and/or aqueous aluminum nitrate using aqueous ammonia followed by peptization of the resulting hydrated solids using nitric acid. The nature of the sol-gel materials and the behavior upon calcination at temperatures up to 1373 K have been investigated using x-ray fluorescence, x-ray powder diffraction, transmission electron microscopy, and electron diffraction. At 333 K, all the gels comprise small (approximately 5 ± 1 nm) particles of anatase together with traces of brookite and highly crystalline ammonium nitrate. The particle size changes little on thermal treatment at 573 K, but increases significantly at higher temperatures and is accompanied by transformation to rutile. Aluminum-modified gels stabilize the anatase phase from 923 K in unmodified TiO2 to 1023 K in the 6Al/TiO2 gel and 1173 K in the 11Al/TiO2 gel. The alumina in the co-modified gel has a dominating effect on stabilizing the anatase phase until 973 K. Only rutile is present at high temperatures, except for small amounts of phase-separated α-Al2O3 (Corundum). No substitutional incorporation of Al3+ ions in the tetragonal rutile lattice occurs at high temperatures.


Materials ◽  
2019 ◽  
Vol 12 (23) ◽  
pp. 3874 ◽  
Author(s):  
Abderrahim El Mragui ◽  
Yuliya Logvina ◽  
Luís Pinto da Silva ◽  
Omar Zegaoui ◽  
Joaquim C.G. Esteves da Silva

Pure TiO2 and Fe- and Co-doped TiO2 nanoparticles (NPs) as photocatalysts were synthesized using wet chemical methods (sol-gel + precipitation). Their crystalline structure and optical properties were analyzed using X-ray diffraction (XRD), Raman spectroscopy and Fourier-transform infrared (FTIR) spectroscopy, ultraviolet-visible light (UV-Vis) diffuse reflectance spectroscopy (DRS), and photoluminescence (PL) spectroscopy. The photocatalytic activity of the synthesized nanoparticles was evaluated through degradation of carbamazepine (CBZ) under UV-A and visible-light irradiations. The XRD and Raman analyses revealed that all synthesized nanomaterials showed only the anatase phase. The DRS results showed that the absorption edge was blue-shifted for Fe-doped TiO2 NPs. The decrease in charge recombination was evidenced from the PL investigation for both Co-doped and Fe-doped TiO2 nanomaterials. An enhancement in photocatalytic degradation of carbamazepine in aqueous suspension under both UV-A light and visible-light irradiations was observed for Fe-doped Titania NPs by comparison with pure TiO2. These results suggest that the doping cations could suppress the electron/hole recombination. Therefore, the photocatalytic activity of TiO2-based nanomaterials was enhanced.


2009 ◽  
Vol 5 ◽  
pp. 95-104 ◽  
Author(s):  
J.A. Pedraza-Avella ◽  
R. López ◽  
F. Martínez-Ortega ◽  
E.A. Páez-Mozo ◽  
Ricardo Gómez

Visible light absorption of TiO2 can be induced by the addition of transition metal impurities. However, many dissimilar results have been reported about this subject and there are various interpretations about the origin of these absorption features. In this work, samples of chromium-doped titania (TiO2-Cr) with different dopant contents (0.1, 0.5, 1.0 and 5.0 wt. %) were prepared by a sol-gel method. Their particle size was determined by dynamic light scattering and it was on the nanometer scale (18 nm). X-ray powder diffraction and Raman spectroscopy showed only the presence of anatase phase in all samples. X-ray photoelectron spectroscopy reveals that the oxidation state of chromium in the prepared materials is different than in the dopant precursor. This change can be associated to the oxidative gelling conditions used in the materials preparation. UV VIS diffuse reflectance spectroscopy showed that the chromium doping, until 1.0 wt. %, did not effectively narrow the TiO2 band-gap but it induces the visible light absorption probably through the formation of color centers.


2014 ◽  
Vol 8 (4) ◽  
pp. 195-202 ◽  
Author(s):  
Marija Milanovic ◽  
Ljubica Nikolic

Pure and lanthanum doped titania nanopowders were synthesized through a room temperature sol-gel method using a template of polyethylene glycol (PEG). The progress of the synthesis in terms of phase formation and size of nanoparticles was monitored by X-ray diffraction, FTIR spectroscopy and SEM analysis. After calcination at 450?C in air, the results have shown the presence of small particles crystallized predominantly in the form of anatase phase, with significant agglomeration. Nitrogen adsorption-desorption measurements confirmed that all prepared powders are mesoporous with an average pore diameter in range 3.1-3.8 nm. The addition of lanthanum ions leads to the nanopowders with the highest specific surface (BET) area (203m2/g). The obtained powders were compared to TiO2 prepared without a template.


Sign in / Sign up

Export Citation Format

Share Document