Effect of granule size on physicochemical, morphological, thermal and pasting properties of native and 2-octenyl-1-ylsuccinylated potato starch prepared by dry heating under different pH conditions

LWT ◽  
2015 ◽  
Vol 61 (1) ◽  
pp. 224-230 ◽  
Author(s):  
Kawaljit Singh Sandhu ◽  
Loveleen Sharma ◽  
Maninder Kaur
LWT ◽  
2014 ◽  
Vol 59 (1) ◽  
pp. 348-355 ◽  
Author(s):  
Khalid Gul ◽  
Charanjit Singh Riar ◽  
Anu Bala ◽  
Mandeep Singh Sibian

Polymers ◽  
2020 ◽  
Vol 12 (2) ◽  
pp. 321
Author(s):  
Greta Adamczyk ◽  
Magdalena Krystyjan ◽  
Grażyna Jaworska

The aim of this paper was to investigate the influence of dietary fibers from oat (OF) and apple (AF) (concentration 0.2%) on the pasting properties, rheological (including thixotropic and anti-thixotropic) and textural properties of 3% and 4% (w/w) waxy potato starch pastes. The samples were characterized by their pasting characteristics, the hysteresis loop test, and textural properties measured during storage. It was found that the breakdown viscosity values of the blends, including oat fibers, were lower than those of the others (waxy potato starch (WPS), WPS-AF), which suggests that these samples would have higher resistance to retrogradation and therefore would form a more stable paste. The pattern of flow curves showed that the investigated waxy potato starch and starch-fiber pastes were non-Newtonian fluids, thinned by shear. Areas of the hysteresis loops indicated that pastes with fibers had anti-thixotropic or mixed thixotropic/anti-thixotropic character. The greatest areas of the anti-thixotropy hysteresis loops were characteristic for WPS, while its mixtures with AF and OF caused a decrease in the value of these areas. It can indicate that starch-fiber blends were more stable during shearing. Fiber-type and starch concentration strongly affected the textural parameters of the starch-fiber gels.


Molecules ◽  
2020 ◽  
Vol 25 (23) ◽  
pp. 5528
Author(s):  
Chia-Long Lin ◽  
Jheng-Hua Lin ◽  
Jia-Jing Lin ◽  
Yung-Ho Chang

Tapioca and potato starches were used to investigate the effect of heat–moisture treatment (HMT; 95–96 °C, 0–60 min, 1–6 iterations) on gelatinization properties, swelling power (SP), solubility and pasting properties. Tapioca starch had similar content and degree of polymerization of amylose, but a higher amylopectin short/long chain ratio, to potato starch. After HMT, the gelatinization temperature range was narrowed for tapioca starch, but was widened for potato starch. Decreases in SP and solubility were less for tapioca than potato starches, coinciding with a progressive shift to the moderate-swelling pasting profile for tapioca but a drastic change to the restricted-swelling profile for potato. Moreover, decreasing extents of SP and maximum viscosity for HMT tapioca starch were, respectively, in the range of 47–63% and 0–36%, and those of HMT potato starch were 89–92% and 63–94%. These findings indicate that the granule expansion and viscosity change of starch during gelatinization can be tailored stepwise by altering the HMT holding time and iteration.


Polymers ◽  
2020 ◽  
Vol 12 (7) ◽  
pp. 1602
Author(s):  
Hesham Alqah ◽  
M. S. Alamri ◽  
A. A. Mohamed ◽  
S. Hussain ◽  
A. A. Qasem ◽  
...  

Starches were extracted from chickpea (C.P.), corn (C.S.), Turkish bean (T.B.), sweet potato (S.P.S.), and wheat starches (W.S.). These starches exhibited different amylose contents. The extracted starches were annealed in excess water and in germinated sorghum extract (GSE) (1.0 g starch/9 mL water). The α-amylase concentration in the GSE was 5.0 mg/10 mL. Annealing was done at 40, 50, and 60 °C for 30 or 60 min. The pasting properties of annealed starches were studied using Rapid Visco-Analyzer (RVA), in addition to the swelling power. These starches exhibited diverse pasting properties as evidenced by increased peak viscosity with annealing, where native starches exhibited peak viscosity as: 2828, 2438, 1943, 2250, and 4601 cP for the C.P., C.S., T.B., W.S., and S.P.S., respectively, which increased to 3580, 2482, 2504, 2514, and 4787 cP, respectively. High amylose content did not play a major role on the pasting properties of the tested starches because sweet potato starch (S.P.S.) (22.4% amylose) exhibited the highest viscosity, whereas wheat starch (W.S.) (25% amylose) had the least. Therefore, the dual effects of granule structure and packing density, especially in the amorphous region, are determinant factors of the enzymatic digestion rate and product. Swelling power was found to be a valuable predictive tool of amylose content and pasting characteristics of the tested starches. The studied starches varied in their digestibility and displayed structural differences in the course of α-amylase digestion. Based on these findings, W.S. was designated the most susceptible among the starches and S.P.S. was the least. The most starch gel setback was observed for the legume starches, chickpeas, and Turkish beans (C.P. 2553 cP and T.B. 1172 cP). These results were discussed with regard to the underlying principles of swelling tests and pasting behavior of the tested starches. Therefore, GSE is an effortless economic technique that can be used for starch digestion (modification) at industrial scale.


2009 ◽  
Vol 61 (6) ◽  
pp. 352-357 ◽  
Author(s):  
Eun Young Park ◽  
Hyun-Na Kim ◽  
Jong-Yea Kim ◽  
Seung-Taik Lim

Polymers ◽  
2021 ◽  
Vol 13 (23) ◽  
pp. 4148
Author(s):  
Greta Adamczyk ◽  
Magdalena Krystyjan ◽  
Mariusz Witczak

The aim of this study was to investigate the impact of fiber from buckwheat hull waste (BH) on the pasting, rheological, and textural properties of 4% and 5% (w/w) pastes and gels based on the potato starches with different amylose/amylopectin contents. The starch and starch/fiber mixtures were characterized by pasting and flow measurements as well as by viscoelastic and textural analysis. The pasting properties showed a greater BH effect (0.2%) on the gelatinization of PS than WPS. The starch gels and starch fiber mixtures showed biopolymer gel behavior. In the WPS/BH pastes, a smaller increase in hardness was noted compared to PS/BH.


Sign in / Sign up

Export Citation Format

Share Document