Quantitative studies of cadmium ion (Cd2+) adsorption on oxidized graphite powder

2020 ◽  
Vol 23 ◽  
pp. 105-110
Author(s):  
Namasivayam Selvanantharajah ◽  
Poobalasuntharam Iyngaran ◽  
Poobalasingam Abiman
Keyword(s):  
Graphite Powder ◽  
Cadmium Ion ◽  
Quantitative Studies ◽  
Oxidized Graphite

scholarly journals Removal of Lead by Oxidized Graphite

2021 ◽  
Vol 7 (1) ◽  
pp. 23
Author(s):  
Namasivayam Selvanantharajah ◽  
Poobalasuntharam Iyngaran ◽  
Poobalasingam Abiman ◽  
Navaratnarajah Kuganathan
Keyword(s):  
Graphite Oxide ◽  
Photoelectron Spectroscopy ◽  
Graphite Powder ◽  
Effective Concentration ◽  
Lead Ion ◽  
Ion Adsorption ◽  
Xps Analysis ◽  
X Ray ◽  
Oxidized Graphite ◽  
Final Composite

Lead ion adsorption on the surfaces of pristine and oxidized graphite is studied quantitatively using X-ray photoelectron spectroscopy (XPS) and standard electrochemical measurements. The XPS analysis confirmed the oxidation of graphite, yielding a final composite consisting of 15.97% of oxygen and 84.03% of carbon in comparison with the pristine graphite powder consisting of 6.13% oxygen and 93.87% carbon. The adsorption of lead (II) ion was confirmed by the peaks observed at 138 eV and 143.8 eV, associated with the emissions from Pb4f 7/2 and Pb4f 5/2, respectively. The effective concentration of Pb2+ ion and the optimum dosage of oxidized graphite were calculated to be 400 µM and 200 mg, respectively. Adsorption capacity of bare graphite was 41.18%, whereas that of oxidized graphite was 73.3%. The present results show that graphite oxide is a candidate material for the adsorption of Pb2+ ion from water.

scholarly journals ELECTROCHEMICAL DISPERSION OF GRAPHITE IN 58% NITRIC ACID TO PRODUCE MULTILAYER GRAPHENE OXIDE

2021 ◽  
Vol 64 (3) ◽  
pp. 59-65
Author(s):  
Elena V. Yakovleva ◽  
Andrey V. Yakovlev ◽  
Ivan N. Frolov ◽  
Anton S. Mostovoy ◽  
Vitaly N. Tseluikin
Keyword(s):  
Graphene Oxide ◽  
Graphite Powder ◽  
Multilayer Graphene ◽  
X Ray Diffraction ◽  
X Ray ◽  
Graphene Layers ◽  
Intercalated Compounds ◽  
Fold Reduction ◽  
Electrochemical Dispersion ◽  
Oxidized Graphite

Electrochemical oxidation of graphite powder in 58% HNO3 was studied. Samples of oxidized graphite were obtained with a imparting of the amount of electricity 500, 700, 1500 mAh g-1. The character of the galvanostatic dependencies allows to select a region of the formation of intercalated compounds of graphite prior to the accumulation of quantity of electricity of 500 mA h g-1. It was found that when the quantity of electricity of over 700 mA h g-1 the process of electrochemical peroxidation of intercalated graphite begins with the formation of multilayer graphene oxide, as confirmed by comprehensive studies using X-ray diffraction, scanning electron microscopy, FTIR spectroscopy, laser diffraction. The synthesized multilayer graphene oxide is characterized by the presence of a spectrum of oxygen-containing functional groups, mainly hydroxyl, as well as carboxyl, epoxy and alkoxyl. X-ray images show a peak at 2θ = 11.45° which intensity increases for re-oxidized graphite compounds and also indicate the formation of a multilayer graphene oxide with an interlayer distance of 7.8 Å. The synthesized material in aqueous suspensions under the action of ultrasound is dispersed with a 7-11-fold reduction in particle size. Graphene layers remains layered structure but the degree of their deformation increases, and the thickness of the layers decreases with an increase in the imparted amount of electricity. 

scholarly journals Adsorption of organic pollutants from the aqueous phase using graphite as a model adsorbent

2020 ◽  
Vol 38 (7-8) ◽  
pp. 286-303
Author(s):  
Ivana Ivancev-Tumbas ◽  
Lucas Landwehrkamp ◽  
Ralph Hobby ◽  
Marco Vernillo ◽  
Stefan Panglisch
Keyword(s):  
Adsorption Capacity ◽  
Organic Compounds ◽  
Resonance Effect ◽  
Graphite Powder ◽  
Carbon Surface ◽  
Virgin Material ◽  
Near Surface ◽  
Adsorption Mechanisms ◽  
Π Interactions ◽  
Oxidized Graphite

Although graphite is not effective as an adsorbent in water treatment, it provides a homogenous, non-porous, carbonaceous structure that is ideal for studying fundamental adsorption mechanisms. High-purity graphite powder (C content 99.5%) was oxidized in an ozone stream, producing a near-surface oxygen content of 5.9 at.%, and was used together with the virgin material to establish adsorption isotherms for organic compounds in aqueous solutions. We examined how the aromaticity and substituents of the adsorptives affect adsorption on the model-activated carbon surface. For both virgin and oxidized graphite, the adsorption capacity for the aromatic compounds decreased in the order 1-naphthol > 2-methoxynaphthalene > naphthalene > anisole > phenol, with significant differences in the adsorption capacities of the two graphite species observed only for anisole, naphthalene, and 1-naphthol. The Freundlich constants (KF) for the five compounds on virgin graphite were 23.9, 10.3, 5.5, 1.4, and 0.8 (nmol mg−1 )/(µmol L−1) n, respectively. Naphthalene and 1-naphthol were slightly more adsorbed on the virgin material, whereas oxidized graphite had marginally better adsorption properties for anisole. The results underline the importance of dispersive and π– π interactions in the adsorption of organic compounds on carbonaceous adsorbents; a second aromatic ring in 1-naphthol and 2-methoxynaphthalene greatly increased the adsorption capacity for these compounds compared with their one-ring counterparts phenol and anisole. Differences were also observed in the adsorption of compounds containing hydroxyl or methoxy substituents, which have electron-donating properties (a resonance effect) but different electron-withdrawal characteristics (caused by induction). Two amino acids occurring as zwitterions, l-tryptophan and l-tyrosine, were also tested as adsorptives. l-Tryptophan, which has a larger aromatic system, achieved higher loading on graphite, suggesting an adsorption mechanism primarily governed by dispersive and π– π interactions for these two ionic compounds as well.

Residual Gas Reaction in the Electron Microscope: II The Design of a Gas-Control Chamber for Quantitative Observations

1969 ◽  
Vol 27 ◽  
pp. 82-83
Author(s):  
Chester J. Calbick ◽  
Richard E. Hartman
Keyword(s):  
Electron Beam ◽  
Electron Microscope ◽  
Local Environment ◽  
Chamber Pressure ◽  
Objective Lens ◽  
Ion Pump ◽  
Quantitative Studies ◽  
Precise Knowledge ◽  
Differential Pumping ◽  
And Control

Quantitative studies of the phenomenon associated with reactions induced by the electron beam between specimens and gases present in the electron microscope require precise knowledge and control of the local environment experienced by the portion of the specimen in the electron beam. Because of outgassing phenomena, the environment at the irradiated portion of the specimen is very different from that in any place where gas pressures and compositions can be measured. We have found that differential pumping of the specimen chamber by a 4" Orb-Ion pump, following roughing by a zeolite sorption pump, can produce a specimen-chamber pressure 100- to 1000-fold less than that in the region below the objective lens.

Comparative strengths and weaknesses of peroxidase and colloidal gold in pre- and post-embedding immunolabeling techniques

1987 ◽  
Vol 45 ◽  
pp. 1002-1005
Author(s):  
D. R. Abrahamson ◽  
P. L. St.John ◽  
E. W. Perry
Keyword(s):  
Electron Microscopy ◽  
Horseradish Peroxidase ◽  
Light Microscopy ◽  
Colloidal Gold ◽  
Light Microscope ◽  
Ultrastructural Localization ◽  
The Other ◽  
Quantitative Studies ◽  
Dense Suspension ◽  
Antigen Localization

Antibodies coupled to tracers for electron microscopy have been instrumental in the ultrastructural localization of antigens within cells and tissues. Among the most popular tracers are horseradish peroxidase (HRP), an enzyme that yields an osmiophilic reaction product, and colloidal gold, an electron dense suspension of particles. Some advantages of IgG-HRP conjugates are that they are readily synthesized, relatively small, and the immunolabeling obtained in a given experiment can be evaluated in the light microscope. In contrast, colloidal gold conjugates are available in different size ranges and multiple labeling as well as quantitative studies can therefore be undertaken through particle counting. On the other hand, gold conjugates are generally larger than those of HRP but usually can not be visualized with light microscopy. Concern has been raised, however, that HRP reaction product, which is exquisitely sensitive when generated properly, may in some cases distribute to sites distant from the original binding of the conjugate and therefore result in spurious antigen localization.

Understanding Why Older People Develop a Wish to Die

Crisis ◽  
2011 ◽  
Vol 32 (4) ◽  
pp. 204-216 ◽  
Author(s):  
M. L. Rurup ◽  
H. R. W. Pasman ◽  
J. Goedhart ◽  
D. J. H. Deeg ◽  
A. J. F. M. Kerkhof ◽  
...  
Keyword(s):  
Older People ◽  
Cohort Studies ◽  
Conceptual Framework ◽  
Life Events ◽  
Traumatic Life Events ◽  
Quantitative Studies ◽  
Wish To Die ◽  
Open Coding ◽  
Death Wishes ◽  
Depth Interviews

Background: Quantitative studies in several European countries showed that 10–20% of older people have or have had a wish to die. Aims: To improve our understanding of why some older people develop a wish to die. Methods: In-depth interviews with people with a wish to die (n = 31) were carried out. Through open coding and inductive analysis, we developed a conceptual framework to describe the development of death wishes. Respondents were selected from two cohort studies. Results: The wish to die had either been triggered suddenly after traumatic life events or had developed gradually after a life full of adversity, as a consequence of aging or illness, or after recurring depression. The respondents were in a situation they considered unacceptable, yet they felt they had no control to change their situation and thus progressively “gave up” trying. Recurring themes included being widowed, feeling lonely, being a victim, being dependent, and wanting to be useful. Developing thoughts about death as a positive thing or a release from problems seemed to them like a way to reclaim control. Conclusions: People who wish to die originally develop thoughts about death as a positive solution to life events or to an adverse situation, and eventually reach a balance of the wish to live and to die.

QUANTITATIVE STUDIES OF IODINE METABOLISM IN SPORADIC, NON-TOXIC GOITRE

1974 ◽  
Vol 76 (1) ◽  
pp. 67-73 ◽  
Author(s):  
H. Agerbæk ◽  
S. E. Jensen
Keyword(s):  
Iodine Deficiency ◽  
Iodine Uptake ◽  
Quantitative Studies ◽  
Euthyroid State ◽  
Iodine Metabolism ◽  
Dynamic Patterns ◽  
Perchlorate Discharge Test ◽  
Normal Controls ◽  
Discharge Test

ABSTRACT In 129 patients with non-toxic goitre and 27 normal controls, thyroid dynamic patterns were estimated in an attempt to elucidate pathogenesis. The clinically euthyroid state was confirmed by measurement of PBI, T3-sephadex uptake and BMR. Thyroid clearance (th. cl.), plasma iodide (PII), and absolute iodine uptake (AIU) were determined and a perchlorate discharge test performed. Twenty patients (16%) had a high AIU and were thus suspected of having dyshormonogenesis; nine were thoroughly investigated and in six dyshormonogenesis was found. Both normals and non-toxic goitre patients had a low PII, but in the goitrous patients values were lowest. The thyroid clearance of iodide was significantly higher in the goitre patients, suggesting iodine deficiency to be a major aetiologic factor for goitre formation. AIU was higher in the goitre patients than in normals, suggesting a larger iodine leakage from the thyroid in these patients.

Employing Exfoliated Graphite as Novel Support Material for Heterogeneous Model Catalysts

2019 ◽  
Author(s):  
Moritz Wolf ◽  
Nico Fischer ◽  
Michael Claeys
Keyword(s):  
Surface Area ◽  
Graphite Powder ◽  
Model Catalysts ◽  
Model Systems ◽  
Exfoliated Graphite ◽  
Support Material ◽  
Heterogeneous Model ◽  
Support Materials ◽  
Metal Support Interaction ◽  
Catalyst Systems

<p>The inert nature of graphitic samples allows for characterisation of rather isolated supported nanoparticles in model catalysts, as long as sufficiently large inter-particle distances are obtained. However, the low surface area of graphite and the little interaction with nanoparticles result in a challenging application of conventional preparation routes in practice. In the present study, a set of graphitic carbon materials was characterised in order to identify potential support materials for the preparation of model catalyst systems. Various sizes of well-defined Co<sub>3</sub>O<sub>4</sub> nanoparticles were synthesised separately and supported onto exfoliated graphite powder, that is graphite after solvent-assisted exfoliation <i>via</i> ultrasonication resulting in thinner flakes with increased specific surface area. The developed model catalysts are ideally suited for sintering studies of isolated nano-sized cobaltous particles as the graphitic support material does not provide distinct metal-support interaction. Furthermore, the differently sized cobaltous particles in the various model systems render possible studies on structural dependencies of activity, selectivity, and deactivation in cobalt oxide or cobalt catalysed reactions.</p>

Sign in / Sign up

Export Citation Format

Share Document