Periodic boundary layer near a two-dimensional stagnation point

1970 ◽  
Vol 43 (3) ◽  
pp. 477-486 ◽  
Author(s):  
Hiroshi Ishigaki

The time-mean characteristics of the laminar boundary layer near a two-dimensional stagnation point, when the velocity of the oncoming flow relative to the body oscillates are investigated analytically. First, when the amplitude of the oscillating velocity is small compared with the oncoming flow velocity, a series expansion is made and the obtained equations are solved numerically. The equations are also solved approximately in the extreme cases when the frequency is low and high. The obtained approximate solutions are compared with the numerical solutions in terms of skin friction. Next, when the frequency is high, the finite-velocity-amplitude case is treated. Time-mean velocity profiles and skin friction are obtained and compared with the small-amplitude case.

Author(s):  
R. S. R. Gorla ◽  
F. Jankowski ◽  
D. Textor

An analysis is presented to investigate the time-mean characteristics of the laminar boundary layer near an axisymmetric stagnation point when the velocity of the oncoming flow relative to the body oscillates. Different solutions are obtained for the small and high values of the reduced frequency parameter. Numerical solutions for the velocity and temperature functions are presented and the wall values of the velocity gradients and temperature gradients are tabulated.


1974 ◽  
Vol 64 (3) ◽  
pp. 529-564 ◽  
Author(s):  
J. Counihan ◽  
J. C. R. Hunt ◽  
P. S. Jackson

By making simple assumptions, an analytical theory is deduced for the mean velocity behind a two-dimensional obstacle (of heighth) placed on a rigid plane over which flows a turbulent boundary layer (of thickness δ). It is assumed thath[Gt ] δ, and that the wake can be divided into three regions. The velocity deficit −uis greatest in the two regions in which the change in shear stress is important, a wall region (W) close to the wall and a mixing region (M) spreading from the top of the obstacle. Above these is the external region (E) in which the velocity field is an inviscid perturbation on the incident boundary-layer velocity, which is taken to have a power-law profileU(y) =U∞(y−y1)n/δn, wheren[Gt ] 1. In (M), assuming that an eddy viscosity (=KhU(h)) can be defined for the perturbed flow in terms of the incident boundary-layer flow and that the velocity is self-preserving, it is found thatu(x,y) has the form$\frac{u}{U(h)} = \frac{ C }{Kh^2U^2(h)} \frac{f(n)}{x/h},\;\;\;\; {\rm where}\;\;\;\; \eta = (y/h)/[Kx/h]^{1/(n+2)}$, and the constant which defines the strength of the wake is$C = \int^\infty_0 y^U(y)(u-u_E)dy$, whereu=uE(x, y) asy→ 0 in region (E).In region (W),u(y) is proportional to Iny.By considering a large control surface enclosing the obstacle it is shown that the constant of the wake flow is not simply related to the drag of the obstacle, but is equal to the sum of the couple on the obstacle and an integral of the pressure field on the surface near the body.New wind-tunnel measurements of mean and turbulent velocities and Reynolds stresses in the wake behind a two-dimensional rectangular block on a roughened surface are presented. The turbulent boundary layer is artificially developed by well-established methods (Counihan 1969) in such a way that δ = 8h. These measurements are compared with the theory, with other wind-tunnel measurements and also with full-scale measurements of the wind behind windbreaks.It is found that the theory describes the distribution of mean velocity reasonably well, in particular the (x/h)−1decay law is well confirmed. The theory gives the correct self-preserving form for the distribution of Reynolds stress and the maximum increase of the mean-square turbulent velocity is found to decay downstream approximately as$ (\frac{x}{h})^{- \frac{3}{2}} $in accordance with the theory. The theory also suggests that the velocity deficit is affected by the roughness of the terrain (as measured by the roughness lengthy0) in proportion to In (h/y0), and there seems to be some experimental support for this hypothesis.


1978 ◽  
Vol 88 (2) ◽  
pp. 241-258 ◽  
Author(s):  
James C. Williams

Solutions have been obtained for a family of unsteady three-dimensional boundary-layer flows which approach separation as a result of the imposed pressure gradient. These solutions have been obtained in a co-ordinate system which is moving with a constant velocity relative to the body-fixed co-ordinate system. The flows studied are those which are steady in the moving co-ordinate system. The boundary-layer solutions have been obtained in the moving co-ordinate system using the technique of semi-similar solutions. The behaviour of the solutions as separation is approached has been used to infer the physical characteristics of unsteady three-dimensional separation.In the numerical solutions of the three-dimensional unsteady laminar boundary-layer equations, subject to an imposed pressure distribution, the approach to separation is characterized by a rapid increase in the number of iterations required to obtain converged solutions at each station and a corresponding rapid increase in the component of velocity normal to the body surface. The solutions obtained indicate that separation is best observed in a co-ordinate system moving with separation where streamlines turn to form an envelope which is the separation line, as in steady three-dimensional flow, and that this process occurs within the boundary layer (away from the wall) as in the unsteady two-dimensional case. This description of three-dimensional unsteady separation is a generalization of the two-dimensional (Moore-Rott-Sears) model for unsteady separation.


1971 ◽  
Vol 46 (1) ◽  
pp. 165-175 ◽  
Author(s):  
Hiroshi Ishigaki

The time-mean skin friction of the laminar boundary layer on a flat plate which is fixed at zero incidence in a fluctuating stream is investigated analytically. Flow oscillation amplitude outside the boundary layer is assumed constant along the surface. First, the small velocity-amplitude case is treated, and approximate formulae are obtained in the extreme cases when the frequency is low and high. Next, the finite velocity-amplitude case is treated under the condition of high frequency, and it is found that the formula obtained for the small-amplitude and high-frequency case is also valid. These results show that the increase of the mean skin friction reduces with frequency and is ultimately inversely proportional to the square of frequency.The corresponding energy equation is also studied simultaneously under the condition of zero heat transfer between the fluid and the surface. It is confirmed that the time-mean surface temperature increases with frequency and tends to be proportional to the square root of frequency. Moreover, it is shown that the timemean recovery factor can be several times as large as that without flow oscillation.


1977 ◽  
Vol 82 (3) ◽  
pp. 507-528 ◽  
Author(s):  
Hugh W. Coleman ◽  
Robert J. Moffat ◽  
William M. Kays

The behaviour of a fully rough turbulent boundary layer subjected to favourable pressure gradients both with and without blowing was investigated experimentally using a porous test surface composed of densely packed spheres of uniform size. Measurements of profiles of mean velocity and the components of the Reynolds-stress tensor are reported for both unblown and blown layers. Skin-friction coefficients were determined from measurements of the Reynolds shear stress and mean velocity.An appropriate acceleration parameterKrfor fully rough layers is defined which is dependent on a characteristic roughness dimension but independent of molecular viscosity. For a constant blowing fractionFgreater than or equal to zero, the fully rough turbulent boundary layer reaches an equilibrium state whenKris held constant. Profiles of the mean velocity and the components of the Reynolds-stress tensor are then similar in the flow direction and the skin-friction coefficient, momentum thickness, boundary-layer shape factor and the Clauser shape factor and pressure-gradient parameter all become constant.Acceleration of a fully rough layer decreases the normalized turbulent kinetic energy and makes the turbulence field much less isotropic in the inner region (forFequal to zero) compared with zero-pressure-gradient fully rough layers. The values of the Reynolds-shear-stress correlation coefficients, however, are unaffected by acceleration or blowing and are identical with values previously reported for smooth-wall and zero-pressure-gradient rough-wall flows. Increasing values of the roughness Reynolds number with acceleration indicate that the fully rough layer does not tend towards the transitionally rough or smooth-wall state when accelerated.


1999 ◽  
Author(s):  
João Henrique D. Guimarães ◽  
Sergio J. F. dos Santos ◽  
Jian Su ◽  
Atila P. Silva Freire

Abstract In present work, the dynamic and thermal behaviour of flows that develop over surfaces that simultaneously present a sudden change in surface roughness and temperature are discussed. In particular, the work is concerned with the physical validation of a newly proposed formulation for the near wall temperature profile. The theory uses the concept of the displacement in origin, together with some asymptotic arguments, to propose a new expression for the logarithmic region of the turbulent boundary layer. The new expressions are, therefore, of universal applicability, being independent of the type of rough surface considered. The present formulation may be used to give wall boundary conditions for two-equation differential models. The theoretical results are validated with experimental data obtained for flows that develop over flat surfaces with sudden changes in surface roughness and in temperature conditions. Measurements of mean velocity and of mean temperature are presented. A reduction of the data provides an estimate of the skin-friction coefficient, the Stanton number, the displacement in origin for both the velocity and the temperature profiles, and the thickness of the internal layers for the velocity and temperature profiles. The skin-friction co-efficient was calculated based on the chart method of Perry and Joubert (J.F.M., 17, 193–211, 1963) and on a balance of the integral momentum equation. The same chart method was used for the evaluation of the Stanton number and the displacement in origin.


2000 ◽  
Vol 122 (3) ◽  
pp. 522-532 ◽  
Author(s):  
H. Lee ◽  
S.-H. Kang

Transition characteristics of a boundary layer on a NACA0012 airfoil are investigated by measuring unsteady velocity using hot wire anemometry. The airfoil is installed in the incoming wake generated by an airfoil aligned in tandem with zero angle of attack. Reynolds number based on the airfoil chord varies from 2.0×105 to 6.0×105; distance between two airfoils varies from 0.25 to 1.0 of the chord length. To measure skin friction coefficient identifying the transition onset and completion, an extended wall law is devised to accommodate transitional flows with pressure gradient and nonuniform inflows. Variations of the skin friction are quite similar to that of the flat plate boundary layer in the uniform turbulent inflow of high intensity. Measured velocity profiles are coincident with families generated by the modified wall law in the range up to y+=40. Turbulence intensity of the incoming wake shifts the onset location of transition upstream. The transitional region becomes longer as the airfoils approach one another and the Reynolds number increases. The mean velocity profile gradually varies from a laminar to logarithmic one during the transition. The maximum values of rms velocity fluctuations are located near y+=15-20. A strong positive skewness of velocity fluctuation is observed at the onset of transition and the overall rms level of velocity fluctuation reaches 3.0–3.5 in wall units. The database obtained will be useful in developing and evaluating turbulence models and computational schemes for transitional boundary layer. [S0098-2202(00)01603-5]


1997 ◽  
Vol 345 ◽  
pp. 101-131
Author(s):  
M. D. KUNKA ◽  
M. R. FOSTER

Because of the importance of oscillatory components in the oncoming flow at certain oceanic topographic features, we investigate the oscillatory flow past a circular cylinder in an homogeneous rotating fluid. When the oncoming flow is non-reversing, and for relatively low-frequency oscillations, the modifications to the equivalent steady flow arise principally in the ‘quarter layer’ on the surface of the cylinder. An incipient-separation criterion is found as a limitation on the magnitude of the Rossby number, as in the steady-flow case. We present exact solutions for a number of asymptotic cases, at both large frequency and small nonlinearity. We also report numerical solutions of the nonlinear quarter-layer equation for a range of parameters, obtained by a temporal integration. Near the rear stagnation point of the cylinder, we find a generalized velocity ‘plateau’ similar to that of the steady-flow problem, in which all harmonics of the free-stream oscillation may be present. Further, we determine that, for certain initial conditions, the boundary-layer flow develops a finite-time singularity in the neighbourhood of the rear stagnation point.


1966 ◽  
Vol 26 (4) ◽  
pp. 793-806 ◽  
Author(s):  
George R. Inger

The approach to equilibrium in a non-equilibrium-dissociating boundary-layer flow along a catalytic or non-catalytic surface is treated from the standpoint of a singular perturbation problem, using the method of matched asymptotic expansions. Based on a linearized reaction rate model for a diatomic gas which facilitates closed-form analysis, a uniformly valid solution for the near equilibrium behaviour is obtained as the composite of appropriate outer and inner solutions. It is shown that, under near equilibrium conditions, the primary non-equilibrium effects are buried in a thin sublayer near the body surface that is described by the inner solution. Applications of the theory are made to the calculation of heat transfer and atom concentrations for blunt body stagnation point and high-speed flat-plate flows; the results are in qualitative agreement with the near equilibrium behaviour predicted by numerical solutions.


1997 ◽  
Vol 119 (3) ◽  
pp. 420-426 ◽  
Author(s):  
R. J. Volino ◽  
T. W. Simon

Measurements from heated boundary layers along a concave-curved test wall subject to high (initially 8 percent) free-stream turbulence intensity and strong (K = (ν/U∞2) dU∞/dx) as high as 9 × 10−6) acceleration are presented and discussed. Conditions for the experiments were chosen to roughly simulate those present on the downstream half of the pressure side of a gas turbine airfoil. Mean velocity and temperature profiles as well as skin friction and heat transfer coefficients are presented. The transition zone is of extended length in spite of the high free-stream turbulence level. Transitional values of skin friction coefficients and Stanton numbers drop below flat-plate, low-free-stream-turbulence, turbulent flow correlations, but remain well above laminar flow values. The mean velocity and temperature profiles exhibit clear changes in shape as the flow passes through transition. To the authors’ knowledge, this is the first detailed documentation of a high-free-stream-turbulence boundary layer flow in such a strong acceleration field.


Sign in / Sign up

Export Citation Format

Share Document