High isolation and compact MIMO antenna system with defected shorting wall

2014 ◽  
Vol 7 (2) ◽  
pp. 167-172 ◽  
Author(s):  
Xi-Wang Dai ◽  
Long Li ◽  
Zhen-Ye Wang ◽  
Chang-Hong Liang
Keyword(s):  
Wireless Local Area Network ◽  
Local Area Network ◽  
Mimo System ◽  
Multiple Input Multiple Output ◽  
Local Area ◽  
Antenna System ◽  
Area Network ◽  
Mimo Antenna ◽  
High Isolation ◽  
Input Multiple Output

In this paper, a compact multiple-input multiple-output (MIMO) antenna system with high isolation is proposed for 2.4 GHz wireless local area network (WLAN) application. The system is composed of two aperture-coupled shorted patch antennas with a spacing of 4 mm (only 0.032λ). The antenna is fed with an H-shaped coupling slot, and the defected shorting wall is used for high isolation. The proposed MIMO system exhibits an isolation of better than −20 dB and a maximum isolation of −43 dB at the central frequency. The envelope correlation coefficient is less than 0.01. The simulated and measured results show that the proposed antenna is a good candidate for MIMO system with higher isolation and better diversity.

scholarly journals Performance analysis of IEEE 802.11ac based WLAN in wireless communication systems

2019 ◽  
Vol 9 (2) ◽  
pp. 1131 ◽  
Author(s):  
A. Z. Yonis
Keyword(s):  
Communication Systems ◽  
Wireless Local Area Network ◽  
Local Area Network ◽  
Multiple Input Multiple Output ◽  
Local Area ◽  
Area Network ◽  
Data Rates ◽  
Input Multiple Output ◽  
Ieee 802.11Ac ◽  
5 Ghz

<p><span lang="EN-US">IEEE 802.11ac based wireless local area network (WLAN) is emerging WiFi standard at 5 GHz, it is new gigabit-per-second standard providing premium services. IEEE 802.11ac accomplishes its crude speed increment by pushing on three distinct measurements firstly is more channel holding, expanded from a maximum of 80 MHz up to 160 MHz modes. Secondly, the denser modulation, now using 256-QAM, it has the ability to increase the data rates up to 7 Gbps using an 8×8 multiple input multiple output (MIMO). Finally, it provides high resolution for both narrow and medium bandwidth channels. This work presents a study to improve the performance of IEEE 802.11ac based WLAN system.</span></p>

Broadband MIMO antenna for HiperLAN/2, WLAN, and WiMAX applications with high isolation

2015 ◽  
Vol 8 (2) ◽  
pp. 309-317 ◽  
Author(s):  
Raefat Jalila El Bakouchi ◽  
Marc Brunet ◽  
Tchanguiz Razban ◽  
Abdelilah Ghammaz
Keyword(s):  
High Performance ◽  
Wireless Local Area Network ◽  
Local Area Network ◽  
Ground Plane ◽  
Local Area ◽  
Area Network ◽  
Mimo Antenna ◽  
High Isolation ◽  
Large Bandwidth ◽  
S Parameters

This paper presents a multiple-input and multiple-output dual-element planar inverted-F antenna (PIFA) array for broadband operation covering the HIgh PERformance radio Local Area Network/2 (5.2 GHz/5.6 GHz), Wireless Local Area Network (5.2 GHz/5.8 GHz), and the Worldwide Interoperability for Microwave Access (5.5 GHz) bands for the compact wireless communication devices. The antenna dimension is reduced substantially with a miniature ground plane. The PIFA array provides a large bandwidth (670 MHz) and a high isolation between its ports less than −26 dB. The proposed antenna has been analyzed and designed with Ansoft HFSS v.11. Then a prototype was fabricated and tested for its performance in terms of bandwidth, S-parameters, and radiation pattern. A parametric study is made to analyze the effect of different PIFA parameters on the operating frequency and the S-parameters. The diversity performances are evaluated using computer simulation technology microwave studio (CSTMWS). The broadband performance and the high isolation are achieved in both simulation and measurement.

scholarly journals Mutual Coupling Reduction in Microstrip Antennas using Defected Ground Structure

2020 ◽  
Author(s):  
Lan Ngoc Nguyen
Keyword(s):  
Wireless Local Area Network ◽  
Local Area Network ◽  
Ground Plane ◽  
Multiple Input Multiple Output ◽  
Microstrip Antennas ◽  
Area Network ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Mimo Antenna ◽  
High Isolation

A Multiple Input Multiple Output (MIMO) antenna with high isolation is proposed in this paper. The proposed antenna includes two sets of four elements (2 x 2) and it is yielded at the central frequency of 5.5 GHz for Wireless Local Area Network (WLAN) applications. Based on RT5880 with height of 1.575 mm, the overall size of MIMO antenna is 140 x 76 x 1.575 mm3. To get high isolation between antenna elements, a Defected Ground Structure (DGS) is integrated on ground plane. Besides, the MIMO antenna witnesses a large bandwidth of 9.1% and an efficiency of 90% while the pick gain is 8.5 dBi. The measurement results are compared to simulation ones to verify the performance of the proposed antenna.

Gain enhancement for MIMO antenna using metamaterial structure

2019 ◽  
Vol 11 (08) ◽  
pp. 851-862 ◽  
Author(s):  
Ngoc Lan Nguyen ◽  
Van Yem Vu
Keyword(s):  
Wireless Local Area Network ◽  
Local Area Network ◽  
Ground Plane ◽  
Multiple Input Multiple Output ◽  
Local Area ◽  
Area Network ◽  
Metamaterial Structure ◽  
Mimo Antenna ◽  
Gain Enhancement ◽  
Unit Cells

AbstractIn this paper, a multiple input multiple output antenna which operates at 5.8 GHz for wireless local area network applications is proposed. The proposed antenna is composed of two sets of four elements antenna array (2 × 2) on the top and a novel metamaterial structure on the ground plane. Here, the ground plane, which includes a lattice of 2 × 5 unit cells of metamaterial structure, is utilized in order to improve parameters of the antenna. Thanks to the proposed metamaterial structure, not only gain and bandwidth of antenna are enhanced, but also mutual coupling is reduced. The final design, with an overall size of 137 × 77 × 3.048 mm3, resulted in a |S11| &lt;−10 dB bandwidth of 1.78 GHz and a peak gain of 9.2 dBi. In addition, the isolation is higher than 18 dB although the close separation from edge to edge of the two antennas is only 2 mm and radiation efficiency of 73% at the operating frequency band. All is simulated based on CST Studio software and the simulated S-parameter results of the antenna are in good agreement with measurement results.

A compact band-notched antenna with high isolation for UWB MIMO applications

2020 ◽  
pp. 1-7
Author(s):  
Issmat Shah Masoodi ◽  
Insha Ishteyaq ◽  
Khalid Muzaffar ◽  
M. Idrees Magray
Keyword(s):  
Wireless Local Area Network ◽  
Local Area Network ◽  
Ground Plane ◽  
Multiple Input Multiple Output ◽  
Local Area ◽  
Antenna System ◽  
Ultra Wideband ◽  
Impedance Bandwidth ◽  
Area Network ◽  
Antenna Module

Abstract A compact antenna module with a single band notch at wireless local area network (WLAN) (5.725–5.825 GHz) for ultra-wideband (UWB) multiple input multiple output (MIMO) applications is proposed. Proposed antenna which acquires size of 0.299 λ × 0.413 λ × 0.005 λ mm3 at 3.1 GHz consists of two symmetrical radiators placed side by side on global merchandise link (GML) 1000 substrate (εr = 3.2, tan δ = 0.004). Isolation between the antenna elements is >18 dB in the whole UWB band, which is achieved by introducing the vertical stub and H-slot between the monopole radiators in the ground plane. The simulated and measured results of the antenna system are in good agreement. The proposed antenna covers entire UWB with impedance bandwidth (|S11| < −15 dB) from 3.1 to 11 GHz except at WLAN notched band. The designed antenna module bears low envelope correlation coefficient and minimal multiplexing efficiency hence fulfilling criteria suitable for various wireless MIMO applications.

scholarly journals Performance evaluation of the IEEE 802.11n random topology WLAN with QoS application

2020 ◽  
Vol 10 (2) ◽  
pp. 1924
Author(s):  
Ziyad Khalaf Farej ◽  
Mustafa Mohammad Jasim
Keyword(s):  
Wireless Local Area Network ◽  
Local Area Network ◽  
Multiple Input Multiple Output ◽  
Local Area ◽  
Antenna System ◽  
Area Network ◽  
Node Number ◽  
Ieee 802.11N ◽  
Random Topology ◽  
The Impact

The IEEE 802.11n supports high data rate transmissions due its physical layer Multiple Input ‎Multiple Output (MIMO) advanced antenna system and MAC layer enhancement features (frame ‎aggregation and block acknowledgement). As a result this standard is very suitable for multimedia ‎services through its Enhanced Distributed Channel Access (EDCA). This paper focuses on ‎evaluating the Quality of Service (QoS) application on the performance of the IEEE 802.11n ‎random topology WLAN. Three different number of nodes (3, 9 and 18) random topology with one ‎access point are modeled and simulated by using the Riverbed OPNET 17.5 Modular to ‎investigate the Wireless Local Area Network (WLAN) performance for different spatial streams. ‎The result clarified the impact of QoS application and showed that its effect is best at the 18 node ‎number topology. For a 4x4 MIMO, when QoS is applied and with respect to the no QoS ‎application case, simulation results show a maximum improvement of 86.4%, 33.9%, 52.2% and ‎‎68.9% for throughput, delay, data drop and retransmission attempts, respectively. ‎

scholarly journals A Graphene-Assembled Film Based MIMO Antenna Array with High Isolation for 5G Wireless Communication

2021 ◽  
Vol 11 (5) ◽  
pp. 2382
Author(s):  
Rongguo Song ◽  
Xiaoxiao Chen ◽  
Shaoqiu Jiang ◽  
Zelong Hu ◽  
Tianye Liu ◽  
...  
Keyword(s):  
Antenna Array ◽  
Antenna Arrays ◽  
Multiple Input Multiple Output ◽  
Frequency Selective Surface ◽  
Antenna System ◽  
Antenna Element ◽  
Mimo Antenna ◽  
High Isolation ◽  
Input Multiple Output ◽  
Alternative Material

With the development of 5G, Internet of Things, and smart home technologies, miniaturized and compact multi-antenna systems and multiple-input multiple-output (MIMO) antenna arrays have attracted increasing attention. Reducing the coupling between antenna elements is essential to improving the performance of such MIMO antenna system. In this work, we proposed a graphene-assembled, as an alternative material rather than metal, film-based MIMO antenna array with high isolation for 5G application. The isolation of the antenna element is improved by a graphene assembly film (GAF) frequency selective surface and isolation strip. It is shown that the GAF antenna element operated at 3.5 GHz has the realized gain of 2.87 dBi. The addition of the decoupling structure improves the isolation of the MIMO antenna array to more than 10 dB and corrects the antenna radiation pattern and operating frequency. The isolation between antenna elements with an interval of 0.4λ is above 25 dB. All experimental results show that the GAF antenna and decoupling structure are efficient devices for 5G mobile communication.

Sign in / Sign up

Export Citation Format

Share Document