Fabrication of Nanohybrid Spinel@CuO Catalysts for Propane Oxidation: Modified Spinel and Enhanced Activity by Temperature-Dependent Acid Sites

2021 ◽  
Author(s):  
Bin Wang ◽  
Guangpeng Yang ◽  
Qilei Yang ◽  
Bing Li ◽  
Dong Wang ◽  
...  
Keyword(s):  
Acid Sites ◽  
Propane Oxidation ◽  
Temperature Dependent ◽  
Enhanced Activity

Synthesis and Characterization of Mesoporous SAPO-11 by Using Carbon Particles

2011 ◽  
Vol 306-307 ◽  
pp. 1576-1579 ◽  
Author(s):  
Jun Liang ◽  
Fu Ping Wang
Keyword(s):  
Mass Transfer ◽  
Carbon Black ◽  
Reaction Temperature ◽  
Acid Sites ◽  
Synthesis And Characterization ◽  
Carbon Particles ◽  
Enhanced Activity ◽  
Low Reaction Temperature ◽  
Zeolite Crystals

Mesoporous SAPO-11 was synthesized hydrothermally by using carbon black and di-n-propylamime (DPA) as templates for the expected mesopores and micropores respectively. The samples were characterized with XRD, nitrogen physisorption, SEM and NH3-TPD techniques. The mesopore volumes of mesoporous SAPO-11 are in range of 0.037 - 0.052 cm3/g. The same amounts of the acid sites according to NH3-TPD results in both mesoporous and conventional SAPO-11 products indicate that the carbon black involved in the synthesis doesn’t affect the crystallization efficiency of SAPO-11. The mesoporous SAPO-11 samples exhibit higher activity compared with conventional ones, especially under low reaction temperature. The enhanced activity can be attributed to the introduction of the mesopores in the zeolite crystals, which decreases the intracrystalline mass transfer limitations.

(111) Monocrystalline Nickel Films

1972 ◽  
Vol 30 ◽  
pp. 512-513
Author(s):  
T.E. Pratt ◽  
R.W. Vook
Keyword(s):  
Film Thickness ◽  
Deposition Rate ◽  
Room Temperature ◽  
Narrow Range ◽  
High Vacuum ◽  
Residual Pressure ◽  
Temperature Dependent ◽  
Deposition Parameters ◽  
Transmission Electron ◽  
Substrate Temperatures

(111) oriented thin monocrystalline Ni films have been prepared by vacuum evaporation and examined by transmission electron microscopy and electron diffraction. In high vacuum, at room temperature, a layer of NaCl was first evaporated onto a freshly air-cleaved muscovite substrate clamped to a copper block with attached heater and thermocouple. Then, at various substrate temperatures, with other parameters held within a narrow range, Ni was evaporated from a tungsten filament. It had been shown previously that similar procedures would yield monocrystalline films of CU, Ag, and Au.For the films examined with respect to temperature dependent effects, typical deposition parameters were: Ni film thickness, 500-800 A; Ni deposition rate, 10 A/sec.; residual pressure, 10-6 torr; NaCl film thickness, 250 A; and NaCl deposition rate, 10 A/sec. Some additional evaporations involved higher deposition rates and lower film thicknesses.Monocrystalline films were obtained with substrate temperatures above 500° C. Below 450° C, the films were polycrystalline with a strong (111) preferred orientation.

An analytical microscopic study of metals in fluidized catalytic cracking catalyst

1986 ◽  
Vol 44 ◽  
pp. 854-855
Author(s):  
Clifford S. Rainey
Keyword(s):  
Electron Microscopy ◽  
Spatial Distribution ◽  
Catalytic Cracking ◽  
Catalyst Deactivation ◽  
Coke Formation ◽  
Acid Sites ◽  
Y Zeolite ◽  
Fcc Catalyst ◽  
Fluidized Catalytic Cracking ◽  
High Regeneration

The spatial distribution of V and Ni deposited within fluidized catalytic cracking (FCC) catalyst is studied because these metals contribute to catalyst deactivation. Y zeolite in FCC microspheres are high SiO2 aluminosilicates with molecular-sized channels that contain a mixture of lanthanoids. They must withstand high regeneration temperatures and retain acid sites needed for cracking of hydrocarbons, a process essential for efficient gasoline production. Zeolite in combination with V to form vanadates, or less diffusion in the channels due to coke formation, may deactivate catalyst. Other factors such as metal "skins", microsphere sintering, and attrition may also be involved. SEM of FCC fracture surfaces, AEM of Y zeolite, and electron microscopy of this work are developed to better understand and minimize catalyst deactivation.

In Vitro Effects of Urokinase — Prevention by Different Inhibitors

1990 ◽  
Vol 64 (03) ◽  
pp. 402-406 ◽  
Author(s):  
M D Oethinger ◽  
E Seifried
Keyword(s):  
In Vitro Study ◽  
Thrombin Time ◽  
Plasma Samples ◽  
Temperature Dependent ◽  
Chloromethyl Ketone ◽  
Control Value ◽  
Dose Time ◽  
In Vitro Effects ◽  
Full Protection

SummaryThe present in vitro study investigated dose-, time- and temperature-dependent effects of two-chain urokinase plasminogen activato(u-PA, urokinase) on normal citrated plasma. When 10 μg/ml u-PA wereadded to pooled normal plasma and incubated for 30 min at an ambient temperature (25° C), α2-antiplas-min decreased to 8% of the control value. Incubation on ice yielded a decrease to 45% of control,whereas α2-antiplasmin was fully consumed at 37° C. Fibrinogen and plasminogen fell to 46% and 39%, respectively, after a 30 min incubation at 25° C. Thrombin time prolonged to 190% of control.Various inhibitors were studied with respect to their suitability and efficacy to prevent these in vitro effects. Aprotinin exhibited a good protective effect on fibrinogen at concentrations exceeding 500 KlU/ml plasma. Its use, however, was limited due to interferences with some haemostatic assays. We could demonstrate that L-Glutamyl-L-Glycyl-L-Arginyl chloromethyl ketone (GGACK) and a specific polyclonal anti-u-PA-antibody (anti-u-PA-IgG) effectively inhibited urokinase-induced plasmin generation without interfering with haemostatic assays. The anti-u-PA-antibody afforded full protection ofα2-antiplasmin at therapeutic levels of u-PA.It is concluded that u-PA in plasma samples from patients during thrombolytic therapy may induce in vitro effects which should be prevented by the use of a suitable inhibitor such as GGACK or specific anti-u-PA-antibody.

Sign in / Sign up

Export Citation Format

Share Document