scholarly journals Study of the Electro-Activation Process of Calcium Lactate, Calcium Ascorbate Solutions, and Their Equimolar Mixture: Assessment of Their Physicochemical Properties

ACS Omega ◽  
2021 ◽  
Author(s):  
Pierre Emerson Cayemitte ◽  
Natela Gerliani ◽  
Philippe Raymond ◽  
Mohammed Aïder
Keyword(s):  
Physicochemical Properties ◽  
Calcium Lactate ◽  
Equimolar Mixture ◽  
Activation Process

scholarly journals An innovative method of activating lime waste. Waste – sorbent – product.

2018 ◽  
pp. 27-35
Author(s):  
Krzysztof Knaś
Keyword(s):  
Chemical Composition ◽  
Physicochemical Properties ◽  
Size Distribution ◽  
Production Technology ◽  
Flue Gas ◽  
Activation Process ◽  
Industrial Installation ◽  
Original Process ◽  
Innovative Method ◽  
Before And After

The paper presents the production technology of sorbents for flue gas desulphurization with the wet limestone method, produced on the basis of limestone waste. The waste was subjected to comprehensive physicochemical tests and the following were studied: size distribution, chemical composition, morphology and reactivity. The analysed waste was subjected to electromagnetic activation to improve the sorption properties lost in the original process. The effect of the activation process was determined by comparing physicochemical properties of the waste before and after its activation. Based on the experience gained, an industrial installation was designed and manufactured industrial.

SEM and Auger microanalysis studies of Cu-Be dynode surfaces at each activation condition

1978 ◽  
Vol 36 (1) ◽  
pp. 524-525
Author(s):  
T. Koshikawa ◽  
Y. Fujii ◽  
E. Sugata ◽  
F. Kanematsu
Keyword(s):  
Electron Emission ◽  
Secondary Electron ◽  
Secondary Electron Emission ◽  
Life Time ◽  
Activation Process ◽  
Beam Diameter ◽  
Activation Temperature ◽  
Electron Multiplier ◽  
Activation Condition ◽  
Activation Conditions

The Cu-Be alloys are widely used as the electron multiplier dynodes after the adequate activation process. But the structures and compositions of the elements on the activated surfaces were not studied clearly. The Cu-Be alloys are heated in the oxygen atmosphere in the usual activation techniques. The activation conditions, e.g. temperature and O2 pressure, affect strongly the secondary electron yield and life time of dynodes.In the present paper, the activated Cu-Be dynode surfaces at each condition are investigated with Scanning Auger Microanalyzer (SAM) (primary beam diameter: 3μmϕ) and SEM. The commercial Cu-Be(2%) alloys were polished with Cr2O3 powder, rinsed in the distilled water and set in the vacuum furnance.Two typical activation condition, i.e. activation temperature 730°C and 810°C in 5x10-3 Torr O2 pressure were chosen since the formation mechanism of the BeO film on the Cu-Be alloys was guessed to be very different at each temperature from the results of the secondary electron emission measurements.

Preparation and characterisation of vanadium pentoxide supported rhodium catalyst

1988 ◽  
Vol 46 ◽  
pp. 946-947
Author(s):  
A. Legrouri
Keyword(s):  
Aqueous Solution ◽  
Thermal Decomposition ◽  
Physicochemical Properties ◽  
Surface Area ◽  
Vanadium Pentoxide ◽  
High Purity ◽  
Gas Adsorption ◽  
Rhodium Catalyst ◽  
Optical Methods ◽  
Reducible Oxides

The industrial importance of metal catalysts supported on reducible oxides has stimulated considerable interest during the last few years. This presentation reports on the study of the physicochemical properties of metallic rhodium supported on vanadium pentoxide (Rh/V2O5). Electron optical methods, in conjunction with other techniques, were used to characterise the catalyst before its use in the hydrogenolysis of butane; a reaction for which Rh metal is known to be among the most active catalysts.V2O5 powder was prepared by thermal decomposition of high purity ammonium metavanadate in air at 400 °C for 2 hours. Previous studies of the microstructure of this compound, by HREM, SEM and gas adsorption, showed it to be non— porous with a very low surface area of 6m2/g3. The metal loading of the catalyst used was lwt%Rh on V2Q5. It was prepared by wet impregnating the support with an aqueous solution of RhCI3.3H2O.

The Binding of Calcium Ions to Bovine Factor X by Rate Dialysis

1978 ◽  
Vol 40 (02) ◽  
pp. 350-357
Author(s):  
Robert H Yue ◽  
Menard M Gertler
Keyword(s):  
Molecular Weight ◽  
Dissociation Constant ◽  
Calcium Ions ◽  
Activation Process ◽  
Factor X ◽  
The Real ◽  
High Affinity ◽  
Binding Data ◽  
Sequential Mechanism ◽  
Bovine Factor

SummaryThe binding of Ca+2 to bovine factor X (molecular weight of 74,000) (Yue und Gertler 1977) was studied by the technique of rate dialysis and with the use of 45Ca+2. The binding data are consistent with a model of sequential mechanism. One mole of Ca+2 binds to the glycoprotein with a dissociation constant of 5.2 × 10-5 M and an additional 39 ± 4 moles of Ca+2 bind to this zymogen with a dissociation constant of 3.7 × 10-3M. The binding of the high affinity Ca+2 causes a functionally significant change in the zymogen, and (calcium) (factor X) complex is the real substrate in the activation process by the protease in Russell’s viper venom.

Studies on the Degradation of Human Fibrinogen by Plasmin and Trypsin

1966 ◽  
Vol 16 (03/04) ◽  
pp. 526-540 ◽  
Author(s):  
E. A Beck ◽  
D. P Jackson
Keyword(s):  
Physicochemical Properties ◽  
Electrophoretic Mobility ◽  
Rapid Loss ◽  
Clotting System ◽  
Human Fibrinogen ◽  
Peptide Bonds ◽  
Physico Chemical ◽  
Starch Gel ◽  
Ph Stat ◽  
Rapid Appearance

SummaryThe effects of trypsin and plasmin on the functional and physicochemical properties of purified human fibrinogen were observed at various stages of proteolysis. Concentrations of plasmin and trypsin that produced fibrinogenolysis at comparable rates as measured in a pH stat produced, at similar rates, loss of precipitability of fibrinogen by heat and ammonium sulphate and alterations in electrophoretic mobility on starch gel. Trypsin produced a more rapid loss of clottability of fibrinogen and a more rapid appearance of inhibitors of the thrombin-fibrinogen clotting system than did plasmin. Consistent differences were noted between the effects of trypsin and plasmin on the immunoelectrophoretic properties of fibrinogen during the early stages of proteolysis.These results are consistent with the hypothesis that trypsin initially reacts with the same peptide bonds of fibrinogen that are split by thrombin, but these same bonds do not appear to be split initially by plasmin. Measurement of the various functional and physico-chemical changes produced by the action of trypsin and plasmin on fibrinogen can be used to recognize various stages of proteolysis.

The effectiveness of granular chalk use for growing winter wheat on grey forest soil

2020 ◽  
pp. 181-191
Author(s):  
M. Tkachenko ◽  
N. Borys ◽  
Ye. Kovalenko
Keyword(s):  
Winter Wheat ◽  
Physicochemical Properties ◽  
Forest Soil ◽  
Active Substance ◽  
Mass Fraction ◽  
Gray Forest Soil ◽  
Mineral Fertilizers ◽  
Acidic Soils ◽  
Grey Forest Soil

The research aims to establish the eff ectiveness of granular chalk use produced by «Slavuta-Calcium» Ltd. under growing Poliska–90 winter wheat variety, changing the physicochemical properties of grey forest soil and the wheat productivity. It also aims to establish optimal dosis of «Slavuta-Calcium» granular chalk as the meliorant and mineral fertilizer for grey forest soil in the system of winter wheat fertilization. In the temporary fi eld studies, various doses of nutrients N60–90–120P30–45–60K60–90–120 combined with «Slavuta–Calcium» granular chalk in a dose of Ca230–460–690 kg/ha of the active substance were studied against the background of secondary plowing of rotation products – soybean biomass that averaged 2.34 t/ha. Granular chalk is a modern complex highly eff ective meliorant with the content of Ca – 37.7 and Mg – 0.2 %, the mass fraction of carbonates (CaCO3 + MgCO3) makes at least 95 %. It is characterized by a high level of solubility when interacting with moisture in soil. It has a form of white granules, the mass fraction of 4.0–6.0 mm in size granules makes not less than 90 % and the one of 1.0 mm in size makes less than 5 %. Reactivity – 97 %. The granular chalk is advisable to apply on acidic soils, as a highly concentrated calcium-magnesium fertilizer, with the former as the dominant fertilizer, to optimize the physicochemical properties of the soil, as well as the plant nutrition system, in particular, increasing the availability of an element for assimilation by plants and as long-term ameliorants. The eff ectiveness of the use of mineral fertilizers, in particular acidic nitrogen on highly and medium acidic soils, after chemical reclamation is increased by 30–50 %, and slightly acidic by 15–20 %. The increase in productivity of crops from the combined eff ects of nutrients and chalk granulated is usually higher than when separately applied. The eff ectiveness of the integrated action of these elements is manifested in the growth of plant productivity and the quality of the resulting products, as well as the optimization of physical chemical properties and soil buff ering in the long term. In order to optimize the physicochemical properties of the arable layer of gray forest soil and the productive nutrition of agricultural crops, winter wheat, in particular, biogenic elements should be used in doses N60-90-120P30-45- 60K60-90-120 with granulated chalk «Slavuta-Calcium» in doses of Ca230-460-690 kg/ha of active substance. Granulated chalk obtained as a result of industrial grinding of solid sedimentary carbonate rocks of natural origin, subsequently under the infl uence of the granulation process of the starting material contains Ca and Mg carbonates of at least 95 %, dense granules which facilitates convenient mechanized application, as well as chalk suitable for accurate metered application on the quest map. Key words: granular chalk, gray forest soil, chemical reclamation, crop productivity.

Characteristics Of The Structure Formation Of Gypsum Binder Modified With Zinc Hydrosilicates

2020 ◽  
pp. 40-46
Keyword(s):  
Synergistic Effect ◽  
Physicochemical Properties ◽  
Structure Formation ◽  
Silicic Acid ◽  
Chemical Properties ◽  
Crystal Formation ◽  
Ability To Act ◽  
Chemical Factors ◽  
Sorption Characteristics

The authors' methodic for assessing the role of chemical and physic-chemical factors during the structure formation of gypsum stone is presented in the article. The methodic is also makes it possible to reveal the synergistic effect and to determine the ranges of variation of controls factors that ensure maximum values of such effect. The effect of a micro-sized modifier based on zinc hydro-silicates on the structure formation of building gypsum is analyzed and corresponding dependencies are found. It is shown that effects of influence of modifier on the properties of gypsum compositions are determined by chemical properties of modifier. Among the mentioned properties are sorption characteristics (which depend on the amount of silicic acid and its state) and physicochemical properties - the ability to act as a substrate during crystal formation. The proposed method can also be extended to other binding substances and materials. This article contributes to the understanding of the processes that occur during the structure formation of composites, which will make it possible to control the structure formation in the future, obtaining materials with a given set of properties.

Sign in / Sign up

Export Citation Format

Share Document