Stream Pollution Load Easing Despite Rising Paper Production

1952 ◽  
Vol 30 (9) ◽  
pp. 892
Keyword(s):  
Pollution Load ◽  
Stream Pollution ◽  
Paper Production

Economics of coated paper production made from deinked pulp

TAPPI Journal ◽  
2013 ◽  
Vol 12 (4) ◽  
pp. 19-27
Author(s):  
PATRICK HUBER ◽  
LAURENT LYANNAZ ◽  
BRUNO CARRÉ
Keyword(s):  
Mechanical Properties ◽  
Optimization Methods ◽  
Coating Process ◽  
Coated Paper ◽  
Paper Production ◽  
Base Paper

The fraction of deinked pulp for coated paper production is continually increasing, with some mills using 100% deinked pulp for the base paper. The brightness of the coated paper made from deinked pulp may be reached through a combination of more or less extensive deinking, compensated by appropriate coating, to optimize costs overall. The authors proposed general optimization methods combined with Kubelka-Munk multilayer calculations to find the most economical combination of deinking and coating process that would produce a coated paper made from DIP, at a given target brightness, while maintaining mechanical properties.

Resource efficiency in deinked pulp production: a review

TAPPI Journal ◽  
2014 ◽  
Vol 13 (11) ◽  
pp. 37-43 ◽  
Author(s):  
LIISA KOTANEN ◽  
MIKA KÖRKKÖ ◽  
ARI ÄMMÄLÄ ◽  
JOUKO NIINIMÄKI
Keyword(s):  
Waste Disposal ◽  
Resource Efficiency ◽  
Raw Material ◽  
Ecological Strategy ◽  
Recycled Paper ◽  
Paper Production ◽  
Recycled Pulp ◽  
Current State ◽  
The Cost ◽  
Pulp Production

The use of recovered paper as a raw material for paper production is by far the most economical and ecological strategy for the disposal of waste paper. However, paper production from recovered paper furnish generates a great amount of residues, and the higher the demand requirements for the end product, the higher the amount of rejected material. The reason for this is that the selectivity of the deinking process is limited; therefore, some valuable components are also lost in reject streams. The rejection of usable components affects the economics of recycled paper production. As the cost of waste disposal continues to increase, this issue is becoming more and more severe. This paper summarizes the current state of the resource efficiency in recycled pulp production and provides information on the volumes of rejected streams and the usable material within them. Various means to use these reject streams are also discussed, including the main findings of a recent thesis by the main author. This review summarizes current internal and external use of reject streams generated in the deinking operations.

Spatial and Temporal variation analysis of water quality of Hemavathi River, Karnataka, India

2018 ◽  
Vol 6 (9) ◽  
pp. 196
Author(s):  
Santhosh K. M ◽  
S. Prashanth
Keyword(s):  
Water Quality ◽  
Agricultural Runoff ◽  
Spatial And Temporal Variation ◽  
Final Conclusion ◽  
Variation Analysis ◽  
Pollution Load ◽  
Quality Of Water ◽  
Pollution Loading ◽  
Origin Point

Urban development, agricultural runoff and industrialization have contributed pollution loading on the environment.  In this study Hemavathi river water from a stretch from its origin point to its sangama was studied for pollution load by determining parameters of water quality like pH, Alkalinity,  Ca, Mg, Nitrate, TDS, BOD, COD , and the results were compared with WHO and BIS standards to draw final conclusion on the quality of water.

Influence of Daily Variation of Flow and Pollution Load on the Performance of Submerged Anaerobic/Aerobic Biofilm System

1990 ◽  
Vol 22 (3-4) ◽  
pp. 153-160 ◽  
Author(s):  
T. Okubo ◽  
M. Okada ◽  
A. Murakami ◽  
Y. Inamori
Keyword(s):  
Organic Carbon ◽  
Field Study ◽  
Laboratory Study ◽  
Hydraulic Retention Time ◽  
Daily Variation ◽  
Synthetic Wastewater ◽  
Constant Flow ◽  
Pollution Load ◽  
Mean Values ◽  
Anaerobic Filter

Effects of daily variation of flow on the performance of submerged anaerobic/aerobic biofilm systems were investigated both by laboratory study using synthetic wastewater and by field study using gray water. In laboratory study, concentration of dissolved organic carbon (DOC) in effluent from anaerobic filter fluctuated with daily variation of flow when average hydraulic retention time (HRT) was below 10 h. However, daily mean values of DOC under the varied flow was almost the same as those under constant flow within the same daily mean HRT. Aerobic filter linked to anaerobic filter reduced the concentration of DOC satisfactorily though the concentration in anaerobic filter increased under short HRT. In field study, percent removal of organic carbon by anaerobic filter was considerably smaller (20-30%) than that in laboratory study (90-95%) both at HRT of 20 h though it was improved up to 60-80% by aerobic filter. Effects of peaking factor of flow on the variation of DOC were evaluated by mathematical analysis. It seemed that the peaking factor hardly affected daily mean values of DOC within the same daily mean HRT though maximum values of DOC increased with the increase of peaking factor.

Development of Dialog System Model for Eutrophication Control between Discharging River Basin and Receiving Water Body – Case Study of Lake Sagami (Japan)

1989 ◽  
Vol 21 (12) ◽  
pp. 1821-1824
Author(s):  
M. Suzuki ◽  
K. Chihara ◽  
M. Okada ◽  
H. Kawashima ◽  
S. Hoshino
Keyword(s):  
Water Management ◽  
Water Quality ◽  
Expert System ◽  
River Basin ◽  
Water Body ◽  
Water Bodies ◽  
Quality Data ◽  
Pollution Load ◽  
Water Quality Data ◽  
Receiving Water

A computer program based on expert system software was developed and proposed as a prototype model for water management to control eutrophication problems in receiving water bodies (Suzuki etal., 1988). The system has several expert functions: 1. data input and estimation of pollution load generated and discharged in the river watershed; 2. estimation of pollution load run-off entering rivers; 3. estimation of water quality of receiving water bodies, such as lakes; and 4. assisting man-machine dialog operation. The program can be used with MS-DOS BASIC and assembler in a 16 bit personal computer. Five spread sheets are utilized in calculation and summation of the pollutant load, using multi-windows. Partial differential equations for an ecological model for simulation of self-purification in shallow rivers and simulation of seasonal variations of water quality in a lake were converted to computer programs and included in the expert system. The simulated results of water quality are shown on the monitor graphically. In this study, the expert system thus developed was used to estimate the present state of one typical polluted river basin. The river was the Katsura, which flows into Lake Sagami, a lake dammed for water supply. Data which had been actually measured were compared with the simulated water quality data, and good agreement was found. This type of expert system is expected to be useful for water management of a closed water body.

Comparison of the efficiency of best stormwater management practices in urban drainage systems

1999 ◽  
Vol 39 (9) ◽  
pp. 269-276 ◽  
Author(s):  
R. Mehler ◽  
M. W. Ostrowski
Keyword(s):  
Stormwater Management ◽  
Management Practices ◽  
Alternative Methods ◽  
Urban Drainage ◽  
Pollution Load ◽  
Load Model ◽  
Urban Stormwater Management ◽  
Sewer Systems ◽  
Combined Sewer ◽  
Stormwater Management Practices

Increasingly extended and alternative methods for urban stormwater management have been discussed in Germany and elsewhere. Without question an economically and ecologically sound combination of central and decentral measures will be a concept of the future. Yet, at present the introduction of approaches other than traditional combined sewer systems is restricted due to missing planning tools and technologies. Adding a number of frequently used Best Stormwater Management Practices (BSMP's) has widely extended the applicability of an existing stormwater water balance and pollution load model.

Biogas Production Using Anaerobic Digestion of Industrial Waste

2016 ◽  
Vol 832 ◽  
pp. 55-62
Author(s):  
Ján Gaduš ◽  
Tomáš Giertl ◽  
Viera Kažimírová
Keyword(s):  
Anaerobic Digestion ◽  
Industrial Waste ◽  
Large Scale ◽  
Biogas Production ◽  
Biogas Plant ◽  
Parallel Operation ◽  
Paper Production ◽  
Biochemical Conversion ◽  
Mixed Biomass ◽  
Economic Balance

In the paper experiments and theory of biogas production using industrial waste from paper production as a co-substrate are described. The main aim of the experiments was to evaluate the sensitivity and applicability of the biochemical conversion using the anaerobic digestion of the mixed biomass in the pilot fermentor (5 m3), where the mesophillic temperature was maintained. It was in parallel operation with a large scale fermentor (100 m3). The research was carried out at the biogas plant in Kolíňany, which is a demonstration facility of the Slovak University of Agriculture in Nitra. The experiments proved that the waste arising from the paper production can be used in case of its appropriate dosing as an input substrate for biogas production, and thus it can improve the economic balance of the biogas plant.

Sign in / Sign up

Export Citation Format

Share Document