Simultaneous degradation and reduction of multiple organic compounds by poly(vinyl imidazole) cryogel-templated Co, Ni, and Cu metal nanoparticles

2020 ◽  
Vol 44 (11) ◽  
pp. 4417-4425
Author(s):  
Melek Tercan ◽  
Sahin Demirci ◽  
Osman Dayan ◽  
Nurettin Sahiner

Simultaneous degradation of methylene blue, eosin Y and 4-nitrophenol reduction by p(vinyl imidazole)–Co cryogel composite catalyst in aqueous environments.

Author(s):  
Natalia V. Karimova ◽  
Michael R Alves ◽  
Man Luo ◽  
Vicki Grassian ◽  
Robert Benny Gerber

Water systems often contain complex macromolecular systems that absorb light. In marine environments, these light absorbing components are often at the air-water interface and can participate in the chemistry of...


2020 ◽  
Vol 289 ◽  
pp. 121494
Author(s):  
Jiraporn Buasakun ◽  
Phakinee Srilaoong ◽  
Gun Chaloeipote ◽  
Ramida Rattanakram ◽  
Chatchawal Wongchoosuk ◽  
...  

2016 ◽  
Vol 22 (34) ◽  
pp. 12106-12112 ◽  
Author(s):  
Lorenzo Milli ◽  
Nicola Zanna ◽  
Andrea Merlettini ◽  
Matteo Di Giosia ◽  
Matteo Calvaresi ◽  
...  
Keyword(s):  

2020 ◽  
Vol 998 ◽  
pp. 84-89
Author(s):  
Jittinat Sirichokthanasarp ◽  
Dang Trung Tri Trinh ◽  
Du Ang Dao Channei ◽  
Kantapat Chansaenpak ◽  
Wilawan Khanitchaidecha ◽  
...  

The dye-pigments and organic compounds are known as significant pollutants in wastewater of textile industrial. Among of treatment technologies, the photocatalysis using TiO2 nano particles has potential on-site process for removing the dye-pigments and organic compounds, due to no hazardous waste and inexpensive. In this work, the TiO2 nanoparticles were synthesized by two different methods of hydrothermal and sol-gel. Nanoparticle of TiO2 synthesized by hydrothermal method contained pure anatase phase as similar as the TiO2 nanoparticles synthesized by sol-gel method. However, the TiO2 synthesized by hydrothermal method provided the higher specific surface area and pore volume rather than the another TiO2. Further, the high efficiency 86% of methylene blue photodegradation was observed during the by using TiO2 synthesized by hydrothermal method as photocatalyst, whereas the efficiency was only 72% for TiO2 synthesized by sol-gel method.


2020 ◽  
Vol 998 ◽  
pp. 78-83
Author(s):  
Yi Yi Zaw ◽  
Du Ang Dao Channei ◽  
Thotsaphon Threrujirapapong ◽  
Wilawan Khanitchaidecha ◽  
Auppatham Nakaruk

Titanium dioxide (TiO2) is known as one of the widely used catalysts in photocatalysis process. Recently, the photocatalysis of TiO2 has been implied in water purification and treatment, particularly dyes and organic compounds degradations. Naturally, the TiO2 can be found in three phases including anatase, rutile and brookite; each phase has its own specific properties such as grain size, stability and band gap energy. In this work, the effect of calcination temperature on the structure, morphology and photocatalytic activity were investigated. The data suggested that the anatase/rutile ratio of TiO2 can be controlled through the calcination process. The phase transformation data strongly indicated the liner function between percentage of rutile phase and calcination temperature. The BET analysis provided the consistent data with XRD patterns by showing that the specific surface area was decreased by increasing calcination temperature. The photodegradation of methylene blue under UV irradiation proved that the mixed phase of anatase/rutile ratio at 78.5/21.5 provided the highest photocatalytic activity. The phase composition ratio can influence the nanoparticles properties including band gap, specific surface area and energy band structure. Therefore, the control of anatase/rutile ratio was an alternative to enhance the photocatalytic activity of TiO2 nanoparticles for dyes and organic compounds degradations.


Langmuir ◽  
2010 ◽  
Vol 26 (7) ◽  
pp. 5153-5159 ◽  
Author(s):  
Timur I. Abdullin ◽  
Oxana V. Bondar ◽  
Yu. G. Shtyrlin ◽  
Mehmet Kahraman ◽  
Mustafa Culha

2014 ◽  
Vol 30 (3) ◽  
pp. 1183-1189 ◽  
Author(s):  
Tarik Ainane ◽  
Fatima Khammour ◽  
Mohammed Talbi ◽  
M’hamed Elkouali

2014 ◽  
Vol 895 ◽  
pp. 547-557 ◽  
Author(s):  
T.K. Tan ◽  
P.S. Khiew ◽  
W.S. Chiu ◽  
S. Radiman ◽  
R. Abd-Shukor ◽  
...  

The commercialized ZnO nanopowder has been employed in this study to investigate the photocatalytic degradation of two organic compounds, Methylene Blue (MB) and Phenol Red (PR) in an aqueous suspension of ZnO nanoparticles under UV light irradiation. This study has considered ZnO as the photocatalyst because it has been reported as a suitable substitute for TiO2 in certain application. For the characterization of the ZnO photocatalyst, X-ray diffraction (XRD), transmission electron microscopy (TEM), specific surface area analysis (BET), and UV-visible spectroscopy were exploited. X-ray diffractometry result for the ZnO nanoparticles exhibit normal crystalline phase features. All observed peaks can be indexed to the pure hexagonal wurtzite crystal structures, with the space group of P63mc. From the XRD pattern, no diffraction peaks from other impurities have been observed. In addition, TEM measurement shows that most of the nanoparticles are spherical and rod-like in shape and fairly monodispersed. A significant degradation of the organic compounds were observed in the presence of the catalyst without the irradiation of the UV light and the degradation increases significantly when irradiated with the UV light for a certain period of time. Besides, for the same period of irradiation, the photodegradation of the organic compounds was increased as the photocatalyst loading increases. The BET measurement for ZnO was 11.9 m2/g. The effect of some parameters such as initial concentration of organic compounds and photocatalyst loading were also determined. Keywords: Nanostructures; Methylene blue; Phenol red; Zinc oxide; Heterogeneous photocatalyst


Sign in / Sign up

Export Citation Format

Share Document