Why biodegradable polymers don't solve the plastic pollution problem

2019 ◽  
Vol 14 (3) ◽  
pp. 54-58
Author(s):  
T. Pultarova
2021 ◽  
Vol 9 ◽  
Author(s):  
Camilla Catarci Carteny ◽  
Ronny Blust

In recent years, biodegradable polymers have been hailed as one of the potential solutions to the plastic pollution problem, due to their ability to fully degrade rather than break down in smaller pieces over time. However, complete degradation of biodegradable polymers is often achievable only under strictly controlled conditions (i.e. increased temperature and pressure), which are not found in the natural environment – particularly in aquatic and marine habitats. This study aims to compare the degradation performance of plastic films made of two different biodegradable polymers – polylactic acid (PLA) and polyhydroxyalkanoates (PHA) – to that of low-density polyethylene (LDPE) films, in a simulated marine environment. Plastic films of the three chosen polymers, of equal dimensions, were exposed to natural sunlight within a novel setup - which simulated the sea surface - for six months. Films were chosen as they are among the most frequently reported type of plastic litter in coastal environments worldwide, and because of the increasing adoption on the market of biodegradable films for packaging. Results showed that, after six months, no consistent degradation could be observed on any of the films–not even the biodegradable ones. Between PLA and PHA films, the latter weathered slightly more than the former, but not at a significant level. Interestingly, differences were reported among the different polymer films in terms of type and extent of biofouling, brittleness, surface charge and surface microstructural changes. Overall, this work suggests that biodegradable plastic behaves rather similarly to traditional plastic in the marine environment over a half-year span. Albeit further experiments on even longer timescales are needed, this study provides evidence that, unless properly disposed of in an industrial composter facility, biodegradable plastic may only contribute to the very problem it was intended to solve.


2021 ◽  
Vol 416 ◽  
pp. 125763
Author(s):  
Loredana Manfra ◽  
Vincenzo Marengo ◽  
Giovanni Libralato ◽  
Maria Costantini ◽  
Francesca De Falco ◽  
...  

Author(s):  
Sandra Kaabel ◽  
J. P. Daniel Therien ◽  
Catherine E. Deschênes ◽  
Dustin Duncan ◽  
Tomislav Friščić ◽  
...  

AbstractLess than 9% of the plastic produced is recycled after use, contributing to the global plastic pollution problem. While polyethylene terephthalate (PET) is one of the most common plastics, its thermomechanical recycling generates a material of lesser quality. Enzymes are highly selective, renewable catalysts active at mild temperatures; however, the current consensus is that they lack activity towards the more crystalline forms of PET. We report here that when used in moist-solid reaction mixtures instead of the typical dilute aqueous solutions, enzymes can directly depolymerize high crystallinity PET in 13-fold higher space-time yield and a 15-fold higher enzyme efficiency than prior reports. Further, this process shows a 26-fold selectivity for terephthalic acid over other hydrolysis products, which allows the direct synthesis of UiO-66 metal-organic framework.


2021 ◽  
Vol 22 (Special Issue) ◽  
Author(s):  
Quratulan Ahmed ◽  
Qadeer Mohammad Ali ◽  
Levent Bat ◽  
Aysah Oztekin ◽  
Sehrish Memon ◽  
...  

Plastic material dominates our life and accordingly, it dominates the environment as a pollutant. Pakistan coasts are facing with plastic pollution problem like the rest of the world. The number and types of microplastics found in sea water and sediment samples from 25 locations along the Arabian Sea coast of Pakistan were explored in this study. The results of the present study show that the region is under a high pollution from microplastics. Microplastic abundance in seawater was found as mean 582.12±246.14 particle. L-1 and in sediment samples was mean 987.40±617.06 particle.kg-1 dry sediment. Microplastic concentration was maximum in Manora both seawater and sediment samples. Fibers were major contribution to total microplastics, up to 99% of all samples both seawater and sediment samples.


2021 ◽  
Vol 3 (2) ◽  
Author(s):  
Luis Felipe Avilés-Ramírez ◽  
Joanna M. Ortiz-Alcantara ◽  
Ma. Leticia Arena-Ortiz

Plastic pollution has become an urgent issue, since its invasion to every ecosystem has led to multiple impacts on the environment and human populations. Certain microbial strains and genera had shown the ability to biodegrade plastic sources under laboratory conditions. In this minireview, we collect and analyze scientific papers and reports of this microbial activity as we contextualize this information on the global plastic pollution problem, to provide an updated state of the art of plastic biodegradation with microbial agents. Along with a broad understanding of the general process of plastic biodegradation hosted by microorganisms. The contributions of this minireview come from the identification of research gaps, as well as proposals for new approaches. One of the main proposals focuses on coastal environments and in particular coastal wetlands as a great microbiome source with potential for plastic biodegradation, whether reported or undiscovered. Our final proposal consists of the application of this knowledge into technologic tools and strategies that have a remarkable impact on the battle against the plastic pollution problem.


2020 ◽  
pp. 202-228
Author(s):  
Gretė Bagdonaitė ◽  
Leila Abi Chaker

More and more oceans are polluted by plastic waste emmitted by humans. Unrestricted production and consumption of plastic products have a major negative impact not only on the world’s lungs – the oceans but also on human health. Ocean plastic pollution is caused by human activities, particularly land-based activities. Therefore, this article addresses two key aspects that should be tackled with this pollution problem. First, the article presents the existing international regulation directed against ocean pollution by land-based sources, highlighting its inefficiencies and shortcomings, while suggesting what decisions should be taken on the international scene. Secondly, Secondly, it discusses ways in which the amount of plastic waste generated can be reduced, with positive consequences not only for the ocean ecosystem but also for national economies.


Polymers ◽  
2021 ◽  
Vol 13 (3) ◽  
pp. 449
Author(s):  
Yu Miao ◽  
Annette von Jouanne ◽  
Alexandre Yokochi

Although plastic is considered an indispensable commodity, plastic pollution is a major concern around the world due to its rapid accumulation rate, complexity, and lack of management. Some political policies, such as the Chinese import ban on plastic waste, force us to think about a long-term solution to eliminate plastic wastes. Converting waste plastics into liquid and gaseous fuels is considered a promising technique to eliminate the harm to the environment and decrease the dependence on fossil fuels, and recycling waste plastic by converting it into monomers is another effective solution to the plastic pollution problem. This paper presents the critical situation of plastic pollution, various methods of plastic depolymerization based on different kinds of polymers defined in the Society of the Plastics Industry (SPI) Resin Identification Coding System, and the opportunities and challenges in the future.


2021 ◽  
pp. 1-16
Author(s):  
Michael S. Bank ◽  
Sophia V. Hansson

AbstractThe microplastic cycle was originally and formally introduced and defined as a novel concept and paradigm for understanding plastic pollution and its fluxes across ecosystem reservoirs. This concept has now been expanded to include macroplastic particles and links all aspects of the fate, transport, and effects of plastic pollution, including source-receptor models in the environment, and expanded on previously established perspectives that viewed the plastic pollution issue in a less integrated manner. The value of this paradigm is that this perspective integrates three basic scientific spheres: environmental chemistry, biology (i.e., trophic transfer), and human health. The goal of this chapter is to introduce readers to the microplastic pollution problem and to outline the microplastic cycle as a concept and holistic paradigm for addressing this ubiquitous environmental and potential public health problem. The specific objectives of this chapter were to (1) introduce this volume and its chapters by outlining the microplastic pollution issue in the context of the entire plastic cycle; (2) evaluate fluxes of microplastics across different ecosystem compartments, including the atmosphere, lithosphere, hydrosphere. and biosphere, including humans; and (3) provide insights on public policy and potential solutions to the microplastic pollution problem.


Processes ◽  
2021 ◽  
Vol 9 (6) ◽  
pp. 921
Author(s):  
Fabio M. Lamberti ◽  
Andy Ingram ◽  
Joseph Wood

Plastic pollution is a global issue that is approaching crisis levels as plastic production is projected to reach 1.1 GT annually by 2050. The bioplastic industry along with a circular production economy are solutions to this problem. One promising bioplastic polylactic acid (PLA) has mechanical properties comparable to polystyrene (PS), so it could replace PS in its applications as a more environmentally sustainable material. However, since the bioplastic PLA also suffers from long biodegradation times in the environment, to ensure that it does not add to the current pollution problem, it should instead be chemically recycled. In this work, PLA was chemically recycled via alcoholysis, using either methanol or ethanol to generate the value-added products methyl lactate and ethyl lactate respectively. Two catalysts, zinc acetate dihydrate (ZnAc) and 4-(dimethylamino)pyridine (DMAP), were tested both individually and in mixtures. A synergistic effect was exhibited on the reaction rate when both catalysts were used in an equal ratio. The methanolysis reaction was determined to be two-step, with the activation energy estimated to be 73 kJ mol−1 for the first step and 40.16 kJ mol−1 for the second step. Both catalysts are cheap and commercially available, their synergistic effect could be exploited for large-scale PLA recycling.


2021 ◽  
Author(s):  
Natalie Mahowald ◽  
Janice Brahney ◽  
Marje Prank ◽  
Gavin Cornwell ◽  
Zbigniew Klimont ◽  
...  

<p>Plastic pollution is one of the most pressing environmental and social issues of the 21<sup>st</sup> century. Recent work has highlighted the atmosphere’s role in transporting microplastics to remote locations. Here we use in situ observations of microplastic deposition combined with an atmospheric transport model and optimal estimation techniques to test hypotheses of the most likely sources of atmospheric plastic. Results suggest that atmospheric microplastics in the western USA are primarily derived from secondary re-emission sources including roads, the ocean and agricultural soil dust. Using our best estimate of plastic sources and modeled transport pathways, most continents were net importers of plastics from the marine environment, underscoring the cumulative role of legacy pollution in the atmospheric burden of plastic. This effort is the first to use high resolution spatial and temporal deposition data along with several hypothesized emission sources to constrain atmospheric plastic. Akin to global biogeochemical cycles, plastics now spiral around the globe with distinct atmospheric, oceanic, cryospheric, and terrestrial lifetimes. Though advancements have been made in the manufacture of biodegradable polymers, our data suggest that extant non-biodegradable polymers will continue to cycle through the Earth’s systems. Due to limited observations and understanding of the source processes, there remain large uncertainties in the, transport, deposition, and source attribution of microplastics. Thus, we prioritize future research directions for understanding the plastic cycle.</p>


Sign in / Sign up

Export Citation Format

Share Document