scholarly journals Bond load-slip behaviour of FRP bars in recycled-aggregate concrete

2020 ◽  
Vol 323 ◽  
pp. 01002
Author(s):  
Ahmed Godat ◽  
Ebtesam Alghafri ◽  
Noura AlTamimi ◽  
Hamda Aljaberi ◽  
Shaima Aldaweela
Keyword(s):  
Concrete Strength ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Experimental Program ◽  
Bond Behaviour ◽  
Aggregate Concrete ◽  
Pull Out ◽  
The Impact ◽  
Frp Bars

This study presents an experimental program conducted to investigate the bond strength of FRP bars in recycled-aggregate concrete compared to the one in normal-aggregate concrete for the improved evaluation of results. The experimental program contains thirty six specimens tested using direct pull-out test. In this study, glass, carbon and basalt FRP bars are used with 12 mm diameter and bar bond lengths of 5d, where d is the bar diameter. The FRP bars are casted in different recycled-aggregate concrete strengths of 30, 45 and 60 MPa. The behaviour of bars in normal-aggregate concrete strength of 30 MPa is used as a benchmark and its behaviour is compared with the ones in the recycled-aggregate concrete. The impact of the concrete strength considered is identified based on the gain in the bond behaviour. The experimental results demonstrate the prospect of the recycled aggregates applied as an alternative to normal aggregates in the FRP reinforced concrete. In addition, the use of the recycled aggregate increases the bearing friction behaviour between the FRP bars and concrete.

Mechanical behaviors of GFRP tube confined recycled aggregate concrete with sea sand

2020 ◽  
pp. 136943322097477
Author(s):  
Yijie Huang ◽  
Jianzhuang Xiao ◽  
Li Qin ◽  
Peng Li
Keyword(s):  
Concrete Strength ◽  
Chloride Ion ◽  
Deformation Curve ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Experimental Program ◽  
Mechanical Behaviors ◽  
River Sand ◽  
Aggregate Concrete ◽  
Sea Sand

An experimental program was undertaken to study the mechanical behaviors of glass fiber-reinforced polymer (GFRP) tube confined recycled aggregate concrete with sea sand (GRACSS) under the axial compression. Two different parameters were mainly considered: recycled coarse aggregates (RCA) replacement percentage (0, 100%) and type of sand (sea sand, river sand). Typical influences of RCA and sea sand on the strength, the deformation and the load–deformation curve of GRACSS were investigated. The test results showed that the failure pattern of GRACSS was similar to that of GFRP tube confined ordinary concrete (GCOC). The strength of GRACSS decreased with an increasing RCA replacement percentage, while sea sand could reduce the negative effect of RCA. It is also found that the peak deformation of GRACSS increased with the increasing RCA replacement percentage whereas with decreasing sea sand chloride ion (Cl–) content. The stiffness of the specimen was obviously influenced by the concrete type. Research findings indicated that the axial load-deformation curve of GRACSS can be divided into elastic-plastic and hardening stages. An analytical expression was proposed to calculate the load-deformation curve of GRACSS. Finally, the finite element method (FEM) was applied to study the effects of outer tube thickness, concrete strength, RCA replacement percentage and Cl– content in sea sand on the mechanical behaviors (strength and deformation) of GRACSS.

Experimental Study on Bond-Slip between Steel Bar and Recycled Aggregate Concrete

2011 ◽  
Vol 250-253 ◽  
pp. 1651-1656 ◽  
Author(s):  
Qing Feng Huang ◽  
Da Fu Wang
Keyword(s):  
Concrete Strength ◽  
Concrete Cover ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Aggregate Concrete ◽  
Bond Slip ◽  
Pull Out ◽  
Steel Bar ◽  
Cover Thickness

By a static and repeated pull-out experiment between steel bar and recycled aggregate concrete, and bond-slip curves between recycled concrete with different recycled coarse aggregate(RCA) replacement percentages were recorded. Based on the analysis of the experimental results, replacement percentages of recycled concrete, cover thickness, anchorage length, concrete strength and loading method was investigated. At last, the bond-slip constitutive relation was also discussed.

scholarly journals Influence of Wetting and Drying Cycles on Physical and Mechanical Behavior of Recycled Aggregate Concrete

Materials ◽  
2020 ◽  
Vol 13 (24) ◽  
pp. 5675
Author(s):  
Caroline S. Rangel ◽  
Mayara Amario ◽  
Marco Pepe ◽  
Enzo Martinelli ◽  
Romildo D. Toledo Filho
Keyword(s):  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Construction And Demolition Waste ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Demolition Waste ◽  
Wetting And Drying ◽  
Aggregate Concrete ◽  
Wetting And Drying Cycles ◽  
The Impact

Recently, concerns have been rising about the impact of increasing the depletion of natural resources and the relevant generation of construction and demolition waste, on the environment and economy. Therefore, several efforts have been made to promote sustainable efficiency in the construction industry and the use of recycled aggregates derived from concrete debris for new concrete mixtures (leading to so-called recycled aggregate concrete, RAC) is one of the most promising solutions. Unfortunately, there are still gaps in knowledge regarding the durability performances of RAC. In this study, we investigate durability of structural RAC subjected to wet-dry cycles. We analyze the results of an experimental campaign aimed at evaluating the degradation process induced by wetting and drying cycles on the key physical and mechanical properties of normal- and high-strength concrete, produced with coarse recycled concrete aggregates (RCAs) of different sizes and origins. On the basis of the results we propose a degradation law for wetting and drying cycles, which explicitly makes a possible correlation between the initial concrete porosity, directly related to the specific properties of the RCAs and the resulting level of damage obtained in RAC samples.

scholarly journals Bond Behaviors Between Full-Recycled-Aggregate Concrete and Deformed Steel-Bar

2017 ◽  
Vol 11 (1) ◽  
pp. 685-698 ◽  
Author(s):  
Changyong Li ◽  
Minglei Zhao ◽  
Fangchun Ren ◽  
Na Liang ◽  
Jie Li ◽  
...  
Keyword(s):  
Bond Length ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Aggregate Concrete ◽  
Bond Slip ◽  
Bond Behavior ◽  
Pull Out ◽  
Steel Bar ◽  
Key Points

Introduction: Full-recycled-aggregate concrete (aRAC) is a new concrete reusing 100% fine and coarse recycled aggregates produced from waste concrete of demolished concrete structures. As there is a lack of studies on the bond behavior between steel bar and aRAC, findings of this study are of significance for the structural application of aRAC. Method: This paper presents the pull-out test results of 24 groups aRAC specimens with deformed steel bar, and discusses the effects of aRAC strength, bond length and lateral constructional stirrups on the bond behavior between deformed steel bar and aRAC. Results and Conclusion: The bond stress and slip at key points of bond-slip curve are analyzed in relation to the tensile strength of aRAC and the bond length of steel bar. The bond-slip relationship between deformed steel bar and aRAC is proposed based on the test and analysis of this study.

scholarly journals Experimental Study on the Mechanical Properties and Compression Size Effect of Recycled Aggregate Concrete

Materials ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2323
Author(s):  
Yubing Du ◽  
Zhiqing Zhao ◽  
Qiang Xiao ◽  
Feiting Shi ◽  
Jianming Yang ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Size Effect ◽  
Compressive Stress ◽  
Failure Modes ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Aggregate Concrete ◽  
Substitution Ratio ◽  
The Impact

To explore the basic mechanical properties and size effects of recycled aggregate concrete (RAC) with different substitution ratios of coarse recycled concrete aggregates (CRCAs) to replace natural coarse aggregates (NCA), the failure modes and mechanical parameters of RAC under different loading conditions including compression, splitting tensile resistance and direct shear were compared and analyzed. The conclusions drawn are as follows: the failure mechanisms of concrete with different substitution ratios of CRCAs are similar; with the increase in substitution ratio, the peak compressive stress and peak tensile stress of RAC decrease gradually, the splitting limit displacement decreases, and the splitting tensile modulus slightly increases; with the increase in the concrete cube’s side length, the peak compressive stress of RAC declines gradually, but the integrity after compression is gradually improved; and the increase in the substitution ratio of the recycled aggregate reduces the impact of the size effect on the peak compressive stress of RAC. Furthermore, an influence equation of the coupling effect of the substitution ratio and size effect on the peak compressive stress of RAC was quantitatively established. The research results are of great significance for the engineering application of RAC and the strength selection of RAC structure design.

scholarly journals Axial Stress-Strain Performance of Recycled Aggregate Concrete Reinforced with Macro-Polypropylene Fibres

2021 ◽  
Vol 13 (10) ◽  
pp. 5741
Author(s):  
Muhammad Junaid Munir ◽  
Syed Minhaj Saleem Kazmi ◽  
Yu-Fei Wu ◽  
Xiaoshan Lin ◽  
Muhammad Riaz Ahmad
Keyword(s):  
Axial Stress ◽  
Peak Stress ◽  
Polypropylene Fibre ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Peak Strain ◽  
Stress Strain ◽  
Polypropylene Fibres ◽  
Aggregate Concrete

The addition of macro-polypropylene fibres improves the stress-strain performance of natural aggregate concrete (NAC). However, limited studies focus on the stress-strain performance of macro-polypropylene fibre-reinforced recycled aggregate concrete (RAC). Considering the variability of coarse recycled aggregates (CRA), more studies are needed to investigate the stress-strain performance of macro-polypropylene fibre-reinforced RAC. In this study, a new type of 48 mm long BarChip macro-polypropylene fibre with a continuously embossed surface texture is used to produce BarChip fibre-reinforced NAC (BFNAC) and RAC (BFRAC). The stress-strain performance of BFNAC and BFRAC is studied for varying dosages of BarChip fibres. Results show that the increase in energy dissipation capacity (i.e., area under the curve), peak stress, and peak strain of samples is observed with an increase in fibre dosage, indicating the positive effect of fibre addition on the stress-strain performance of concrete. The strength enhancement due to the addition of fibres is higher for BFRAC samples than BFNAC samples. The reduction in peak stress, ultimate strain, toughness and specific toughness of concrete samples due to the utilisation of CRA also reduces with the addition of fibres. Hence, the negative effect of CRA on the properties of concrete samples can be minimised by adding BarChip macro-polypropylene fibres. The applicability of the stress-strain model previously developed for macro-synthetic and steel fibre-reinforced NAC and RAC to BFNAC and BFRAC is also examined.

Recycling of Waste Concrete and Fly Ash for Recycled Aggregate Concrete: Fundamental Characteristics Evaluation

2009 ◽  
Vol 620-622 ◽  
pp. 255-258 ◽  
Author(s):  
Cheol Woo Park
Keyword(s):  
Fly Ash ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Experimental Program ◽  
Concrete Aggregate ◽  
Fine Aggregate ◽  
Recycled Concrete Aggregate ◽  
Aggregate Concrete ◽  
Waste Concrete

As the amount of waste concrete has been increased and recycling technique advances, this study investigates the applicability of recycled concrete aggregate for concrete structures. In addition fly ash, the industrial by-product, was considered in the concrete mix. Experimental program performed compressive strength and chloride penetration resistance tests with various replacement levels of fine recycled concrete aggregate and fly ash. In most case, the design strength, 40MPa, was obtained. It was known that the replacement of the fine aggregate with fine RCA may have greater influence on the strength development rather than the addition of fly ash. It is recommended that when complete coarse aggregate is replaced with RCA the fine RCA replacement should be less than 60%. The recycled aggregate concrete can achieve sufficient resistance to the chloride ion penetration and the resistance can be more effectively controlled by adding fly ash. It I finally conclude that the recycled concrete aggregate can be successfully used in the construction field and the recycling rate of waste concrete and flay ash should be increased without causing significant engineering problems.

scholarly journals Carbonation Properties of Recycled Aggregate Concrete by Specified Concrete Strength

2017 ◽  
Vol 5 (1) ◽  
pp. 85-93
Author(s):  
Jun Lee ◽  
Bong-Chun Lee ◽  
Young-Keun Cho ◽  
Kwang-Min Park ◽  
Sang-Hwa Jung
Keyword(s):  
Concrete Strength ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Aggregate Concrete

scholarly journals MECHANICAL PROPERTIES OF RECYCLED AGGREGATE CONCRETE WITH STEEL FIBER: A REVIEW

2019 ◽  
Vol 26 (3) ◽  
pp. 37-42
Author(s):  
Ashtar S. Al-Luhybi
Keyword(s):  
Mechanical Properties ◽  
Steel Fiber ◽  
Recycled Aggregate Concrete ◽  
Strength Characteristics ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Aggregate Concrete ◽  
Building Process

In the building process, the recycling of aggregates arising from building and demolition debris is one of the best alternatives to maintain the environment and the areas needed to bury these debris. It also helps to preserve natural concrete sources from depletion efficiently. The use of recycled aggregates in new concrete manufacturing, however, leads to a decrease in concrete\\\’s strength characteristics. This reduction rises with the rise in the percentage of recycled aggregates used in concrete, which has caused many researchers to undertake many researches on how to enhance the characteristics of recycled aggregate-containing concrete. This paper presents several studies that examined the effect of adding steel fiber to improve the properties of concrete containing a coarse recycled aggregate.

Sign in / Sign up

Export Citation Format

Share Document