Investigation of Engine Performance and Combustion and Use of Oxidation Catalysts in an LPG-Diesel Dual-Fuel Engine

2021 ◽  
Vol 147 (6) ◽  
Author(s):  
Wittison Kamei ◽  
Niranjan Sahoo ◽  
Vemulapalli V. D. N. Prasad
Keyword(s):  
Engine Performance ◽  
Dual Fuel ◽  
Oxidation Catalysts

scholarly journals Numerical Study of Engine Performance and Emissions for Port Injection of Ammonia into a Gasoline\Ethanol Dual-Fuel Spark Ignition Engine

2021 ◽  
Vol 11 (4) ◽  
pp. 1441
Author(s):  
Farhad Salek ◽  
Meisam Babaie ◽  
Amin Shakeri ◽  
Seyed Vahid Hosseini ◽  
Timothy Bodisco ◽  
...  
Keyword(s):  
Numerical Study ◽  
Combustion Process ◽  
Engine Performance ◽  
Spark Ignition ◽  
Spark Ignition Engine ◽  
Combustion Model ◽  
Dual Fuel ◽  
Spark Ignition Engines ◽  
Performance And Emissions ◽  
Hc Emissions

This study aims to investigate the effect of the port injection of ammonia on performance, knock and NOx emission across a range of engine speeds in a gasoline/ethanol dual-fuel engine. An experimentally validated numerical model of a naturally aspirated spark-ignition (SI) engine was developed in AVL BOOST for the purpose of this investigation. The vibe two zone combustion model, which is widely used for the mathematical modeling of spark-ignition engines is employed for the numerical analysis of the combustion process. A significant reduction of ~50% in NOx emissions was observed across the engine speed range. However, the port injection of ammonia imposed some negative impacts on engine equivalent BSFC, CO and HC emissions, increasing these parameters by 3%, 30% and 21%, respectively, at the 10% ammonia injection ratio. Additionally, the minimum octane number of primary fuel required to prevent knock was reduced by up to 3.6% by adding ammonia between 5 and 10%. All in all, the injection of ammonia inside a bio-fueled engine could make it robust and produce less NOx, while having some undesirable effects on BSFC, CO and HC emissions.

scholarly journals Parametric Knocking Performance Investigation of Spark Ignition Natural Gas Engines and Dual Fuel Engines

2020 ◽  
Vol 8 (6) ◽  
pp. 459 ◽  
Author(s):  
La Xiang ◽  
Gerasimos Theotokatos ◽  
Haining Cui ◽  
Keda Xu ◽  
Hongkai Ben ◽  
...  
Keyword(s):  
Natural Gas ◽  
Compression Ratio ◽  
Engine Performance ◽  
Spark Ignition ◽  
Combustion Model ◽  
Dual Fuel ◽  
Ignition Timing ◽  
Natural Gas Engines ◽  
Study Results ◽  
Pilot Fuel

Both spark ignition (SI) natural gas engines and compression ignition (CI) dual fuel (DF) engines suffer from knocking when the unburnt mixture ignites spontaneously prior to the flame front arrival. In this study, a parametric investigation is performed on the knocking performance of these two engine types by using the GT-Power software. An SI natural gas engine and a DF engine are modelled by employing a two-zone zero-dimensional combustion model, which uses Wiebe function to determine the combustion rate and provides adequate prediction of the unburnt zone temperature, which is crucial for the knocking prediction. The developed models are validated against experimentally measured parameters and are subsequently used for performing parametric investigations. The derived results are analysed to quantify the effect of the compression ratio, air-fuel equivalence ratio and ignition timing on both engines as well as the effect of pilot fuel energy proportion on the DF engine. The results demonstrate that the compression ratio of the investigated SI and DF engines must be limited to 11 and 16.5, respectively, for avoiding knocking occurrence. The ignition timing for the SI and the DF engines must be controlled after −38°CA and 3°CA, respectively. A higher pilot fuel energy proportion between 5% and 15% results in increasing the knocking tendency and intensity for the DF Engine at high loads. This study results in better insights on the impacts of the investigated engine design and operating settings for natural gas (NG)-fuelled engines, thus it can provide useful support for obtaining the optimal settings targeting a desired combustion behaviour and engine performance while attenuating the knocking tendency.

scholarly journals Hydrogen Injection in a Dual Fuel Engine Fueled with Low-Pressure Injection of Methyl Ester of Thevetia Peruviana (METP) for Diesel Engine Maintenance Application

Energies ◽  
2020 ◽  
Vol 13 (21) ◽  
pp. 5663 ◽  
Author(s):  
Mahantesh Marikatti ◽  
N. R. Banapurmath ◽  
V. S. Yaliwal ◽  
Y.H. Basavarajappa ◽  
Manzoore Elahi M Soudagar ◽  
...  
Keyword(s):  
Diesel Engine ◽  
Methyl Ester ◽  
Gas Flow ◽  
Engine Performance ◽  
Gaseous Fuel ◽  
Dual Fuel ◽  
Injection Timing ◽  
Thevetia Peruviana ◽  
Oil Source ◽  
Engine Maintenance

The present work is mapped to scrutinize the consequence of biodiesel and gaseous fuel properties, and their impact on compression-ignition (CI) engine combustion and emission characteristics in single and dual fuel operation. Biodiesel prepared from non-edible oil source derived from Thevetia peruviana belonging to the plant family of Apocynaceaeis. The fuel has been referred as methyl ester of Thevetia peruviana (METP) and adopted as pilot fuel for the effective combustion of compressed gaseous fuel of hydrogen. This investigation is an effort to augment the engine performance of a biodiesel-gaseous fueled diesel engine operated under varied engine parameters. Subsequently, consequences of gas flow rate, injection timing, gas entry type, and manifold gas injection on the modified dual-fuel engine using conventional mechanical fuel injections (CMFIS) for optimum engine performance were investigated. Fuel consumption, CO, UHC, and smoke formations are spotted to be less besides higher NOx emissions compared to CMFIS operation. The fuel burning features such as ignition delay, burning interval, and variation of pressure and heat release rates with crank angle are scrutinized and compared with base fuel. Sustained research in this direction can convey practical engine technology, concerning fuel combinations in the dual fuel mode, paving the way to alternatives which counter the continued fossil fuel utilization that has detrimental impacts on the climate.

Desulfation of Pd-based Oxidation Catalysts for Lean-burn Natural Gas and Dual-fuel Applications

2015 ◽  
Vol 8 (4) ◽  
pp. 1472-1477 ◽  
Author(s):  
Nathan Ottinger ◽  
Rebecca Veele ◽  
Yuanzhou Xi ◽  
Z. Gerald Liu
Keyword(s):  
Natural Gas ◽  
Dual Fuel ◽  
Oxidation Catalysts ◽  
Lean Burn

Improvement of dual-fuel biodiesel-producer gas engine performance acting on biodiesel injection parameters and strategy

Fuel ◽  
2017 ◽  
Vol 209 ◽  
pp. 754-768 ◽  
Author(s):  
A.P. Carlucci ◽  
A. Ficarella ◽  
D. Laforgia ◽  
L. Strafella
Keyword(s):  
Engine Performance ◽  
Dual Fuel ◽  
Producer Gas ◽  
Gas Engine ◽  
Injection Parameters

scholarly journals Characterization and Evaluation of Methane Oxidation Catalysts for Dual-Fuel Diesel and Natural Gas Engines

2016 ◽  
Vol 2 (4) ◽  
pp. 204-214 ◽  
Author(s):  
Donnie J. Worth ◽  
Marc E. J. Stettler ◽  
Paul Dickinson ◽  
Kieran Hegarty ◽  
Adam M. Boies
Keyword(s):  
Natural Gas ◽  
Methane Oxidation ◽  
Dual Fuel ◽  
Oxidation Catalysts ◽  
Natural Gas Engines

ENGINE PERFORMANCE AND EXHAUST EMISSION OF DIESEL DUAL FUEL ENGINE FUELLED BY BIODIESEL, DIESEL AND NATURAL GAS

2016 ◽  
Vol 78 (6) ◽  
Author(s):  
Zulkifli Abdul Majid ◽  
Rahmat Mohsin ◽  
Abdul Hakim Shihnan
Keyword(s):  
Natural Gas ◽  
Nitrogen Oxide ◽  
Corn Oil ◽  
Methyl Esters ◽  
Direct Injection ◽  
Engine Performance ◽  
Poor Performance ◽  
Exhaust Emission ◽  
Dual Fuel ◽  
Engine Torque

The performance and exhaust emission of 6 cylinder four stroke direct injection diesel dual fuel (DDF) engine were investigated, the duel fuel used is corn oil methyl esters consist of 5%, 10%, 15% and 20% blends with diesel and compressed natural gas (CNG). Experiment was conducted at a fixed compression ratio of 17.5:1 with variance of engine speed 1400, 1800, 2400 and 2600 rpm. Combination of Biodiesel and CNG showed a better result on engine performance in terms of horse power and engine torque compared to other types of tested fuel. The substantial decrease of 25.6 % in exhaust emission flue was observed, giving lower value of UHC and nitrogen oxide (NOx). However, when the fuel is blended with CNG, a poor performance on exhaust emission was recorded, which include carbon dioxide (CO2), carbon monoxide (CO), unburned hydrocarbon (UHC) and nitrogen oxide (NOx) due to presence of CNG in fuel. 

Sign in / Sign up

Export Citation Format

Share Document