TERTIARY X-RADIATION—A PROBLEM FOR STAFF PROTECTION?

2020 ◽  
Vol 189 (3) ◽  
pp. 304-311
Author(s):  
H Eder ◽  
M Seidenbusch ◽  
L S Oechler

Abstract The influence of tertiary x-radiation on the radiological staff is widely unknown. Tertiary radiation is caused as the scattered radiation of the patient impacts the walls, floor, ceiling and surrounding air. The question that arises is does tertiary x-radiation provide a relevant contribution to the staff doses. The impact of tertiary radiation was investigated by means of measurements of the personal dose equivalent Hp(10) on an anthropomorphic Alderson Rando male phantom and also on operators/assistants staying in clinical practice. Further, the protective effect of lead foils, especially under tertiary radiation was also investigated. Correlations could be derived for clinical angiographic/interventional procedures between dose area products (DAPs) and dose length products (DLPs) vs. dorsal doses of staff persons. Generally, the staff doses that are a result of tertiary radiation depend on the x-ray energy and range from 0.15 to 0.55% of the scattered radiation impact caused by irradiation of the patient. Hence, a back panel with 0.125-mm lead equivalent is sufficient to protect the staff from tertiary radiation created within the room environment.

2008 ◽  
Vol 18 (1) ◽  
pp. 31-40 ◽  
Author(s):  
David J. Zajac

Abstract The purpose of this opinion article is to review the impact of the principles and technology of speech science on clinical practice in the area of craniofacial disorders. Current practice relative to (a) speech aerodynamic assessment, (b) computer-assisted single-word speech intelligibility testing, and (c) behavioral management of hypernasal resonance are reviewed. Future directions and/or refinement of each area are also identified. It is suggested that both challenging and rewarding times are in store for clinical researchers in craniofacial disorders.


Author(s):  
Halit Dogan ◽  
Md Mahbub Alam ◽  
Navid Asadizanjani ◽  
Sina Shahbazmohamadi ◽  
Domenic Forte ◽  
...  

Abstract X-ray tomography is a promising technique that can provide micron level, internal structure, and three dimensional (3D) information of an integrated circuit (IC) component without the need for serial sectioning or decapsulation. This is especially useful for counterfeit IC detection as demonstrated by recent work. Although the components remain physically intact during tomography, the effect of radiation on the electrical functionality is not yet fully investigated. In this paper we analyze the impact of X-ray tomography on the reliability of ICs with different fabrication technologies. We perform a 3D imaging using an advanced X-ray machine on Intel flash memories, Macronix flash memories, Xilinx Spartan 3 and Spartan 6 FPGAs. Electrical functionalities are then tested in a systematic procedure after each round of tomography to estimate the impact of X-ray on Flash erase time, read margin, and program operation, and the frequencies of ring oscillators in the FPGAs. A major finding is that erase times for flash memories of older technology are significantly degraded when exposed to tomography, eventually resulting in failure. However, the flash and Xilinx FPGAs of newer technologies seem less sensitive to tomography, as only minor degradations are observed. Further, we did not identify permanent failures for any chips in the time needed to perform tomography for counterfeit detection (approximately 2 hours).


2021 ◽  
Vol 13 (1) ◽  
Author(s):  
Matthew G. Hanson ◽  
Barry Chan

Abstract Background Symptomatic pericardial effusion (PCE) presents with non-specific features and are often missed on the initial physical exam, chest X-ray (CXR), and electrocardiogram (ECG). In extreme cases, misdiagnosis can evolve into decompensated cardiac tamponade, a life-threatening obstructive shock. The purpose of this study is to evaluate the impact of point-of-care ultrasound (POCUS) on the diagnosis and therapeutic intervention of clinically significant PCE. Methods In a retrospective chart review, we looked at all patients between 2002 and 2018 at a major Canadian academic hospital who had a pericardiocentesis for clinically significant PCE. We extracted the rate of presenting complaints, physical exam findings, X-ray findings, ECG findings, time-to-diagnosis, and time-to-pericardiocentesis and how these were impacted by POCUS. Results The most common presenting symptom was dyspnea (64%) and the average systolic blood pressure (SBP) was 120 mmHg. 86% of people presenting had an effusion > 1 cm, and 89% were circumferential on departmental echocardiogram (ECHO) with 64% having evidence of right atrial systolic collapse and 58% with early diastolic right ventricular collapse. The average time-to-diagnosis with POCUS was 5.9 h compared to > 12 h with other imaging including departmental ECHO. Those who had the PCE identified by POCUS had an average time-to-pericardiocentesis of 28.1 h compared to > 48 h with other diagnostic modalities. Conclusion POCUS expedites the diagnosis of symptomatic PCE given its non-specific clinical findings which, in turn, may accelerate the time-to-intervention.


2021 ◽  
Vol 20 (1) ◽  
pp. 41-48
Author(s):  
Ai-Ping Han ◽  
Li Li

The new heterocyclic compound 4-methyl-3-((4-(pyridin-3-yl) pyrimidin-2-yl) amino) benzoic acid (1) designed utilizing methyl 3-amino-4-methylbenzoate (2) as a starting material was successfully fabricated and eventually characterized utilizing single crystal X-ray crystallography, 1H NMR and IR. In biological study, to evaluate the protective effect of compound on acute tracheobronchitis ICR mice model, the ELISA assay was performed to determine the level of inflammatory mediators IL-6 and TNF-α in serum. Then, the western blot was performed to determine the activation of PKA-NF-κB pathway in tissues.


Polymers ◽  
2021 ◽  
Vol 13 (13) ◽  
pp. 2212
Author(s):  
Worawat Poltabtim ◽  
Ekachai Wimolmala ◽  
Teerasak Markpin ◽  
Narongrit Sombatsompop ◽  
Vichai Rosarpitak ◽  
...  

The potential utilization of wood/polyvinyl chloride (WPVC) composites containing an X-ray protective filler, namely bismuth oxide (Bi2O3) particles, was investigated as novel, safe, and environmentally friendly X-ray shielding materials. The wood and Bi2O3 contents used in this work varied from 20 to 40 parts per hundred parts of PVC by weight (pph) and from 0 to 25, 50, 75, and 100 pph, respectively. The study considered X-ray shielding, mechanical, density, water absorption, and morphological properties. The results showed that the overall X-ray shielding parameters, namely the linear attenuation coefficient (µ), mass attenuation coefficient (µm), and lead equivalent thickness (Pbeq), of the WPVC composites increased with increasing Bi2O3 contents but slightly decreased at higher wood contents (40 pph). Furthermore, comparative Pbeq values between the wood/PVC composites and similar commercial X-ray shielding boards indicated that the recommended Bi2O3 contents for the 20 pph (40 ph) wood/PVC composites were 35, 85, and 40 pph (40, 100, and 45 pph) for the attenuation of 60, 100, and 150-kV X-rays, respectively. In addition, the increased Bi2O3 contents in the WPVC composites enhanced the Izod impact strength, hardness (Shore D), and density, but reduced water absorption. On the other hand, the increased wood contents increased the impact strength, hardness (Shore D), and water absorption but lowered the density of the composites. The overall results suggested that the developed WPVC composites had great potential to be used as effective X-ray shielding materials with Bi2O3 acting as a suitable X-ray protective filler.


Author(s):  
Paul C. D. Bank ◽  
Leo H. J. Jacobs ◽  
Sjoerd A. A. van den Berg ◽  
Hanneke W. M. van Deutekom ◽  
Dörte Hamann ◽  
...  

AbstractThe in vitro diagnostic medical devices regulation (IVDR) will take effect in May 2022. This regulation has a large impact on both the manufacturers of in vitro diagnostic medical devices (IVD) and clinical laboratories. For clinical laboratories, the IVDR poses restrictions on the use of laboratory developed tests (LDTs). To provide a uniform interpretation of the IVDR for colleagues in clinical practice, the IVDR Task Force was created by the scientific societies of laboratory specialties in the Netherlands. A guidance document with explanations and interpretations of relevant passages of the IVDR was drafted to help laboratories prepare for the impact of this new legislation. Feedback from interested parties and stakeholders was collected and used to further improve the document. Here we would like to present our approach to our European colleagues and inform them about the impact of the IVDR and, importantly we would like to present potentially useful approaches to fulfill the requirements of the IVDR for LDTs.


Sign in / Sign up

Export Citation Format

Share Document