ENHANCED IMAGE RESOLUTION OF DUAL-MODE ULTRASOUND ARRAY USING CODED EXCITATION

2007 ◽  
Author(s):  
Yayun Wan ◽  
Ajay Shrestha ◽  
Emad Ebbini
Keyword(s):  
Image Resolution ◽  
Dual Mode ◽  
Coded Excitation

scholarly journals Research on Golay-coded excitation in real-time imaging of high frequency ultrasound biomicroscopy

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Xiaochun Wang ◽  
Jun Yang ◽  
Jianjun Ji ◽  
Yusheng Zhang ◽  
Sheng Zhou
Keyword(s):  
Real Time ◽  
High Frequency ◽  
Single Pulse ◽  
Ultrasound Biomicroscopy ◽  
Image Resolution ◽  
High Frequency Ultrasound ◽  
Coded Excitation ◽  
Real Time Imaging ◽  
Detection Depth ◽  
Frequency Ultrasound

AbstractHigh frequency ultrasonic imaging provides clinicians with high-resolution diagnostic images and more accurate measurement results. The technique is now widely used in ophthalmology, dermatology, and small animal imaging. However, since ultrasonic attenuation in tissue increases rapidly with increasing frequency, the depth of detection of high frequency ultrasound in tissue is limited to a few millimeters. In this paper, a novel method of using Golay-coded excitation as a replacement for conventional single-pulse excitation in high frequency ultrasound biomicroscopy was proposed, and real-time imaging was realized. While maintaining the transmission voltage and image resolution unchanged, the detection depth can be effectively improved. The ultrasonic transmission frequency is 30 MHz and the transmission voltage is ± 60 V p-p. In this study, 4-bit, 8-bit, and 16-bit coding sequences and decoding compression were used. To verify the effectiveness of the coding sequence in real-time imaging of ultrasound biomicroscopy, we designed a 10-μm diameter line target echo experiment, an ultrasound phantom experiment, and an in vitro porcine eye experiment. The experimental results show that the code/decode method of signal processing can not only maintain a resolution consistent with that of single-pulse transmission, but can also improve the detection depth and signal-to-noise ratio.

Design and Development of an Automated Dual-Mode Microscopic System Using Electrically Tunable Lenses

2021 ◽  
pp. 1-12
Author(s):  
Neelam Barak ◽  
Vineeta Kumari ◽  
Gyanendra Sheoran
Keyword(s):  
Focal Depth ◽  
Numerical Aperture ◽  
Image Plane ◽  
Image Resolution ◽  
Proof Of Concept ◽  
Dual Mode ◽  
Modes Of Operation ◽  
Viable Solution ◽  
Difficult Challenge ◽  
Tunable Lenses

Maintaining telecentricity and zooming in microscopic systems with prolonged depths of focus is a difficult challenge because these properties degrade while moving to different axial planes in the extended focal depth. In this paper, we propose the proof of concept for an automated dual-mode microscopic system that combines two electrically tunable lenses (ETLs) with a variable numerical aperture controller placed. It acts as a viable solution to allow both multiplane microscopic zooming and telecentricity with consistent image resolution throughout the objective's extended focal depth. The image plane remains fixed for both the modes of operation, namely telecentricity and multiplane zooming. To validate the performance of the proposed idea, both simulations and experiments are carried out at various ETL curvature ranges. Over the whole zoom distance range, the experimental zoom ratio is determined to range from −2.723X to −34.42X. The experimental and simulation findings are compared and found to be quite similar, with magnification error percentages of 2.26% for zoom mode and 1.27% for telecentric mode. The comprehensive explanation of simulation and experimental results demonstrate the feasibility of the proposed method for both multiplane zoom and telecentric operations on a single platform in microscopic applications.

The Resolution and Contrast in Biological Sections Determined by Inelastic and Elastic Scattering

1973 ◽  
Vol 31 ◽  
pp. 224-225
Author(s):  
D. L. Misell
Keyword(s):  
Electron Microscopy ◽  
Adverse Effect ◽  
Elastic Scattering ◽  
Inelastic Scattering ◽  
Amorphous Carbon ◽  
Polymeric Materials ◽  
Chromatic Aberration ◽  
Image Resolution ◽  
Quantitative Estimates ◽  
Elastic Ratio

In the electron microscopy of biological sections the adverse effect of chromatic aberration on image resolution is well known. In this paper calculations are presented for the inelastic and elastic image intensities using a wave-optical formulation. Quantitative estimates of the deterioration in image resolution as a result of chromatic aberration are presented as an alternative to geometric calculations. The predominance of inelastic scattering in the unstained biological and polymeric materials is shown by the inelastic to elastic ratio, I/E, within an objective aperture of 0.005 rad for amorphous carbon of a thickness, t=50nm, typical of biological sections; E=200keV, I/E=16.

In situ REM imaging of surface processes on ceramic bulk crystals from 300 to 1670 K in a conventional TEM

1991 ◽  
Vol 49 ◽  
pp. 660-661
Author(s):  
Z. L. Wang ◽  
J. Bentley
Keyword(s):  
High Temperatures ◽  
Image Resolution ◽  
Atomic Processes ◽  
Crystal Surfaces ◽  
Beam Radiation ◽  
Surface Areas ◽  
Transmission Electron ◽  
Reflection Electron Microscopy ◽  
Gas Reactions

Studying the behavior of surfaces at high temperatures is of great importance for understanding the properties of ceramics and associated surface-gas reactions. Atomic processes occurring on bulk crystal surfaces at high temperatures can be recorded by reflection electron microscopy (REM) in a conventional transmission electron microscope (TEM) with relatively high resolution, because REM is especially sensitive to atomic-height steps.Improved REM image resolution with a FEG: Cleaved surfaces of a-alumina (012) exhibit atomic flatness with steps of height about 5 Å, determined by reference to a screw (or near screw) dislocation with a presumed Burgers vector of b = (1/3)<012> (see Fig. 1). Steps of heights less than about 0.8 Å can be clearly resolved only with a field emission gun (FEG) (Fig. 2). The small steps are formed by the surface oscillating between the closely packed O and Al stacking layers. The bands of dark contrast (Fig. 2b) are the result of beam radiation damage to surface areas initially terminated with O ions.

Magnetic Domain Observation of an Amorphous Fe-Si-B Ribbon by Means of a High Voltage Scanning Electron Microscope

1981 ◽  
Vol 39 ◽  
pp. 320-321
Author(s):  
K. Tsuno ◽  
Y. Harada ◽  
T. Sato
Keyword(s):  
Electron Microscope ◽  
Scanning Electron Microscope ◽  
High Voltage ◽  
Amorphous Ribbon ◽  
Image Resolution ◽  
Objective Lens ◽  
Magnetic Domains ◽  
Scattered Electron ◽  
Voltage Scanning ◽  
Scanning Electron

Magnetic domains of ferromagnetic amorphous ribbon have been observed using Bitter powder method. However, the domains of amorphous ribbon are very complicated and the surface of ribbon is not flat, so that clear domain image has not been obtained. It has been desired to observe more clear image in order to analyze the domain structure of this zero magnetocrystalline anisotropy material. So, we tried to observe magnetic domains by means of a back-scattered electron mode of high voltage scanning electron microscope (HVSEM).HVSEM method has several advantages compared with the ordinary methods for observing domains: (1) high contrast (0.9, 1.5 and 5% at 50, 100 and 200 kV) (2) high penetration depth of electrons (0.2, 1.5 and 8 μm at 50, 100 and 200 kV). However, image resolution of previous HVSEM was quite low (maximum magnification was less than 100x), because the objective lens cannot be excited for avoiding the application of magnetic field on the specimen.

Low-voltage, high-resolution scanning electron microscopy of polymers

1987 ◽  
Vol 45 ◽  
pp. 466-467 ◽  
Author(s):  
S. J. Krause ◽  
W.W. Adams ◽  
S. Kumar ◽  
T. Reilly ◽  
T. Suziki
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Low Voltage ◽  
Chromatic Aberration ◽  
Image Resolution ◽  
Resolution Limit ◽  
Crossover Point ◽  
New Generation ◽  
Beam Damage ◽  
Scanning Electron

Scanning electron microscopy (SEM) of polymers at routine operating voltages of 15 to 25 keV can lead to beam damage and sample image distortion due to charging. Imaging polymer samples with low accelerating voltages (0.1 to 2.0 keV), at or near the “crossover point”, can reduce beam damage, eliminate charging, and improve contrast of surface detail. However, at low voltage, beam brightness is reduced and image resolution is degraded due to chromatic aberration. A new generation of instruments has improved brightness at low voltages, but a typical SEM with a tungsten hairpin filament will have a resolution limit of about 100nm at 1keV. Recently, a new field emission gun (FEG) SEM, the Hitachi S900, was introduced with a reported resolution of 0.8nm at 30keV and 5nm at 1keV. In this research we are reporting the results of imaging coated and uncoated polymer samples at accelerating voltages between 1keV and 30keV in a tungsten hairpin SEM and in the Hitachi S900 FEG SEM.

The use of an energy-filtering electron microscope to reduce chromatic aberration in images of thick biological specimens

1986 ◽  
Vol 44 ◽  
pp. 88-91
Author(s):  
L. D. Peachey ◽  
J. P. Heath ◽  
G. Lamprecht
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Electron Beam ◽  
Cross Section ◽  
Electron Scattering ◽  
Chromatic Aberration ◽  
Image Resolution ◽  
Incident Electron Energy ◽  
Energy Filtering ◽  
Transmission Electron

Biological specimens of cells and tissues generally are considerably thicker than ideal for high resolution transmission electron microscopy. Actual image resolution achieved is limited by chromatic aberration in the image forming electron lenses combined with significant energy loss in the electron beam due to inelastic scattering in the specimen. Increased accelerating voltages (HVEM, IVEM) have been used to reduce the adverse effects of chromatic aberration by decreasing the electron scattering cross-section of the elements in the specimen and by increasing the incident electron energy.

Flux-pinning-related defect structures in melt-processed YBa2Cu3O7-x

1993 ◽  
Vol 51 ◽  
pp. 936-937
Author(s):  
Z. L. Wang ◽  
R. Kontra ◽  
A. Goyal ◽  
D. M. Kroeger ◽  
L.F. Allard
Keyword(s):  
Volume Fraction ◽  
Local Density ◽  
Stacking Faults ◽  
Image Resolution ◽  
Defect Structures ◽  
Atomic Structures ◽  
Transmission Electron ◽  
Point Image ◽  
Related Defect ◽  
Point To Point

Previous studies of Y2BaCuO5/YBa2Cu3O7-δ(Y211/Y123) interfaces in melt-processed and quench-melt-growth processed YBa2Cu3O7-δ using high resolution transmission electron microscopy (HRTEM) and energy dispersive X-ray spectroscopy (EDS) have revealed a high local density of stacking faults in Y123, near the Y211/Y123 interfaces. Calculations made using simple energy considerations suggested that these stacking faults may act as effective flux-pinners and may explain the observations of increased Jc with increasing volume fraction of Y211. The present paper is intended to determine the atomic structures of the observed defects. HRTEM imaging was performed using a Philips CM30 (300 kV) TEM with a point-to-point image resolution of 2.3 Å. Nano-probe EDS analysis was performed using a Philips EM400 TEM/STEM (100 kV) equipped with a field emission gun (FEG), which generated an electron probe of less than 20 Å in diameter.Stacking faults produced by excess single Cu-O layers: Figure 1 shows a HRTEM image of a Y123 film viewed along [100] (or [010]).

Towards 1-Ångstrom-resolution STEM

1993 ◽  
Vol 51 ◽  
pp. 996-997
Author(s):  
H.S. von Harrach ◽  
D.E. Jesson ◽  
S.J. Pennycook
Keyword(s):  
High Resolution ◽  
Field Emission ◽  
Phase Contrast ◽  
Spherical Aberration ◽  
A Priori ◽  
Dark Field ◽  
Image Resolution ◽  
Objective Lens ◽  
Annular Dark Field ◽  
First Results

Phase contrast TEM has been the leading technique for high resolution imaging of materials for many years, whilst STEM has been the principal method for high-resolution microanalysis. However, it was demonstrated many years ago that low angle dark-field STEM imaging is a priori capable of almost 50% higher point resolution than coherent bright-field imaging (i.e. phase contrast TEM or STEM). This advantage was not exploited until Pennycook developed the high-angle annular dark-field (ADF) technique which can provide an incoherent image showing both high image resolution and atomic number contrast.This paper describes the design and first results of a 300kV field-emission STEM (VG Microscopes HB603U) which has improved ADF STEM image resolution towards the 1 angstrom target. The instrument uses a cold field-emission gun, generating a 300 kV beam of up to 1 μA from an 11-stage accelerator. The beam is focussed on to the specimen by two condensers and a condenser-objective lens with a spherical aberration coefficient of 1.0 mm.

Sign in / Sign up

Export Citation Format

Share Document