Organic municipal solid waste gasification for electricity production

Author(s):  
Lara Azzi ◽  
Rayan Hijazi ◽  
Chantai Maatouk
2019 ◽  
Vol 37 (6) ◽  
pp. 631-642 ◽  
Author(s):  
Ana Carolina Medina Jimenez ◽  
Reynaldo Palacios- Bereche ◽  
Silvia Nebra

In Brazil, in 2016, 196,050 tonnes day-1 of municipal solid waste (MSW) were collected, which means a waste generation of 1.035 kg per capita per day. Only 59.1% of the waste has adequate destination in sanitary landfills, whereas the remaining 40.9% has inadequate destination in controlled landfills and open dumps (ABRELPE, 2018). Among all the states in the country, the State of São Paulo has the biggest per capita generation: 2.290 kg. Today, the only waste destination practiced in the country is deposition in landfills, but other possibilities can be considered. Among thermal treatment routes, the gasification of MSW is an interesting alternative to be studied, because of its versatility and relatively low emissions. The aim of this work is to evaluate the potential of electricity generation through MSW gasification in Santo André city, Brazil, comparing three waste gasification technologies: TPS Termiska Processer AB, Carbogas and Energos. These alternatives have operated commercially for a few years, and data are available. Specific characteristics of each technology were taken into account, such as the reactor type and fuel properties. For the electricity production scheme, two energy conversion systems were assumed: an internal combustion engine and a steam power cycle. From the process parameters adopted, the results showed that Carbogas technology, coupled to internal combustion engines, presents the highest efficiency of electricity generation (30%) and also the lowest cost of electrical energy produced (US$65.22 MWh-1) when Santo André’s gate fee is applied.


Fuel ◽  
2021 ◽  
Vol 289 ◽  
pp. 119903
Author(s):  
Navid Kardani ◽  
Annan Zhou ◽  
Majidreza Nazem ◽  
Xiaoshan Lin

Processes ◽  
2020 ◽  
Vol 8 (1) ◽  
pp. 84 ◽  
Author(s):  
Qinyang Gu ◽  
Wei Wu ◽  
Baosheng Jin ◽  
Zheng Zhou

Municipal solid waste (MSW) gasification could be a novel method that shows the various advantages over traditional MSW treatments in China. Other research concluded that MSW gasification was operating by the assistant heat, and the gasification may occur under medium temperature. So, this study is aimed to investigate MSW gasification and pyrolysis behavior and analyze the syngas evolution and reaction mechanism. The MSW samples were collected in daily life and the experiments were carried out in a fixed tubular reactor below 650 °C. The effects of medium temperature and oxygen content on syngas quality were elucidated in depth. The results have shown that temperature can promote the syngas quality in the range of 550–650 °C, because the increasing temperature strengthens the reaction rate. The oxygen content should be controlled in a certain range, or oxidation reactions will be more prominent during gasification. The optimal gasification condition in this study was obtained at 650 °C and an oxygen concentration of 1.25%, the combustible gas yield and the lower heating value (LHV) of syngas of this condition were 0.296 L/g and 10.98 kJ/L, respectively. This study provides insights for MSW gasification under medium temperature, and a practical gasification system can be designed under a certain condition.


2019 ◽  
Vol 140 ◽  
pp. 01006
Author(s):  
Olga Barysheva ◽  
Yuri Khabibullin ◽  
Aida Mukhametzianova

At present, processing and recycling of municipal solid waste (MSW) has become more relevant in our country and the world at large. This problem concerns large towns and cities, where every year millions of tons of all kinds of fractions of household waste are produced. Disposal or recycling of solid waste is an environmental issue, but it is associated with the solution of complex technical, energy and economic challenges. The purpose of this study is to identify the advantages and disadvantages of modern methods of processing and disposal of MSW with the prospect of developing and creating a device for recycling MSW taking into account modern approaches to energy saving and environmental protection. The main results of the study are to create a simple, reliable and technically sound method of MSW disposal to obtain additional energy. The significance of the results obtained for the construction industry is the design of a device for the disposal of solid waste with the production of solid combustion products and further their use as building materials and products for various purposes. Because of the technological process of MSW processing, it becomes possible to generate some returns through use of resulting thermal energy for electricity production.


Sign in / Sign up

Export Citation Format

Share Document