Ultra-Wideband Suppression of SSN Using Localized Topology With CSRRs and Embedded Capacitance in High-Speed Circuits

2013 ◽  
Vol 61 (2) ◽  
pp. 764-772 ◽  
Author(s):  
Hao-Ran Zhu ◽  
Jian-Jie Li ◽  
Jun-Fa Mao
Author(s):  
Furkan Barin ◽  
Ertan Zencir

In this paper, an ultra-wideband fully differential two-stage telescopic 65-nm CMOS op-amp is presented, which uses low-voltage design techniques such as level shifter circuits and low-voltage cascode current mirrors. The designed op-amp consists of two stages. While the telescopic first stage provides high speed and low swing, the second stage provides high gain and large swing. Common-mode feedback circuits (CMFB), which contain five transistors OTA and sensing resistors, are used to set the first-stage output to a known value. The designed two-stage telescopic operational amplifier has 41.04[Formula: see text]dB lower frequency gain, 1.81[Formula: see text]GHz gain-bandwidth product (GBW) and 51.9∘ phase margin under 5[Formula: see text]pF load capacitance. The design consumes a total current of 11.9[Formula: see text]mA from a 1.2-V supply voltage. Presented fully differential two-stage telescopic op-amp by using low-voltage design techniques is suitable for active filter in vehicle-to-everything (V2X) applications with 120[Formula: see text][Formula: see text]m[Formula: see text]m layout area.


2020 ◽  
Vol 2020 ◽  
pp. 1-15
Author(s):  
Long Wen ◽  
Jinkun Han ◽  
Liangliang Song ◽  
Qi Zhang ◽  
Kai Li ◽  
...  

There exists an electromagnetic shielding effect on radio signals in a tunnel, which results in no satellite positioning signal in the tunnel scenario. Moreover, because vehicles always drive at a high speed on the highway, the real-time localization system (RTLS) has a bottleneck in a highway scenario. Thus, the navigation and positioning service in tunnel and highway is an important technology difficulty in the construction of a smart transportation system. In this paper, a new technology combined downlink time difference of arrival (DL-TDoA) is proposed to realize precise and automated RTLS in tunnel and highway scenarios. The DL-TDoA inherits ultra-wideband (UWB) technology to measure the time difference of radio signal propagation between the location tag and four different location base stations, to obtain the distance differences between the location tag and four groups of location base stations. The proposed solution achieves a higher positioning efficiency and positioning capacity to achieve dynamic RTLS. The DL-TDoA technology based on UWB has several advantages in precise positioning and navigation, such as positioning accuracy, security, anti-interference, and power consumption. In the final experiments on both static and dynamic tests, DL-TDoA represents high accuracy and the mean errors of 11.96 cm, 37.11 cm, 50.06 cm, and 87.03 cm in the scenarios of static tests and 30 km/h, 60 km/h, and 80 km/h in dynamic tests, respectively, which satisfy the requirements of RTLS.


2018 ◽  
Vol 60 (4) ◽  
pp. 936-941 ◽  
Author(s):  
Angel Blanco Granja ◽  
Bruno Cimoli ◽  
Sebastián Rodríguez ◽  
Rolf Jakoby ◽  
Jesper Bevensee Jensen ◽  
...  

2015 ◽  
Vol 65 (6) ◽  
pp. 472 ◽  
Author(s):  
M. Sreenivasa Rao ◽  
Chandan C. Mishra ◽  
K. Krishna Naik ◽  
K. Maheshwara Reddy

Electronic warfare receiver works in the wide electromagnetic spectrum in dense radar signal environment. Current trends in radar systems are ultra wideband and low probability of intercept radar technology. Detection of signals from various radar stations is a concern. Performance and probability of intercept are mainly dependent on high speed ADC technology. The sampling and reconstruction functions have to be optimized to capture incoming signals at the receiver to extract characteristics of the radar signal. The compressive sampling of the input signal with orthonormal base vectors, projecting the basis in the union of subspaces and recovery through convex optimisation techniques is the current traditional approach. Modern trends in signal processing suggest the random modulator pre-integrator (RMPI), which sample the input signal at information rate non-adaptively and recovery by the processing of discrete and finite vectors. Analysis of RMPI theory, application to EW receiver, simulation and recovery of EW receiver signals are discussed.


Sign in / Sign up

Export Citation Format

Share Document