Photocatalytic Treatment of Wastewater From 5–Fluorouracil Manufacturing

1996 ◽  
Vol 118 (1) ◽  
pp. 2-8 ◽  
Author(s):  
M. Anheden ◽  
D. Y. Goswami ◽  
G. Svedberg

This paper presents some of the experimental results from a study conducted to demonstrate the potential use of photocatalytic oxidation for decolorization and COD reduction of wastewater from 5–fluorouracil manufacturing. A series of batch experiments, were carried out using diluted solutions of the wastewater with 0.1 percent w/v TiO2. Low pressure mercury lamps were used to simulate the UV part of sunlight. The experiments showed that a complete decolorization and a substantial reduction of COD was achieved within 20 hours with a 20 percent solution. During the reaction period, the pH was noted to decrease considerably, indicating formation of acids. Adding hydrogen peroxide to the solution was found to significantly increase the reaction rates. Adding 2400 ppm of H2O2 gave an 80 percent decrease in color in one hour and a 70-80 percent decrease in COD in 20 hours. The influence of UV-light intensity was also examined. This experiment showed that with a UV-intensity of 15 W/m2, i.e., a cloudy day, the decolorization rate was still considerable, while the COD reduction rate was very low.

1994 ◽  
Vol 29 (9) ◽  
pp. 129-132 ◽  
Author(s):  
H. Gulyas ◽  
D. Bockelmann ◽  
L. Hemmerling ◽  
D. Bahnemann ◽  
I. Sekoulov

Refractory organic compounds in samples of a biologically treated oil reclaiming wastewater with a COD of about 300 mg/l were removed by ozonation with or without hydrogen peroxide or by irradiation with UV light in the presence of titanium dioxide in laboratory scale batch experiments. A 5 hrs UV/TiO2 treatment at pH 3 (energy consumption: about 0.9 kWh/l) resulted in a COD elimination of 70% and an enhanced biodegradability of the organic wastewater constituents. Ozonation was hardly affected by hydrogen peroxide, and a treatment for 47 min (energy consumption about 0.005 kWh/l) led to a COD reduction of about 17% and also to an improved biodegradability. Both processes are suitable for further treatment of biologically oxidized oil reclaiming wastewaters.


1995 ◽  
Vol 31 (5-6) ◽  
pp. 131-134 ◽  
Author(s):  
Ritva L. Rajala-Mustonen ◽  
Helvi Heinonen-Tanski

Chlorine and its derivatives are no longer regarded as acceptable disinfectants of water because of compounds they form with organic material in water. These compounds have been proved to be mutagenic and carcinogenic to man. Alternative disinfectants like UV radiation and ozonization are regarded as less harmful disinfectants of microorganisms in water. In the present study the effect of UV radiation alone and together with hydrogen peroxide, and ozone treatment on the inactivation of coliphages in tap water were studied. Two phage types, DNA- and RNA-phages were seeded into tap water and exposed to these disinfectants in batch experiments. The inactivation of phages was determined as a reduction of phage titer as a function of contact time. Disinfection with ozone proved to inactivate coliphages more rapidly than UV light or UV light together with hydrogen peroxide (H2O2). After two minutes exposure time the reduction in phage titer was from 6 to 8 log units with ozone while with UV light or UV with H2O2 the reduction was from three to four log units. According to these results ozonization seemed to be more efficient disinfectant than UV light radiation.


2004 ◽  
Vol 49 (4) ◽  
pp. 117-122 ◽  
Author(s):  
C.Y. Kwan ◽  
W. Chu

The photodegradation of a herbicide 2,4-dichlorophenoxyacetic acid (2,4-D) by ferrous oxalate/UV/H2O2 was studied. Ferrous oxalate, the more photoactive and reactive species, was found to react faster with hydrogen peroxide for hydroxyl radical production than ferrous ions under UV irradiation. About 2.9 times greater rate enhancement was found with the addition of 0.3 mM oxalate than that of a solution containing 0.1 mM Fe2+ and 1 mM H2O2 in the presence of UV light at 253.7 nm. The kinetics dependence of hydrogen peroxide concentration and initial solution pH were also investigated. A threefold increase in peroxide concentration could accelerate the removal of 2,4-D and nearly complete the reaction in 30 min of illumination. The initial decay rate of 2,4-D treated by ferrous oxalate/UV/H2O2 accelerated from 0.0029 to 0.0034 s-1 and the overall removal of the starting material increased from 78% to 99.9%. The 2,4-D transformation at lower initial pH had higher reaction rates than that at higher pH and different reaction mechanisms were identified. The efficiency of the herbicide decomposition was retarded 2.6 times and 9.6 times as initial pH increased from 2.8 to 5.1 and 9.0, respectively.


2018 ◽  
Vol 15 (1) ◽  
pp. 11-20 ◽  
Author(s):  
Maria A. Morosanova ◽  
Anton S. Fedorov ◽  
Elena I. Morosanova

Background: The consumption of antioxidants, including phenolic compounds, is considered important for preventing the oxidative damage diseases and ageing. The total polyphenol content (TPC) is the parameter used to estimate the quality of plant-derived products. Methods: Phenol oxidase activity of green bean (Phaseolus vulgaris) crude extract (in the presence of hydrogen peroxide) and banana (Musa sp.) pulp crude extract has been studied spectrophotometrically using catechol, gallic acid, caffeic acid, ferulic acid, and quercetin as substrates. All studied compounds have been oxidized in the presence of green bean crude extract and hydrogen peroxide; all studied compounds except ferulic acid have been oxidized in the presence of banana pulp crude extract. Michaelis constants (Km) and maximum reaction rates (Vmax) have been determined for oxidation in the presence of green bean crude extract and hydrogen peroxide (Km are 3.8×10-4 M, 1.6×10-3 M, 2.2×10-4 M, 2.3×10-4 M, 1.4×10-4 M and Vmax are 0.046 min-1, 0.102 min-1, 0.185 min-1, 0.053 min-1, 0.041 min-1 for catechol, gallic acid, caffeic acid, ferulic acid, and quercetin, respectively) and for oxidation in the presence of banana pulp crude extract (Km are 1.6×10-3 M, 3.8×10-3 M, 2.2×10-3 M, 4.2×10-4 M and Vmax are 0.058 min-1, 0.025 min-1, 0.027 min-1, 0.015 min-1 for catechol, gallic acid, caffeic acid, and quercetin, respectively). The influence of 3-methyl-2-benzothiazolinone hydrazone (MBTH) on the oxidation reactions kinetics has been studied: Michaelis constants values decrease and maximum reaction rates increase, which contributes to the increase in sensitivity of the determination. Results: Kinetic procedures of Total Polyphenol Content (TPC) determination using crude plants extracts in the presence of MBTH have been proposed (time of analysis is 1 min). For gallic acid (used as a standard for TPC determination) detection limit is 5.3×10-5 M, quantitation limit is 1.8×10-4 M, and linear range is 1.8×10-4 - 1.3×10-3 M for green bean crude extract; detection limit is 2.9×10-5 M, quantitation limit is 9.5×10-5 M, and linear range is 9.5×10-5 - 2.4×10-3 M for banana pulp crude extract. Proposed procedures are characterized by higher interference thresholds for sulfites, ascorbic acid, and citric acid compared to pure enzymes (horseradish peroxidase and mushroom tyrosinase) in the same conditions. Compared with standard Folin-Ciocalteu (FC) method the procedures described in this work are also characterized by less interference and more rapid determination. Conclusion: The procedures have been applied to TPC determination in tea, coffee, and wine samples. The results agree with the FC method for tea and coffee samples and are lower for wine samples, probably, due to sulfites interference.


Proceedings ◽  
2019 ◽  
Vol 16 (1) ◽  
pp. 44
Author(s):  
Kozak ◽  
Włodarczyk-Makuła

The aim of the research was to determine the effectiveness of removing micro-organic pollutants, including PAHs, using the modified Fenton method. The tested material was pretreated coke wastewater, in which the initial chemical oxygen demand (COD) value and initial polycyclic aromatic hydrocarbons (PAHs) concentration were determined. The samples were then subjected to an oxidation procedure. Before the process, the pH was adjusted to 3.5–3.8. Next, the following doses of sodium carbonate—hydrogen peroxide (2/3): 1.2 g/L, 1.5 g/L and 2 g/L, and a constant dose of iron sulphate were added. The next step was exposing the samples to UV light for 6 min and separating the organic matrix from the samples of wastewater. After the tests, the final value of the COD and the final PAHs concentration were determined. The average content of organic pollutants in pretreated coke wastewater determined by the COD index was 538 mg/L, and after the oxidation process, the COD index decreased in the range from 9 to 29%. The efficiency of the degradation of the sum of 16 PAHs was varied and was in the range of 94–97.6%. The research results show that sodium carbonate—hydrogen peroxide (2/3) can be used for the degradation of organic pollutants, such as PAHs, in the modified Fenton process.


2019 ◽  
Vol 82 (11) ◽  
pp. 1896-1900
Author(s):  
A. M. JONES-IBARRA ◽  
C. Z. ALVARADO ◽  
CRAIG D. COUFAL ◽  
T. MATTHEW TAYLOR

ABSTRACT Chicken carcass frames are used to obtain mechanically separated chicken (MSC) for use in other further processed food products. Previous foodborne disease outbreaks involving Salmonella-contaminated MSC have demonstrated the potential for the human pathogen to be transmitted to consumers via MSC. The current study evaluated the efficacy of multiple treatments applied to the surfaces of chicken carcass frames to reduce microbial loads on noninoculated frames and frames inoculated with a cocktail of Salmonella enterica serovar Enteritidis and Salmonella enterica serovar Typhimurium. Inoculated or noninoculated frames were left untreated (control) or were subjected to treatment using a prototype sanitization apparatus. Treatments consisted of (i) a sterile water rinse, (ii) a water rinse followed by 5 s of UV-C light application, or (iii) an advanced oxidation process (AOP) combining 5 or 7% (v/v) hydrogen peroxide (H2O2) with UV-C light. Treatment with 7% H2O2 and UV-C light reduced numbers of aerobic bacteria by up to 1.5 log CFU per frame (P < 0.05); reductions in aerobic bacteria subjected to other treatments did not statistically differ from one another (initial mean load on nontreated frames: 3.6 ± 0.1 log CFU per frame). Salmonella numbers (mean load on inoculated, nontreated control was 5.6 ± 0.2 log CFU per frame) were maximally reduced by AOP application in comparison with other treatments. No difference in Salmonella reductions obtained by 5% H2O2 (1.1 log CFU per frame) was detected compared with that obtained following 7% H2O2 use (1.0 log CFU per frame). The AOP treatment for sanitization of chicken carcass frames reduces microbial contamination on chicken carcass frames that are subsequently used for manufacture of MSC.


1992 ◽  
Vol 27 (1) ◽  
pp. 57-68 ◽  
Author(s):  
D.W. Sundstrom ◽  
B.A. Weir ◽  
T. A. Barber ◽  
H. E. Klei

Abstract This project investigated the destruction of organic compounds and microorganisms in water by ultraviolet catalyzed oxidation using hydrogen peroxide as the oxidizing agent. The combination of UV light and hydrogen peroxide was effective in decomposing all of the organic compounds studied. The rates of destruction increased with increasing peroxide concentration and UV light intensity, and were highly dependent on chemical structure. The destruction of mixtures of organic compounds showed strong interactions between reacting components. The inactivation of E. coli and B. subtilis spores by UV light and/or hydrogen peroxide was studied in flat plate reactors. By using thin liquid films, the combination of UV light and peroxide greatly increased the rates of inactivation of both microorganisms. The results were correlated by a mixed second order kinetic model.


2012 ◽  
Vol 45 (8) ◽  
pp. 581-587
Author(s):  
Cheng-Zhu Zhu ◽  
Qiao-Hong Liu ◽  
Jun Lu ◽  
Shu-Chuan Peng ◽  
Hui-Qi Hou

2011 ◽  
Vol 233-235 ◽  
pp. 1684-1689 ◽  
Author(s):  
Heng Shen Xie ◽  
Zhi Min Zong ◽  
Qing Wei ◽  
Pei Zhi Zhao ◽  
Jian Jun Zhao ◽  
...  

Shenfu bituminous coal (SFBC) and Xilinhaote lignite (XL) were subject to photo-catalytic oxidation with hydrogen peroxide over titanium dioxide. The reaction mixtures were extracted with acetone exhaustively. The extracts were analyzed with FTIR and GC/MS. The results show that coals be oxidized selectively and degraded partially. Compared with the bituminite coal, the oxidation effect of the lignite coal with active hydrogens is more obvious. The alkyl side chains of the macromolecules, particularly, chains of methyl, methylene and aromatic, are the most vulnerable in relation to other compounds in coals. Moreover, the increasing of straight-chain alkanes and the decreasing of condensed nucleus in SFBC and XL through oxidation suggest that the oxidation is an effective method of coal utilization with no difficultly, also be friendly towards the environment after treated as well as in the process of the treatment.


Sign in / Sign up

Export Citation Format

Share Document