Influence of the Contribution of Body Waves to the Result of the Microseismic Sounding Method

2020 ◽  
Vol 66 (2) ◽  
pp. 191-197
Author(s):  
A. A. Tsukanov ◽  
A. V. Gorbatikov
Keyword(s):  
Body Waves ◽  
Microseismic Sounding

scholarly journals Slithering CSF: Cerebrospinal Fluid Dynamics in the Stationary and Moving Viper Boa, Candoia aspera

Biology ◽  
2021 ◽  
Vol 10 (7) ◽  
pp. 672
Author(s):  
Bruce A. Young ◽  
Skye Greer ◽  
Michael Cramberg
Keyword(s):  
Cerebrospinal Fluid ◽  
Cardiac Cycle ◽  
Low Frequency ◽  
Mean Amplitude ◽  
The Body ◽  
Body Waves ◽  
Lower Amplitude ◽  
Lateral Undulation ◽  
Recovery From Anesthesia ◽  
The Relationship

In the viper boa (Candoia aspera), the cerebrospinal fluid (CSF) shows two stable overlapping patterns of pulsations: low-frequency (0.08 Hz) pulses with a mean amplitude of 4.1 mmHg that correspond to the ventilatory cycle, and higher-frequency (0.66 Hz) pulses with a mean amplitude of 1.2 mmHg that correspond to the cardiac cycle. Manual oscillations of anesthetized C. aspera induced propagating sinusoidal body waves. These waves resulted in a different pattern of CSF pulsations with frequencies corresponding to the displacement frequency of the body and with amplitudes greater than those of the cardiac or ventilatory cycles. After recovery from anesthesia, the snakes moved independently using lateral undulation and concertina locomotion. The episodes of lateral undulation produced similar influences on the CSF pressure as were observed during the manual oscillations, though the induced CSF pulsations were of lower amplitude during lateral undulation. No impact on the CSF was found while C. aspera was performing concertina locomotion. The relationship between the propagation of the body and the CSF pulsations suggests that the body movements produce an impulse on the spinal CSF.

Seismic cone penetration test and seismic tomography in permafrost

2004 ◽  
Vol 41 (5) ◽  
pp. 796-813 ◽  
Author(s):  
Anne-Marie LeBlanc ◽  
Richard Fortier ◽  
Michel Allard ◽  
Calin Cosma ◽  
Sylvie Buteau
Keyword(s):  
Seismic Tomography ◽  
Dynamic Properties ◽  
Cone Penetration Test ◽  
The Body ◽  
Body Waves ◽  
Reconstruction Technique ◽  
Seismic Velocities ◽  
Penetration Test ◽  
Cone Penetration ◽  
Seismic Cone Penetration Test

Two high-resolution multi-offset vertical seismic profile (VSP) surveys were carried out in a permafrost mound near Umiujaq in northern Quebec, Canada, while performing seismic cone penetration tests (SCPT) to study the cryostratigraphy and assess the body waves velocities and the dynamic properties of warm permafrost. Penetrometer-mounted triaxial accelerometers were used as the VSP receivers, and a swept impact seismic technique (SIST) source generating both compressional and shear waves was moved near the surface following a cross configuration of 40 seismic shot-point locations surrounding each of the two SCPTs. The inversion of travel times based on a simultaneous iterative reconstruction technique (SIRT) provided tomographic images of the distribution of seismic velocities in permafrost. The Young's and shear moduli at low strains were then calculated from the seismic velocities and the permafrost density measured on core samples. The combination of multi-offset VSP survey, SCPT, SIST, and SIRT for tomographic imaging led to new insights in the dynamic properties of permafrost at temperatures close to 0 °C. The P- and S-wave velocities in permafrost vary from 2400 to 3200 m/s and from 900 to 1750 m/s, respectively, for a temperature range between –0.2 and –2.0 °C. The Young's modulus varies from 2.15 to 13.65 GPa, and the shear modulus varies from 1.00 to 4.75 GPa over the same range of temperature.Key words: permafrost, seismic cone penetration test, vertical seismic profiling, seismic tomography, dynamic properties.

scholarly journals Body waves in poroelastic media saturated by two immiscible fluids

1996 ◽  
Vol 101 (B11) ◽  
pp. 25149-25159 ◽  
Author(s):  
Kagan Tuncay ◽  
M. Yavuz Corapcioglu
Keyword(s):  
Immiscible Fluids ◽  
Body Waves ◽  
Poroelastic Media

The foreshock sequence of the 1986 Chalfant, California, earthquake

1988 ◽  
Vol 78 (1) ◽  
pp. 172-187
Author(s):  
Kenneth D. Smith ◽  
Keith F. Priestley
Keyword(s):  
Main Shock ◽  
Slip Surface ◽  
Body Waves ◽  
Aftershock Distribution ◽  
Time Period ◽  
Main Shocks ◽  
Short Period ◽  
Local Shear ◽  
Stress Drops ◽  
Foreshock Activity

Abstract The ML 6.4 Chalfant, California, earthquake of 21 July 1986 was preceded by an extensive foreshock sequence. Foreshock activity is characterized by shallow clustering activity, including 7 events greater than ML 3, beginning 18 days before the earthquake, an ML 5.7 foreshock 24 hr before the main shock that ruptured only in the upper 10 km of the crust, and an “off-fault” cluster of activity perpendicular to the slip surface of the ML 5.7 foreshock associated with the hypocenter of the main shock. The Chalfant sequence occurred within the local short-period network, and the spatial and temporal development of the foreshock sequence can be observed in detail. Seismicity of the July 1986 time period is largely confined to two nearly conjugate planes; one striking N30°E and dipping 60° to the northwest associated with the ML 5.7 foreshock and the other striking N25°W and dipping 70° to the southwest associated with the main shock. Focal mechanisms for the foreshock period fall into two classes in agreement with these two planes. Shallow clustering of earthquakes in July and the ML 5.7 principal foreshock occur at the intersection of the two planes at a depth of approximately 7 km. The seismic moments determined from inversion of the teleseismic body waves are 4.2 × 1025 and 2.5 × 1025 dyne-cm for the principal foreshock and the main shock, respectively. Slip areas for these two events can be estimated from the aftershock distribution and result in stress drops of 63 bars for the principal foreshock and 16 bars for the main shock. The main shock occurred within an “off-fault” cluster of earthquakes associated with the principal foreshock. This cluster of activity occurs at a predicted local shear stress high in relation to the slip surface of the 20 July earthquake, and this appears to be the triggering mechanism of the main shock. The shallow rupture depth of the principal foreshock indicates that this event was anomalous with respect to the character of main shocks in the region.

Strain to Ground Motion Conversion of DAS Data for Earthquake Magnitude and Stress Drop Determination

2021 ◽  
Author(s):  
Itzhak Lior ◽  
Anthony Sladen ◽  
Diego Mercerat ◽  
Jean-Paul Ampuero ◽  
Diane Rivet ◽  
...  
Keyword(s):  
Early Warning ◽  
Stress Drop ◽  
Source Parameters ◽  
Simulated Data ◽  
Earthquake Early Warning ◽  
Body Waves ◽  
Ocean Bottom ◽  
Correlated Noise ◽  
S Wave ◽  
Earthquake Source Parameters

<p>The use of Distributed Acoustic Sensing (DAS) presents unique advantages for earthquake monitoring compared with standard seismic networks: spatially dense measurements adapted for harsh environments and designed for remote operation. However, the ability to determine earthquake source parameters using DAS is yet to be fully established. In particular, resolving the magnitude and stress drop, is a fundamental objective for seismic monitoring and earthquake early warning. To apply existing methods for source parameter estimation to DAS signals, they must first be converted from strain to ground motions. This conversion can be achieved using the waves’ apparent phase velocity, which varies for different seismic phases ranging from fast body-waves to slow surface- and scattered-waves. To facilitate this conversion and improve its reliability, an algorithm for slowness determination is presented, based on the local slant-stack transform. This approach yields a unique slowness value at each time instance of a DAS time-series. The ability to convert strain-rate signals to ground accelerations is validated using simulated data and applied to several earthquakes recorded by dark fibers of three ocean-bottom telecommunication cables in the Mediterranean Sea. The conversion emphasizes fast body-waves compared to slow scattered-waves and ambient noise, and is robust even in the presence of correlated noise and varying wave propagation directions. Good agreement is found between source parameters determined using converted DAS waveforms and on-land seismometers for both P- and S-wave records. The demonstrated ability to resolve source parameters using P-waves on horizontal ocean-bottom fibers is key for the implementation of DAS based earthquake early warning, which will significantly improve hazard mitigation capabilities for offshore and tsunami earthquakes.</p>

Azimuthal multiple signal classification of dispersive and aliased surface waves recorded in 3D seismic acquisition

Geophysics ◽  
2021 ◽  
pp. 1-84
Author(s):  
Chunying Yang ◽  
Wenchuang Wang
Keyword(s):  
Surface Wave ◽  
Surface Waves ◽  
Body Waves ◽  
Signal Classification ◽  
Dispersion Pattern ◽  
Velocity Spectrum ◽  
Low Velocity ◽  
Surface Wave Dispersion ◽  
Multiple Signal Classification ◽  
Multiple Signal

Irregular acquisition geometry causes discontinuities in the appearance of surface wave events, and a large offset causes seismic records to appear as aliased surface waves. The conventional method of sampling data affects the accuracy of the dispersion spectrum and reduces the resolution of surface waves. At the same time, ”mode kissing” of the low-velocity layer and inhomogeneous scatterers requires a high-resolution method for calculating surface wave dispersion. This study tested the use of the multiple signal classification (MUSIC) algorithm in 3D multichannel and aliased wavefield separation. Azimuthal MUSIC is a useful method to estimate the phase velocity spectrum of aliased surface wave data, and it represent the dispersion spectra of low-velocity and inhomogeneous models. The results of this study demonstrate that mode-kissing affects dispersion imaging, and inhomogeneous scatterers change the direction of surface-wave propagation. Surface waves generated from the new propagation directions are also dispersive. The scattered surface wave has a new dispersion pattern different to that of the entire record. Diagonal loading was introduced to improve the robustness of azimuthal MUSIC, and numerical experiments demonstrate the resultant effectiveness of imaging aliasing surface waves. A phase-matched filter was applied to the results of azimuthal MUSIC, and phase iterations were unwrapped in a fast and stable manner. Aliased surface waves and body waves were separated during this process. Overall, field data demonstrate that azimuthal MUSIC and phase-matched filters can successfully separate aliased surface waves.

The rupture process and aftershock distribution of the 6 April 1992 MS 6.8 earthquake, Offshore British Columbia

1995 ◽  
Vol 85 (3) ◽  
pp. 716-735 ◽  
Author(s):  
John F. Cassidy ◽  
Garry C. Rogers
Keyword(s):  
Surface Waves ◽  
Triple Junction ◽  
Rupture Process ◽  
Body Waves ◽  
Ocean Bottom Seismometer ◽  
Strain Accumulation ◽  
Transform Fault ◽  
Junction Region ◽  
Long Period ◽  
Initial Rupture

Abstract On 6 April 1992, a magnitude 6.8 (MS) earthquake occurred in the triple-junction region at the northern end of the Cascadia subduction zone. This was the largest earthquake in at least 75 yr to occur along the 110-km-long Revere-Dellwood-Wilson (RDW) transform fault and the first large earthquake in this region recorded by modern broadband digital seismic networks. It thus provides an opportunity to examine the rupture process along a young (<2 Ma) oceanic transform fault and to gain better insight into the tectonics of this triple-junction region. We have investigated the source parameters and the rupture process of this earthquake by modeling broadband body waves and long-period surface waves and by accurately locating the mainshock and the first 10 days of aftershocks using a well-located “calibration” event recorded during an ocean-bottom seismometer survey. Analysis of P and SH waveforms reveals that this was a complex rupture sequence consisting of three strike-slip subevents in 12 sec. The initial rupture occurred 5 to 6 km to the SW of the seafloor trace of the RDW fault at 50.55° N, 130.46° W. The dominant subevent occurred 2 to 3 sec later and 4.3 km beneath the seafloor trace of the RDW fault, and a third subevent occurred 5 sec later, 18 km to the NNW, suggesting a northwestward propagating rupture. The aftershock sequence extended along a 60- to 70-km-long segment of the RDW fault, with the bulk of the activity concentrated ∼30 to 40 km to the NNW of the epicenter, consistent with this interpretation. The well-constrained mechanism of the initial rupture (strike/dip/slip 339°/90°/−168°) and of the largest aftershock (165°/80°/170°) are rotated 15° to 20° clockwise relative to the seafloor trace of the RDW fault but are parallel to the Pacific/North America relative plate motion vector. In contrast, the mechanisms of the dominant subevent (326°/87°/−172°), and the long-period solution derived from surface waves aligns with the RDW fault. This suggests that small earthquakes (M < 6) in this area occur along faults that are optimally aligned with respect to the regional stress field, whereas large earthquakes, involving tens of kilometers of rupture, activate the RDW fault. For the mainshock, we estimate a seismic moment (from surface waves) of 1.0 × 1026 dyne-cm, a stress drop of 60 bars, and an average slip of 1.2 m. This represents only 21 yr of strain accumulation, implying that there is either a significant amount of aseismic slip along the RDW fault or that much of the strain accumulation manifests itself as deformation within the Dellwood and Winona blocks or along the continental margin.

Sign in / Sign up

Export Citation Format

Share Document