Viscosity of binary and ternary liquid nonelectrolyte mixtures. Derivation of correlation equations

1981 ◽  
Vol 46 (2) ◽  
pp. 329-339 ◽  
Author(s):  
Pavol Škubla
Keyword(s):  
Kinetic Theory ◽  
Reaction Rates ◽  
Ternary Mixtures ◽  
Kinetic Theory Of Gases ◽  
Correlation Equations ◽  
Binary And Ternary Mixtures ◽  
Model Equations ◽  
Molecule Model ◽  
Eyring's Theory ◽  
Absolute Reaction

Equations for the correlation of viscosity of liquid binary and ternary mixtures were derived from the Eyring's theory of absolute reaction rates and from the three-molecule model of viscosity interactions. Another equation for the correlation of viscosity of binary mixtures was derived from the same theory and from the four-molecule model. Equations for the correlation of viscosity of binary and ternary mixtures were further derived from the quasi-crystalline model of liquids with the use of some relations of the kinetic theory of gases. The derived equations involve the same number of coefficients as the corresponding equations of McAllister or Chandramouli and Laddha and moreover are linear with respect to these coefficients.

Viscosity of binary and tertinary liquid nonelectrolyte mixtures. Comparison of correlation equations and analysis of viscosity curves

1981 ◽  
Vol 46 (2) ◽  
pp. 303-328 ◽  
Author(s):  
Pavol Škubla
Keyword(s):  
Experimental Data ◽  
Binary Mixtures ◽  
Chemical Nature ◽  
Ternary Mixtures ◽  
Correlation Equations ◽  
Binary And Ternary Mixtures

The derived equations for correlation of viscosity of binary and ternary mixtures were tested and compared with those of McAllister, Chandramouli and Laddha. Testing on a large number of experimental data revealed that the equations for correlation of viscosity of binary mixtures are approximately as accurate as the equation of McAllister. On adding another coefficient, the relative deviations are lowered by 26-40%. Equations for correlation of viscosity of ternary mixtures are about as accurate as the equation of Chandramouli and Laddha. Analysis of viscosity curves of binary mixtures revealed a correlation between their form and the chemical nature of the components of the mixture.

Energy saving technology for sintering of black bricks from high-siliceous clay

MRS Advances ◽  
2020 ◽  
Vol 5 (61) ◽  
pp. 3123-3131
Author(s):  
Mario Flores Nicolas ◽  
Marina Vlasova ◽  
Pedro Antonio Márquez Aguilar ◽  
Mykola Kakazey ◽  
Marcos Mauricio Chávez Cano ◽  
...  
Keyword(s):  
Low Temperature ◽  
Oxygen Deficiency ◽  
Glass Ceramics ◽  
Total Content ◽  
Ceramic Materials ◽  
Ternary Mixtures ◽  
High Porosity ◽  
Reducing Conditions ◽  
Binary And Ternary Mixtures ◽  
Dark Color

AbstractThe low-temperature synthesis of bricks prepared from high-siliceous clays by the method of plastic molding of blanks was used. For the preparation of brick blanks, binary and ternary mixtures of high-siliceous clays, black sand, and bottle glass cullet were used. Gray-black low-porosity and high-porosity ceramics was obtained by sintering under conditions of oxygen deficiency. It has been established that to initiate plastic in mixtures containing high-siliceous clay, it is necessary to add montmorillonite/bentonite additives, carry out low-temperature sintering, and introduce low-melting glass additives with a melting point ranging from 750 to 800 °C. The performed investigations have shown that the sintering of mixtures with a total content of iron oxide of about 5 wt% under reducing conditions at Tsint. = 800°C for 8 h leads to the formation of glass ceramics consisting of quartz, feldspars, and a phase. The main sources of the appearance of a dark color is the formation of [Fe3+O4]4- and [Fe3+O6]9- anions in the composition of the glass phase and feldspars. By changing the contents of clay, sand, and glass in sintering, it is possible to obtain two types of ceramic materials: (a) in the form of building bricks and (b) in the form of porous fillers.

Properties of Refrigerants from Cubic Equations of State

2008 ◽  
Vol 59 (5) ◽  
Author(s):  
Viorel Feroiu ◽  
Dan Geana ◽  
Catinca Secuianu
Keyword(s):  
Experimental Data ◽  
Vapor Pressure ◽  
Equations Of State ◽  
Ternary Mixtures ◽  
Volumetric Properties ◽  
Mixing Rules ◽  
Saturation Curve ◽  
Equilibrium Thermodynamic ◽  
Liquid Equilibrium ◽  
Binary And Ternary Mixtures

Vapour � liquid equilibrium, thermodynamic and volumetric properties were predicted for three pure hydrofluorocarbons: difluoromethane (R32), pentafluoroethane (R125) and 1,1,1,2 � tetrafluoroethane (R134a) as well as for binary and ternary mixtures of these refrigerants. Three cubic equations of state GEOS3C, SRK (Soave � Redlich � Kwong) and PR (Peng � Robinson) were used. A wide comparison with literature experimental data was made. For the refrigerant mixtures, classical van der Waals mixing rules without interaction parameters were used. The GEOS3C equation, with three parameters estimated by matching several points on the saturation curve (vapor pressure and corresponding liquid volumes), compares favorably to other equations in literature, being simple enough for applications.

Catalytic hydrogenation of binary and ternary mixtures of unsaturated substances in the liquid phase on platinum

1979 ◽  
Vol 44 (8) ◽  
pp. 2378-2383 ◽  
Author(s):  
Libor Červený ◽  
Radka Junová ◽  
Vlastimil Růžička
Keyword(s):  
Liquid Phase ◽  
Binary Mixtures ◽  
Silica Gel ◽  
Catalytic Hydrogenation ◽  
Ternary Systems ◽  
Ternary Mixtures ◽  
Unsaturated Alcohol ◽  
Solvent Concentration ◽  
Binary And Ternary Mixtures ◽  
Hydrogenation Selectivity

Hydrogenation of olefinic substrates in binary and ternary mixtures using 5% Pt on silica gel as the catalyst was studied in normal conditions in the liquid phase with methanol or cyclohexane or in solvent-free systems. The effect of the solvent concentration on the selectivity of hydrogenation of the unsaturated alcohol-olefin binary mixtures was investigated. In ternary systems of unsaturated substrates, the effect of each of the substrates on the selectivity of hydrogenation of the remaining two substances was examined. Another system was found in which a jump change of the hydrogenation selectivity occurred on the vanishing of the fastest reacting substance.

scholarly journals How to Improve Physico-Chemical Properties of Silk Fibroin Materials for Biomedical Applications?—Blending and Cross-Linking of Silk Fibroin—A Review

Materials ◽  
2021 ◽  
Vol 14 (6) ◽  
pp. 1510
Author(s):  
Sylwia Grabska-Zielińska ◽  
Alina Sionkowska
Keyword(s):  
Silk Fibroin ◽  
Biomedical Applications ◽  
Magnetic Particles ◽  
Chemical Properties ◽  
Ternary Mixtures ◽  
Cross Linking ◽  
Advantages And Disadvantages ◽  
Physico Chemical ◽  
Binary And Ternary Mixtures ◽  
To Receive

This review supplies a report on fresh advances in the field of silk fibroin (SF) biopolymer and its blends with biopolymers as new biomaterials. The review also includes a subsection about silk fibroin mixtures with synthetic polymers. Silk fibroin is commonly used to receive biomaterials. However, the materials based on pure polymer present low mechanical parameters, and high enzymatic degradation rate. These properties can be problematic for tissue engineering applications. An increased interest in two- and three-component mixtures and chemically cross-linked materials has been observed due to their improved physico-chemical properties. These materials can be attractive and desirable for both academic, and, industrial attention because they expose improvements in properties required in the biomedical field. The structure, forms, methods of preparation, and some physico-chemical properties of silk fibroin are discussed in this review. Detailed examples are also given from scientific reports and practical experiments. The most common biopolymers: collagen (Coll), chitosan (CTS), alginate (AL), and hyaluronic acid (HA) are discussed as components of silk fibroin-based mixtures. Examples of binary and ternary mixtures, composites with the addition of magnetic particles, hydroxyapatite or titanium dioxide are also included and given. Additionally, the advantages and disadvantages of chemical, physical, and enzymatic cross-linking were demonstrated.

Sign in / Sign up

Export Citation Format

Share Document