LOW DIMENSIONAL NON-CRYSTALLOGRAPHIC METALLIC NANOSTRUCTURES: HRTEM SIMULATION, MODELS AND EXPERIMENTAL RESULTS

2006 ◽  
Vol 20 (13) ◽  
pp. 725-751 ◽  
Author(s):  
J. L. RODRÍGUEZ-LÓPEZ ◽  
J. M. MONTEJANO-CARRIZALES ◽  
M. JOSÉ-YACAMÁN

Modern nanoparticle research in the field of small metallic systems has confirmed that many nanoparticles take on some Platonic and Archimedean solids related shapes. A Platonic solid looks the same from any vertex, and intuitively they appear as good candidates for atomic equilibrium shapes. A very clear example is the icosahedral ( I h ) particle that only shows {111} faces that contribute to produce a more rounded structure. Indeed, many studies report the I h as the most stable particle at the size range r≤20 Å for noble gases and for some metals. In this review, we report on the structure and shape of mono- and bimetallic nanoparticles in the wide size range from 1–300 nm. First, we present AuPd nanoparticles in the 1–2 nm size range that show dodecahedral atomic growth packing, one of the Platonic solid shapes that have not been identified before in this small size range for metallic particles. Next, with particles in the size range of 2–5 nm, we present an energetic surface reconstruction phenomenon observed also on bimetallic nanoparticle systems of AuPd and AuCu , similar to a re-solidification effect observed during cooling process in lead clusters. These binary alloy nanoparticles show the fivefold edges truncated, resulting in {100} faces on decahedral structures, an effect largely envisioned and reported theoretically, with no experimental evidence in the literature before. Next nanostructure we review is a monometallic system in the size range of ≈5 nm that we termed the decmon. We present here some detailed geometrical analysis and experimental evidence that supports our models. Finally, in the size range of 100–300 nm, we present icosahedrally derived star gold nanocrystals which resembles the great stellated dodechaedron, which is a Kepler–Poisont solid. We conclude then that the shape or morphology of some mono- and bimetallic particles evolves with size following the sequence from atoms to the Platonic solids, and with a slightly greater particle's size, they tend to adopt Archimedean related shapes. If the particle's size is still greater, they tend to adopt shapes beyond the Archimedean (Kepler–Poisont) solids, reaching at the very end the bulk structure of solids. We demonstrate both experimentally and by means of computational simulations for each case that this structural atomic growth sequence is followed in such mono- and bimetallic nanoparticles.

Author(s):  
A. Gómez ◽  
P. Schabes-Retchkiman ◽  
M. José-Yacamán ◽  
T. Ocaña

The splitting effect that is observed in microdiffraction pat-terns of small metallic particles in the size range 50-500 Å can be understood using the dynamical theory of electron diffraction for the case of a crystal containing a finite wedge. For the experimental data we refer to part I of this work in these proceedings.


2005 ◽  
Vol 900 ◽  
Author(s):  
Peter N. Njoki ◽  
Jin Luo ◽  
Aisley Jacob ◽  
Rizwan Munawar ◽  
Bilal Khan ◽  
...  

ABSTRACTThe ability to control composition and size in the synthesis of bimetallic nanoparticles is important for the exploitation of the bimetallic catalytic properties. This paper reports recent findings of an investigation of the synthesis of gold-platinum (AuPt) bimetallic nanoparticles in aqueous solution via reduction of AuCl4− and PtCl42− using a combination of reducing and capping agents. In addition to characterization of the morphological properties of the AuPt nanoparticles using TEM and XRD, the electrocatalytic activity of the carbon-supported AuPt nanoparticle catalysts was also examined for oxygen reduction reaction (ORR) using the rotating disk electrode (RDE) technique. The findings have implications to the design of bimetallic nanoparticle catalysts for fuel cell reactions.


Author(s):  
Yu E. Liu ◽  
Yufeng Sun

The investigation of the airfoil is a key design issue in the development and deployment of helium compressor for High Temperature Gas Cooled Reactor. As the helium physical properties are different from the air’s, three flow cases are studied to find out the similarities between helium and air using Fluent in this paper. They are flow within the divergent nozzles, flow around cylinders and flow over cascades under same inlet conditions and geometry. The results indicated some similarity relationships between helium and air cascade flow. NACA 65-(12A10)10 compressor blade was used as sample blade for both air and helium cascades. To test the performance of the blades, calculations were carried out under the condition of kinematics similitude, but different working fluid. The numerical simulation results of air cascades are correlated with NACA experiment results of air subsonic cascades very well. The numerical simulation models for the air subsonic cascades were used to test the performance of similar helium cascades. The cascade performance for helium flows were compared with the air flows and the results are presented in this paper. The purpose of numerical studies is to use blades in the current air compressor as the blades for helium compressor, to develop scaling blades in NACA 65-(12A10)10 blade size range, and to identify practical limitations to the scaling of current conventional blades. The analysis and conclusions presented in this paper can be used as a reference to helium compressor design features and the experimental research works.


2017 ◽  
Vol 17 (6) ◽  
pp. 4159-4176 ◽  
Author(s):  
Pascal Lemaitre ◽  
Arnaud Querel ◽  
Marie Monier ◽  
Thibault Menard ◽  
Emmanuel Porcheron ◽  
...  

Abstract. This article presents new measurements of the efficiency with which aerosol particles of accumulation mode size are collected by a 1.25 mm sized raindrop. These laboratory measurements provide the link to reconcile the scavenging coefficients obtained from theoretical approaches with those from experimental studies. We provide here experimental proof of the rear capture mechanism in the flow around drops, which has a fundamental effect on submicroscopic particles. These experiments thus confirm the efficiencies theoretically simulated by Beard (1974). Finally, we propose a semi-analytical expression to take into account this essential mechanism to calculate the collection efficiency for drops within the rain size range.


Nanomaterials ◽  
2019 ◽  
Vol 9 (8) ◽  
pp. 1183 ◽  
Author(s):  
Daniel Shi ◽  
Zhijun Ouyang ◽  
Yili Zhao ◽  
Jie Xiong ◽  
Xiangyang Shi

Iron/palladium bimetallic nanoparticles (Fe/Pd NPs) are important catalytic materials for the field of environmental remediation. In the present study, filter paper was employed as a substrate for the assembly of Fe/Pd NPs and further applied for the catalytic conversion of hexavalent chromium Cr(VI) toward trivalent Cr(III). First, a filter paper with negative charge was assembled with a layer of positively charged polyethylenimine (PEI) through electrostatic interaction; then, the abundant amine groups of PEI were used to complex Fe(III) ions, followed by reduction via sodium borohydride to produce an Fe NP-assembled filter paper. Thereafter, the Fe/Pd NPs were produced by the reduction of PdCl42− through Fe NPs. The prepared filter paper assembled with Fe/Pd NPs with a mean diameter of 10.1 nm was characterized by various techniques. The Fe/Pd NP-assembled filter paper possesses powerful catalytic activity and can be used to transform Cr(VI) to Cr(III). With its low cost, high sustainability, and convenient industrialization potential, the developed approach may be extended to produce other bimetallic NP-immobilized filter paper for different environmental remediation applications.


2008 ◽  
Vol 131 (1) ◽  
Author(s):  
Thomas Geike ◽  
Valentin L. Popov

The negative squeeze lubrication problem is investigated by means of numerical simulations that account for the dynamics of vaporization. The model is based on bubble dynamics, governed by the Rayleigh–Plesset equation, and the Reynolds equation for compressible fluids. Unlike most existing simulation models our model can predict tensile stresses in the fluid film prior to its rupture, which is in accordance with experimental evidence.


2010 ◽  
Vol 82 (19) ◽  
Author(s):  
Shankar Sivaramakrishnan ◽  
Jianguo Wen ◽  
Michael. E. Scarpelli ◽  
Benjamin J. Pierce ◽  
Jian-Min Zuo

1972 ◽  
Vol 55 (1) ◽  
pp. 74-81 ◽  
Author(s):  
Brian L. Kotzin ◽  
Robert F. Baker

Experimental evidence suggests that exposure of sea urchin gastrulae to 5-bromodeoxyuridine (BUdR), an analog of thymidine, causes a reduction in the rate of synthesis of some RNA species usually transcribed at this stage of development. In pulse-chase experiments, 3H (in gastrula stage 8–15S nuclear DNA labeled with BUdR-3H) could not be chased, with unlabeled BUdR, into 20–60S size-range DNA; in similar experiments in which gastrulae were pulsed with thymidine-3H and then chased with unlabeled thymidine, 3H in 8–15S nuclear DNA could be extensively chased into 20–60S DNA. DNA-RNA hybridization assays indicate that gastrula stage nuclear DNA in the range of 20–60S has greater sequence homology for gastrula stage RNA-3H than does nuclear DNA of similar size-range taken from gastrulae exposed to BUdR for 1 hr. An explanation is offered for the effect of BUdR on transcription and DNA replication in sea urchin embryos.


2018 ◽  
Vol 10 (34) ◽  
pp. 4114-4121 ◽  
Author(s):  
Danny Valera ◽  
Mireya Sánchez ◽  
José R. Domínguez ◽  
José Alvarado ◽  
Patricio J. Espinoza-Montero ◽  
...  

The evaluation and application of glassy carbon electrodes modified with bimetallic nanoparticle deposits.


Sign in / Sign up

Export Citation Format

Share Document