Second Order Universal Filter Using Four Terminal Floating Nullor (FTFN)

2019 ◽  
Vol 28 (06) ◽  
pp. 1950091 ◽  
Author(s):  
Ashish Ranjan ◽  
Subrahmanyam Perumalla ◽  
Ravi Kumar ◽  
Vista John ◽  
Shantikumar Yumnam
Keyword(s):  
Notch Filter ◽  
Second Order ◽  
Band Pass Filter ◽  
Universal Filter ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Input Selection ◽  
Single Output ◽  
Low Pass ◽  
Four Terminal Floating Nullor

In this research paper, a voltage mode second order universal filter using Four Terminal Floating Nullor (FTFN) is presented. The proposed design uses Three Input Single Output (TISO) for the realization of all filter responses namely Low Pass Filter (LPF), High Pass Filter (HPF), Band Pass Filter (BPF), Notch Filter (NF) and All Pass Filter (APF) by using proper input selection. The analog building block, FTFN is simply realized with two commercially available AD844 ICs. The proposed second order universal filter comes with a single FTFN block with four passive components in which no component matching is required for filter realization. The universal filter is well verified using PSPICE simulation. In addition, experimental verification for the second order APF has been performed that confirms the theoretical expectations.

DX-MOCCII Based Fully Cascadable Second Order Current-Mode Universal Filter

2018 ◽  
Vol 27 (07) ◽  
pp. 1850113 ◽  
Author(s):  
Ashok Kumar ◽  
Sajal K. Paul
Keyword(s):  
Notch Filter ◽  
Current Mode ◽  
Second Order ◽  
Current Conveyors ◽  
Band Pass Filter ◽  
Universal Filter ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Band Pass ◽  
Circuit Configuration

The paper presents a new second-order single input multiple output (SIMO) type current mode (CM) universal filter. The proposed circuit uses two dual-X second generation multi-output current conveyors (DX-MOCCII), two grounded capacitors and three grounded resistors. The circuit configuration realizes low-pass filter (LPF), high-pass filter (HPF), band-pass filter (BPF), notch filter (NF) and all-pass filter (APF) responses simultaneously at different output terminals. The new circuit enjoys the features of low input impedance and high output impedance, which is desirable and useful for cascadability in CM circuits. For realizing the universal filter responses, the proposed circuit configuration does not require matching constraint of passive components and both active and passive sensitivities are found low. In addition, the extension of the proposed circuit as a resistorless universal filter has also been presented. As an application of the proposed filter, inverting band pass output is connected to a negative unity gain current follower in a close loop to design voltage and CM multiphase sinusoidal oscillators (MSOs). Comparison of the proposed configuration with available literature is given. The PSPICE simulation of the filter and its application as MSO are performed to verify the agreement with the theoretical proposition.

A New DVCC+ Based Second-Order Current-Mode Universal Filter Consisting of Only Grounded Capacitors

2017 ◽  
Vol 26 (09) ◽  
pp. 1750130 ◽  
Author(s):  
Ahmet Abaci ◽  
Erkan Yuce
Keyword(s):  
Notch Filter ◽  
Current Mode ◽  
Second Order ◽  
Pass Band ◽  
Current Conveyors ◽  
Universal Filter ◽  
Pass Filter ◽  
Low Pass ◽  
Band Pass ◽  
High Output Impedance

In this paper, a new second-order current-mode universal filter using only two plus-type differential voltage current conveyors, three resistors and two grounded capacitors is proposed. The proposed circuit with two identical inputs and three outputs can simultaneously provide second-order high output impedance low-pass, band-pass and notch filter responses. Also, it can realize high-pass and all-pass filter responses with interconnection of relevant output currents. It can be easily tuned electronically. It can be operated properly at high frequencies. A number of simulations based on SPICE program and an experimental test are achieved in order to demonstrate the performance of the proposed filter.

Fractional Order Capacitor in First-Order and Second-Order Filter

2020 ◽  
Vol 12 (1) ◽  
pp. 75-78
Author(s):  
Kanchan Sengar ◽  
Arun Kumar
Keyword(s):  
Fractional Order ◽  
Second Order ◽  
Active Filters ◽  
Band Pass Filter ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Order Filter ◽  
Low Pass ◽  
Band Pass ◽  
High Pass

Background: Fractional order Butterworth and Chebyshev (low-pass filter circuits, highpass filter circuits and band-pass filters circuits) types of first and second order filter circuits have been simulated and their transfer function are derived. The effect of change of the fractional order α on the behavior of the circuits is investigated. Objective: This paper presents the use of fractional order capacitor in active filters. The expressions for the magnitude, phase, the quality factor, the right-phase frequencies, and the half power frequencies are derived and compared with their previous counterpart. Methods: The circuits have been simulated using Orcad as well as MATLAB for the different value of α. We have developed the fractional gain and phase equations for low pass filter circuits, high pass filter circuits and band pass filter circuits in Sallen-Key topology. Results: It is observed that the bandwidth increases significantly with fractional order other than unity for the low pass as well as high pass and band pass filters. Conclusion: We have also seen that in the frequency domain, the magnitude and phase plots in the stop band change nearly linearly with the fractional order. If we compare the fractional Butterworth filters for low-pass and high-pass type with conventional filters then we find that the roll-off rate is equal to the next higher order filter.

NOVEL VOLTAGE-MODE UNIVERSAL FILTER USING ONLY TWO CDBAs

2005 ◽  
Vol 14 (01) ◽  
pp. 159-164 ◽  
Author(s):  
SUDHANSHU MAHESHWARI ◽  
IQBAL A. KHAN
Keyword(s):  
Pass Band ◽  
Universal Filter ◽  
Input Selection ◽  
Voltage Mode ◽  
Single Output ◽  
Control Computer ◽  
Low Pass ◽  
Band Pass ◽  
Pass Through ◽  
High Pass

A novel voltage-mode universal filter employing only two current differencing buffered amplifiers (CDBAs) is proposed. The filter uses four inputs and single output to realize six responses, viz. low-pass, high-pass, inverting band-pass, noninverting band-pass, band-elimination, and all-pass through input selection with independent pole-Q control. Computer simulation results using SPICE are also given to verify the theory.

Novel Low-Pass Microwave Filter Based on Rectangular Ring DGS

2013 ◽  
Vol 273 ◽  
pp. 371-374
Author(s):  
Bao Ping Li ◽  
Yan Liang Zhang
Keyword(s):  
Stop Band ◽  
Center Frequency ◽  
Pass Band ◽  
Band Pass Filter ◽  
Defected Ground Structure ◽  
Ground Structure ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Compact Size ◽  
Low Pass

Due to the frequency response periodicity of distributed transmission line, microstrip band-pass filter usually produces parasitic pass-band and outputs harmonics away from the center frequency of main pass-band. Based on the study of rectangular ring defected ground structure, a 5-order microstrip LPF(low-pass filter) was designed using the single-pole band-stop and slow-wave characteristics of the rectangular ring DGS(Defected Ground Structure) and SISS(Step-Impedance Shunt Stub) structure. Compared with traditional LPF, this LPF presents the advantages of compact size, low insertion loss, broad stop-band and high steep. It also validates the requirements of miniaturization and high performance for filters.

Study of a second order low pass filter based on hybrid SETMOS

2013 ◽  
Author(s):  
Li Cai ◽  
Qiang Kang ◽  
Dang Yuan Shi
Keyword(s):  
Second Order ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Low Pass

The Design of Ideal Positioning Servo System

2015 ◽  
Vol 816 ◽  
pp. 132-139
Author(s):  
Ľubica Miková ◽  
Alexander Gmiterko ◽  
Michal Kelemen
Keyword(s):  
Frequency Characteristic ◽  
Pid Controller ◽  
Transfer Functions ◽  
Servo System ◽  
Second Order ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Low Pass ◽  
Degree Of Stability

The paper deals with the design of an ideal positioning servo system. To achieve this aim, we will derive transfer functions of the PID controller and the second-order low-pass filter while using typical fault frequencies for PID controller with a low pass filter. Consequently, an overall frequency characteristic of the open servo system will be depicted. This characteristic will be further used to determine the amplitude and phase safety, which determine the degree of stability system.

Chatter alleviation for a class of second-order under-actuated mechanical systems with matched and mismatched disturbances

2016 ◽  
Vol 23 (3) ◽  
pp. 458-468
Author(s):  
Jinjin Shi ◽  
Jinxiang Wang ◽  
Fangfa Fu
Keyword(s):  
Sliding Mode ◽  
Mechanical Systems ◽  
Design Procedure ◽  
Second Order ◽  
Control Input ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Sliding Surfaces ◽  
Low Pass ◽  
Mismatched Disturbances

The chattering phenomenon and a system with both matched and mismatched disturbances are the major difficulties in sliding mode control design. This paper presents an effective design procedure to alleviate these two difficulties for a class of second-order under-actuated mechanical systems. In the proposed design, new hierarchical sliding surfaces are designed and a modified disturbance observer is utilized to estimate the lumped disturbance which is a linear combination of the matched and mismatched disturbances. The chatter in control input is filtered out by an integrator, which acts as a low-pass filter. The asymptotic stabilities of the entire sliding surfaces are guaranteed. A design study considering lateral control of a vehicle with matched and mismatched disturbances demonstrates the effectiveness of the proposed design.

Sign in / Sign up

Export Citation Format

Share Document