scholarly journals Evaluation of a Novel Water Treatment Residual Nanoparticles as a Sorbent for Arsenic Removal

2015 ◽  
Vol 2015 ◽  
pp. 1-10 ◽  
Author(s):  
Elsayed Elkhatib ◽  
Ahmed Mahdy ◽  
Fatma Sherif ◽  
Hala Hamadeen
Keyword(s):  
Water Treatment ◽  
Arsenic Removal ◽  
Batch Adsorption ◽  
Hydroxyl Groups ◽  
Surface Complexes ◽  
Surface Hydroxyl ◽  
Ph Values ◽  
First Order Kinetics ◽  
The Stability ◽  
Water Treatment Residual

A novel sorbent, water treatment residual nanoparticles (nWTR), was synthesized and used to remove As(V) from water solutions. The kinetics and equilibrium of As(V) adsorption by nWTR were evaluated. The kinetic data for nWTR at 3 different pH values indicate that As(V) sorption is biphasic, is favored at low pH values, and followed the power function and first-order kinetics models fit. The results of the batch adsorption study showed that nWTR was effective in As(V) removal and its removal capability was 16 times higher than that of bulk WTR. Fourier transmission infrared (FTIR), SEM-EDX spectra, and As fractionation results indicate the crucial role of surface hydroxyl groups in As retention onto nWTR and the high capability of nWTR to immobilize As(V). The stability of As-nWTR surface complexes is suggested as less than 2% of adsorbed As(V) was released from nWTR after 4 consecutive desorption cycles.

scholarly journals THERMODINAMIC PARAMETERS ON THE SORPTION OF PHOSPHATE IONS BY MONTMORILLONITE

2016 ◽  
Vol 4 (1) ◽  
Author(s):  
Ikhsan Jaslin ◽  
Wijayanti Endang ◽  
Sunarto Sunarto
Keyword(s):  
Active Sites ◽  
Surface Complexation ◽  
Outer Sphere ◽  
Hydroxyl Groups ◽  
Process Data ◽  
Surface Complexes ◽  
Surface Complexation Model ◽  
Surface Hydroxyl ◽  
Phosphate Ions ◽  
Sorbate Concentration

The sorption of phosphate by montmorillonite at 10, 30, and 50 oC were investigated aiming to mainly determine thermodynamic parameters for the formation of surface complexes in the adsorption of phosphate ions by montmorillonite. Data were collected by adsorption edge experiments investigating the effect of pH, adsorption isotherms enabling the effect of sorbate concentration, and acid-base titration calculating protons released or taken up by adsorption process. Data analysis was carried out using surface complexation model to fit the data collected in this study using the parameters obtained from previous study, as well as to calculate the values of ΔH and ΔS. Previous study reported that phosphate ions formed two outer-sphere surface complexes with active sites of montmorillonite through hydrogen bonding. In the first complex,  [(XH)0– H2L─]─, the phosphate was held to permanent-charge X─ sites on the tetrahedral siloxane faces, and the second complex, [[(SO─)(SOH)]– – [H2L]─] 2─ was formed through the interaction between the phosphate and variable charge surface hydroxyl groups at the edges of montmorillonite crystals and on the octahedral alumina faces. The values of ΔH for the first and second reactions are 39.756 and 3.765x10-7 kJ mol‒1 respectively. Since both reactions have positive enthalpy values, it can be concluded that the reactions are endothermic. Large energy for the first reaction is needed by X─  sites (permanent negatively charge sites of montmorillonite) to be partially desolvated, on which K+ or other surface cations are replaced by H+ ions in the surface protonated process, and are then ready to interact phosphate ions in the solution. Small values of ΔH for the second reactions indicates that hydrogen bonds formed by phosphate and SOH sites in the second reaction are easily broken out, and the phosphate can easily desorbed from the surface. The values of ΔS for the first and second reactions are 122.523 and 2.393 x10-2  J K‒1 mol‒1, which are greater than -10 kJ mol‒1 and indicates that the surface reactions occurs through dissociative mechanisms.Keywords:   montmorillonite, adsorption edge, extended constant capacitance, surface complexation model, enthalpy, reaction mechanisms

Study on properties of modified nano-TiO2 and its application on antibacterial finishing of textiles

2013 ◽  
Vol 44 (3) ◽  
pp. 351-372 ◽  
Author(s):  
Liming Wang ◽  
Ying Ding ◽  
Yong Shen ◽  
Zaisheng Cai ◽  
Huifang Zhang ◽  
...  
Keyword(s):  
Antibacterial Property ◽  
Antibacterial Properties ◽  
Dispersion Property ◽  
Hydroxyl Groups ◽  
Nano Tio2 ◽  
Ph Values ◽  
Transmission Electron ◽  
Particle Size Analyzer ◽  
Reactive Groups ◽  
The Stability

The dispersion property of modified nano-TiO2 particles and its antibacterial properties on cotton fabrics were studied. The nano-TiO2 particles were modified with reactive groups (such as hydroxyl groups, amino groups and silica groups). The modified nano-TiO2 particles were characterized by particle size analyzer, Fourier transform-infrared spectroscopy and transmission electron microscopy. Besides, the chemical load technology of optimizing the nano-TiO2 on the textile fiber combined with fiber by grafting and cross-linking was studied. The results showed that the stability of nano-TiO2 sol was related to the concentration of the modifier and the pH values of the system. The washing fastness and the antibacterial property of the fabric treated by modified nano-TiO2 had been increased and the antibacterial property of treated fabric was also related to the concentration of the modifier. By determining the fiber’s crystallinity, as well as the fabric’s breaking strength and tear strength, the influence of the modified nano-TiO2 photocatalyst on the structural properties of cotton fiber was discussed.

scholarly journals The influence of thermal treatment on properties of kaolin

2016 ◽  
Vol 70 (5) ◽  
pp. 595-601 ◽  
Author(s):  
Elizabeth Erasmus
Keyword(s):  
South African ◽  
Spinel Phase ◽  
Surface Group ◽  
Atomic Ratio ◽  
Pozzolanic Activity ◽  
Diffusion Control ◽  
Hydroxyl Groups ◽  
Surface Hydroxyl ◽  
First Order Kinetics ◽  
Different Temperatures

The kinetics of dehydroxylation of South African kaolin revealed that both the inner and the surface hydroxyl groups disappear according to first order kinetics, however, the surface group disappeared faster than the inner groups, showing that diffusion control kinetics is also important. The temperature dependent transformations of the kaolin was measure by means of fractional conversion of the ratios between AlO6:AlO4 and Si-O-Al:Si-O-Si, which showed kobs values 0.0168 s-1 and 0.0089 s-1 for the transformation to the spinel phase and values of 0.0165 s-1 and 0.0156 s-1 for the transformation to mullite respectively. The pozzolanic activities of the kaolin calcined at different temperatures showed a maximum pozzolanic activity when the kaolin is calcined at 650?C and the pozzolanic activity for mullite is even less than for the uncalcined kaolin. XPS revealed that the atomic ratio between Si and Al did not change from kaolin to metakaolin (Si:Al = ca. 1.2) however the mullite showed a atomic ratio of Si:Al = 1.52, implying that some deallumination occurred during calcination at high temperatures.

scholarly journals Defluoridation performance comparison of aluminum hydroxides with different crystalline phases

2022 ◽  
Author(s):  
Wei-Zhuo Gai ◽  
Shi-Hu Zhang ◽  
Yang Yang ◽  
Kexi Sun ◽  
Hong Jia ◽  
...  
Keyword(s):  
Aluminum Hydroxide ◽  
Performance Comparison ◽  
Hydroxyl Group ◽  
Fluoride Removal ◽  
Hydroxyl Groups ◽  
Order Kinetic ◽  
Crystalline Phases ◽  
Surface Hydroxyl ◽  
Ph Values ◽  
Aluminum Hydroxides

Abstract Aluminum hydroxide is an eye catching and extensively researched adsorbent for fluoride removal and its defluoridation performance is closely related to the preparation method and crystalline phase. In this research, the defluoridation performances of aluminum hydroxides with different crystalline phases are compared and evaluated in terms of fluoride removal capacity, sensitivity to pH values and residual Al contents after defluoridation. It is found that the defluoridation performance of different aluminum hydroxides follows the order of boehmite > bayerite > gibbsite. The fluoride adsorption on aluminum hydroxides follows pseudo-second-order kinetic model and Langmuir isotherm model, and the maximum defluoridation capacities of boehmite, bayerite and gibbsite are 42.08, 2.97 and 2.74 mg m−2, respectively. The pH values and FTIR analyses reveal that the ligand exchange between fluoride and surface hydroxyl groups is the fluoride removal mechanism. Different aluminum hydroxides have different surface hydroxyl group densities, which results in the different defluoridation capacities. This work provides a new idea to prepare aluminum hydroxide with outstanding defluoridation performance.

IRON OXIDES FROM ELECTROFILTER ASH FOR WATER TREATMENT (ARSENIC REMOVAL)

2009 ◽  
Vol 8 (4) ◽  
pp. 895-900 ◽  
Author(s):  
Ionel Balcu ◽  
Adina Segneanu ◽  
Marius Mirica ◽  
Mirela Iorga ◽  
Catalin Badea ◽  
...  
Keyword(s):  
Water Treatment ◽  
Iron Oxides ◽  
Arsenic Removal

The synthesis and structure of silica-supported bis(h5-cyclopentadienyl)dichlorotitanium(IV) complexes

1986 ◽  
Vol 51 (7) ◽  
pp. 1430-1438 ◽  
Author(s):  
Alena Reissová ◽  
Zdeněk Bastl ◽  
Martin Čapka
Keyword(s):  
Free Surface ◽  
Hydroxyl Groups ◽  
Titanium Complex ◽  
Surface Hydroxyl ◽  
Surface Hydroxyl Groups ◽  
Free Hydroxyl ◽  
Cyclopentadienyl Anion

The title complexes have been obtained by functionalization of silica with cyclopentadienylsilanes of the type Rx(CH3)3 - xSi(CH2)nC5H5 (x = 1-3, n = 0, 1, 3), trimethylsilylation of free surface hydroxyl groups, transformation of the bonded cyclopentadienyl group to the cyclopentadienyl anion, followed by coordination of (h5-cyclopentadienyl)trichlorotitanium. The effects of single steps of the above immobilization on texture of the support, the number of free hydroxyl groups, the coverage of the surface by cyclopentadienyl groups and the degree of their utilization in anchoring the titanium complex have been investigated. ESCA study has shown that the above anchoring leads to formation of the silica-supported bis(h5-cyclopentadienyl)dichlorotitanium(IV) complex.

scholarly journals Measurement of the Intestinal pH in Mice under Various Conditions Reveals Alkalization Induced by Antibiotics

Antibiotics ◽  
2021 ◽  
Vol 10 (2) ◽  
pp. 180
Author(s):  
Kouki Shimizu ◽  
Issei Seiki ◽  
Yoshiyuki Goto ◽  
Takeshi Murata
Keyword(s):  
Antibiotic Treatment ◽  
High Protein Diet ◽  
Intestinal Bacteria ◽  
High Protein ◽  
Protein Diet ◽  
Germ Free ◽  
Treatment Regimens ◽  
Ph Values ◽  
Specific Pathogen ◽  
The Stability

The intestinal pH can greatly influence the stability and absorption of oral drugs. Therefore, knowledge of intestinal pH is necessary to understand the conditions for drug delivery. This has previously been measured in humans and rats. However, information on intestinal pH in mice is insufficient despite these animals being used often in preclinical testing. In this study, 72 female ICR mice housed in SPF (specific pathogen-free) conditions were separated into nine groups to determine the intestinal pH under conditions that might cause pH fluctuations, including high-protein diet, ageing, proton pump inhibitor (PPI) treatment, several antibiotic treatment regimens and germ-free mice. pH was measured in samples collected from the ileum, cecum and colon, and compared to control animals. An electrode, 3 mm in diameter, enabled accurate pH measurements with a small amount of gastrointestinal content. Consequently, the pH values in the cecum and colon were increased by high-protein diet, and the pH in the ileum was decreased by PPI. Drastic alkalization was induced by antibiotics, especially in the cecum and colon. The alkalized pH values in germ-free mice suggested that the reduction in the intestinal bacteria caused by antibiotics led to alkalization. Alkalization of the intestinal pH caused by antibiotic treatment was verified in mice. We need further investigations in clinical settings to check whether the same phenomena occur in patients.

Modeling of sorption kinetics of U(VI) micro-quantities nanostructured materials with anatase mesoporous structures

2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Veniamin Zheleznov ◽  
Aleksey Golikov ◽  
Tatiana Sokolnitskaya ◽  
Sergey Ivannikov
Keyword(s):  
Nanostructured Materials ◽  
Sorption Kinetics ◽  
Uranyl Ion ◽  
Competitive Sorption ◽  
Hydroxyl Groups ◽  
Complex Ions ◽  
The Stability ◽  
Kinetics Of ◽  
Mesoporous Structures ◽  
Ionic Forms

Abstract The sorption kinetics of uranyl ions micro-quantities from fluoride solutions by nanostructured materials with anatase mesoporous structures has been studied. Using the model of competitive sorption of ions and positively charged complexes of uranyl ion on deprotonated hydroxyl groups of an anatase, kinetic curves of changes in the ratio of ionic forms of uranium in solution were calculated. Modeling was carried out under the assumption of a two-stage mechanism of uranium complex ions sorption. The modeling considered the influence of the uranyl ion carbonate complexes formation. The shift in equilibrium among ionic forms of uranyl correlates with the stability of the complexes in solution.

Sign in / Sign up

Export Citation Format

Share Document