scholarly journals Suppression Method of Jump Points for Multipole Magnetic Encoder at Low Temperature Based on Single-Pole Angle Value Fitting

2019 ◽  
Vol 2019 ◽  
pp. 1-18
Author(s):  
L. Wang ◽  
Q. M. Ren ◽  
J. C. Han ◽  
Y. D. Zhang

To eliminate the jump points of multipole angle values after subdivision at low temperature, the magnetic field and temperature field characteristics of a multipole magnetic encoder are analyzed in this study, and the effect of changes in magnetic field strength and temperature field on the precision of angle values is studied. To eliminate the jump point of multipole angle values caused by changes in the temperature field, the suppression method based on single-pole angle value fitting is proposed. The error between the single-pole and multipole angle values is tabulated by the oversampling linear interpolation method, and the precision of fitting single-pole to multipole angle values is effectively improved. The error of the angle value caused by changes in the temperature field is studied and analyzed, and the relationship between the jump angle values and the pole number of the multipole magnetic encoder is obtained. Furthermore, the jump point is compensated for by the jump range of the multipole angle values. Finally, the angle accuracy of the multipole magnetic encoder in a cryogenic chamber is experimentally verified. The experimental results show that the low-temperature jump point compensation method proposed for the multipole magnetic encoder in this paper can effectively suppress the jump of the angle values.


1998 ◽  
Vol 5 (3) ◽  
pp. 937-939 ◽  
Author(s):  
Nobuhiko Sakai ◽  
Hiroshi Ohkubo ◽  
Yasushi Nakamura

A 3 T superconducting magnet has been designed and constructed for magnetic Compton-profile (MCP) measurements with the new capabilities that the magnetic field direction can be altered quickly (within 5 s) and liquid-He refill is not required for more than one week. For the latter capability, two refrigerators have been directly attached to the cryostat to maintain the low temperature of the radiation shields and for the recondensation of liquid He. The system has been satisfactorily operated for over one week.



1996 ◽  
Vol 46 (S3) ◽  
pp. 1213-1214 ◽  
Author(s):  
T. E. Hargreaves ◽  
J. Akimitsu ◽  
D. F. Brewer ◽  
N. E. Hussey ◽  
H. Noma ◽  
...  


1993 ◽  
Vol 208 (3-4) ◽  
pp. 356-362 ◽  
Author(s):  
L. Legrand ◽  
I. Rosenman ◽  
Ch. Simon ◽  
G. Collin


1993 ◽  
Vol 10 (4) ◽  
pp. 275-277
Author(s):  
J.O. Murphy ◽  
J.M. Lopez ◽  
C.P. Dyt

AbstractThe effect of varying magnetic field strength on the frequency of oscillatory motions for cellular multimode magnetoconvection has been investigated. In addition the influence of the thermal, viscous and magnetic diffusivities have been taken into account and the range of preferred horizontal scales established. The relationship between the period of oscillation and the magnetic field strength is determined.





Minerals ◽  
2019 ◽  
Vol 9 (10) ◽  
pp. 609 ◽  
Author(s):  
Wan ◽  
Qu ◽  
Li ◽  
He ◽  
Bu ◽  
...  

Nonpolar hydrocarbon oil (NHO) is one of the most extensively used collectors in the flotation of molybdenite due to its excellent selectivity. However, NHO has low sensibility at pulp temperature. At low temperatures (<283 K), although more kerosene is used, the recovery of molybdenite flotation is still lower than at room temperature. In this study, magnetizing treatment, which is an efficient, low-cost, innovative, and environmentally friendly emulsification method, was used to improve the flotation performance of NHO in low-temperature molybdenite flotation. The test results showed that, compared with unmagnetized kerosene (UMK), the optimum dosage of magnetized kerosene (MK) could be reduced by 11% at 298 K. At the same dosage of kerosene, the flotation recovery of MK was 3% higher than UMK at 278 K. The surface tension measurement results showed that the surface tension of MK rose periodically as the magnetic field intensity increased, and there was a maximum surface tension within each period. Further, the magnetic field intensity had the maximum flotation recovery of molybdenite at the maximum surface tension of MK. Combined with the analysis based on the Girifalco–Good theory and the static drop volume method of interfacial tension, the interfacial tension of kerosene–water was shown to decrease with the increase of the surface tension of kerosene. This finding indicates that the dispersibility of kerosene in pulp could be improved by reducing the size of oil droplets, thereby improving the molybdenite flotation recovery of kerosene at low-temperature pulp. It is helpful to improve the flotation recovery of molybdenite using NHO as a collector for low-temperature pulp (<283 K).



2017 ◽  
Vol 38 (4) ◽  
pp. 555-565
Author(s):  
Alicja Przybył ◽  
Rafał Rakoczy ◽  
Maciej Konopacki ◽  
Marian Kordas ◽  
Radosław Drozd ◽  
...  

Abstract The aim of the study was to present an experimental investigation of the influence of the RMF on mixing time. The obtained results suggest that the homogenization time for the tested experimental set-up depending on the frequency of the RMF can be worked out by means of the relationship between the dimensionless mixing time number and the Reynolds number. It was shown that the magnetic field can be applied successfully to mixing liquids.



2012 ◽  
Vol 503 ◽  
pp. 3-7
Author(s):  
Meng Zhao ◽  
Ji Bin Zou ◽  
Jing Shang

According to researching the spin traveling wave pump, the relationship of the characteristics of magnetic fluid and the press is investigated under the spin magnetic field by the theory method. The relationship of moving, magnetic field and press is investigated by the decoupled computation between the magnetic field and force. The method is scientificity and rationality by the testing. The distributing shape of magnetic fluid in the pump is affected by the adding magnetic field under the spin magnetic field when the magnetic fluid is filled in the pump. At the same time, the adding magnetic field is affected by magnetic particles of magnetic fluid. The magnetic fluid can be moved by the effect of the adding magnetic field in the pump. The flux of magnetic fluid increases with the magnetic field.



Sign in / Sign up

Export Citation Format

Share Document