scholarly journals Two-Dimensional Rotorcraft Downwash Flow Field Measurements by Lidar-Based Wind Scanners with Agile Beam Steering

2014 ◽  
Vol 31 (4) ◽  
pp. 930-937 ◽  
Author(s):  
Mikael Sjöholm ◽  
Nikolas Angelou ◽  
Per Hansen ◽  
Kasper Hjorth Hansen ◽  
Torben Mikkelsen ◽  
...  
Keyword(s):  
Flow Field ◽  
Wind Energy ◽  
Continuous Wave ◽  
Beam Steering ◽  
Vertical Plane ◽  
Line Of Sight ◽  
Opening Angle ◽  
Wind Component ◽  
Good Resolution ◽  
Two Dimensional

Abstract A major risk to helicopters is the unexpected encounter of degraded visual environments in close-to-ground operations, where a loss of visibility often is caused by clouds of dust (brownout) or snow (whiteout) stirred up by intense downwash. The understanding of the phenomenon is limited, and there is a need for instruments that can measure flow fields on scales larger than a few meters with good resolution. This paper reports on the use of synchronized continuous-wave Doppler lidars for rotorcraft downwash flow field studies. Built from a modified ZephIR wind lidar and a double-prism arrangement for agile beam steering, a wind scanner—WindScanner—has been developed at the Department of Wind Energy at the Technical University of Denmark (DTU) Risø campus. The WindScanner measures the line-of-sight component of the airflow remotely and by rapid steering, the line-of-sight direction and the focus position; all points in space within a cone with a full opening angle of 120° can be reached from about 8 m out to some hundred meters depending on the range resolution required. The first two-dimensional mean wind fields measured in a horizontal plane and in a vertical plane below a hovering search and rescue helicopter are presented. Since the line-of-sight directions of the two synchronized WindScanners were scanned within the plane of interest, the influence of the wind component perpendicular to the plane was avoided. The results also demonstrate the possibilities within less demanding flows encountered within complex terrain and wind-energy-related research for which the WindScanner technology primarily has been developed.

scholarly journals Acquisition of a 3 min, two-dimensional glacier velocity field with terrestrial radar interferometry

2017 ◽  
Vol 63 (240) ◽  
pp. 629-636 ◽  
Author(s):  
DENIS VOYTENKO ◽  
TIMOTHY H. DIXON ◽  
DAVID M. HOLLAND ◽  
RYAN CASSOTTO ◽  
IAN M. HOWAT ◽  
...  
Keyword(s):  
Velocity Field ◽  
Flow Field ◽  
Feature Tracking ◽  
High Spatial Resolution ◽  
Velocity Fields ◽  
Radar Interferometry ◽  
Line Of Sight ◽  
Two Dimensional ◽  
Outlet Glacier ◽  
Glacier Velocity

ABSTRACTOutlet glaciers undergo rapid spatial and temporal changes in flow velocity during calving events. Observing such changes requires both high temporal and high spatial resolution methods, something now possible with terrestrial radar interferometry. While a single such radar provides line-of-sight velocity, two radars define both components of the horizontal flow field. To assess the feasibility of obtaining the two-dimensional (2-D) flow field, we deployed two terrestrial radar interferometers at Jakobshavn Isbrae, a major outlet glacier on Greenland's west coast, in the summer of 2012. Here, we develop and demonstrate a method to combine the line-of-sight velocity data from two synchronized radars to produce a 2-D velocity field from a single (3 min) interferogram. Results are compared with the more traditional feature-tracking data obtained from the same radar, averaged over a longer period. We demonstrate the potential and limitations of this new dual-radar approach for obtaining high spatial and temporal resolution 2-D velocity fields at outlet glaciers.

CALCULATION OF THE DEPENDENCE OF THE DISTANCE TO THE LOCATED OBJECT FROM THE CORNER POSITION OF THE VEHICLE LINE

2018 ◽  
pp. 14-18
Author(s):  
V. V. Artyushenko ◽  
A. V. Nikulin
Keyword(s):  
Real Time ◽  
Statistical Physics ◽  
Angular Position ◽  
Three Dimensional ◽  
Line Of Sight ◽  
Two Dimensional ◽  
Radar Station ◽  
Flight Mode ◽  
Vector Algebra ◽  
Analytical Expressions

To simulate echoes from the earth’s surface in the low flight mode, it is necessary to reproduce reliably the delayed reflected sounding signal of the radar in real time. For this, it is necessary to be able to calculate accurately and quickly the dependence of the distance to the object being measured from the angular position of the line of sight of the radar station. Obviously, the simplest expressions for calculating the range can be obtained for a segment or a plane. In the text of the article, analytical expressions for the calculation of range for two-dimensional and three-dimensional cases are obtained. Methods of statistical physics, vector algebra, and the theory of the radar of extended objects were used. Since the calculation of the dependence of the range of the object to the target from the angular position of the line of sight is carried out on the analytical expressions found in the paper, the result obtained is accurate, and due to the relative simplicity of the expressions obtained, the calculation does not require much time.

scholarly journals Influence of a Standing Wave Flow-Field on the Dynamics of a Spray Diffusion Flame

Fluids ◽  
2021 ◽  
Vol 6 (1) ◽  
pp. 27
Author(s):  
J. Barry Greenberg ◽  
David Katoshevski
Keyword(s):  
Liquid Phase ◽  
Flow Field ◽  
Standing Wave ◽  
Diffusion Flame ◽  
Stokes Number ◽  
Flame Height ◽  
Wave Flow ◽  
Two Dimensional ◽  
Governing Equations ◽  
First Time

A theoretical investigation of the influence of a standing wave flow-field on the dynamics of a laminar two-dimensional spray diffusion flame is presented for the first time. The mathematical analysis permits mild slip between the droplets and their host surroundings. For the liquid phase, the use of a small Stokes number as the perturbation parameater enables a solution of the governing equations to be developed. Influence of the standing wave flow-field on droplet grouping is described by a specially constructed modification of the vaporization Damkohler number. Instantaneous flame front shapes are found via a solution for the usual Schwab–Zeldovitch parameter. Numerical results obtained from the analytical solution uncover the strong bearing that droplet grouping, induced by the standing wave flow-field, can have on flame height, shape, and type (over- or under-ventilated) and on the existence of multiple flame fronts.

scholarly journals Two-dimensional flow field distribution characteristics of flocking drainage pipes in tunnel

Open Physics ◽  
2020 ◽  
Vol 18 (1) ◽  
pp. 139-148
Author(s):  
Shiyang Liu ◽  
Xuefu Zhang ◽  
Feng Gao ◽  
Liangwen Wei ◽  
Qiang Liu ◽  
...  
Keyword(s):  
Flow Field ◽  
Field Distribution ◽  
Rapid Development ◽  
Maximum Velocity ◽  
Distribution Characteristics ◽  
Two Dimensional ◽  
Dimensional Flow ◽  
Laboratory Test Results ◽  
Transverse Distance ◽  
Two Dimensional Flow

AbstractWith the rapid development of traffic infrastructure in China, the problem of crystal plugging of tunnel drainage pipes becomes increasingly salient. In order to build a mechanism that is resilient to the crystal plugging of flocking drainage pipes, the present study used the numerical simulation to analyze the two-dimensional flow field distribution characteristics of flocking drainage pipes under different flocking spacings. Then, the results were compared with the laboratory test results. According to the results, the maximum velocity distribution in the flow field of flocking drainage pipes is closely related to the transverse distance h of the fluff, while the longitudinal distance h of the fluff causes little effect; when the transverse distance h of the fluff is less than 6.25D (D refers to the diameter of the fluff), the velocity between the adjacent transverse fluffs will be increased by more than 10%. Moreover, the velocity of the upstream and downstream fluffs will be decreased by 90% compared with that of the inlet; the crystal distribution can be more obvious in the place with larger velocity while it is less at the lower flow rate. The results can provide theoretical support for building a mechanism to deal with and remove the crystallization of flocking drainage pipes.

Flow Visualization by Means of Contactless Inductive Flow Tomography in the Presence of a Magnetic Brake

2015 ◽  
Vol 15 (1) ◽  
pp. 41-48 ◽  
Author(s):  
Matthias Ratajczak ◽  
Thomas Wondrak ◽  
Klaus Timmel ◽  
Frank Stefani ◽  
Sven Eckert
Keyword(s):  
Magnetic Field ◽  
External Magnetic Field ◽  
Magnetic Fields ◽  
Flow Field ◽  
Continuous Casting ◽  
Flow Structure ◽  
Cross Section ◽  
Two Dimensional ◽  
Slab Casting ◽  
Two Dimensional Flow

AbstractIn continuous casting DC magnetic fields perpendicular to the wide faces of the mold are used to control the flow in the mold. Especially in this case, even a rough knowledge of the flow structure in the mold would be highly desirable. The contactless inductive flow tomography (CIFT) allows to reconstruct the dominating two-dimensional flow structure in a slab casting mold by applying one external magnetic field and by measuring the flow-induced magnetic fields outside the mold. For a physical model of a mold with a cross section of 140 mm×35 mm we present preliminary measurements of the flow field in the mold in the presence of a magnetic brake. In addition, we show first reconstructions of the flow field in a mold with the cross section of 400 mm×100 mm demonstrating the upward scalability of CIFT.

A Study of Two-Dimensional Supersonic Air Ejector Systems

1973 ◽  
Vol 187 (1) ◽  
pp. 733-743
Author(s):  
R. S. Benson ◽  
V. A. Eustace
Keyword(s):  
Flow Field ◽  
Secondary Flow ◽  
Ambient Pressure ◽  
Performance Characteristics ◽  
Constant Density ◽  
Two Dimensional ◽  
Theoretical Predictions ◽  
Flow Field Characteristics ◽  
Air Ejector

The performance and flow field characteristics for two-dimensional ejector systems are determined theoretically for the condition when operation is independent of ambient pressure. The method considers the detailed inviscid interaction between the primary and secondary streams within the mixing tube and an estimate is made of the secondary flow entrained by the two-stream viscous mixing region. The validity of the theory is tested by comparing the performance characteristics of an experimental ejector facility with theoretical predictions and by comparing the theoretical flow field, in terms of constant density contours, with infinite fringe interferograms.

Effects of Valve Disc on Flow Characteristics Inside a Swing Check Valve During Opening and Closing Processes

2021 ◽  
Author(s):  
Yi-xiang Xu ◽  
Qiang Ru ◽  
Huai-yu Yao ◽  
Zhi-jiang Jin ◽  
Jin-yuan Qian
Keyword(s):  
Flow Field ◽  
Working Conditions ◽  
Power Plants ◽  
Flow Characteristics ◽  
Check Valve ◽  
Opening Angle ◽  
Piping System ◽  
Total Moment ◽  
Valve Disc ◽  
Opening And Closing

Abstract The check valve is one of the most important devices for safety protection of the piping system in thermal and nuclear power plants. As the key component of the check valve, the valve disc accounts for a major effect on the flow characteristics especially during the opening and closing processes. In this paper, a typical swing check valve is taken as the research object. In order to make a comparative study, three working conditions of 30% THA (Turbine Heat Acceptance), 50% THA and 100% THA are selected. Focusing on the effects of valve disc, how does the valve disc motion interact with the flow field around the valve disc is analyzed with the help of the dynamic mesh technology. The results show that under the combined action of fluid force and gravity, the check valve can be opened and closed quickly. During the opening process, the maximum total moment of the disc appears between 45° ∼ 50° opening angle, and during the closing process the maximum total moment occurs when the disc fully closed. The flow field near the valve disc has similar variation rules with the rotation of the valve disc in the three working conditions, and the pressure near the valve disc reaches the maximum value at the moment of opening and closing. This study can provide some suggestions for the further optimal design of similar swing check valve.

Sign in / Sign up

Export Citation Format

Share Document