scholarly journals An improved non-enzymatic electrochemical sensor amplified with CuO nanostructures for sensitive determination of uric acid

2021 ◽  
Vol 19 (1) ◽  
pp. 481-491
Author(s):  
Jamil A. Buledi ◽  
Sidra Ameen ◽  
Saba A. Memon ◽  
Almas Fatima ◽  
Amber R. Solangi ◽  
...  
Keyword(s):  
Uric Acid ◽  
Copper Oxide ◽  
Dynamic Range ◽  
Limit Of Detection ◽  
Supporting Electrolyte ◽  
Electrochemical Determination ◽  
Potential Range ◽  
Oxide Nanostructures ◽  
Growth Method

Abstract This study displays the facile and fluent electrochemical determination of uric acid (UA) through exceptional copper oxide nanostructures (CuO), as an effective sensing probe. The copper oxide nanostructures were fabricated via an aqueous chemical growth method using sodium hydroxide as a reducing agent, which massively hold hydroxide source. Copper oxide nanostructures showed astonishing electrocatalytic behavior in the detection of UA. Different characterization techniques such as XRD, FESEM, and EDS were exploited to determine crystalline nature, morphologies, and elemental composition of synthesized nanostructures. The cyclic voltammetry (CV) was subjected to investigate the electrochemical performance of UA using copper oxide nanostructures modified glassy carbon electrode CuO/GCE. The CV parameters were optimized at a scan rate of 50 mV/s with −0.7 to 0.9 potential range, and the UA response was investigated at 0.4 mV. PBS buffer of pH 7.4 was exploited as a supporting electrolyte. The linear dynamic range for UA was 0.001–351 mM with a very low limit of detection observed as 0.6 µM. The proposed sensor was successfully applied in urine samples for the detection of UA with improved sensitivity and selectivity.

A highly selective and sensitive electrochemical determination of melamine based on succinic acid functionalized copper oxide nanostructures

RSC Advances ◽  
2015 ◽  
Vol 5 (127) ◽  
pp. 105090-105097 ◽  
Author(s):  
Razium Ali Soomro ◽  
Keith Richard Hallam ◽  
Zafar Hussain Ibupoto ◽  
Aneela Tahira ◽  
Sana Jawaid ◽  
...  
Keyword(s):  
Copper Oxide ◽  
Succinic Acid ◽  
Electrochemical Sensor ◽  
Electrochemical Determination ◽  
Oxide Nanostructures ◽  
Aqueous Environments

This study presents the development of a highly selective and sensitive electrochemical sensor for the determination of melamine from aqueous environments.

scholarly journals Determination of uric acid in human serum by an enzymatic method using N-methyl-N-(4-aminophenyl)-3-methoxyaniline reagent

2003 ◽  
Vol 68 (8-9) ◽  
pp. 691-698 ◽  
Author(s):  
Milena Jelikic-Stankov ◽  
Predrag Djurdjevic ◽  
Dejan Stankov
Keyword(s):  
Uric Acid ◽  
Human Serum ◽  
Limit Of Detection ◽  
Ascorbate Oxidase ◽  
Acid Oxidation ◽  
Uric Acid Concentration ◽  
Enzymatic Method ◽  
Limit Of Quantification ◽  
Relative Standard

In this work a new enzymatic method for the determination of uric acid in human serum has been developed. The method is based on the oxidative coupling reaction between the N-methyl-N-(4-aminophenyl)-3-methoxyaniline (NCP) reagent and the hydrogen ? donor reagent N-ethyl-N-(2-hydroxy-3-sulfopropyl)-3-methylaniline (TOOS), in the system involving three enzymes: uricase, peroxidase and ascorbate oxidase. Using this method uric acid could be determined in concentrations up to 1.428 mmol/L, with a relative standard deviation of up to 1.8 %. The effect of the medium pH and the NCP concentration on the linearity of the chromogen absorbance versus the uric acid concentration curve was investigated. The influence of the uricase activity on the maximum rate of uric acid oxidation was also examined. The use of the NCP reagent demonstrated a more precise and more sensitive determination of the uric acid compared to the determination with 4-aminoantipyrine (4-AA) as the coupling regent. The sensitivity of the method determined from the calibration curve was 0.71 absorbance units per mmol/L of uric acid; the limit of detection was LOD = 0.0035 mmol/L and the limit of quantification was LOQ = 0.015 mmol/L of uric acid.

scholarly journals A novel online coupling of ion selective electrode with the flow injection system for the determination of vitamin B1

2016 ◽  
Vol 13 (2) ◽  
pp. 458-469
Author(s):  
Baghdad Science Journal
Keyword(s):  
Flow Injection ◽  
Dynamic Range ◽  
Limit Of Detection ◽  
Vitamin B1 ◽  
Pharmaceutical Formulations ◽  
Ion Selective Electrode ◽  
Injection System ◽  
Selective Electrode ◽  
Flow Injection System

A simple, fast, selective of a new flow injection analysis method coupled with potentiometric detection was used to determine vitamin B1 in pharmaceutical formulations via the prepared new selective membranes. Two electrodes were constructed for the determination of vitamin B1 based on the ion-pair vitamin B1-phosphotungestic acid (B1-PTA) in a poly (vinyl chloride) supported with a plasticized di-butyl phthalate (DBPH) and di-butyl phosphate (DBP). Applications of these ion selective electrodes for the determination of vitamin B1 in the pharmaceutical preparations for batch and flow injection systems were described. The ion selective membrane exhibited a near-Nernstian slope values 56.88 and 58.53 mV / decade, with the linear dynamic range of vitamin B1 was 5 x 10-5- 1 x 10-2 and 1 x 10-4-1 x 10-2 mol.L-1, in batch and FIA, respectively. The limit of detection was 3.5 x 10-5 and 9.5 x 10-5 mol.L-1, with the percentage linearity 98.85 and 95.22 in batch and FIA, respectively. The suggested ion selective electrode has been utilized perfection in the determination of vitamin B1 in pharmaceutical formulations using batch and flow injection system, respectively.

scholarly journals Simultaneous Determination of Trace Mefenamic Acid in Pharmaceutical Samples via Flow Injection Fluorometry

2020 ◽  
Vol 10 (03) ◽  
pp. 395-401
Author(s):  
Mohammad K. Hammood ◽  
Maryam Hamed
Keyword(s):  
Flow Injection ◽  
Mefenamic Acid ◽  
Dynamic Range ◽  
Limit Of Detection ◽  
Basic Medium ◽  
Minimum Concentration ◽  
Pharmaceutical Samples ◽  
Fluorescence Measurements ◽  
532 Nm

Mefenamic acid belongs to non-steroidal anti-inflammatory drugs that are used widely for the treatment of analgesia. Our aim from this study is to establish a new assay for the quantitative determination of mefenamic acid (MFA) in the pharmaceutical sample by two sensitive and rapid flow injection-fluorometric methods. A homemade fluorometer was used in fluorescence measurements, which using solid-state laser diode 405 and 532 nm as a source, combined with a continuous flow injection technique. The first method depends on the effect of MFA on calcein blue (CLB) fluorescence at 405 nm. Another method is a study of rhodamine-6G (Rh-6G) fluorescence after adding MFA, and recording at 532 nm. Optimum parameters as fluorescent dye concentration, basic medium, flow rate, sample volume, purge time, and delay coil have been investigated. The dynamic range of MFA was 0.2 to 2 mmol.L-1; 0.5 to 2.3 mmol.L-1 with linearity percentage (% r2) 98.92 and 99.83%, for Rh-6G and CLB, respectively. Limit of detection at a minimum concentration in calibration curve 189.34 and 199.89 ng/sample, for Rh-6G and CLB, respectively. The comparison of developed methods with the classical method (UV-vis spectrophotometry) was achieved. The proposed methods were successfully applied for the determination of MFA in the pharmaceutical samples and can be used as an alternative method.

Defects regulating of graphene ink for electrochemical determination of ascorbic acid, dopamine and uric acid

Talanta ◽  
2018 ◽  
Vol 180 ◽  
pp. 248-253 ◽  
Author(s):  
Li Fu ◽  
Aiwu Wang ◽  
Guosong Lai ◽  
Weitao Su ◽  
François Malherbe ◽  
...  
Keyword(s):  
Ascorbic Acid ◽  
Uric Acid ◽  
Electrochemical Determination

Preparation of three-dimensional hollow graphene balls and simultaneous electrochemical determination of dopamine and uric acid

2018 ◽  
Vol 29 (14) ◽  
pp. 12330-12339 ◽  
Author(s):  
Hong Yan Yue ◽  
Shan Shan Song ◽  
Shuo Huang ◽  
Xin Gao ◽  
Bao Wang ◽  
...  
Keyword(s):  
Uric Acid ◽  
Three Dimensional ◽  
Electrochemical Determination

scholarly journals Zinc/Aluminium–Quinclorac Layered Nanocomposite Modified Multi-Walled Carbon Nanotube Paste Electrode for Electrochemical Determination of Bisphenol A

Sensors ◽  
2019 ◽  
Vol 19 (4) ◽  
pp. 941 ◽  
Author(s):  
Rahadian Zainul ◽  
Nurashikin Abd Azis ◽  
Illyas Md Isa ◽  
Norhayati Hashim ◽  
Mohamad Syahrizal Ahmad ◽  
...  
Keyword(s):  
Electron Microscope ◽  
Bisphenol A ◽  
Electrochemical Impedance ◽  
Limit Of Detection ◽  
Electrochemical Determination ◽  
Multiwalled Carbon ◽  
Baby Bottle ◽  
Double Hydroxide ◽  
Paste Electrode

This paper presents the application of zinc/aluminium-layered double hydroxide-quinclorac (Zn/Al-LDH-QC) as a modifier of multiwalled carbon nanotubes (MWCNT) paste electrode for the determination of bisphenol A (BPA). The Zn/Al-LDH-QC/MWCNT morphology was examined by a transmission electron microscope and a scanning electron microscope. Electrochemical impedance spectroscopy was utilized to investigate the electrode interfacial properties. The electrochemical responses of the modified electrode towards BPA were thoroughly evaluated by using square-wave voltammetry technique. The electrode demonstrated three linear plots of BPA concentrations from 3.0 × 10−8–7.0 × 10−7 M (R2 = 0.9876), 1.0 × 10−6–1.0 × 10−5 M (R2 = 0.9836) and 3.0 × 10−5–3.0 × 10−4 M (R2 = 0.9827) with a limit of detection of 4.4 × 10−9 M. The electrode also demonstrated good reproducibility and stability up to one month. The presence of several metal ions and organic did not affect the electrochemical response of BPA. The electrode is also applicable for BPA determination in baby bottle and mineral water samples with a range of recovery between 98.22% and 101.02%.

HPLC method for measurement of purine nucleotide degradation products in cerebrospinal fluid

1996 ◽  
Vol 42 (5) ◽  
pp. 756-760 ◽  
Author(s):  
L Kuracka ◽  
T Kalnovicová ◽  
B Líska ◽  
P Turcáni
Keyword(s):  
Cerebrospinal Fluid ◽  
Uric Acid ◽  
Neurological Disorders ◽  
Limit Of Detection ◽  
Degradation Products ◽  
Potassium Phosphate ◽  
Hplc Method ◽  
Potassium Phosphate Buffer ◽  
Nucleotide Degradation

Abstract We describe a convenient method for the separation and quantification of xanthine, hypoxanthine, and uric acid in 20 microL of cerebrospinal fluid (CSF) with use of HPLC and ultraviolet detection. The analysis is performed on a Sepharon SGX C18 column and the elution system consists of potassium phosphate buffer, pH 5.1, with 20 mL/L methanol. The lower limit of detection was 4 pmol for hypoxanthine and xanthine and 6 pmol for uric acid. Analytical recoveries of purine metabolites ranged from 98.6% to 102.9%. The intra- and interassay CVs were <3%. The applicability of the method is illustrated with the determination of micromolar concentrations of xanthine, hypoxanthine, and uric acid in CSF samples obtained from 113 patients with various neurological disorders.

Sign in / Sign up

Export Citation Format

Share Document