Analysis of Compositionally and Structurally Graded Si:H and Si1−xGex:H Thin Films by Real Time Spectroscopic Ellipsometry

2008 ◽  
Vol 1066 ◽  
Author(s):  
Nikolas Podraza ◽  
Jing Li ◽  
Christopher R. Wronski ◽  
Mark W. Horn ◽  
Elizabeth C. Dickey ◽  
...  

ABSTRACTSilicon-germanium (Si1−xGex:H) thin films have been prepared by plasma enhanced chemical vapor deposition of SiH4 and GeH4 and measured during growth using real time spectroscopic ellipsometry. A two-layer virtual interface analysis has been applied to study the structural evolution of Si:H films prepared in multistep processes utilizing alternating intermediate and low H2-dilution material layers, which have been designed to produce predominately amorphous films with a controlled distribution of microcrystalline particles. The compositional evolution of alloy-graded a-Si1−xGex:H has been studied as well using similar methods. In each case, depth profiles of microcrystalline content, fμc, or Ge content, x, have been extracted. Additionally, real time spectroscopic ellipsometry has been used to monitor post-deposition exposure of a-Si:H, a-Si1−xGex:H, and a-Ge:H films to a hydrogen plasma in situ in order to determine sub-surface amorphous film modification similar to that which would occur when a highly H2-diluted layer is deposited on a layer prepared with lower dilution. These analyses provide guidance for enhanced performance of Si:H based solar cells, through controlled bandgap grading using compositionally graded amorphous binary alloys (a-Si1−xGex:H) or the incorporation of controlled fractions of microcrystallites into bulk amorphous i-layer materials, and by providing a fundamental understanding of the modification of component layers during the deposition of subsequent layers in multilayer stacks.

2005 ◽  
Vol 862 ◽  
Author(s):  
N. J. Podraza ◽  
G. M. Ferreira ◽  
C. R. Wronski ◽  
R. W. Collins

AbstractThe growth of hydrogenated silicon (Si:H) and silicon-germanium alloys (Si1-xGex:H) by plasma-enhanced chemical vapor deposition (PECVD) on crystalline silicon (c-Si) substrates has been studied by real time spectroscopic ellipsometry (RTSE). The motivation is to develop deposition phase diagrams that can provide greater insight into the optimization of amorphous Si1-xGex:H (a-Si1-xGex:H) for multijunction photovoltaics. In initial studies, the phase diagram for bottom cell a-Si1-xGex:H (Eg ˜ 1.4 eV) is found to exhibit fundamental similarities to that for Si:H when both materials are prepared under standard PECVD conditions that optimize pure a-Si:H. These similarities suggest directions for optimizing a-Si1-xGex:H by identifying conditions under which a smooth, stable surface is obtained to the largest possible bulk layer thickness. In phase diagram development for PECVD Si1-xGex:H on c-Si, it has been found that the highest surface stability and smoothest surfaces are obtained using cathodic deposition (self bias: ˜-20 V) with a H2-dilution level just below that of the amorphous-to-(mixed-phase microcrystalline) [→(a+μc)] transition for a thick layer. Due to the promising nature of these results, full phase diagrams are compared for cathodic and anodic Si1-xGex:H as well as for cathodic and anodic Si:H, all on c-Si substrates. The cathodic phase diagram for Si1-xGex:H reveals a narrow range of significant improvement in surface structural evolution near the →(a+μc) transition, and for a-Si:H reveals an extension of the ultrasmooth protocrystalline regime to a much wider range of thickness.


2011 ◽  
Vol 317-319 ◽  
pp. 341-344
Author(s):  
Long Gu ◽  
Hui Dong Yang ◽  
Bo Huang

Amorphous Silicon-germanium films were prepared by radio frequency plasma enhanced chemical vapor deposition (RF-PECVD) on glass substrates. The structural characteristics, deposition rate, photosensitivity, and optical band gap of the silicon-germanium thin films were investigated with plasma power varying from 15W to 45W. The deposition rate increased within a certain range of plasma power. With the plasma power increasing, the photosensitivity of the thin films decreased. It is evident that varying the plasma power changes the deposition rate, photosensitivity, which was fundamentally crucial for the fabrication of a-Si/a-SiGe/a-SiGe stacked solar cells. For our deposition system, the most optimization value was 30-35W.


2003 ◽  
Vol 762 ◽  
Author(s):  
A. S. Ferlauto ◽  
G. M. Ferreira ◽  
R.J. Koval ◽  
J.M. Pearce ◽  
C.R. Wronski ◽  
...  

AbstractThe ability to characterize the phase of the intrinsic (i) layers incorporated into amorphous silicon [a-Si:H] and microcrystalline silicon [μc-Si:H] thin film solar cells is critically important for cell optimization. In our research, a new method has been developed to extract the thickness evolution of the μc-Si:H volume fraction in mixed phase amorphous + microcrystalline silicon [(a+μc)-Si:H] i-layers. This method is based on real time spectroscopic ellipsometry measurements performed during plasma-enhanced chemical vapor deposition of the films. In the analysis, the thickness at which crystallites first nucleate from the a-Si:H phase can be estimated, as well as the nucleation density and microcrystallite cone angle. The results correlate well with structural and solar cell measurements.


2002 ◽  
Vol 756 ◽  
Author(s):  
Zhigang Xu ◽  
Jag Sankar ◽  
Sergey Yarmolenko ◽  
Qiuming Wei

ABSTRACTLiquid fuel combustion chemical vapor deposition technique was successfully used for YSZ thin film processing. The nucleation rates were obtained for the samples processed at different temperatures and total-metal-concentrations in the liquid fuel. An optimum substrate temperature was found for the highest nucleation rate. The nucleation rate was increased with the total-metal-concentration. Structural evolution of the thin film in the early processing stage was studied with regard to the formation of nuclei, crystallites and final crystals on the films. The films were found to be affected by high temperature annealing. The crystals and the thin films were characterized with scanning electron microscopy.


2014 ◽  
Vol 141 (8) ◽  
pp. 084708 ◽  
Author(s):  
Aomar Hadjadj ◽  
Fadila Larbi ◽  
Mickaël Gilliot ◽  
Pere Roca i Cabarrocas

Sign in / Sign up

Export Citation Format

Share Document