On the “Lamellar” Morphology of Poly(p-Phenylene Terephthalamide) and Poly(p-Phenylene Benzobisthiazole)

1988 ◽  
Vol 134 ◽  
Author(s):  
Eric J. Roche
Keyword(s):  
Thin Films ◽  
Molecular Weight ◽  
Quench Rate ◽  
Lamellar Morphology

ABSTRACTRow-nucleated structures in PPTA and PBZT thin films are compared and their dependence upon quench rate and molecular weight illustrated. It is proposed that the lamellar appearance of the morphology is due to a coherent periodic twisting of fibrillar ribbons. The role of crystallosolvate phases is discussed.

Structural Reorganization in Thin Films of High Molecular Weight Block Copolymer Self-Assembly

2013 ◽  
Vol 853 ◽  
pp. 53-56
Author(s):  
Sung Min Park ◽  
Hyung Ju Ahn ◽  
Sang Woo Kim ◽  
Jin Sam Gong ◽  
Du Yeol Ryu
Keyword(s):  
Thin Films ◽  
Molecular Weight ◽  
Block Copolymer ◽  
High Molecular Weight ◽  
Thermal Annealing ◽  
Self Assembly ◽  
Film Surface ◽  
Structural Reorganization ◽  
Solvent Vapor ◽  
Lamellar Morphology

We demonstrate the structural reorganization of microdomain arrays toward the perpendicular orientation of lamellar morphology in high-molecular-weight PS-b-PMMA films using a combinational approach by solvent-vapor and sequential thermal annealing processes. Solvent annealing with a PMMA-selective acetone vapor induced a cylindrical morphology. However, the sequential thermal annealing of block copolymer (BCP) films led to structural reorganization to an equilibrium lamellar morphology, where the lamellar microdomains were oriented to normal to the film surface. This technique suggests an efficient route for directing orientation and structural reorganization of microdomain arrays in the thin films of high-molecular-weight BCP self-assembly.

The study of interfacial reactions of nickel thin films on GaAs

1983 ◽  
Vol 41 ◽  
pp. 156-157
Author(s):  
L.J. Chen ◽  
Y.F. Hsieh
Keyword(s):  
Thin Films ◽  
Integrated Circuits ◽  
Interfacial Reactions ◽  
Metal Contacts ◽  
Nickel Thin Films ◽  
Thin Foils ◽  
The Status ◽  
Si Doped ◽  
Electron Microscopes

One measure of the maturity of a device technology is the ease and reliability of applying contact metallurgy. Compared to metal contact of silicon, the status of GaAs metallization is still at its primitive stage. With the advent of GaAs MESFET and integrated circuits, very stringent requirements were placed on their metal contacts. During the past few years, extensive researches have been conducted in the area of Au-Ge-Ni in order to lower contact resistances and improve uniformity. In this paper, we report the results of TEM study of interfacial reactions between Ni and GaAs as part of the attempt to understand the role of nickel in Au-Ge-Ni contact of GaAs.N-type, Si-doped, (001) oriented GaAs wafers, 15 mil in thickness, were grown by gradient-freeze method. Nickel thin films, 300Å in thickness, were e-gun deposited on GaAs wafers. The samples were then annealed in dry N2 in a 3-zone diffusion furnace at temperatures 200°C - 600°C for 5-180 minutes. Thin foils for TEM examinations were prepared by chemical polishing from the GaA.s side. TEM investigations were performed with JE0L- 100B and JE0L-200CX electron microscopes.

Transmission Electron Microscopy studies of texture of Cr underlayer of magnetic recording hard disk

1991 ◽  
Vol 49 ◽  
pp. 580-581
Author(s):  
L. Tang ◽  
G. Thomas ◽  
M. R. Khan ◽  
S. L. Duan
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Magnetic Recording ◽  
Magnetic Thin Films ◽  
Magnetic Films ◽  
Substrate Bias ◽  
Epitaxial Relationship ◽  
Transmission Electron

Cr thin films are often used as underlayers for Co alloy magnetic thin films, such as Co1, CoNi2, and CoNiCr3, for high density longitudinal magnetic recording. It is belived that the role of the Cr underlayer is to control the growth and texture of the Co alloy magnetic thin films, and, then, to increase the in plane coercivity of the films. Although many epitaxial relationship between the Cr underlayer and the magnetic films, such as ﹛1010﹜Co/ {110﹜Cr4, ﹛2110﹜Co/ ﹛001﹜Cr5, ﹛0002﹜Co/﹛110﹜Cr6, have been suggested and appear to be related to the Cr thickness, the texture of the Cr underlayer itself is still not understood very well. In this study, the texture of a 2000 Å thick Cr underlayer on Nip/Al substrate for thin films of (Co75Ni25)1-xTix dc-sputtered with - 200 V substrate bias is investigated by electron microscopy.

Transmission Electron Microscopy of Evaporated Perylene Thin Films

1990 ◽  
Vol 48 (2) ◽  
pp. 336-337
Author(s):  
C. Ewins ◽  
J.R. Fryer
Keyword(s):  
Electron Microscopy ◽  
Thin Films ◽  
Transmission Electron Microscopy ◽  
Molecular Electronics ◽  
High Vacuum ◽  
Amorphous Layer ◽  
Electric Heater ◽  
Transmission Electron ◽  
Polycyclic Aromatic

The preparation of thin films of organic molecules is currently receiving much attention because of the need to produce good quality thin films for molecular electronics. We have produced thin films of the polycyclic aromatic, perylene C10H12 by evaporation under high vacuum onto a potassium chloride (KCl) substrate. The role of substrate temperature in determining the morphology and crystallography of the films was then investigated by transmission electron microscopy (TEM).The substrate studied was the (001) face of a freshly cleaved crystal of KCl. The temperature of the KCl was controlled by an electric heater or a cold finger. The KCl was heated to 200°C under a vacuum of 10-6 torr and allowed to cool to the desired temperature. The perylene was then evaporated over a period of one minute from a molybdenum boat at a distance of 10cm from the KCl. The perylene thin film was then backed with an amorphous layer of carbon and floated onto copper microscope grids.

Degradation in a Methyl-phenyl Co-Polymeric Polysilane for LED Applications

2003 ◽  
Vol 769 ◽  
Author(s):  
Asha Sharma ◽  
Deepak ◽  
Monica Katiyar ◽  
Satyendra Kumar ◽  
V. Chandrasekhar ◽  
...  
Keyword(s):  
Thin Films ◽  
Molecular Weight ◽  
Light Source ◽  
Room Temperature ◽  
Light Exposure ◽  
Room Temperature Photoluminescence ◽  
Pl Spectrum ◽  
Pl Intensity ◽  
Methyl Phenyl

AbstractThe optical degradation of polysilane copolymer has been studied in spin cast thin films and solutions using light source of 325 nm wavelength. The room temperature photoluminescence (PL) spectrum of these films show a sharp emission at 368 nm when excited with a source of 325 nm. However, the PL intensity deteriorates with time upon light exposure. Further the causes of this degradation have been examined by characterizing the material for its transmission behaviour and changes occurring in molecular weight as analysed by GPC data.

scholarly journals The role of the substrate on the mechanical and thermal stability of Pd thin films during hydrogen (de)sorption

2021 ◽  
Vol 46 (5) ◽  
pp. 4137-4153
Author(s):  
Neha Verma ◽  
Rob Delhez ◽  
Niek M. van der Pers ◽  
Frans D. Tichelaar ◽  
Amarante J. Böttger
Keyword(s):  
Thin Films ◽  
Thermal Stability ◽  
Thermal Stability Of

scholarly journals Adiponectin: Structure, Physiological Functions, Role in Diseases, and Effects of Nutrition

Nutrients ◽  
2021 ◽  
Vol 13 (4) ◽  
pp. 1180
Author(s):  
Kayvan Khoramipour ◽  
Karim Chamari ◽  
Amirhosein Ahmadi Hekmatikar ◽  
Amirhosein Ziyaiyan ◽  
Shima Taherkhani ◽  
...  
Keyword(s):  
Cardiovascular Disease ◽  
Amino Acids ◽  
Molecular Weight ◽  
Energy Regulation ◽  
Treatment Interventions ◽  
Adipose Tissues ◽  
Physiological Functions ◽  
Cellular Events ◽  
Healthy Nutrition

Adiponectin (a protein consisting of 244 amino acids and characterized by a molecular weight of 28 kDa) is a cytokine that is secreted from adipose tissues (adipokine). Available evidence suggests that adiponectin is involved in a variety of physiological functions, molecular and cellular events, including lipid metabolism, energy regulation, immune response and inflammation, and insulin sensitivity. It has a protective effect on neurons and neural stem cells. Adiponectin levels have been reported to be negatively correlated with cancer, cardiovascular disease, and diabetes, and shown to be affected (i.e., significantly increased) by proper healthy nutrition. The present review comprehensively overviews the role of adiponectin in a range of diseases, showing that it can be used as a biomarker for diagnosing these disorders as well as a target for monitoring the effectiveness of preventive and treatment interventions.

Sign in / Sign up

Export Citation Format

Share Document