Novel Microstructures in Microwave Sintered Silicon Nitride

1996 ◽  
Vol 430 ◽  
Author(s):  
M. E. Brito ◽  
K. Hirao ◽  
M. Toriyama ◽  
M. Hirota

AbstractPreliminary results on microwave sintering of seeded silicon nitride show that a well defined bi-modal grain size distribution is attainable in Si3N4-Y2O3-Al2O 3-MgO sintered bodies by microwave sintering at 28 GHz of materials seeded with ß-Si3N4 particles (2 vol. %). A positive effect on the mechanical performance is anticipated for these microstructurally controlled silicon nitride ceramics

1986 ◽  
Vol 71 ◽  
Author(s):  
G.J. Van Der Kolk ◽  
M.J. Verkerk

AbstractAl was evaporated at oxygen partial pressures, PO2, varying between 10−7 and 10−4 Pa on substrates of silicon nitride. The substrate temperature was varied between 20 °C and 250°C. The films were annealed at temperatures up to 500°C.For Al films deposited at 20°C, it was found that the average grain size decreases with increasing oxygen partial pressure. After annealing recrystallization was observed. The relative increase of grain size was less for higher values of pO2. Annealing gave rise to a broad grain size distribution.For Al films deposited at 250°C, the presence of oxygen caused the growth of rough inhomogeneous films. This inhomogeneous structure remained during annealing.


2016 ◽  
Vol 2 (1) ◽  
pp. 13-18
Author(s):  
Imran Khan ◽  
M S A Khan

In the present work we have studied the electrical conductivity, dielectric constant and dielectric loss of Sintered Silicon Nitride ceramics. In this study it was found that the grain size has great impact on electrical conductivity and dielectric properties of Sintered Silicon Nitride Ceramics. The result shows more efficiency of electrical and dielectric properties with nano sized grains.  The sintering was performed in a programmable furnace at 950 K. The dc conductivity measured in the temperature range 300 K to 900 K. At higher temperature (T > 800 K), the dc conductivity increases exponentially with temperature for both of the investigated samples. Dielectric constant and loss are measured in the temperature range 300 K to 900 K with frequency range 1 KHz to 1 MHz. To confirm the grain size, the samples are characterized by the Scanning Electron Microscope (SEM). These types of samples can be used as a high temperature semi-conducting materials.


2013 ◽  
Vol 33 (6) ◽  
pp. 1 ◽  
Author(s):  
Qunhui YANG ◽  
Mujun LI ◽  
Shengxiong YANG ◽  
Benduo ZHU ◽  
Fuwu JI ◽  
...  

1970 ◽  
Vol 2 (2) ◽  
pp. K69-K73 ◽  
Author(s):  
M. Reinbold ◽  
H. Hoffmann

Materials ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 2849
Author(s):  
Marcin Jan Dośpiał

This paper presents domain and structure studies of bonded magnets made from nanocrystalline Nd-(Fe, Co)-B powder. The structure studies were investigated using scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HRTEM), Mössbauer spectroscopy and X-ray diffractometry. On the basis of performed qualitative and quantitative phase composition studies, it was found that investigated alloy was mainly composed of Nd2(Fe-Co)14B hard magnetic phase (98 vol%) and a small amount of Nd1.1Fe4B4 paramagnetic phase (2 vol%). The best fit of grain size distribution was achieved for the lognormal function. The mean grain size determined from transmission electron microscopy (TEM) images on the basis of grain size distribution and diffraction pattern using the Bragg equation was about ≈130 nm. HRTEM images showed that over-stoichiometric Nd was mainly distributed on the grain boundaries as a thin amorphous border of 2 nm in width. The domain structure was investigated using a scanning electron microscope and metallographic light microscope, respectively, by Bitter and Kerr methods, and by magnetic force microscopy. Domain structure studies revealed that the observed domain structure had a labyrinth shape, which is typically observed in magnets, where strong exchange interactions between grains are present. The analysis of the domain structure in different states of magnetization revealed the dynamics of the reversal magnetization process.


Author(s):  
Anna Dobkowska ◽  
Boguslawa Adamczyk – Cieślak ◽  
Dariusz Kuc ◽  
Eugeniusz Hadasik ◽  
Tomasz Płociński ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document