Modelling of Tgs Growth in Space

1981 ◽  
Vol 9 ◽  
Author(s):  
L. C. Liu ◽  
W. R. Wilcox ◽  
R. Kroes ◽  
R. Lal
Keyword(s):  
Growth Rate ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Maximum Temperature ◽  
Ramp Rate ◽  
State Behavior ◽  
Constant Growth Rate ◽  
Constant Growth ◽  
Maximum Temperature Gradient ◽  
Linear Ramp

ABSTRACTTo maintain a constant growth rate in the absence of convection it is necessary to program down the temperature. Trial and error numerical computations were performed to find the first approximation for the required isothermal dissolution period, linear ramp; and polynomial temperature variation period. The linear ramp rate was limited by the specified maximum temperature gradient. The isothermal dissolution turned out to be unnecessary. The linear ramp had to be stopped before the polynomial period was begun to avoid overshooting the specified maximum growth rate. After a few hours the temperature profile approached steady state behavior.

A note on growth curves of rabbit lines selected on growth rate or litter size

1993 ◽  
Vol 57 (2) ◽  
pp. 332-334 ◽  
Author(s):  
A. Blasco ◽  
E. Gómez
Keyword(s):  
Growth Rate ◽  
Litter Size ◽  
Growth Curves ◽  
Live Weight ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Standard Errors ◽  
Adult Weight ◽  
Weight Growth ◽  
Using Data

Two synthetic lines of rabbits were used in the experiment. Line V, selected on litter size, and line R, selected on growth rate. Ninety-six animals were randomly collected from 48 litters, taking a male and a female each time. Richards and Gompertz growth curves were fitted. Sexual dimorphism appeared in the line V but not in the R. Values for b and k were similar in all curves. Maximum growth rate took place in weeks 7 to 8. A break due to weaning could be observed in weeks 4 to 5. Although there is a remarkable similarity of the values of all the parameters using data from the first 20 weeks only, the higher standard errors on adult weight would make 30 weeks the preferable time to take data for live-weight growth curves.

Reassessment of Maximum Growth Rates for C3 and C4 Crops

1978 ◽  
Vol 14 (1) ◽  
pp. 1-5 ◽  
Author(s):  
J. L. Monteith
Keyword(s):  
Growth Rate ◽  
Growth Rates ◽  
Growing Season ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Crop Growth ◽  
Close Inspection ◽  
Similar Difference ◽  
Photosynthetic Efficiencies

SUMMARYFigures for maximum crop growth rates, reviewed by Gifford (1974), suggest that the productivity of C3 and C4 species is almost indistinguishable. However, close inspection of these figures at source and correspondence with several authors revealed a number of errors. When all unreliable figures were discarded, the maximum growth rate for C3 stands fell in the range 34–39 g m−2 d−1 compared with 50–54 g m−2 d−1 for C4 stands. Maximum growth rates averaged over the whole growing season showed a similar difference: 13 g m−2 d−1 for C3 and 22 g m−2 d−1 for C4. These figures correspond to photosynthetic efficiencies of approximately 1·4 and 2·0%.

Interpretation of Experimental Data with Regard to the Activated Sludge Model No.1 and Calibration of the Model for Municipal Wastewater Treatment Plants

1992 ◽  
Vol 25 (6) ◽  
pp. 167-183 ◽  
Author(s):  
H. Siegrist ◽  
M. Tschui
Keyword(s):  
Experimental Data ◽  
Growth Rate ◽  
Activated Sludge ◽  
Municipal Wastewater ◽  
Wastewater Treatment Plants ◽  
Treatment Plant ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Municipal Wastewater Treatment ◽  
Activated Sludge Model

The wastewater of the municipal treatment plants Zürich-Werdhölzli (350000 population equivalents), Zürich-Glatt (110000), and Wattwil (20000) have been characterized with regard to the activated sludge model Nr.1 of the IAWPRC task group. Zürich-Glatt and Wattwil are partly nitrifying treatment plants and Zürich-Werdhölzli is fully nitrifying. The mixing characteristics of the aeration tanks at Werdhölzli and Glatt were determined with sodium bromide as a tracer. The experimental data were used to calibrate hydrolysis, heterotrophic growth and nitrification. Problems arising by calibrating hydrolysis of the paniculate material and by measuring oxygen consumption of heterotrophic and nitrifying microorganisms are discussed. For hydrolysis the experimental data indicate first-order kinetics. For nitrification a maximum growth rate of 0.40±0.07 d−1, corresponding to an observed growth rate of 0.26±0.04 d−1 was calculated at 10°C. The half velocity constant found for 12 and 20°C was 2 mg NH4-N/l. The calibrated model was verified with experimental dam of me Zürich-Werdhölzli treatment plant during ammonia shock load.

Dietary Protein Requirements of Fishes — A Reassessment

1987 ◽  
Vol 44 (11) ◽  
pp. 1995-2001 ◽  
Author(s):  
Stephen H. Bowen
Keyword(s):  
Growth Rate ◽  
Dietary Protein ◽  
Protein Concentration ◽  
Trophic Ecology ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Intake Rate ◽  
Protein Requirement ◽  
Fish Physiology ◽  
Protein Retention

It is widely believed that fishes require more dietary protein than other vertebrates. Many aspects of fish physiology, nutrition, and trophic ecology have been interpreted within the context of this high protein requirement. Here, fishes are compared with terrestrial homeotherms in terms of (1) protein requirement for maintenance, (2) relative protein concentration in the diet required for maximum growth rate, (3) protein intake rate required for maximum growth rate, (4) efficiency of protein retention in growth, and (5) weight of growth achieved per weight of protein ingested. The two animal groups compared differ only in relative protein concentration in the diet required for maximum growth rate. This difference is explained in terms of homeotherms' greater requirement for energy and does not reflect absolute differences in protein requirement. The remaining measures of protein requirement suggest that fishes and terrestrial homeotherms are remarkably similar in their use of protein as a nutritional resource. Reinterpretation of the role of protein in fish physiology, nutrition, and trophic ecology is perhaps in order.

Allometric scaling and taxonomic variation in nutrient utilization traits and maximum growth rate of phytoplankton

2012 ◽  
Vol 57 (2) ◽  
pp. 554-566 ◽  
Author(s):  
Kyle F. Edwards ◽  
Mridul K. Thomas ◽  
Christopher A. Klausmeier ◽  
Elena Litchman
Keyword(s):  
Growth Rate ◽  
Allometric Scaling ◽  
Maximum Growth ◽  
Nutrient Utilization ◽  
Maximum Growth Rate

Instability waves on the air–sea interface

1993 ◽  
Vol 248 ◽  
pp. 363-381 ◽  
Author(s):  
G. H. Wheless ◽  
G. T. Csanady
Keyword(s):  
Surface Tension ◽  
Growth Rate ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Surface Velocity ◽  
Instability Waves ◽  
Interface Surface ◽  
Fluid Properties ◽  
Compound Matrix Method ◽  
Order Of Magnitude

We used a compound matrix method to integrate the Orr–Sommerfeld equation in an investigation of short instability waves (λ < 6 cm) on the coupled shear flow at the air–sea interface under suddenly imposed wind (a gust model). The method is robust and fast, so that the effects of external variables on growth rate could easily be explored. As expected from past theoretical studies, the growth rate proved sensitive to air and water viscosity, and to the curvature of the air velocity profile very close to the interface. Surface tension had less influence, growth rate increasing somewhat with decreasing surface tension. Maximum growth rate and minimum wave speed nearly coincided for some combinations of fluid properties, but not for others.The most important new finding is that, contrary to some past order of magnitude estimates made on theoretical grounds, the eigenfunctions at these short wavelengths are confined to a distance of the order of the viscous wave boundary-layer thickness from the interface. Correspondingly, the perturbation vorticity is high, the streamwise surface velocity perturbation in typical cases being five times the orbital velocity of free waves on an undisturbed water surface. The instability waves should therefore be thought of as fundamentally different flow structures from free waves: given their high vorticity, they are akin to incipient turbulent eddies. They may also be expected to break at a much lower steepness than free waves.

scholarly journals Breeding records of Leptotila rufaxilla (Aves: Columbidae) in southwestern Brazilian Amazon with notes on nesting in some regions of occurrence

2021 ◽  
Vol 28 (3) ◽  
pp. e18793
Author(s):  
Jônatas Lima ◽  
Railene Almeida ◽  
Edson Guilherme
Keyword(s):  
Growth Rate ◽  
Brazilian Amazon ◽  
Nesting Success ◽  
Daily Survival Rate ◽  
Forest Fragment ◽  
Lowland Forest ◽  
Constant Growth Rate ◽  
Nestling Period ◽  
Constant Growth ◽  
Southwestern Amazonia

We present new aspects of breeding biology of Gray-fronted Dove Leptotila rufaxilla, from five nests found between 2012 and 2014 in a lowland forest fragment in southwestern Brazil. The nests simple/platform shape were built at a mean height of 1.90 m above ground. The clutch size was two eggs white and elliptic, incubated for 15 days (based on three nests). We recorded predation in two nests still in incubation phase. Minimum hatch weight of nestlings was 10 g and young fledged with a mean mass of 56 g. The constant growth rate (K) of nestlings was 0.40 with a growth asymptote of 60.7 g. Daily survival rate, Mayfield and apparent nesting success in the incubation period was 90, 20 and 56%, respectively, while in the nestling period were all 100%. Our data and the contribution of citizen science showed that L. rufaxilla breeds over the year, mainly in the rainy season, both in southwestern Amazonia and in other regions of occurrence.

scholarly journals Economics Research Output in BRICS Countries: A Scientometric Dimension

2019 ◽  
Vol 9 (1) ◽  
pp. 14-21
Author(s):  
Kiran P. Savanur
Keyword(s):  
Growth Rate ◽  
Web Of Science ◽  
Research Output ◽  
Activity Index ◽  
Citation Impact ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Economic Research ◽  
Brics Countries ◽  
Economics Research

This article examines the research output of economics published by BRICS countries during 1991-2016. Data collected from the Web of Science database. Growth rate (CAGR), Collaboration index, Transformative Activity index (TAI), Co-authorship index and Relative Citation Impact (RCI) indicators have been adopted to analyze the quantity and impact of economic research. We found that all five BRICS countries contributed approximately 10 percentile of the world’s economics research. The highest contribution was made by China with a total of 4424 articles which is 40.59 percent. Russia has the maximum growth rate of 27.99. Overall collaboration rate of economics publications of BRICS countries is moderate.

scholarly journals Efficacy of Experimental Mouth Rinses on Caries-Related Biofilms in vitro

2021 ◽  
Vol 2 ◽  
Author(s):  
Josiana Steiger ◽  
Olivier Braissant ◽  
Tuomas Waltimo ◽  
Monika Astasov-Frauenhoffer
Keyword(s):  
Growth Rate ◽  
Antimicrobial Agents ◽  
Growth Parameters ◽  
Screening Method ◽  
Maximum Growth ◽  
Maximum Growth Rate ◽  
Screening Process ◽  
Mouth Rinses ◽  
Amine Fluoride

This study assessed the efficacy of tin and Polyethylenglycol (PEG-3) tallow aminopropylamine in different concentrations on Streptococcus mutans (S. mutans) biofilms to establish a new screening process for different antimicrobial agents and to gain more information on the antibacterial effects of these agents on cariogenic biofilms. Isothermal microcalorimetry (IMC) was used to determine differences in two growth parameters: lag time and growth rate; additionally, reduction in active biofilms was calculated. Experimental mouth rinses with 400 and 800 ppm tin derived from stannous fluoride (SnF2) revealed results (43.4 and 49.9% active biofilm reduction, respectively) similar to meridol mouth rinse (400 ppm tin combined with 1,567 ppm PEG-3 tallow aminopropylamine; 55.3% active biofilm reduction) (p &gt; 0.05), while no growth of S. mutans biofilms was detected during 72 h for samples treated with an experimental rinse containing 1,600 ppm tin (100% active biofilm reduction). Only the highest concentration (12,536 ppm) of rinses containing PEG-3 tallow aminopropylamine derived from amine fluoride (AmF) revealed comparable results to meridol (57.5% reduction in active biofilm). Lower concentrations of PEG-3 tallow aminopropylamine showed reductions of 16.9% for 3,134 ppm and 33.5% for 6,268 ppm. Maximum growth rate was significantly lower for all the samples containing SnF2 than for the samples containing control biofilms (p &lt; 0.05); no differences were found between the control and all the PEG-3 tallow aminopropylamine (p &gt; 0.05). The growth parameters showed high reproducibility rates within the treated groups of biofilms and for the controls; thus, the screening method provided reliable results.

Sign in / Sign up

Export Citation Format

Share Document